Development of Carbotrap B-packed needle trap device for determination of volatile organic compounds in air

Needle trap device technique: From fabrication to sampling

Needle Trap Device (NTD) as a novel, versatile, and eco-friendly technique has played an important role in analytical and environmental chemistry. The distinctive role of this interdisciplinary technique can be defended through the sampling and analysis of biological samples and industrial pollutants in gaseous and liquid environments. In recent years, significant efforts have been made to enhance the performance of the needle trap device resulting in the development of novel extraction routes by various packing materials with improved selectivity and enhanced adsorption characteristics. These achievements can lead to the facilitated pre-concentration of desired analytes. This review tries to have a comparative and comprehensive survey of the three important areas of NTD technique: I) Fabrication and preparation procedures of NTDs; II) Sampling techniques of pollutants using NTDs; and III) Employed materials as adsorbents in NTDs. In the packing-material section, the commercial and synthetic adsorbents such as carbon materials, metal-organic frameworks, aerogel, and polymers are considered. Furthermore, the limitations and potential areas for future development of the NTD technique are presented.

Electrothermaly conditioned carbon fibre for the analysis of volatile pollutants

This study deals with the development of an inexpensive and single-step sorbent manufacturing methodology for the analysis of air pollutants. Disposable carbon fibre sorbents were prepared in a few minutes using the electrothermal conditioning technique. The sorbent conditioning current and time were optimised to obtain the best extraction of benzene, toluene, ethylbenzene and xylenes (BTEX) from the air samples. After sorbent characterisation, analysis parameters affecting the BTEX extraction efficiency, such as sampling volume, humidity and sampling flow rate, were optimised for active BTEX sampling. Under optimum conditions, validation parameters such as the limit of detection (LOD), repeatability, reproducibility, and linear range were found to be 0.07-0.11 mg m ^- 3, 1.1%-1.8%, 5.6%-9.5% and 0.24-45 mg m ^- 3, respectively. Thereafter, the BTEX analysis was successfully conducted using the proposed method, with acceptable recovery values (96%-103%) in the real indoor environments.

Development of a Needle Trap Device Packed with HKUST-1 Sorbent for Sampling and Analysis of BTEX in Air

In this study, we developed a needle trap device packed with HKUST-1 (Cu-based metal-organic framework) for the sampling and analysis of benzene, toluene, ethylbenzene, and xylene (BTEX) in ambient air for the first time. The HKUST-1 was synthesized via the electrochemical process. Afterwards, the adsorbent was packed into 22 gauge needles. To provide the different concentrations of BTEX, the syringe pump was connected to the glass chamber to inject a specific rate of the BTEX compounds. Design-expert software (version 7) was used to optimize the analytical parameters including breakthrough volume, desorption conditions and sampling conditions. The best desorption conditions were achieved at 548 K for 6 min, and the best sampling conditions were determined at 309 K of sampling temperature and 20 % of relative humidity. According to the results, the limit of quantification (LOQ) and limit of detection (LOD) of the developed needle trap device (NTD) were in the range of 0.52–1.41 and 0.16–0.5 mg/m3, respectively. In addition, the repeatability and reproducibility of the method were calculated to be in the range of 5.5–13.2 and 5.3–12.3 %, respectively. The analysis of needles stored in the refrigerator (>277 K) and room temperature (298 K) showed that the NTD can store the BTEX analytes for at least 10 and 6 days, respectively. Our findings indicated that the NTD packed with HKUST-1 sorbent can be used as a trustworthy and useful technique for the determination of BTEX in air.

Advances in pretreatment and analysis methods of aromatic hydrocarbons in soil

Benzene compounds that are prevalent in the soil as organic pollutants mainly include BTEX (benzene, toluene, ethylbenzene, and three xylene isomers) and PAHs (polycyclic aromatic hydrocarbons). These pose a severe threat to many aspects of human health. Therefore, the accurate measurement of BTEX and PAHs concentrations in the soil is of great importance. The samples for analysis of BTEX and PAHs need to be suitable for the various detection methods after pretreatment, which include Soxhlet extraction, ultrasonic extraction, solid-phase microextraction, supercritical extraction, and needle trap. The detection techniques mainly consist of gas chromatography (GC), mass spectrometry (MS), and online sensors, and provide comprehensive information on contaminants in the soil. Their performance is evaluated in terms of sensitivity, selectivity, and recovery. Recently, there has been rapid progress in the pretreatment and analysis methods for the quantitative and qualitative analyses of BTEX and PAHs. Therefore, it is necessary to produce a timely and in-depth review of the emerging pretreatment and analysis methods, which is unfortunately absent from the recent literature. In this work, state-of-art extraction techniques and analytical methods have been summarized for the determination of BTEX and PAHs in soil, with a particular focus on the potential and limitations of the respective methods for different aromatic hydrocarbons. Accordingly, the paper will describe the basic methodological knowledge, as well as the recent advancement of pretreatment and analysis methods for samples containing BTEX and PAHs.

