1
|
Omar RA, Talreja N, Chuhan D, Ashfaq M. Waste-derived carbon nanostructures (WD-CNs): An innovative step toward waste to treasury. ENVIRONMENTAL RESEARCH 2024; 246:118096. [PMID: 38171470 DOI: 10.1016/j.envres.2023.118096] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Key Words] [MESH Headings] [Track Full Text] [Subscribe] [Scholar Register] [Received: 10/13/2023] [Revised: 12/05/2023] [Accepted: 12/31/2023] [Indexed: 01/05/2024]
Abstract
With the growing population, the accumulation of waste materials (WMs) (industrial/household waste) in the environment incessantly increases, affecting human health. Additionally, it affects the climate and ecosystem of terrestrial and water habitats, thereby needing effective management technology to control environmental pollution. In this aspect, managing these WMs to develop products that mitigate the associated issues is necessary. Researchers continue to focus on WMs management by adopting a circular economy. These WMs convert into useful/value-added products such as polymers and nanomaterials (NMs), especially carbon nanomaterials (CNs). The conversion/transformation of waste material into useful products is one of the best solutions for managing waste. Waste-derived CNs (WD-CNs) have established boundless promises for numerous applications like environmental remediation, energy, catalysts, sensors, and biomedical applications. This review paper discusses the several sources of waste material (agricultural, plastic, industrial, biomass, and other) transforming into WD-CNs, such as carbon nanotubes (CNTs), biochar, graphene, carbon nanofibers (CNFs), carbon dots, etc., are extensively elaborated and their application. The impact of metal doping within the WD-CNs is briefly discussed, along with their applicability to end applications.
Collapse
Affiliation(s)
- Rishabh Anand Omar
- Centre for Environmental Science and Engineering, Indian Institute of Technology Kanpur, Kanpur, 208016, India
| | - Neetu Talreja
- Department of Science, Faculty of Science and Technology, Alliance University, Anekal, Bengaluru-562 106, Karnataka, India.
| | - Divya Chuhan
- Department of Drinking Water and Sanitation, Ministry of Jal Shakti, 1208-A, Pandit Deendayal Antyodaya Bhawan, CGO Complex, Lodhi Road, New Delhi 110003 India
| | - Mohammad Ashfaq
- Department of Biotechnology, University Centre for Research & Development (UCRD), Chandigarh University, Gharaun, Mohali, 140413, Punjab, India.
| |
Collapse
|
2
|
Modekwe HU, Daramola MO, Mamo MA, Moothi K. Recent advancements in the use of plastics as a carbon source for carbon nanotubes synthesis - A review. Heliyon 2024; 10:e24679. [PMID: 38304810 PMCID: PMC10830538 DOI: 10.1016/j.heliyon.2024.e24679] [Citation(s) in RCA: 0] [Impact Index Per Article: 0] [Reference Citation Analysis] [Abstract] [Key Words] [Track Full Text] [Figures] [Journal Information] [Subscribe] [Scholar Register] [Received: 02/13/2023] [Revised: 12/23/2023] [Accepted: 01/11/2024] [Indexed: 02/03/2024] Open
Abstract
Plastics, which majorly consist of polypropylene (PP), polyethylene (linear low-density polyethylene (LLDPE), low-density polyethylene (LDPE) and high-density polyethylene (HDPE)), polystyrene (PS), polyvinyl chloride (PVC), polyethylene terephthalate (PET), etc., are the most abundant municipal solid wastes (MSW). They have been utilized as a cheap carbon feedstock in the synthesis of carbon nanotubes (CNTs) because of their high hydrocarbon content, mainly carbon and hydrogen, especially for the polyolefins. In this review, the detailed progress made so far in the use of plastics (both waste and virgin) as cheap carbon feedstock in the synthesis of CNTs (only) over the years is studied. The primary aim of this work is to provide an expansive landscape made so far, especially in the areas of catalysts, catalyst supports, and the methods employed in their preparations and other operational growth conditions, as well as already explored applications of plastic-derived CNTs. This is to enable researchers to easily access, understand, and summarise previous works done in this area, forging ahead towards improving the yield and quality of plastic-derived CNTs, which could extend their market and use in other purity-sensitive applications.
