Implication of cell culture methods and biases on UV inactivation of viruses

Approaching easy water disinfection for all: Can in situ electrochlorination outperform conventional chlorination under realistic conditions?

Electrochlorination has gained research interest for its potential application as decentralized water treatment. A number of studies have displayed promising efficiency for water disinfection. However, a comprehensive comparison of in situ electrodisinfection to existing disinfection techniques, particularly under realistic water composition and flow rates, still needs additional research efforts. The aim of this study is to evaluate in situ electrochlorination while comparing the treatment with conventional chemical chlorination for point-of-entry decentralized disinfection at the household level. An electrochemical flow cell reactor was operated in a single pass mode considering water flow and water consumption for a household of four family members. Disinfection efficiency assessment of both electrochemical and chemical chlorination was conducted using bacterial and viral surrogates, E. coli and MS2 bacteriophage. Furthermore, a techno-economic analysis was conducted, using the levelized cost of water, to compare two electrochemical chlorination scenarios (i.e., electrical grid energy use, and solar panel powered system) and benchmarked against the baseline treatment of chemical chlorination. The findings revealed increased inactivation efficiency of in situ electrochlorination over conventional chlorination (p-value < 0.05). The synergetic impact of radicals and chlorine, and/or contribution of high chlorine concentration at acidic pH near anode surface were identified as key factors that could enhance disinfection performance of in situ electrochlorination. The techno-economic analysis demonstrated that electrochemical treatment, when operated using renewable energy sources, is not only a more environmentally sustainable approach, but also emerges as a more economically feasible solution for decentralized water treatment application. The results highlight that in situ electrochlorination is a more advanced alternative to decentralized water chlorination. However, further fundamental research on products and by-products formation under various water matrices is required.

Germicidal efficacy of continuous and pulsed ultraviolet-C radiation on pathogen models and SARS-CoV-2

Ultraviolet radiation's germicidal efficacy depends on several parameters, including wavelength, radiant exposure, microbial physiology, biological matrices, and surfaces. In this work, several ultraviolet radiation sources (a low-pressure mercury lamp, a KrCl excimer, and four UV LEDs) emitting continuous or pulsed irradiation were compared. The greatest log reductions in E. coli cells and B. subtilis endospores were 4.1 ± 0.2 (18 mJ cm-2) and 4.5 ± 0.1 (42 mJ cm-2) with continuous 222 nm, respectively. The highest MS2 log reduction observed was 2.7 ± 0.1 (277 nm at 3809 mJ cm-2). Log reductions of SARS-CoV-2 with continuous 222 nm and 277 nm were ≥ 3.4 ± 0.7, with 13.3 mJ cm-2 and 60 mJ cm-2, respectively. There was no statistical difference between continuous and pulsed irradiation (0.83-16.7% [222 nm and 277 nm] or 0.83-20% [280 nm] duty rates) on E. coli inactivation. Pulsed 260 nm radiation (0.5% duty rate) at 260 nm yielded significantly greater log reduction for both bacteria than continuous 260 nm radiation. There was no statistical difference in SARS-CoV-2 inactivation between continuous and pulsed 222 nm UV-C radiation and pulsed 277 nm radiation demonstrated greater germicidal efficacy than continuous 277 nm radiation. Greater radiant exposure for all radiation sources was required to inactivate MS2 bacteriophage. Findings demonstrate that pulsed irradiation could be more useful than continuous UV radiation in human-occupied spaces, but threshold limit values should be respected. Pathogen-specific sensitivities, experimental setup, and quantification methods for determining germicidal efficacy remain important factors when optimizing ultraviolet radiation for surface decontamination or other applications.

Development of porcine embryos cultured in media irradiated with ultraviolet-C

Sterilization of the culture medium using ultraviolet (UV)-C reduces the potential adverse effects of microorganisms and allows for long-term use. In the present study, we investigated the effects of a medium directly irradiated with UV-C prior to in vitro culture on the development and quality of porcine in vitro-fertilized embryos and the free amino acid composition of the culture media. The culture media (porcine zygote medium [PZM-5] and porcine blastocyst medium [PBM]) were irradiated with UV-C at 228 and 260 nm for 1 and 3 days, respectively. Next, the culture media were irradiated with UV-C at 228 nm for 3, 7, or 14 days. After in vitro fertilization, the embryos were cultured in the UV-C-irradiated media for 7 days. Free amino acid levels in culture media irradiated with 228 and 260 nm UV-C for 3 days were analysed. The blastocyst formation rate of embryos cultured in media irradiated with 260 nm UV-C for 3 days was significantly lower than that of embryos cultured in non-irradiated control media. However, 228 nm UV-C irradiation for up to 14 days did not affect blastocyst formation rates and quality in the resulting blastocysts. Moreover, 260 nm UV-C irradiation significantly increased the taurine concentration in both culture media and decreased methionine concentration in the PBM. In conclusion, UV-C irradiation at 228 nm before in vitro culture had no detrimental effects on embryonic development. However, 260 nm UV-C irradiation decreased embryo development and altered the composition of free amino acids in the medium.