Development of a new needle trap-based method for the determination of some volatile organic compounds in the indoor environment

Volatile Organic Compounds (VOCs) are a large group of chemicals mostly found in indoor environments such as homes and workplaces. Long term exposure to certain VOCs can cause symptoms in some individuals and therefore, monitoring and controlling air quality can help better manage chronic respiratory diseases. In this study, we aimed to develop an easy-to-use, economical, in house needle trap-based methodology to detect certain VOCs to be used for public and occupational health. For this purpose, a multi-bed (packed with PDMS/Carbopack-X/Carboxen-1000) needle trap device (NTD) was utilized for sampling, enrichment, and injection of the VOCs into the gas chromatography. The performance of the developed method was investigated for the analysis of the group known as BTEX (benzene, toluene, ethylbenzene and xylene). Operational and instrumental parameters such as sampling flow rate and relative humidity, desorption time and temperature were optimized, and the analytical figures of merit of the proposed method have indicated that very low levels of BTEX in air samples can be easily determined by this new method. Overall results have shown that multi-bed NTD offers a high sensitive procedure for sampling and analysis of BTEX in concentration range of 0.002-0.298 mg/m³ in indoor air.

A review of new adsorbents for separation of BTEX biomarkers

The biomarker analysis of benzene, toluene, ethylbenzene and xylene (BTEXs) in biological samples is the primary technique for evaluating these compounds in occupational and environmental exposures. The BTEX biomarkers are widely used to study the BTEX distribution in the environment and workplaces. Liquid-liquid extraction and solid-phase liquid extraction are among the most commonly used conventional methods to analyze biological indices of BTEXs. New methods have been proposed to analyze BTEX biomarkers using novel adsorbents such as sol-gel composite nanotubes, molecularly imprinted polymers and metal-organic frameworks, which are based on the application of needle trap devices, microextraction by packed sorbent, and solid-phase microextraction techniques. This paper provides an overview of new methods since 2015 regarding applying microextraction methods based on new adsorbents and analyzing BTEX biomarker compounds for occupational and environmental exposures. The results were compared with the liquid-phase microextraction methods recommended for urinary BTEX biomarkers.

Fan-based device for integrated air sampling and microextraction

In this article, a new air sampler based on a conventional computer fan is presented and evaluated. The fan has a double role as it acts as the air pumping system and supports the sorptive phases, which are located on its blades. The compact design and the reduced energy consumption (it can operate with a standard cell phone charger) confers high portability to the device. Also, a simple alternative integrated into the fan is proposed for using an internal standard during the sampling, thus increasing the precision of the measurements. In this first communication, sol-gel Carbowax 20 M coated fabric phases are used as sorptive membranes thanks to their planar geometry, mechanical and thermal stability, and their versatility covering different interaction chemistries. After sampling, the fabric phases are placed in a headspace vial, which is finally analyzed by gas chromatography-mass spectrometry. The sampler has been characterized for the extraction of selected volatile organic compounds (chloroform, benzaldehyde, toluene, and cyclohexane) from air and its versatility has also been evaluated by the identification of semi-volatile compounds in working place (toluene and xylene in laboratory residue storage room) and biogenic volatile compounds in natural samples (terpenes in fresh pine needles and orange peel samples).

Determination of peppermint compounds in breath by needle trap micro-extraction coupled with gas chromatography-tandem mass spectrometry

Breath analysis is an alternative approach for disease diagnosis and for monitoring therapy. The lack of standardized procedures for collecting and analysing breath samples currently limits its use in clinical practice. In order to overcome this limitation, the "Peppermint Consortium" was established within the breath community to carry out breath wash-out experiments and define reference values for a panel of compounds contained in the peppermint oil capsule. Here, we present a needle trap micro-extraction technique coupled with gas chromatography and tandem mass spectrometry for a rapid and accurate determination of alpha-pinene, beta-pinene, limonene, eucalyptol, menthofuran, menthone, menthol and menthyl acetate in mixed breath samples. Detection limits between 1 and 20 pptv were observed when 25 mL of a humidified standard gas mixture were loaded into a needle trap device at a flow rate of 10 mL/min. Inter- and intra-day precisions were lower than 15%, thus confirming the reliability of the assay. Our procedure was used to analyse breath samples taken from a nominally healthy volunteer who were invited to swallow a 200 mg capsule of peppermint oil. Six samples were collected at various times within six hours of ingestion. Analyte concentrations were not affected by the sampling mode (i.e. mixed vs. end-tidal fraction), whereas respiratory rate and exhalation flow rate values slightly influenced the concentration of the target compounds in breath samples.

