Liquid chromatographic determination of polythiols based on pre-column excimer fluorescence derivatization and its application to α-lipoic acid analysis

Pharmacological elevation of glutathione inhibits status epilepticus-induced neuroinflammation and oxidative injury

Glutathione (GSH) is a major endogenous antioxidant, and its depletion has been observed in several brain diseases including epilepsy. Previous studies in our laboratory have shown that dimercaprol (DMP) can elevate GSH via post-translational activation of glutamate cysteine ligase (GCL), the rate limiting GSH biosynthetic enzyme and inhibit neuroinflammation in vitro. Here we determined 1) the role of cysteamine as a new mechanism by which DMP increases GSH biosynthesis and 2) its ability to inhibit neuroinflammation and neuronal injury in the rat kainate model of epilepsy. DMP depleted cysteamine in a time- and concentration-dependent manner in a cell free system. To guide the in vivo administration of DMP, its pharmacokinetic profile was determined in the plasma, liver, and brain. The results confirmed DMP's ability to cross the blood-brain-barrier. Treatment of rats with DMP (30 mg/kg) depleted cysteamine in the liver and hippocampus that was associated with increased GCL activity in these tissues. GSH levels were significantly increased (20 %) in the hippocampus 1 h after 30 mg/kg DMP administration. Following DMP (30 mg/kg) administration once daily, a marked attenuation of GSH depletion was seen in the SE model. SE-induced inflammatory markers including cytokine release, microglial activation, and neuronal death were significantly attenuated in the hippocampus with DMP treatment. Taken together, these results highlight the importance of restoring redox status with rescue of GSH depletion by DMP in post epileptogenic insults.

Reduced Graphene Oxide Sheets as Inhibitors of the Photochemical Reactions of α-Lipoic Acid in the Presence of Ag and Au Nanoparticles

The influence of Ag and Au nanoparticles and reduced graphene oxide (RGO) sheets on the photodegradation of α-lipoic acid (ALA) was determined by UV-VIS spectroscopy. The ALA photodegradation was explained by considering the affinity of thiol groups for the metallic nanoparticles synthesized in the presence of trisodium citrate. The presence of excipients did not induce further changes when ALA interacts with Ag and Au nanoparticles with sizes of 5 and 10 nm by exposure to UV light. Compared to the Raman spectrum of ALA powder, changes in Raman lines' position and relative intensities when ALA has interacted with films obtained from Au nanoparticles with sizes between 5 and 50 nm were significant. These changes were explained by considering the chemical mechanism of surface-enhanced Raman scattering (SERS) spectroscopy. The photodegradation of ALA that had interacted with metallic nanoparticles was inhibited in the presence of RGO sheets.

Investigation of lipoic acid - 4-methoxybenzyl alcohol reaction and evaluation of its analytical usefulness

The presented work is aimed to synthesize a new UV active derivative of α-lipoic acid (ALA) by its esterification with 4-methoxybenzyl alcohol (4-MBA, anise alcohol). The formation of ester was confirmed by ¹HNMR, FTIR and UV spectroscopy. The analytical usefulness of the obtained compound for quantification of ALA in food items was examined using HPLC-UV and GC-MS systems. It was found that it is possible to assay ALA in the ester form in the concentration ranges: 5·10^-6-1·10^-4 mol L^-1 by HPLC-UV and 1∙10^-7-5∙10^-5 mol L^-1 by GC-MS techniques. The GC-MS procedure was applied for the determination of ALA in the food samples.

The first method for determination of lipoyllysine in human urine after oral lipoic acid supplementation

Aim: The first method on urinary excreted amounts of lipoyllysine (LLys) after lipoic acid (LA) supplementation was developed and validated. The suggested procedure allowed simultaneous determination of LLys and LA. Methodology & results: After the conversion of analytes into their reduced forms with tris(2-carboxyethyl)phosphine and derivatization via thiol group with 1-benzyl-2-chloropyridinium bromide, separation of analytes derivatives was performed on C18 column using a gradient mobile phase consisting of acetic acid and acetonitrile. The calibration curves for LA and LLys were linear (R² > 0.999) in the range of 0.4-12 μM concentration and all validation results were acceptable, according to the US FDA bioanalytical method guidelines. Conclusion: This method was effectively applied for LA and LLys quantification in human urine after oral LA supplementation.

Application of simultaneous separation and derivatization for the determination of α-lipoic acid in urine samples by high-performance liquid chromatography with spectrofluorimetric detection

To help to clarify therapeutic functions of lipoic acid (LA) in biochemical and clinical practice we have elaborated a fast, simple and accurate HPLC method enabling determination of LA in human urine. The proposed analytical approach includes reduction of LA with tris(2-carboxyethyl)phosphine and simultaneous separation and derivatization of the analyte with butylamine and o-phthaldialdehyde followed by spectrofluorimetric detection at λ_ex  = 340 nm and λ_em  = 440 nm. The assay was performed using gradient elution and the mobile phase containing 0.0025 mol L^-1 o-phthaldialdehyde in 0.0025 mol L^-1 NaOH and acetonitrile. Linearity of the detector response for LA was observed in the range of 0.3-8 μmol L^-1 . Limits of detection and quantification for LA in urine samples were 0.02 and 0.03 μmol L^-1 , respectively. The total analysis time, including sample work-up, was <20 min. The analytical procedure was successfully applied to analysis of real urine samples delivered from six healthy volunteers who received a single 100 mg dose of LA.

