In-situ monitoring of dental erosion in tooth enamel when exposed to soft drinks

Effect of two erosive protocols using acidic beverages on the shear bond strength of orthodontic brackets to bovine enamel

OBJECTIVE

To assess the short-term effect of two in vitro erosive challenge protocols on the bond strength of metal orthodontic brackets on bovine enamel.

METHODS

Sixty bovine incisors were selected and randomly divided into six groups: AS7 (artificial saliva - 7 days, Control Group); CC7 (Coca-Cola™ - 7 days); LJ7 (lime juice - 7 days); AS30 (artificial saliva - 30 days, Control Group); CC30 (Coca-Cola™ - 30 days); LJ30 (lime juice - 30 days). Microhardness testing was performed prior to the erosive challenge to verify the standardization of samples. Immersion was performed 4x/day for five minutes, for either 7 or 30 days. After immersions were concluded, the brackets were bonded and shear bond strength was assessed after 48 hours. The Adhesive Remnant Index (ARI) was also assessed. Data were analyzed by two-way ANOVA, followed by Tukey's post-hoc and Student's t test for paired samples, and the Kruskal-Wallis non-parametric test (α = 5%).

RESULTS

The mean and standard deviation of microhardness testing of total samples were 281.89 ± 44.51 KHN. There was no statistically significant difference in shear bond strength for the time factor (7 or 30 days; F5.54= 0.105; p  = 0.901). However, there was a statistically significant difference for the solution factor (F5.54= 6.671; p  = 0.003). These differences occurred among solutions of Saliva x Coca-Cola™ (p  = 0.003) and Coca-Cola™ x Lime Juice (p = 0.029). The assessment of the Adhesive Remnant Index showed no significant difference between groups.

CONCLUSIONS

The immersion time used in the erosion protocols did not affect the bond strength of brackets to teeth. Coca-Cola™ induced significantly higher shear bond strength values than lime juice and artificial saliva. However, the short term effects of 7/30 days in this in vitro study may not be extrapolated for in vivo ones. Clinical studies should be conducted, substantiating the laboratory results.

In situ monitoring and analysis of enamel demineralisation using synchrotron X-ray scattering

Dental caries is one of the most common chronic diseases that affect human teeth. It often initiates in enamel, undermining its mechanical function and structural integrity. Little is known about the enamel demineralisation process caused by dental caries in terms of the microstructural changes and crystallography of the inorganic mineral phase. To improve the understanding of the carious lesion formation process and to help identify efficient treatments, the evolution of the microstructure at the nano-scale in an artificially induced enamel erosion region was probed using advanced synchrotron small-angle and wide-angle X-ray scattering (SAXS and WAXS). This is the first in vitro and time-resolved investigation of enamel demineralisation using synchrotron X-ray techniques which allows in situ quantification of the microstructure evolution over time in a simulated carious lesion. The analysis revealed that alongside the reduction of mineral volume, a heterogeneous evolution of hydroxyapatite (HAp) crystallites (in terms of size, preferred orientation and degree of alignment) could be observed. It was also found that the rate and direction of dissolution depends on the crystallographic orientation. Based on these findings, a novel conceptual view of the process is put forward that describes the key structural parameters in establishing high fidelity ultrastructure-based numerical models for the simulation of the enamel demineralisation process.

STATEMENT OF SIGNIFICANCE

Hydroxyapatite (HAp) crystallites in the enamel dissolve during dental caries although little is known about the structural-chemical relationships that control the dynamic demineralisation process. For the first time this work investigated the in situ evolution of nano-scale morphology and the spatial distribution of ultrastructural HAp crystallites of human enamel during demineralisation in simulated caries. Advanced synchrotron SAXS and WAXS techniques showed that the heterogeneous evolution of crystallites (size, preferred orientation and degree of alignment) could be attributed to crystallographic-orientation-dependent anisotropic dissolution. Hence we propose a novel conceptual schematic diagram to describe the demineralisation process. These findings have important implications for understanding the detailed mechanisms of enamel demineralisation and provide insight into potential enamel remineralisation that could restore structural integrity and function.

Calcium orthophosphates (CaPO4): occurrence and properties

The present overview is intended to point the readers' attention to the important subject of calcium orthophosphates (CaPO4). This type of materials is of the special significance for the human beings because they represent the inorganic part of major normal (bones, teeth and antlers) and pathological (i.e., those appearing due to various diseases) calcified tissues of mammals. For example, atherosclerosis results in blood vessel blockage caused by a solid composite of cholesterol with CaPO4, while dental caries and osteoporosis mean a partial decalcification of teeth and bones, respectively, that results in replacement of a less soluble and harder biological apatite by more soluble and softer calcium hydrogenorthophosphates. Therefore, the processes of both normal and pathological calcifications are just an in vivo crystallization of CaPO4. Similarly, dental caries and osteoporosis might be considered as in vivo dissolution of CaPO4. In addition, natural CaPO4 are the major source of phosphorus, which is used to produce agricultural fertilizers, detergents and various phosphorus-containing chemicals. Thus, there is a great significance of CaPO4 for the humankind and, in this paper, an overview on the current knowledge on this subject is provided.