Effects of packing density, flow and humidity on the performance of needle trap devices

A low-cost internal standard loader for solid-phase sorbing tools

Solid-phase sorption is widely used for the analysis of gaseous specimens as it allows at the same time to preconcentrate target analytes and store samples for relatively long periods. The addition of internal standards (ISs) in the analytical workflow can greatly reduce the variability of the analyses and improve the reliability of the protocols. In this work, we describe the development and testing of a portable system for the reliable production of gaseous mixture of8D-Toluene in a 1L Silonite canister as well as its reproducible loading into solid-phase sorbing tools as ISs. The portable system was tested using needle trap microextraction, solid-phase extraction, and thin-film microextraction techniques commonly employed for the analysis of gaseous samples. Even though our specific interest is in breath analysis, the system can also be used for the collection of any kind of gaseous specimen. A microcontroller allows the fine control of the sampling flow by a digital mass flow controller. Flow rate and sample volume could be set either through a rotary encoder mounted onto the control board or through a dedicated android app. The variability of the airflow is in the range 5-200 ml min-1and it is lower than 1%, whereas the variability of the IS (8D-Toluene) concentration dispensed over time by the loader measured by selected-ion flow-tube mass spectrometry (MS) is <3%. This combination resulted in intra- and inter-day precision of the amount loaded in the sorbent tools lower than 15%. No carry-over was detected in the loader after the delivery of the8D-Toluene measured by gas chromatography-MS. The8D-Toluene concentration in the canister was stable for up to three weeks at room temperature.

On-line trace monitoring of volatile halogenated compounds in air by improved thermal desorption-gas chromatography-mass spectrometry

Volatile halogenated compounds (VHCs) are important industrial chemicals and play a crucial role in potential stratospheric ozone-depletion and global warming. Profiling of VHCs is of great significance but replete with challenges due to the species' richness and diversity. In this study, we developed a novel method employing water removal mode combined with thermal desorption-gas chromatography-mass spectrometry (TD-GC-MS) for on-line measurement of VHCs at the ultratrace level. By removing water with Nafion dryer tandem cold trap device, VHCs could achieve better separation and identification, and detection precision of VHCs lower than 10%. The proposed method exhibited limits of detection for VHCs ranging from 0.1 to 6.2 pptv. Benefiting from the improved trapping efficiency due to water removal, we successfully quantified 34 VHCs at the Shangdianzi background station and achieved a comprehensive assessment of VHCs in ambient air.

Development of a new needle trap-based method for the determination of some volatile organic compounds in the indoor environment

Volatile Organic Compounds (VOCs) are a large group of chemicals mostly found in indoor environments such as homes and workplaces. Long term exposure to certain VOCs can cause symptoms in some individuals and therefore, monitoring and controlling air quality can help better manage chronic respiratory diseases. In this study, we aimed to develop an easy-to-use, economical, in house needle trap-based methodology to detect certain VOCs to be used for public and occupational health. For this purpose, a multi-bed (packed with PDMS/Carbopack-X/Carboxen-1000) needle trap device (NTD) was utilized for sampling, enrichment, and injection of the VOCs into the gas chromatography. The performance of the developed method was investigated for the analysis of the group known as BTEX (benzene, toluene, ethylbenzene and xylene). Operational and instrumental parameters such as sampling flow rate and relative humidity, desorption time and temperature were optimized, and the analytical figures of merit of the proposed method have indicated that very low levels of BTEX in air samples can be easily determined by this new method. Overall results have shown that multi-bed NTD offers a high sensitive procedure for sampling and analysis of BTEX in concentration range of 0.002-0.298 mg/m³ in indoor air.

Determination of peppermint compounds in breath by needle trap micro-extraction coupled with gas chromatography-tandem mass spectrometry

Breath analysis is an alternative approach for disease diagnosis and for monitoring therapy. The lack of standardized procedures for collecting and analysing breath samples currently limits its use in clinical practice. In order to overcome this limitation, the "Peppermint Consortium" was established within the breath community to carry out breath wash-out experiments and define reference values for a panel of compounds contained in the peppermint oil capsule. Here, we present a needle trap micro-extraction technique coupled with gas chromatography and tandem mass spectrometry for a rapid and accurate determination of alpha-pinene, beta-pinene, limonene, eucalyptol, menthofuran, menthone, menthol and menthyl acetate in mixed breath samples. Detection limits between 1 and 20 pptv were observed when 25 mL of a humidified standard gas mixture were loaded into a needle trap device at a flow rate of 10 mL/min. Inter- and intra-day precisions were lower than 15%, thus confirming the reliability of the assay. Our procedure was used to analyse breath samples taken from a nominally healthy volunteer who were invited to swallow a 200 mg capsule of peppermint oil. Six samples were collected at various times within six hours of ingestion. Analyte concentrations were not affected by the sampling mode (i.e. mixed vs. end-tidal fraction), whereas respiratory rate and exhalation flow rate values slightly influenced the concentration of the target compounds in breath samples.

