Photoelectrocatalytic degradation of 17α-ethinylestradiol and estrone under UV and visible light using nanotubular oxide arrays grown on Ti-0.5wt%W

Poly(vinylidene fluoride) membrane with immobilized TiO2 for degradation of steroid hormone micropollutants in a photocatalytic membrane reactor

The lack of effective technologies to remove steroid hormones (SHs) from aquatic systems is a critical issue for both environment and public health. The performance of a flow-through photocatalytic membrane reactor (PMR) with TiO₂ immobilized on a photostable poly(vinylidene fluoride) membrane (PVDF-TiO₂) was evaluated in the context of SHs degradation at concentrations from 0.05 to 1000 µg/L under UV exposure (365 nm). A comprehensive investigation into the membrane preparation approach, including varying the surface Ti content and distribution, and membrane pore size, was conducted to gain insights on the rate-limiting steps for the SHs degradation. Increasing surface Ti content from 4 % to 6.5 % enhanced the 17β-estradiol (E2) degradation from 46 ± 12-81 ± 6 %. Apparent degradation kinetics were independent of both TiO₂ homogeneity and membrane pore size (0.1-0.45 µm). With optimized conditions, E2 removal was higher than 96 % at environmentally relevant feed concentration (100 ng/L), a flux of 60 L/m²h, 25 mW/cm², and 6.5 % Ti. These results indicated that the E2 degradation on the PVDF-TiO₂ membrane was limited by the catalyst content and light penetration depth. Further exploration of novel TiO₂ immobilization approach that can offer a larger catalyst content and light penetration is required to improve the micropollutant removal efficiency in PMR.

Potential of low-cost TiO2-PVC composite in photoelectrocatalytic degradation of reactive orange 16 under visible light

In recent years, previously reported studies revealed a high efficiency of pollutant degradation by coupling photocatalysis and electrochemical processes (PECs) using titanium dioxide (TiO₂) photoelectrode rather than using photocatalysis or electrocatalysis alone. However, some of the TiO₂ photoelectrodes that have been reported were not cost-effective. This is due to the use of expensive chemicals and certain expensive equipment in the fabrication process, other than involving complicated preparation steps. Therefore, this study is aimed at investigating the PEC performance and stability of low-cost TiO₂-polyvinyl chloride (TiO₂-PVC) composite photoelectrode for Reactive Orange 16 (RO16) degradation. The materials characterisation using the ATR-FTIR, XRD and UV-Vis DRS proved that TiO₂ and TiO₂-PVC were successfully synthesised. The micrograph obtained for the surface characterisation using the FESEM showed that the smooth surface of freshly prepared photoelectrodes turned slightly rough with tiny pits formation after five continuous PEC processes. Nevertheless, the photoelectrode retained its original shape in good condition for further PEC processes. By PEC process, the fabricated photoelectrode showed 99.4% and 51.1% of colour and total organic carbon (TOC) removal, respectively, at optimised PEC parameters (1.0 mol L^-1 NaCl concentration, 10 V applied voltage, 120 min degradation time and initial pH 2). Moreover, the fabricated photoelectrode demonstrated sufficient reusability potential (~ 96.3%) after five cycles of PEC processes. In summary, a low-cost and stable composite photoelectrode with high efficiency in RO16 degradation was successfully fabricated and could be potentially applied for other emerging pollutants degradation via the PEC degradation technique.

Photo-Fenton process applied for the treatment of industrial wastewaters containing diclofenac: optimization with low iron ions concentrations and without pH control

Diclofenac (DCF) can cause several adverse effects in the environment and it should be removed from industrial pharmaceutical wastewaters. Advanced oxidation processes (AOPs) are promising methods for the DCF degradation. But, in many cases, AOPs require acidic pH. However, at this condition, DCF precipitates, which may hinder its oxidation. Thus, in this work, some AOP were studied for the DCF degradation, especially the photo-Fenton process, applying the experimental design technique (Doehlert matrix), operating without and with pH control (between 6.5 and 7.0). As independent variables, the initial ferrous ion concentration ([Fe²⁺]) and the molar addition rate of H₂O₂ (F_H2O2) were evaluated. Empirical models were proposed and optimized conditions were determined without ([Fe²⁺] = 0.27 mmol L^-1 and F_H2O2 = 1.64 mmol min^-1) and with pH control ([Fe²⁺] = 1.0 mmol L^-1 and F_H2O2 = 1.64 mmol L^-1), with the following predicted mineralization percentages: 93% and 68%, respectively. So, photo-Fenton process without pH control presented the best performances. Furthermore, at this condition, iron concentration respects the limit value established by the Brazilian environmental legislation. That is, in this condition, additional processes, in order to remove iron ions, would not be necessary, that is very interesting for applications on an industrial scale.