Low-cost and disposable sensors for the simultaneous determination of coenzyme Q10 and α-lipoic acid using manganese (IV) oxide-modified screen-printed graphene electrodes

In this work, for the first time, manganese (IV) oxide-modified screen-printed graphene electrodes (MnO₂/SPGEs) were developed for the simultaneous electrochemical detection of coenzyme Q10 (CoQ10) and α-lipoic acid (ALA). This sensor exhibits attractive benefits such as simplicity, low production costs, and disposability. Cyclic voltammetry (CV) was used to characterize the electrochemical behavior of the analyte and investigate the capacitance and electroactive surface area of the unmodified and modified electrode surfaces. The electrochemical behavior of CoQ10 and ALA on MnO₂/SPGEs was also discussed. Additionally, square wave anodic stripping voltammetry (SWASV) was used for the quantitative determination of CoQ10 and ALA. Under optimal conditions, the obtained signals are linear in the concentration range from 2.0 to 75.0 μg mL^-1 for CoQ10 and 0.3-25.0 μg mL^-1 for ALA. The low limits of detection (LODs) were found to be 0.56 μg mL^-1 and 0.088 μg mL^-1 for CoQ10 and ALA, respectively. Moreover, we demonstrated the utility and applicability of the MnO₂/SPGE sensor through simultaneous measurements of CoQ10 and ALA in dietary supplements. The sensor provides high accuracy measurements, exhibiting its high potential for practical applications.

Determination of lipoic acid in biological samples

α-Lipoic acid (LA) is a unique antioxidant that is not only effective in affording protection against oxidative stress but also plays an essential role in metabolic processes of all living organisms. Therefore, the determination of LA and its metabolites content is crucial for understanding their physiological and pathophysiological functions. Most of the recently developed methods for the detection and determination of LA and its metabolites in various biological samples have focused on sample preparation procedures involving but not limited to sampling, extraction and storage. The main goal of this review is to summarize and critically evaluate the current state of the art of analytical procedures applied to the determination of LA and related compounds in biological samples.

Fast quantification of α-lipoic acid in biological samples and dietary supplements using batch injection analysis with amperometric detection

Batch injection analysis (BIA) with amperometric detection, using a pyrolytic graphite electrode modified with cobalt phthalocyanine (PG/CoPc), was employed for determination of α-lipoic acid (ALA) in pharmaceutical product and in synthetic urine samples. The proposed BIA method is based on the application of a potential of +0.9V vs. Ag/AgCl, KCl sat, enabling quantification of ALA over a concentration range from 1.3×10(-6) to 1.0×10(-4)molL(-1), with a detection limit of 1.5×10(-8)molL(-1). A sampling rate of 180 injections per hour was attained and measurements of the reproducibility of successive injections (100µmolL(-1) ALA on the same electrode) showed a RSD of 2.11% for 40 successive injections. The new sensor was utilised for ALA quantification in a dietary pharmaceutical supplement and in synthetic urine and the results obtained for both samples were compared with parallel analysis using high performance liquid chromatography (HPLC), the method recommended by the United States Pharmacopeia. The results obtained were similar (at a 95% confidence level) and in the case of the synthetic urine sample (prepared with a known amount of ALA) the recovery was situated between 98.0% and 102.6%.

Analysis of Reaction between α-Lipoic Acid and 2-Chloro-1-methylquinolinium Tetrafluoroborate Used as a Precolumn Derivatization Technique in Chromatographic Determination of α-Lipoic Acid

The present study offers results of analysis concerning the course of reaction between reduced α-lipoic acid (LA) and 2-chloro-1-methylquinolinium tetrafluoroborate (CMQT). In water environments, the reaction between CMQT and hydrophilic thiols proceeds very rapidly and the resultant products are stable. For the described analysis, optimum reaction conditions, such as concentration of the reducing agent, environment pH, and concentration of the reagent were carefully selected. The spectrophotometric assay was carried out measuring absorbance at λ = 348 nm (i.e., the spectral band of the obtained reaction product). Furthermore, the calibration curve of lipoic acid was registered. It was concluded that the Lambert-Beer law was observed within the range 1-10 μmol L(-1). Later, the reaction between LA and CMQT was used as precolumn derivatization in a chromatographic determination of the lipoic acid in the range 2.5-50 μmol L(-1). Practical applicability of the designed methods was evaluated by determining lipoic acid in Revitanerv pharmaceutical preparation which contains 300 mg LA in a single capsule. The error of the determination did not exceed 0.5% in relation to the declared value.

Highly sensitive and selective derivatization-LC method for biomolecules based on fluorescence interactions and fluorous separations

A fluorescence derivatization LC method is a powerful tool for the analysis with high sensitivity and selectivity of biological compounds. In this review, we introduce new types of fluorescence derivatization LC analysis methods. These are (1) detection-selective derivatization methods based on fluorescence interactions generated from fluorescently labeled analytes: excimer fluorescence derivatization and fluorescence resonance energy transfer (FRET) derivatization; (2) separation-selective derivatization methods using the fluorous separation technique: fluorous derivatization, F-trap fluorescence derivatization, and fluorous scavenging derivatization (FSD).