Xanthan gum-added natural surfactant solution of Chuback: A green and clean technique for enhanced oil recovery

Innovative xanthan gum-based nanocomposites for asphaltene precipitation prevention in shale and carbonate rocks

Asphaltene deposition in porous media creates many challenges in porous media. This study synthesizes ZnO/SiO2/xanthan nanocomposites (NCs) to adsorb asphaltene and reduce its effect on the shale and carbonate rocks. NCs structure is analyzed using SEM, EDX, BET, and FTIR tests. Also, the rocks' surface is analyzed by an atomic force microscopy (AFM) test after 48 and 96 h of contact with 20 ppm NCs and 20 mg asphaltene. Core flooding tests are performed on shale rocks using 20 ppm NCs at 5500, 4000, and 2500 psi at 48 h. Using AFM in calcite and dolomite formations and selecting core flooding tests based on that are new scenarios that followed in this paper. FTIR results confirm asphaltene adsorption on NCs's surface by changing 854 and 962 cm-1 peaks. AFM tests confirmed asphaltene adsorption on NCs surface, too. Average roughness, root mean square roughness, peak to valley roughness, and average size of the shale were higher than the carbonate sheets. At 20 ppm NCs in shale reservoirs, permeability reduction in porous media was increased up to 39.5 %, and asphaltene precipitation decreased from 8.95 and 20.06 wt% to 2.25 and 10.25 wt%, which shows our suggested scenarios were efficient.

New molecular and macroscopic understandings of novel green chemicals based on Xanthan Gum and bio-surfactants for enhanced oil recovery

This research investigates the interactions between a novel environmentally friendly chemical fluid consisting of Xanthan gum and bio-based surfactants, and crude oil. The surfactants, derived from various leaves using the spray drying technique, were characterized using Fourier-transform infrared (FTIR) spectroscopy, zeta potential analysis, Dynamic light scattering, and evaluation of critical micelle concentration. Static emulsion tests were conducted to explore the emulsification between crude oil and the polymer-surfactant solution. Analysis of the bulk oil FTIR spectra revealed that saturated hydrocarbons and light aromatic hydrocarbons exhibited a higher tendency to adsorb onto the emulsion phase. Furthermore, the increased presence of polar hydrocarbons in emulsion phases generated by polar surfactants confirmed the activation of electrostatic forces in fluid-fluid interactions. Nuclear magnetic resonance spectroscopy showed that the xanthan solution without surfactants had a greater potential to adsorb asphaltenes with highly fused aromatic rings, while the presence of bio-based surfactants reduced the solution's ability to adsorb asphaltenes with larger cores. Microfluidic tests demonstrated that incorporating surfactants derived from Morus nigra and Aloevera leaves into the xanthan solution enhanced oil recovery. While injection of the xanthan solution resulted in a 49.8% recovery rate, the addition of Morus nigra and Aloevera leaf-derived surfactants to the xanthan solution increased oil recovery to 58.1% and 55.8%, respectively.

Impact of the Naturally Driven Surfactant in EOR Application: Experimental, Microscopic, and Numerical Analyses

While synthetic, conventional surfactants have a known negative environmental impact, their high cost poses a significant challenge. In contrast, naturally extracted surfactants are cheaper and are readily available. The applicability of natural surfactants depends on the saponin concentration, extraction, and synthesis methods. Certain parameters, such as their efficiency in obtaining the required interfacial tension (IFT) values, salinity tolerance, and stability under reservoir conditions, must be examined. Kazakhstan produces a substantial quantity of flaxseed, and flaxseed oil is a good source of fatty acids that can be converted to natural surfactants. Therefore, the work aims to identify the potential of the natural-flaxseed oil surfactant. The experimental study evaluated the synthesized surfactant, effective concentration, salinity's effect, interfacial tension, rheology, and oil recovery concerns in vugs limestone. A microscopic study was conducted to provide insight into the flow in the vugus matrix. At the same time, the numerical method was also employed to establish a potential recovery understanding. The Fourier spectrometer results proved the distinct presence of the triterpenoid. The critical micelle concentrations are 6 and 2.5 wt % for solution in 0 and seawater salinity, respectively. The IFT was reduced by 40-48% and is more effective in seawater solutions. The oil additional recovery was 39-50% after surfactants. The presence of a fractured vugus did not affect the success of the application. Despite the difficulty in modeling the system, the numerical results agree with the experiments and show only 7% differences in total recovery. The research offers novel natural surfactants that can be applied in offshore Kazakhstan.

