A π-π stacking perylene imide/Bi2WO6 hybrid with dual transfer approach for enhanced photocatalytic degradation

Nanoscale-controlled organicinorganic hybrid spheres for comprehensive enrichment of ultratrace chlorobenzenes in marine and fresh water

The size of the adsorbent has the potential to influence extraction performance, but the size effect at the nanoscale is still poorly understood. In this study, organic-inorganic hybrid nanospheres (OIHNs) with controllable nanoscale sizes of 30, 50, and 100 nm were successfully prepared. These materials were further fabricated as solid phase microextraction (SPME) coatings with similar thicknesses, and coupled with gas chromatography-mass spectrometry (GC-MS) to investigate their extraction performance. The results showed that the extraction capacities of OIHNs for chlorobenzenes (CBs) and polycyclic aromatic hydrocarbons (PAHs) were much better than those of their corresponding derived carbon materials, despite the smaller specific surface areas and lower porosities of them. In addition, the enrichment performance increased significantly with decreasing particle size, and the OIHN-30 coating demonstrated the best performance, with enrichment factors ranging from 1098 to 6853 for CBs. Finally, a highly sensitive and practical analytical method was established with a wide linear range of 0.5-5000 ng·L-1, and the limits of quantification (LOQs) were 0.43-1.7 ng·L-1. The determinations of ultratrace CBs in five marine water samples and five fresh water samples were realized successfully. This study is expected to contribute to a deep understanding of the environmental effects of nanoparticles and the design of high-performance adsorbents.

Enhancing Visible-Light Photocatalysis with Pd(II) Porphyrin-Based TiO2 Hybrid Nanomaterials: Preparation, Characterization, ROS Generation, and Photocatalytic Activity

Novel hybrid TiO2-based materials were obtained by adsorption of two different porphyrins on the surface of nanoparticles-commercially available 5,10,15,20-tetrakis(4-sulfonatophenyl)porphyrin (TPPS) and properly modified metalloporphyrin-5,10,15,20-tetrakis(2,6-difluoro-3-sulfophenyl)porphyrin palladium(II) (PdF2POH). The immobilization of porphyrins on the surface of TiO2 was possible due to the presence of sulfonyl groups. To further elevate the adsorption of porphyrin, an anchoring linker-4-hydroxybenzoic acid (PHBA)-was used. The synthesis of hybrid materials was proven by electronic absorption spectroscopy, dynamic light scattering (DLS), and photoelectrochemistry. Results prove the successful photosensitization of TiO2 to visible light by both porphyrins. However, the presence of the palladium ion in the modifier structure played a key role in strong adsorption, enhanced charge separation, and thus effective photosensitization. The incorporation of halogenated metalloporphyrins into TiO2 facilitates the enhancement of the comprehensive characteristics of the investigated materials and enables the evaluation of their performance under visible light. The effectiveness of reactive oxygen species (ROS) generation was also determined. Porphyrin-based materials with the addition of PHBA seemed to generate ROS more effectively than other composites. Interestingly, modifications influenced the generation of singlet oxygen for TPPS but not hydroxyl radical, in contrast to PdF2POH, where singlet oxygen generation was not influenced but hydroxyl radical generation was increased. Palladium (II) porphyrin-modified materials were characterized by higher photostability than TPPS-based nanostructures, as TPPS@PHBA-P25 materials showed the highest singlet oxygen generation and may be oxidized during light exposure. Photocatalytic activity tests with two model pollutants-methylene blue (MB) and the opioid drug tramadol (TRML)-confirmed the light dose-dependent degradation of those two compounds, especially PdF2POH@P25, which led to the virtually complete degradation of MB.

Construction of dual Z-scheme Bi2WO6/g-C3N4/black phosphorus quantum dots composites for effective bisphenol A degradation

In this work, a novel dual Z-scheme Bi₂WO₆/g-C₃N₄/black phosphorus quantum dots (Bi₂WO₆/g-C₃N₄/BPQDs) composites were fabricated and utilized towards photocatalytic degradation of bisphenol A (BPA) under visible-light irradiation. Optimizing the content of g-C₃N₄ and BPQDs in Bi₂WO₆/g-C₃N₄/BPQDs composites to a suitable mass ratio can enhance the visible-light harvesting capacity and increase the charge separation efficiency and the transfer rate of excited-state electrons and holes, resulting in much higher photocatalytic activity for BPA degradation (95.6%, at 20 mg/L in 120 min) than that of Bi₂WO₆ (63.7%), g-C₃N₄ (25.0%), BPQDs (8.5%), and Bi₂WO₆/g-C₃N₄ (79.6%), respectively. Radical trapping experiments indicated that photogenerated holes (h⁺) and superoxide radicals (•O₂^-) played crucial roles in photocatalytic BPA degradation. Further, the possible degradation pathway and photocatalytic mechanism was proposed by analyzing the BPA intermediates. This work also demonstrated that the Bi₂WO₆/g-C₃N₄/BPQDs as effective photocatalysts was stable and have promising potential to remove environmental contaminants from real water samples.

Advances in Hybrid Composites for Photocatalytic Applications: A Review

Heterogeneous photocatalysts have garnered extensive attention as a sustainable way for environmental remediation and energy storage process. Water splitting, solar energy conversion, and pollutant degradation are examples of nowadays applications where semiconductor-based photocatalysts represent a potentially disruptive technology. The exploitation of solar radiation for photocatalysis could generate a strong impact by decreasing the energy demand and simultaneously mitigating the impact of anthropogenic pollutants. However, most of the actual photocatalysts work only on energy radiation in the Near-UV region (<400 nm), and the studies and development of new photocatalysts with high efficiency in the visible range of the spectrum are required. In this regard, hybrid organic/inorganic photocatalysts have emerged as highly potential materials to drastically improve visible photocatalytic efficiency. In this review, we will analyze the state-of-art and the developments of hybrid photocatalysts for energy storage and energy conversion process as well as their application in pollutant degradation and water treatments.

Tetragonal/orthorhombic-bismuth tungstate homojunction formed through in situ bismuth induced phase transformation as highly efficient photocatalyst for pollutant degradation

Tetragonal/orthorhombic-bismuth tungstate (t/o-Bi₂WO₆) homojunctions of high photocatalytic efficiencies were fabricated through a novel in situ Bi induced phase transformation. The photocatalytic efficiencies of t-Bi₂WO₆ were greatly enhanced via formation of the homojunction. Photocatalytic degradation of rhodamine B (RhB), a recalcitrant organic pollutant, under simulated sunlight illumination was investigated as a demonstration for the efficiency enhancement. A 6.22 folds improvement was achieved with formation of the homojunction in terms of reaction rate constants. The homojunction catalyst was demonstrated to be photocatalytically stable over a five cycles operation. The t/o-Bi₂WO₆ homojunction enhances separation and utilization efficiency of photo-generated charge carriers and thus greatly boosts the catalytic efficiency. Trapping tests and electron spin resonance spectroscopy were conducted to reveal that singlet oxygen (¹O₂), hole (h⁺), electrons (e^-), and superoxide anion radical (O₂^-) are the main working reactive species for RhB degradation. Density functional theory (DFT) calculations were performed to prove the feasibility of Bi induced phase transformation of t-Bi₂WO₆ to o-Bi₂WO₆. The present development offers a new design route for high efficiency photocatalysts for water pollution control.