Fabrication of graphitic carbon nitride functionalized P-CoFe2O4 for the removal of tetracycline under visible light: Optimization, degradation pathways and mechanism evaluation

Catalytic wet air oxidation removal of tetracycline by La2O3 immobilized on recycled polyethylene terephthalate using the response surface methodology

This study investigated the removal of tetracycline from the aqueous solutions by lanthanum oxide nanoparticles covered with polyethylene terephthalate (PET) using a low-cost and facile co-precipitation method, via catalytic wet air oxidation process (CWAO) by response surface methodology (RSM). XRD, FTIR, SEM, and EDX-map techniques have been employed to investigate the crystal structure, functional groups on the surface, morphologic characteristics, and elemental composition, respectively. Under optimum conditions (pH= 9, initial TC concentration= 20 mg L-1, nanocomposite dosage= 1.5 g L-1, pressure= 4 bar, temperature= 70 °C, and time= 90 min), TC removal efficiency by La2O3-PET was achieved at about 99.9%. The environmental parameters were assessed to determine tetracycline catalytic wet air oxidation degradation rate, which included cleaning gases, hydrogen peroxide, type of organic compounds, anions, radical scavenger and reusability. The ANOVA results indicated that the polynomial model proves that the model is entirely meaningful (F-value> 0.001 and P-value< 0.0001) and has high coefficient values of adjusted R2 (0.7404) and predicted R2 (0.5940). The findings indicated that the variables of time, pH, temperature, dosage, and TC concentration have the greatest role in removing tetracycline, respectively. However, pressure as a factor does not have a considerable influence on the performance of the system. In general, due to the presence of the role of additional anionics, the effectiveness of this method for removing tetracycline from drinking water was 82.76%. The catalyst indicated pleasing stability and recycling power during eight testing cycles. Further, the estimated electrical energy per order consumption (EEO) for the CWAO/La2O3-PET system was calculated as 5.31 kWh m-3 with an operational cost (OC) utilization of 1.78 USD kg-1 and it has been shown that this process is feasible and economically comparable to other CWAO processes. The breakdown intermediate products of tetracycline in the CWAO were examined using gas chromatography/mass spectrometry (GC-MS) analysis. The toxicity analyses for the removal of TC were carried out using Daphnia magna and the CWAO process achieved a remarkable decrease in the presence of La2O3-PET nanocomposite (LC50 and toxicity unit (TU) 48 h equal to 0.634 and 157.72 vol percent).

Novel Enzyme-Assisted Recycle Amplification Strategy for Tetracycline Detection Based on Oxidized Single-Walled Carbon Nanohorns

In this study, oxidized single-walled carbon nanohorns (oxSWCNHs) were prepared using nitric acid oxidation and subsequently combined with 3'6-carboxyfluorescein through charge transfer to prepare fluorescent probes. These oxSWCNHs were used to quench fluorogen signals at short distances and dissociate ssDNA using cryonase enzymes. We established a method for rapidly detecting tetracycline (TC) in complex samples based on the amplification of cryonase enzyme signals. After optimizing the experimental conditions, our method showed a detection limit of 5.05 ng/mL, with good specificity. This method was used to determine the TC content in complex samples, yielding a recovery rate of 90.0-103.3%. This result validated the efficacy of our method in detecting TC content within complex samples.

MIL-101(Fe)/WS2 composites activated Na2S2O8 with visible light for removal of tetracycline

MIL-101(Fe)/WS2 catalyst was composited using a solvothermal method. To study the physical and chemical properties of the composite material, a series of characterizations such as scanning electron microscope (SEM), X-ray diffraction (XRD), and catalytic experiments were carried out. The photocatalysis of the prepared catalyst in the degradation of tetracycline was investigated using persulfate (PS, Na2S2O8) as a cocatalyst under visible light illumination. The above system can remove about 80% of tetracycline within 40 min. After three cyclic experiments, the material showed good recycling. According to material characterization and various experimental results, the enhanced performance of the material was attributed to the reduction of the recombination efficiency of photogenerated e- and h+, and activated persulfate to produce a large number of free radicals such as O2•-, SO4•- and 1O2 produced by the active sites provided by the catalyst's high specific surface area.

