Mass transfer through membranes with surface roughness

Ultra-high flux mesh membranes coated with tannic acid-ZIF-8@MXene composites for efficient oil-water separation

Oil/water separation has become a global concern due to the increasing discharge of multi-component harmful oily wastewater. Super wetting membranes have been shown to be an effective material for oil/water separation. Ultra-high flux stainless-steel meshes (SSM) with superhydrophilicity and underwater superoleophobicity were fabricated by tannic acid (TA) modified ZIF-8 nanoparticles (TZIF-8) and two-dimensional MXene materials for oil/water separation. The TZIF-8 increased the interlayer space of MXene, enhancing the flux permeation (69,093 L m-2h-1) and rejection of the composite membrane (TZIF-8@MXene/SSM). The TZIF-8@MXene/SSM membrane showed an underwater oil contact angle of 154.2°. The membrane maintained underwater superoleophobic after stability and durability tests, including various pH solutions, organic solvents, reusability, etc. In addition, the oil/water separation efficiency of TZIF-8@MXene/SSM membranes was higher than 99% after treatment in harsh conditions and recycling. The outstanding anti-fouling, stability, durability, and recyclability properties of TZIF-8@MXene/SSM membrane highlight the remarkable potential of membranes for complex oil/water separation process.

Pervaporation Membranes Based on Polyelectrolyte Complex of Sodium Alginate/Polyethyleneimine Modified with Graphene Oxide for Ethanol Dehydration

Pervaporation is considered the most promising technology for dehydration of bioalcohols, attracting increasing attention as a renewable energy source. In this regard, the development of stable and effective membranes is required. In this study, highly efficient membranes for the enhanced pervaporation dehydration of ethanol were developed by modification of sodium alginate (SA) with a polyethylenimine (PEI) forming polyelectrolyte complex (PEC) and graphene oxide (GO). The effect of modifications with GO or/and PEI on the structure, physicochemical, and transport characteristics of dense membranes was studied. The formation of a PEC by ionic cross-linking and its interaction with GO led to changes in membrane structure, confirmed by spectroscopic and microscopic methods. The physicochemical properties of membranes were investigated by a thermogravimetric analysis, a differential scanning calorimetry, and measurements of contact angles. The theoretical consideration using computational methods showed favorable hydrogen bonding interactions between GO, PEI, and water, which caused improved membrane performance. To increase permeability, supported membranes without treatment and cross-linked were developed by the deposition of a thin dense layer from the optimal PEC/GO (2.5%) composite onto a developed porous substrate from polyacrylonitrile. The cross-linked supported membrane demonstrated more than two times increased permeation flux, higher selectivity (above 99.7 wt.% water in the permeate) and stability for separating diluted mixtures compared to the dense pristine SA membrane.

Asymmetric water transport in dense leaf cuticles and cuticle-inspired compositionally graded membranes

Most of the aerial organs of vascular plants are covered by a protective layer known as the cuticle, the main purpose of which is to limit transpirational water loss. Cuticles consist of an amphiphilic polyester matrix, polar polysaccharides that extend from the underlying epidermal cell wall and become less prominent towards the exterior, and hydrophobic waxes that dominate the surface. Here we report that the polarity gradient caused by this architecture renders the transport of water through astomatous olive and ivy leaf cuticles directional and that the permeation is regulated by the hydration level of the cutin-rich outer cuticular layer. We further report artificial nanocomposite membranes that are inspired by the cuticles' compositionally graded architecture and consist of hydrophilic cellulose nanocrystals and a hydrophobic polymer. The structure and composition of these cuticle-inspired membranes can easily be varied and this enables a systematic investigation of the water transport mechanism.

Gas permeation through rubbery polymer nano-corrugated membranes

The purpose of this investigation is to fabricate PDMS membranes with reliable surface roughness in order to reduce the surface resistances and to study its impact on the permeation rate. The permeance of CO₂ through PDMS membranes with rough surfaces at nanoscale is studied and compared with the one of membranes with flat surfaces. At very low thickness, rough membranes have a permeance greater than that of membranes with flat surfaces. The enhancement occurs in a regime where the gas transport is sorption desorption surface rate limited, and cannot be explained by the increase in surface area due to the corrugation. The analysis, introducing a phenomenological model in analogy with electrical flow, indicates that nano-corrugation reduces the surface resistance. To test the model, the permeance of N₂ is also measured in the same experimental conditions and the influence of surface roughness on permeation rate of CO₂, He, CH₄ and N₂ is studied. The comparison among the gases suggests that the Henry’s coefficient depends on the surface roughness and allows discussing the role of roughness on membrane selectivity.

Copolymerization modification of poly(vinyltriethoxysilane) membranes for ethanol recovery by pervaporation

A novel thin PVTES-HSO membrane with an optimal PV performance greatly transcending the upper limit of PDMS membranes is prepared.

One-Step Transformation from Hierarchical-Structured Superhydrophilic NF Membrane into Superhydrophobic OSN Membrane with Improved Antifouling Effect

The hierarchical-structured superhydrophilic poly(ethylenimine)/poly(acrylic acid) (PEI/PAA)calcium silicate hydrate (CSH) multilayered membranes (PEI/PAA-CSH)n were prepared as aqueous nanofiltration (NF) membrane, and then they were transformed into superhydrophobic organic solvent nanofiltration (OSN) membranes by one-step modification of trimethylperfluorinatedsilane (PFTS). Investigation on surface structures and properties of these multilayered membranes (PEI/PAA-CSH)n indicated that the hierarchical-structured (PEI/PAA-CSH)n multilayered membrane produced by in situ incorporation of CSH aggregates into PEI/PAA multilayers facilitated its one-step transformation from superhydrophilicity into superhydrophobicity. Both of the superwetting membranes showed better nanofiltration performances for retention of dyes of water and ethanol solution, respectively. Moreover, the long-term performance and antifouling behaviors, investigated by retention of methyl blue (MB), bovine serum albumin (BSA), and humic acid (HA) aqueous water solution and nonaqueous ethanol solution indicated that both of the superhydrophilic and superhydrophobic membrane showed higher stability and excellent antifouling property.