Optimization of large volume injection-programmable temperature vaporization-gas chromatography–mass spectrometry analysis for the determination of estrogenic compounds in environmental samples

Transformation of 17β-estradiol to estrone by unknown wild-type enzyme in commercial arylsulfatase from Helix pomatia

This work for the first time reported the complete transformation of 17β-estradiol (E2) to estrone (E1) by unknown wild-type enzyme present in the widely used commercial arylsulfatase derived from Helix pomatia. It was found that acetate could effectively inhibit the unknown enzyme with a half inhibitory concentration (IC50) of 140.9 μM, while phosphate and citrate showed no inhibition. Since the buffer solutions with phosphate and citrate have been used in the enzymatic hydrolysis of natural estrogen conjugates for decades, the transformation of E2 to E1 likely occurred during such procedure, inevitably leading to overestimated E1, but underestimated E2. It was further suggested that acetate should be used to prevent this undesirable transformation during the enzymatic hydrolysis of natural estrogen conjugates.

Focused ultrasound solid-liquid extraction for the determination of organic biomarkers in beachrocks

Beachrocks are consolidated coastal sedimentary formations resulting mainly from the relative rapid cementation of beach sediments by different calcium carbonate polymorphs. Although previous works have already studied the elemental composition and the mineral phases composing these cements, few of them have focused their attention on the organic matter present therein. This work describes an extraction methodology based on focused ultrasound solid-liquid extraction (FUSLE), followed by analysis using large volume injection (LVI) in a programmable temperature vaporizer (PTV) combined with gas chromatography-mass spectrometry (GC-MS) in order to determine organics such as polycyclic aromatic hydrocarbons (PAHs) and biomarkers (hopanes), which can increase and confirm the information obtained so far. This goal has been achieved after the optimization of the main parameters affecting the extraction procedure, such as, extraction solvent, FUSLE variables (amplitude, extraction time and pulse time) and also variables affecting the LVI-PTV (vent time, injection speed and cryo-focusing temperature). The developed method rendered results comparable to traditional extraction methods in terms of accuracy (77-109%) and repeatability (RSD<23%). Finally, the analyses performed over real beachrock samples from the Bay of Biscay (Northern Spain) revealed the presence of the 16 EPA priority PAHs, as well as some organic biomarkers which could increase the knowledge about such beachrock formation.

Analysis of estrogens and estrogen mimics in edible matrices--a review

This review provides a brief survey of the biological effects of selected endocrine-disrupting compounds that are formed after internal exposure of organisms. Further, the present analytical methods available for the determination of these compounds in foodstuffs are critically evaluated. The attention is primarily devoted to the methods for sample pretreatment, which are the main source of errors and are usually the most time-consuming step of the whole analysis. This review is focused on selected natural and synthetic estrogens, estrogen conjugates, and chemical additives used in the plastic industry that can act as estrogen mimics.

Calibration and field test of the Polar Organic Chemical Integrative Samplers for the determination of 15 endocrine disrupting compounds in wastewater and river water with special focus on performance reference compounds (PRC)