Facile synthesis of NaA zeolite supported Co2Fe1 for highly efficient degradation of Acid Orange 7 by activation of peroxymonosulfate

The development of heterogeneous Co-based catalysts with an effective combination mode of Co/Fe and supporter, a facile synthetic method, and a low treatment cost is an important environment challenge for azo dyes degradation by peroxymonosulfate (PMS) activation. In this study, NaA zeolite supported CoxFey with various molar ratio of Fe/Si and Co/Fe was synthesized by a facile hydrothermal process, and used to activate PMS for Acid Orange 7 (AO7) degradation. NaA zeolite supported Co2Fe1 with the Fe/Si molar ratio of 1:10 showed superior catalytic performance compared with other NaA zeolite supported CoxFey. In a system containing 0.6 g/L catalysts, 4 mM PMS, pH 5 and T = 30℃, 95.8% AO7 and 79.1% COD conversion could be achieved at 20 and 60 min, respectively, and the first order kinetic rate constant reached 0.14795 min-1. Moreover, NaA zeolite supported Co2Fe1/PMS system exhibited excellent catalytic effect in a wide pH range of 3-9. Temperature had an obvious effect on AO7 degradation, and the activation energy was 31.36 kJ/mol. HCO3- demonstrated an obvious depression on AO7 degradation, while Cl-, SO42- and H2PO4- had a relatively poor impact. Quenching experiments showed that both sulfate radicals ([Formula: see text]) and hydroxyl radicals (·OH) were generated in the PMS reaction system, and the [Formula: see text] was the dominant active radical. During 3 cycles experiments, an acceptable AO7 conversion ratio (91.8%) within 30 min arrived, suggesting the good stability of NaA zeolite supported Co2Fe1.

Strategic insight into enhanced photocatalytic remediation of pharmaceutical contaminants using spherical CdO nanoparticles in visible light region

The sustainable control of pharmaceutical micropollutants in water and wastewater environments is a great challenge in the 21st century. To address these issues, unique CdO nanoparticles (NPs) were synthesized using a facile hydrothermal approach and investigated for photocatalytic control of the antibiotic tetracycline, multidrug-resistant bacteria (MDRB), and total coliform in the wastewater effluent. The NPs were characterized using a range of techniques and it exhibited a spherical-like crystal structure with a mean size of 40 nm. The vibrational stretching mode of 1419 cm^-1 confirmed the formation of Cd-O (M - O). The synthesis protocol formed smoother surfaces and 1.88 eV band gap energy of CdO NPs, inducing excellent photocatalytic activity under visible LED light (blue and white) irradiation. The optimal catalyst dose and pH were 100 mg/L and 8-9, respectively. Blue light proved more effective than white light, resulting in 28% higher efficiency (93 ± 0.47%) in tetracycline degradation than white light under an identical intensity (20 mW/cm²). White light required a four-fold higher light intensity (80 mW/cm²) than blue light to induce comparable photocatalytic MDRB inactivation. Bacterial cell lysis by the photocatalytic treatment was confirmed by transmission electron microscopy (TEM). The used catalyst was easily recovered by 5 min of centrifugation and re-used without any noticeable change in the photocatalytic decomposition. The trapping experiment revealed that the CdO-based NPs contributed primarily to the generation of •O₂^- and •OH radicals (Type I), but the •O₂^- radicals were the dominant reactive oxygen species (ROS) in the photocatalytic process.

Visible-light-driven simultaneous decontamination of multi-antibiotics by facile synthesized BiOCl loaded food wastes biochar

Environmental dissemination caused by widespread use of antibiotics has been regarded as a possible hazard to aquatic ecosystem and human health. The increasing misgivings make it imperative to develop a novel catalyst with remarkable visible-light-driven activity to remove antibiotics, especially for their simultaneous decontamination. Herein, C/BiOCl composites were successfully prepared by decorating BiOCl nanosheets on food wastes biochar (C) by a simple hydrolysis strategy. Not only the binary system of tetracycline antibiotics, but also the ternary mixture could be simultaneously photodegraded over 25% C/BiOCl within 15 min irradiation. The improved photocatalytic activities could be ascribed to the introduction of biochar, endowing increased surface area, enhanced separation of photo-generated charge carriers, and better light absorption. The as-prepared 25% C/BiOCl also demonstrated satisfactory stability and positive removal effect in actual water samples. The present work provides new insights into the development of biochar-based photocatalysts for simultaneous degradation of multiple antibiotics.

N self-doped hierarchically porous carbon derived from biomass as an efficient adsorbent for the removal of tetracycline antibiotics