Release of harmful volatile organic compounds (VOCs) from photo-degraded plastic debris: A neglected source of environmental pollution

Environmental pollution associated to plastic debris is gaining increasing relevance not only as a threat to ecosystems but also for its possible harmful effects on biota and human health. The release of toxic volatile organic compounds (VOCs) is a potential hazard associated with the environmental weathering of plastic debris. Artificial aging of reference polymers (polystyrene, polypropylene, polyethylene terephthalate, high and low density polyethylene) was performed in a Solar Box at 40 °C and 750 W/m². The volatile degradation products were determined before and after 1, 2, 3 and 4 weeks of aging using a validated analytical procedure combining headspace (HS) with needle trap microextraction (NTME) and gas chromatography/mass spectrometry (GC-MS). A progressive increase in VOCs was observed during artificial photo-degradation, whose chemical profile resulted polymer-dependent and included carbonyls, lactones, esters, acids, alcohols, ethers, aromatics. The amount of extractable fraction in polar solvents generally showed a similar trend. The same analytical procedure was used to determine VOCs released from plastic debris collected at a marine beach. All samples released harmful compounds (e.g. acrolein, benzene, propanal, methyl vinyl ketone, and methyl propenyl ketone), supporting the initial hypothesis that microplastics represent an unrecognized source of environmental pollution.

The styrene purification performance of biotrickling filter with toluene-styrene acclimatization under acidic conditions

The obvious disadvantages of biotrickling filters (BTFs) are the long start-up time and low removal efficiency (RE) when treating refractory hydrophobic volatile organic compounds (VOCs), which limits its industrial application. It is worthwhile to investigate how to reduce the start-up period of the BTF for treating hydrophobic VOCs. Here, we present the first study to evaluate the strategy of toluene induction combined with toluene-styrene synchronous acclimatization during start-up in a laboratory-scale BTF inoculated with activated sludge for styrene removal, as well as the effects of styrene inlet concentration (0.279 to 2.659 g·m^-3), empty bed residence time (EBRT) (i.e., 136, 90, 68, 45, 34 sec), humidity (7.7% to 88.9%), and pH (i.e., 4, 3, 2.5, 2) on the performance of the BTF system. The experiments were carried out under acidic conditions (pH 4.5) to make fungi dominant in the BTF. The start-up period for styrene in the BTF was shortened to about 28 days. A maximum elimination capacity (EC_max) of 126 g·m^-3·hr^-1 with an RE of 80% was attained when styrene inlet loading rate (ILR) was below 180 g·m^-3·hr^-1. The highest styrene RE(s) [of BTF] that could be achieved were 95% and 93.4%, respectively, for humidity of 7.7% and at pH 2. A single dominant fungal strain was isolated and identified as Candida palmioleophila strain MA-M11 based on the 26S ribosomal RNA gene. Overall, the styrene induction with the toluene-styrene synchronous acclimatization could markedly reduce the start-up period and enhance the RE of styrene. The BTF dominated by fungi exhibited good performance under low pH and humidity and great potential in treating styrene with higher inlet concentrations. Implications: The application of the toluene induction combined with toluene-styrene synchronous acclimatization demonstrated to be a promising approach for the highly efficient removal of styrene. The toluene induction can accelerate biofilm formation, and the adaptability of microorganisms to styrene can be improved rapidly by the toluene-styrene synchronous acclimatization. The integrated application of two technologies can shorten the start-up period of biotrickling filters markedly and promote its industrial application.

Determination of volatile organic compounds in exhaled breath of heart failure patients by needle trap micro-extraction coupled with gas chromatography-tandem mass spectrometry

The analytical performances of needle trap micro-extraction (NTME) coupled with gas chromatography-tandem mass spectrometry were evaluated by analyzing a mixture of twenty-two representative breath volatile organic compounds (VOCs) belonging to different chemical classes (i.e. hydrocarbons, ketones, aldehydes, aromatics and sulfurs). NTME is an emerging technique that guarantees detection limits in the pptv range by pre-concentrating low volumes of sample, and it is particularly suitable for breath analysis. For most VOCs, detection limits between 20 and 500 pptv were obtained by pre-concentrating 25 ml of a humidified standard gas mixture at a flow rate of 15 ml min^-1. For all compounds, inter- and intra-day precisions were always below 15%, confirming the reliability of the method. The procedure was successfully applied to the analysis of exhaled breath samples collected from forty heart failure (HF) patients during their stay in the University Hospital of Pisa. The majority of patients (about 80%) showed a significant decrease of breath acetone levels (a factor of 3 or higher) at discharge compared to admission (acute phase) in correspondence to the improved clinical conditions during hospitalization, thus making this compound eligible as a biomarker of HF exacerbation.

Techniques and issues in breath and clinical sample headspace analysis for disease diagnosis

Analysis of volatile organic compounds (VOCs) from breath or clinical samples for disease diagnosis is an attractive proposition because it is noninvasive and rapid. There are numerous studies showing its potential, yet there are barriers to its development. Sampling and sample handling is difficult, and when coupled with a variety of analytical instrumentation, the same samples can give different results. Background air and the environment a person has been exposed to can greatly affect the VOCs emitted by the body; however, this is not an easy problem to solve. This review investigates the use of VOCs in disease diagnosis, the analytical techniques employed and the problems associated with sample handling and standardization. It then suggests the barriers to future development.