In this work, home-made Polar Organic Chemical Integrative Samplers (POCIS) were studied for passive sampling of 15 endocrine disrupting compounds (4 alkylphenols and steroid hormones) in influent and effluent samples of wastewater treatment plants (WWTPs) as well as up- and downstream of the receiving river water. POCIS calibration at laboratory conditions was carried out using a continuous-flow calibration system. The influence of the exposure position of the POCIS within the calibration device, horizontal or vertical, to the water flow direction was evaluated. While the sampling rates of most of the target substances were not affected by the sampler position, for cis-ADT, E1, E2 and E3, the vertical position provided the highest analyte accumulation. Hence, the POCIS samplers were preferably exposed vertical to the water flow in overall experiments. Using the continuous-flow calibration device, lab-based sampling rates were determined for all the target compounds (RSBPA = 0.0326 L/d; RScisADT = 0.0800 L/d, RSE1 = 0.0398 L/d, RSEQ = 0.0516 L/d, RSTT = 0.0745 L/d, RSE2 = 0.0585 L/d, RSEE2 = 0.0406 L/d, RSNT = 0.0846 L/d, RSPG = 0.0478 L/d and RSE3 = 0.1468 L/d), except for DES, MeEE2, 4tOP, 4OP, 4NPs, where the uptake after 14 days POCIS exposure was found to be insignificant or indicated a no linear behaviour. Recoveries from POCIS extractions were in the range between 71 and 152% for most of the target analytes except for DES and E3 with around 59%. Good precision of the sampling procedure up till 20% was observed and limits of detection were at ng/L level. Two deuterated compounds ([(2)H3]-E2 and [(2)H4]-EQ) were successfully tested as performance reference compounds (PRC, [Formula: see text] = 0.0507 L/d and [Formula: see text] = 0.0543 L/d)). Finally, the POCIS samplers were tested for monitoring EDCs at two wastewater treatment plants, in Halle and Leipzig (Germany). BPA, E1, EQ, E2, MeEE2, NT, EE2, PG and E3 were quantified and their time-weighted average concentrations calculated on the basis of the lab-derived sampling rates were compared with the results based on conventional grab samples. While the influent concentration of BPA, cisADT, E1, TT, PG, EE2 reached the μg/L level, the rest of the target analytes were determined at ng/L. The analyte concentrations in the effluent never exceed ng/L level except for BPA. The concentration determined by spot sampling was partially lower (BPA, E1, TT) or comparable (EQ, E2, EE2, PG, E3) to the concentration obtained by POCIS using performance reference compounds (PRC).

Membrane-assisted solvent extraction coupled to large volume injection–gas chromatography–mass spectrometry for the determination of a variety of endocrine disrupting compounds in environmental water samples

Membrane-assisted solvent extraction coupled to large volume injection in a programmable temperature vaporisation injector using gas chromatography–mass spectrometry analysis was optimised for the simultaneous determination of a variety of endocrine disrupting compounds in environmental water samples (estuarine, river and wastewater). Among the analytes studied, certain hormones, alkylphenols and bisphenol A were included. The nature of membranes, extraction solvent, extraction temperature, solvent volume, extraction time, ionic strength and methanol addition were evaluated during the optimisation of the extraction. Matrix effects during the extraction step were studied in different environmental water samples: estuarine water, river water and wastewater (influent and effluent). Strong matrix effects were observed for most of the compounds in influent and effluent samples. Different approaches were studied in order to correct or minimise matrix effects, which included the use of deuterated analogues, matrix-matched calibration, standard addition calibration, dilution of the sample and clean-up of the extract using solid-phase extraction (SPE). The use of deuterated analogues corrected satisfactorily matrix effect for estuarine and effluent samples for most of the compounds. However, in the case of influent samples, standard addition calibration and dilution of the sample were the best approaches. The SPE clean-up provided similar recoveries to those obtained after correction with the corresponding deuterated analogue but better chromatographic signal was obtained in the case of effluent samples. Method detection limits in the 5-54 ng L(-1) range and precision, calculated as relative standard deviation, in the 2-25% range were obtained.

Membrane assisted solvent extraction coupled to large volume injection-gas chromatography-mass spectrometry for trace analysis of synthetic musks in environmental water samples

This work describes the optimisation, validation and application of membrane assisted solvent extraction (MASE) together with a large volume injection (LVI) in a programmable temperature vaporisation (PTV) injector coupled to gas chromatography-mass spectrometry (GC-MS) for the quantification of ten synthetic musk fragrances (musks) in surface and wastewater samples. Regarding the MASE, musks were extracted from 150 mL of aqueous samples to 200 μL of n-hexane hold in home-made low density polyethylene (LDPE) bags. The extraction took 240 min and the performance of the method made possible the direct analysis of the extracts by LVI-PTV-GC-MS without needing any further treatment and avoiding losses of analytes. During the optimisation of LVI-PTV set-up, the response surfaces of every analyte signal against the cryo-focussing temperature, injection speed and vent time were built. Finally, the figures of merit of the whole procedure allowed the analysis of most of the musks owing to the low method detection limits (between 4 and 25 ng L⁻¹) and good precisions (<20%). In fact, this method was successfully applied to the analysis of musks in surface and wastewater samples. Galaxolide and tonalide are the main two synthetic musks observed in most of the analysed environmental water samples.