Application of Green Polymeric Nanocomposites for Enhanced Oil Recovery by Spontaneous Imbibition from Carbonate Reservoirs

This study experimentally investigates the effect of green polymeric nanoparticles on the interfacial tension (IFT) and wettability of carbonate reservoirs to effectively change the enhanced oil recovery (EOR) parameters. This experimental study compares the performance of xanthan/magnetite/SiO₂ nanocomposites (NC) and several green materials, i.e., eucalyptus plant nanocomposites (ENC) and walnut shell ones (WNC) on the oil recovery with performing series of spontaneous imbibition tests. Scanning electron microscopy (SEM), X-ray diffraction (XRD), energy-dispersive X-ray spectroscopy (EDAX), and BET (Brunauer, Emmett, and Teller) surface analysis tests are also applied to monitor the morphology and crystalline structure of NC, ENC, and WNC. Then, the IFT and contact angle (CA) were measured in the presence of these materials under various reservoir conditions and solvent salinities. It was found that both ENC and WNC nanocomposites decreased CA and IFT, but ENC performed better than WNC under different salinities, namely, seawater (SW), double diluted salted (2 SW), ten times diluted seawater (10 SW), formation water (FW), and distilled water (DIW), which were applied at 70 °C, 2000 psi, and 0.05 wt.% nanocomposites concentration. Based on better results, ENC nanofluid at salinity concentrations of 10 SW and 2 SW ENC were selected for the EOR of carbonate rocks under reservoir conditions. The contact angles of ENC nanocomposites at the salinities of 2 SW and 10 SW were 49 and 43.4°, respectively. Zeta potential values were -44.39 and -46.58 for 2 SW and 10 SW ENC nanofluids, which is evidence of the high stability of ENC nanocomposites. The imbibition results at 70 °C and 2000 psi with 0.05 wt.% ENC at 10 SW and 2 SW led to incremental oil recoveries of 64.13% and 60.12%, respectively, compared to NC, which was 46.16%.

Effect of Rheological Properties of Polymer Solution on Polymer Flooding Characteristics

Polymer flooding is an appropriate enhanced oil recovery (EOR) process that can increase macroscopic sweep efficiency. We examined two polymeric superpushers at different salinities (10,000 and 42,000 ppm of NaCl and 18,000 ppm of CaCl₂) and temperatures (30 to 75 °C) as polymer-flooding agents for the EOR process. Rheological and thixotropic tests were attempted to find shear viscosity change when the polymer solutions were introduced under different salinity and temperatures, followed by describing the rheological behavior with the two most common rheological models used for polymer solutions, and then a quadratic model with Design-Expert to detect the effective parameters. Core flooding tests were conducted afterward to determine the final proposed fluid. An increase in the concentration of monovalent ions and the addition of divalent ions adversely affected both types of polymers used, which was similar to the effects of a temperature increase. The Flopaam 3630S at 1000 ppm has more stability under harsh conditions and enables 22% and 38% oil recovery in carbonate and sandstone core rocks, respectively. Consequently, Flopaam 3630S can be the perfect polymer agent for different chemical flooding procedures in high-salinity oil reservoirs.

Spontaneous Imbibition Oil Recovery by Natural Surfactant/Nanofluid: An Experimental and Theoretical Study

Organic surfactants have been utilized with different nanoparticles in enhanced oil recovery (EOR) operations due to the synergic mechanisms of nanofluid stabilization, wettability alteration, and oil-water interfacial tension reduction. However, investment and environmental issues are the main concerns to make the operation more practical. The present study introduces a natural and cost-effective surfactant named Azarboo for modifying the surface traits of silica nanoparticles for more efficient EOR. Surface-modified nanoparticles were synthesized by conjugating negatively charged Azarboo surfactant on positively charged amino-treated silica nanoparticles. The effect of the hybrid application of the natural surfactant and amine-modified silica nanoparticles was investigated by analysis of wettability alteration. Amine-surfactant-functionalized silica nanoparticles were found to be more effective than typical nanoparticles. Amott cell experiments showed maximum imbibition oil recovery after nine days of treatment with amine-surfactant-modified nanoparticles and fifteen days of treatment with amine-modified nanoparticles. This finding confirmed the superior potential of amine-surfactant-modified silica nanoparticles compared to amine-modified silica nanoparticles. Modeling showed that amine surfactant-treated SiO₂ could change wettability from strongly oil-wet to almost strongly water-wet. In the case of amine-treated silica nanoparticles, a strongly water-wet condition was not achieved. Oil displacement experiments confirmed the better performance of amine-surfactant-treated SiO₂ nanoparticles compared to amine-treated SiO₂ by improving oil recovery by 15%. Overall, a synergistic effect between Azarboo surfactant and amine-modified silica nanoparticles led to wettability alteration and higher oil recovery.