Robust strategies to eliminate endocrine disruptive estrogens in water resources

The widespread occurrence and ubiquitous distribution of estrogens, i.e., estrone (E1), estradiol (E2), and estriol (E3) in our water matrices, is an issue of global concern. Public and regulatory authorities are concerned and placing joint efforts to eliminate estrogens and related environmentally hazardous compounds, due to their toxic influences on the environmental matrices, ecology, and human health, even at low concentrations. However, most of the available literature is focused on the occurrence of estrogens in different water environments with limited treatment options. Thus, a detailed review to fully cover the several treatment processes is needed. This review comprehensively and comparatively discusses many physical, chemical, and biological-based treatments to eliminate natural estrogens, i.e., estrone (E1), estradiol (E2), and estriol (E3) and related synthetic estrogens, e.g., 17α-ethinylestradiol (EE2) and other related hazardous compounds. The covered techniques include adsorption, nanofiltration, ultrafiltration, ultrasonication, photocatalysis of estrogenic compounds, Fenton, Fenton-like and photo-Fenton degradation of estrogenic compounds, electro-Fenton degradation of estrogenic compounds, ozonation, and biological methods for the removal of estrogenic compounds are thoroughly discussed with suitable examples. The studies revealed that treatment plants based on chemical and biological approaches are cost-friendly for removing estrogenic pollutants. Further, there is a need to properly monitor and disposal of the usage of estrogenic drugs in humans and animals. Additional studies are required to explore a robust and more advanced oxidation treatment strategy that can contribute effectively to industrial-scale applications. This review may assist future investigations, monitoring, and removing estrogenic compounds from various environmental matrices. In concluding remarks, a way forward and future perspectives focusing on bridging knowledge gaps in estrogenic compounds removal are also proposed.

Enhanced periphyton biodegradation of endocrine disrupting hormones and microplastic: Intrinsic reaction mechanism, influential humic acid and microbial community structure elucidation

Endocrine-disrupting compounds (EDCs), as well as microplastics, have drawn global attention due to their presence in the aquatic ecosystem and persistence in wastewater treatment plants (WWTPs). In the present study, for simultaneous bio-removal of two EDCs, 17α-ethinylestradiol (EE2), bisphenol A (BPA), and a microplastic, polypropylene (PP) four kinds of periphytic biofilms were employed. Additionally, the effect of humic acid (HA) on the removal efficacy of these biofilms was evaluated. It was observed that EE2 and BPA (0.2 mg L^-1 each) were completely (∼100%) removed within 36 days of treatment; and the biodegradation of EE2, BPA, and PP was significantly enhanced in the presence of HA. Biodegradation of EE2 and BPA was evaluated through Ultra-high performance liquid chromatography (UHPLC), and Gas chromatography coupled with tandem mass spectrometry (GC-MS/MS) was used to determine the mechanism of degradation. Gel permeation chromatography (GPC) and SEM had validated the biodegradation of PP (5.2-14.7%). MiSeqsequencing showed that the community structure of natural biofilm changed after the addition of HA, as well as after the addition of EDCs and PP. This change in community structure might be a key factor regarding variable biodegradation percentages. The present study revealed the potential of periphytic biofilms for the simultaneous removal of pollutants of different chemical natures, thus provides a promising new method for wastewater treatment applications.

Recent Advances in Endocrine Disrupting Compounds Degradation through Metal Oxide-Based Nanomaterials

Endocrine Disrupting Compounds (EDCs) comprise a class of natural or synthetic molecules and groups of substances which are considered as emerging contaminants due to their toxicity and danger for the ecosystems, including human health. Nowadays, the presence of EDCs in water and wastewater has become a global problem, which is challenging the scientific community to address the development and application of effective strategies for their removal from the environment. Particularly, catalytic and photocatalytic degradation processes employing nanostructured materials based on metal oxides, mainly acting through the generation of reactive oxygen species, are widely explored to eradicate EDCs from water. In this review, we report the recent advances described by the major publications in recent years and focused on the degradation processes of several classes of EDCs, such as plastic components and additives, agricultural chemicals, pharmaceuticals, and personal care products, which were realized by using novel metal oxide-based nanomaterials. A variety of doped, hybrid, composite and heterostructured semiconductors were reported, whose performances are influenced by their chemical, structural as well as morphological features. Along with photocatalysis, alternative heterogeneous advanced oxidation processes are in development, and their combination may be a promising way toward industrial scale application.

Efficient degradation of endocrine-disrupting compounds by heterostructured perovskite photocatalysts and its correlation with their ferroelectricity

Heterostructured perovskites photocatalysts for endocrine-disrupting compounds degradation and their ferroelectric properties.