A needle trap device method for sampling and analysis of semi-volatile organic compounds in air

Semi-volatile organic compounds (SVOCs), such as phthalates, organophosphates, and polybrominated diphenyl ethers, are emerging as an important class of pollutants that are of serious health concerns. Determining concentrations of these pollutants is of great importance for environmental and exposure studies. In this work, a needle trap device (NTD) method was developed to measure the concentration of SVOCs in air samples. Sorbents were packed in the NTD to capture SVOCs with the aid of a sampling pump. NTD operational parameters, such as desorption temperature, desorption time, and sampling flow rate, were optimized for the target SVOCs. The limit of detection for air sampling by the NTD method ranged between 5 pg and 1 ng, depending on the SVOC compound. The variations in terms of NTD repeatability and reproducibility were lower than 14% for all cases. In addition, the influence of other experimental parameters, such as sampling temperature and humidity, breakthrough volume, NTD storage time, as well as carryover effect were examined. Finally, NTDs were used to determine emissions of gas-phase SVOCs from various consumer products in an emission cell and to collect total airborne SVOC samples (gas and particle phases) in an office. The results of NTD method were in an agreement with data obtained by conventional active sampling methods using Tenax® sorbent tubes and polyurethane foam samplers, but with improvements of relative standard deviation, sensitivity, and sampling time. The results demonstrated that the NTD method is a simple, sensitive, effective, reusable, and inexpensive technique for sampling and analyzing SVOCs in the concentration range from 2 ng m^-3 to 100 μg m^-3 in air.

Preparation of Carbotrap/silica composite for needle trap field sampling of halogenated volatile organic compounds followed by gas chromatography/mass spectrometry determination

BACKGROUND

A needle trap device (NTD) was packed with Carbotrap/silica composite sorbent and applied for field sampling of halogenated volatile organic compounds (HVOCs) followed by gas chromatography/mass spectrometry (GC/MS) separation and determination.

METHODS

Carbotrap B, as a highly pure surface sorbent, was prepared using sol-gel method to improve its surface properties for adsorption/desorption of the target analytes. The effects of important experimental variables on the sampling and determination of trichloroethylene (thrCE) and tetrachloroethylene (tetCE) using the proposed NTD-GC/MS strategy were evaluated and optimized.

RESULTS

The results showed that sampling temperature and relative humidity interfered with sampling efficiency of the developed method and peak area responses of the analytes decreased with increasing temperature and relative humidity. The peak areas of the analytes increased with raising desorption temperature from 180 to 250 °C, and increasing desorption time from 1 to 3 min. The carryover experiments showed that the carryover effect disappeared after 3 min of desorption time. The Limits of Detection (LODs) and Limits of Quantitation (LOQs) of the analytes were in the range 0.01-0.03 and 0.05-0.09, respectively.

CONCLUSIONS

The results indicated that the developed NTD-GC/MS procedure can be used as a technology with high sensitivity for the field sampling and determination of HVOCs.

Evaluation of a novel hollow fiber membrane technique for collection of 1,1-dimethylhydrazine in air

The purpose of this study was to develop a novel one-step method for the time-weighted average determination of 1,1-dimethylhydrazine (UDMH) in the air followed by spectrophotometric detection. For this reason, 0.1% hydrochloric acid as the absorbent was used in hollow fiber (HF) membrane for sampling of UDMH from an atmospheric standard chamber. Response surface methodology (RSM) with central composite design (CCD) was used to optimize the sampling parameters, such as flow rate and sampling time. Moreover, several analytical parameters including breakthrough (BT) volume, storage time, and carryover effect of the proposed HF were investigated. The results showed that optimal sampling rate was 9.90 mL/min. In order to validate the proposed method, it was compared with the National Institute for Occupational Safety and Health (NIOSH) 3515 method, which showed good compatibility between the two methods. Intra- and inter-day repeatability values of the HF method were in the range 0.082-0.1 and 0.091-0.12, respectively, and the limits of detection (LODs) and limits of quantitation (LOQs) were 0.002 and 0.006 ng/mL, respectively. The storage time of the proposed HF was 7 days at 2 °C. These results demonstrated that the one-step HF membrane offered a high sensitivity for sampling of UDMH in air.