Collapse
Affiliation(s)
- Helen U. Modekwe
- Renewable Energy and Biomass Research Group, Department of Chemical Engineering, Faculty of Engineering & the Built Environment, University of Johannesburg, Doornfontein Campus, 2028, Johannesburg, South Africa
| | - Michael O. Daramola
- Department of Chemical Engineering, Faculty of Engineering, Built Environment and Information Technology, University of Pretoria, Private bag X20 Hatfield, 0028, Pretoria, South Africa
| | - Messai A. Mamo
- Research Centre for Synthesis and Catalysis, Department of Chemical Science, Faculty of Science, University of Johannesburg, Doornfontein Campus, 2028, Johannesburg, South Africa
| | - Kapil Moothi
- School of Chemical and Minerals Engineering, Faculty of Engineering, North-West University, Potchefstroom 2520, South Africa
- Department of Chemical Engineering, Faculty of Engineering and the Built Environment, University of Johannesburg, Doornfontein campus, 2028, Johannesburg, South Africa
| |
Collapse
|
3
|
Ribeiro RS, Vieira O, Fernandes R, Roman FF, Diaz de Tuesta JL, Silva AMT, Gomes HT. Synthesis of low-density polyethylene derived carbon nanotubes for activation of persulfate and degradation of water organic micropollutants in continuous mode. JOURNAL OF ENVIRONMENTAL MANAGEMENT 2022; 308:114622. [PMID: 35124314 DOI: 10.1016/j.jenvman.2022.114622] [Citation(s) in RCA: 7] [Impact Index Per Article: 3.5] [Reference Citation Analysis] [Abstract] [Key Words] [MESH Headings] [Track Full Text] [Subscribe] [Scholar Register] [Received: 09/13/2021] [Revised: 01/24/2022] [Accepted: 01/25/2022] [Indexed: 06/14/2023]
Abstract
Plastic derived carbon nanotubes (CNTs) were tested as catalysts in persulfate activation for the first time. Four catalysts were prepared by wetness impregnation and co-precipitation (using Al2O3, Ni, Fe and/or Al) and implemented to grow CNTs by chemical vapour deposition (CVD) using low-density polyethylene (LDPE) as carbon feedstock. A catalyst screening was performed in batch mode and the best performing CNTs (CNT@Ni+Fe/Al2O3-cp) led to a high venlafaxine mass removal rate (3.17 mg g-1 h-1) in ultrapure water after 90 min (even with a mixture of micropollutants). Its degradation increased when the matrix was replaced by drinking water and negligibly affected in surface water. A composite polymeric membrane was then fabricated with CNT@Ni+Fe/Al2O3-cp and polyvinylidene fluoride (PVDF), a high venlafaxine mass removal rate in surface water being also observed in 24 h of continuous operation. Therefore, the results herein reported open a window of opportunity for the valorisation of plastic wastes in this catalytic application performed in continuous mode.
Collapse
Affiliation(s)
- Rui S Ribeiro
- Laboratory of Separation and Reaction Engineering - Laboratory of Catalysis and Materials (LSRE-LCM), Faculdade de Engenharia, Universidade do Porto, Rua Dr. Roberto Frias, 4200-465, Porto, Portugal.
| | - Octávia Vieira
- Laboratory of Separation and Reaction Engineering - Laboratory of Catalysis and Materials (LSRE-LCM), Faculdade de Engenharia, Universidade do Porto, Rua Dr. Roberto Frias, 4200-465, Porto, Portugal
| | - Rita Fernandes
- Laboratory of Separation and Reaction Engineering - Laboratory of Catalysis and Materials (LSRE-LCM), Faculdade de Engenharia, Universidade do Porto, Rua Dr. Roberto Frias, 4200-465, Porto, Portugal
| | - Fernanda F Roman
- Laboratory of Separation and Reaction Engineering - Laboratory of Catalysis and Materials (LSRE-LCM), Faculdade de Engenharia, Universidade do Porto, Rua Dr. Roberto Frias, 4200-465, Porto, Portugal; Centro de Investigação de Montanha (CIMO), Instituto Politécnico de Bragança, Campus de Santa Apolónia, 5300-253, Bragança, Portugal
| | - Jose L Diaz de Tuesta
- Centro de Investigação de Montanha (CIMO), Instituto Politécnico de Bragança, Campus de Santa Apolónia, 5300-253, Bragança, Portugal.