Facile preparation, catalytic performance and reaction mechanism of MnxCo1-xOδ/3DOM-m Ti0.7Si0.2W0.1Oy catalysts for the simultaneous removal of soot and NOx

In this work, three-dimensionally ordered macroporous-mesoporous Ti0.7Si0.2W0.1Oy (3DOM-m TiSiWO) supported MnxCo1-xOδ catalysts with different x values were prepared using the colloidal crystal template method and incipient wetness impregnation method. The...

Stability of Polymeric Membranes to UV Exposure before and after Coating with TiO2 Nanoparticles

The combination of photocatalysis and membrane filtration in a single reactor has been proposed, since the photocatalytic treatment may degrade the pollutants retained by the membrane and reduce fouling. However, polymeric membranes can be susceptible to degradation by UV radiation and free radicals. In the present study, five commercial polymeric membranes were exposed to ultraviolet (UV) radiation before and after applying a sol–gel coating with TiO₂ nanoparticles. Membrane stability was characterized by changes in hydrophilicity as well as analysis of soluble substances and nanoparticles detached into the aqueous medium, and by Fourier transform infrared spectroscopy (FTIR), scanning electron microscope (SEM), and energy-dispersive X-ray spectrometry (EDS) for structural, morphological, and elemental distribution analysis, respectively. The TiO₂ coating conferred photocatalytic properties to the membranes and protected them during 6 h of UV radiation exposures, reducing or eliminating chemical and morphological changes, and in some cases, improving their mechanical resistance. A selected commercial nanofiltration membrane was coated with TiO₂ and used in a hybrid reactor with a low-pressure UV lamp, promoting photocatalysis coupled with cross-flow filtration in order to remove 17α-ethinylestradiol spiked into an aqueous matrix, achieving an efficiency close to 100% after 180 min of combined filtration and photocatalysis, and almost 80% after 90 min.

Rapidly degradation of di-(2-ethylhexyl) phthalate by Z-scheme Bi2O3/TiO2@reduced graphene oxide driven by simulated solar radiation

Di(2-ethylhexyl) phthalate (DEHP) is a priority environmental pollutant with carcinogenic, teratogenic, and mutagenic toxicity. Because it is widely used and ubiquitous in water, it is urgent to use a non-toxic, fast, and non-temperature dependent photocatalyst for degradation. Herein, a Z-scheme heterojunction composite catalyst consisting of Bi₂O₃ and TiO₂ with reduced graphene oxide (rGO) as a two-dimensional template was designed and characterized. Under simulated solar radiation, the catalyst doped with 4% rGO presented the best photocatalytic DEHP (10 mg L^-1) degradation at pH = 6, reaching 89% conversion in 90 min, and the degradation rate was 2.05 times higher than unmodified materials. The successful preparation of the Z-scheme junction enhanced the utilization of visible light region, thereby improving the DEHP's photocatalytic degradation performance. Subsequently, density functional theory (DFT) combined with GC-MS metabolite detection to propose a complete DEHP photocatalytic degradation mechanism. ·O₂^- and ·OH were detected as the primary reactive oxygen radicals involved in DEHP degradation, which easily attacked the O11 site with a high Fukui index (f⁰) through de-esterification, β-oxidation, and hydroxylation. While satisfying the rapid degradation, the highly repeatable catalyst cleaved the aromatic ring so that DEHP achieved mineralization during the degradation process. Therefore, its ability to completely degrade was very promising for environmental remediation, especially in water treatment. Besides, there were only a few studies on the degradation mechanism and reaction pathway of DEHP under visible light, which provided a theoretical basis for the aromatic compounds' photocatalysis research.

Degradation of organic pollutants by intimately coupling photocatalytic materials with microbes: a review

With the rapid development of industry and agriculture, large amounts of organic pollutants have been released into the environment. Consequently, the degradation of refractory organic pollutants has become one of the toughest challenges in remediation. To solve this problem, intimate coupling of photocatalysis and biodegradation (ICPB) technology, which allows the simultaneous action of photocatalysis and biodegradation and thus integrates the advantages of photocatalytic reactions and biological treatments, was developed recently. ICPB consists mainly of porous carriers, photocatalysts, biofilms, and an illuminated reactor. Under illumination, photocatalysts on the surface of the carriers convert refractory pollutants into biodegradable products through photocatalytic reactions, after which these products are completely degraded by the biofilms cultivated in the carriers. Additionally, the biofilms are protected by the carriers from the harmful light and free radicals generated by the photocatalyst. Compared with traditional technologies, ICPB remarkably improves the degradation efficiency and reduces the cost of bioremediation. In this review, we introduce the origin and mechanisms of ICPB, discuss the development of reactors, carriers, photocatalysts, and biofilms used in ICPB, and summarize the applications of ICPB to treat organic pollutants. Finally, gaps in this research as well as future perspectives are discussed.