In this study, we developed a simple strategy to synthesize a N self-doped hierarchically porous carbon adsorbent (LPC-NC) derived from biomass using potassium oxalate monohydrate and calcium carbonate and remove tetracyclines that are major antibiotics frequently measured in surface water. In the pyrolysis process, the N-enriching lotus seed pots biomass decomposed and formed a porous carbon matrix with self-doped N. The LPC-NC displayed high adsorption amount (506.6 mg/g for tetracycline (TTC) and 445.3 mg/g for oxytetracycline (OTC)), short equilibrium time (30 min) and stable reusability (the decline efficiency<8.0% after five cycles). Batch adsorption experimental and theoretical studies showed that the high adsorption capacity of LPC-NC for tetracyclines was mainly ascribed to the self-doped pyridinic-N species and the adsorption capacity of pyridinic-N species at the edge location was better than that of pyridinic-N species at the vacancy location. Importantly, we believe that the high adsorption performance of LPC-NC for tetracyclines is due to the activation of carbon π electrons by destroying the integrity of conjugation on LPC-NC, thus enhancing the π-π interaction between LPC-NC and tetracyclines. In addition, the results of solid-state nuclear magnetic resonance (NMR) confirmed that the hierarchically porous structure of LPC-NC was conducive to the adsorption of tetracyclines. These insights provide new ideas for the rational design of N-doped carbon-based adsorbents for the efficient removal of tetracyclines.

Efficient degradation of orange II by core shell CoFe2O4-CeO2 nanocomposite with the synergistic effect from sodium persulfate

Novel core shell CoFe₂O₄-CeO₂ (CoFe-Ce) nanocomposite was synthesized and investigated as an efficient photocatalyst to activate sodium persulfate (Na2S2O8, PS) for orange Ⅱ (OⅡ) degradation. The CoFe-Ce nanocomposite was successfully designed and synthesized by a facile hydrothermal reaction followed by calcination and characterized by X-ray diffraction (XRD), field emission scanning electron microscopy (FE-SEM), transmission electron microscopy (TEM), ultraviolet-visible diffuse reflectance spectroscopy (UV-Vis DRS), and vibrating sample magnetometer (VSM). Compared with pure CoFe₂O₄ and CeO₂, the photocatalytic efficiency of CoFe-Ce nanocomposite was significantly improved. Under the irradiation of visible light, the catalytic degradation efficiency of orange II could reach to 98.5% within 60 min. Additionally, the as-prepared material could be recycled for at least five times using magnetic separation ability of the nanocomposite, and during the cycling the dye degradation rate was almost unchanged. The active species produced during the degradation were studied by classical quenching experiments, and the different types of free radicals produced in the system were further confirmed by electron paramagnetic resonance (EPR) spectroscopy. This novel nanocomposite is expected to have potential application for degradation of organic pollutants in wastewater by utilizing solar energy.

Facile fabrication of N-doped hierarchical porous carbons derived from soft-templated ZIF-8 for enhanced adsorptive removal of tetracycline hydrochloride from water

N-doped hierarchical porous carbons (NHPCs) were successfully prepared from soft-templated zeolitic imidazolate framework-8 (ZIF-8) precursors using sodium dodecylbenzene sulfonate (SDBS) as a template through facile one-step carbonization and applied in tetracycline hydrochloride (TCH) adsorption. The NHPC synthesized at 1000 °C with an SDBS/Zn²⁺ molar ratio of 0.075 exhibited the highest TCH adsorption (q_m = 80.92 mg g^-1) owing to its relatively large BET surface area (1067.41 m² g^-1) and pore volume (1.22 cm³ g^-1) and the stronger surface interaction between TCH and NHPCs (HC1000-0.075). Compared with surfactant-free ZIF-8-derived carbon (HC), introduction of SDBS in the ZIF-8 precursor not only improved the pore structure of the carbon materials but also increased the nitrogen content and the number of surface functional groups. Adsorption kinetics and isotherms showed that the pseudo-second-order model and Sips model fit the TCH adsorption behavior on HC and HC1000-0.075 well. Adsorption experiments and characterizations revealed that the adsorption mechanism involved in TCH adsorption on HC1000-0.075 mainly depended on the synergistic effect of pore filling, H-bonding, π-π interactions, and weak electrostatic interactions. This study provides an effective and simple strategy for fabricating MOF-derived NHPCs as a promising adsorbent for the removal of antibiotics from water.

Synthesis and Characterization of New Ferrite-Lignin Hybrids

The paper presents the synthesis and characterization of new cobalt ferrite-lignin hybrids. The hybrids were obtained through the combustion of cobalt nitrate and ferric nitrate, two kinds of lignin being used as combustion agents. The temperatures of calcination were 500 °C and 900 °C, respectively. The hybrids were characterized by Fourier transform infrared spectroscopy (FT-IR), X-ray powder diffraction (XRD), scanning electron microscopy (SEM), energy-dispersive X-ray (EDX), and X-ray photoelectron spectroscopy (XPS). The magnetic properties were also assessed by vibrating sample magnetometer system (VSM). This facile synthesis method made it possible to obtain cobalt ferrite-lignin hybrids with a spinel structure. Their particle sizes and crystallite sizes have increased with an increment in the calcination temperature. A different occupancy of cations at octahedral and tetrahedral sites also occurred upon the increase in temperature. The hybrids comprising organic lignin presented the best magnetic properties.