| | - Adrián M T Silva
- Laboratory of Separation and Reaction Engineering - Laboratory of Catalysis and Materials (LSRE-LCM), Faculdade de Engenharia, Universidade do Porto, Rua Dr. Roberto Frias, 4200-465, Porto, Portugal
| | - Helder T Gomes
- Centro de Investigação de Montanha (CIMO), Instituto Politécnico de Bragança, Campus de Santa Apolónia, 5300-253, Bragança, Portugal
| |
Collapse
|
4
|
Ultrasensitive electrochemical determination of trace ceftizoxime using a thin film of Preyssler nanocapsules on pencil graphite electrode surface modified with reduced graphene oxide. Microchem J 2021. [DOI: 10.1016/j.microc.2021.106160] [Citation(s) in RCA: 5] [Impact Index Per Article: 1.7] [Reference Citation Analysis] [Track Full Text] [Journal Information] [Subscribe] [Scholar Register] [Indexed: 01/04/2023]
|
5
|
Poteryaeva VA, Bubenchikov MA, Bubenchikov AM, Lun-Fu AV. The interaction of atoms and molecules with nanocapsules and hollow nanowires. Sci Rep 2020; 10:15631. [PMID: 32973202 PMCID: PMC7518270 DOI: 10.1038/s41598-020-72327-6] [Citation(s) in RCA: 4] [Impact Index Per Article: 1.0] [Reference Citation Analysis] [Abstract] [Track Full Text] [Download PDF] [Figures] [Journal Information] [Subscribe] [Scholar Register] [Received: 05/23/2020] [Accepted: 08/27/2020] [Indexed: 11/13/2022] Open
Abstract
Nanoporous membranes are widely used in various fields, such as gas separation, water purification, catalytic processes, and the use of batteries in electrodes. Nowadays, hollow carbon spheres or nanowires are attracting attention of researchers and experimenters due to high adjustability of their mechanical and chemical properties. This makes it possible, among other things, to more accurately adjust permeability of membranes created from this material for various atoms and molecules, which ensures a good degree of gas separation. The mathematical simulation of gas separation via nanocapsule and hollow nanowire porous membrane is performed. Research has shown that such membranes are able to separate He/\documentclass[12pt]{minimal}
\usepackage{amsmath}
\usepackage{wasysym}
\usepackage{amsfonts}
\usepackage{amssymb}
\usepackage{amsbsy}
\usepackage{mathrsfs}
\usepackage{upgreek}
\setlength{\oddsidemargin}{-69pt}
\begin{document}$$\text{CH}_4$$\end{document}CH4/\documentclass[12pt]{minimal}
\usepackage{amsmath}
\usepackage{wasysym}
\usepackage{amsfonts}
\usepackage{amssymb}
\usepackage{amsbsy}
\usepackage{mathrsfs}
\usepackage{upgreek}
\setlength{\oddsidemargin}{-69pt}
\begin{document}$$\text{H}_2$$\end{document}H2/\documentclass[12pt]{minimal}
\usepackage{amsmath}
\usepackage{wasysym}
\usepackage{amsfonts}
\usepackage{amssymb}
\usepackage{amsbsy}
\usepackage{mathrsfs}
\usepackage{upgreek}
\setlength{\oddsidemargin}{-69pt}
\begin{document}$$\text{N}_2$$\end{document}N2 gas mixtures.
Collapse
Affiliation(s)
- Valentina A Poteryaeva
- Department of Mechanics and Mathematics, National Research Tomsk State University, Tomsk, Russia, 634050.
| | - Michael A Bubenchikov
- Department of Mechanics and Mathematics, National Research Tomsk State University, Tomsk, Russia, 634050.,Gazprom Transgaz Tomsk Ltd., Tomsk, Russia, 634029
| | | | | |
Collapse
|
6
|
Designing Business Solutions for Plastic Waste Management to Enhance Circular Transitions in Kenya. SUSTAINABILITY 2018. [DOI: 10.3390/su10051664] [Citation(s) in RCA: 38] [Impact Index Per Article: 6.3] [Reference Citation Analysis] [Track Full Text] [Subscribe] [Scholar Register] [Indexed: 11/16/2022]
|