Determination of dopamine in presence of ascorbic acid and uric acid using poly (Spands Reagent) modified carbon paste electrode

Ti3C2Tx (MXene)/Pt nanoparticle electrode for the accurate detection of DA coexisting with AA and UA

Dopamine (DA), uric acid (UA) and ascorbic acid (AA) are biomolecules widely distributed in the human body and play an important role in many physiological processes. An abnormal concentration of them is associated with various diseases. Thus, the accurate and fast detection of them has been one of the major demands in the healthcare industry. In this study, we demonstrate that Ti₃C₂T_x/PtNP modified glassy carbon electrodes (GCEs) show a good electrochemical performance in the detection of DA and UA. However, there is no response signal to AA for either the CV or DPV curve due to the electrostatic repulsion between the negatively charged electrode surface and the negatively charged AA. Ti₃C₂T_x(MXene)/Pt nanoparticles (PtNPs) are prepared by etching Ti₃AlC₂(MAX) with HF and reducing H₂PtCl₆ with a NaBH₄ aqueous solution. The morphology of Ti₃C₂T_x/PtNPs is multilayered accordion-like Ti₃C₂T_x decorated with PtNPs with a diameter of 10-20 nm. Furthermore, it is found that the electrochemical detection of DA will be enhanced by AA. The electrochemical detection rule of AA enhanced DA can be expressed as follows: I_(DA+AA) = 0.011216C_AA + 0.039950C_DA + 1.1175(I_(DA+AA) is the peak current of DA coexisting with AA. C_AA is the concentration of AA. C_DA is the concentration of DA). This can be used as a calibration to correct the concentration of DA when AA and DA coexist. Notably, AA promotes the stability of the electrode because it cleans the oxidation products from the electrode surface in time. In addition, the sensor exhibits good reproducibility and satisfactory recovery results in a real sample.

A highly selective and sensitive electrochemical sensor for dopamine based on a functionalized multi-walled carbon nanotube and poly(N-methylaniline) composite

Dopamine (DA) is an important neurotransmitter used for diagnosing various diseases from its abnormal concentrations in human fluids. Herein, an electrochemical sensor based on a composite of re-doped poly(N-methylaniline) (rePNMA) and modified multi-walled carbon nanotubes (fMWCNTs), termed fMWCNT-rePNMA, was developed to measure DA concentration. The successful modification of the fMWCNT surface was confirmed by Fourier transform infrared spectroscopy (FTIR), Raman spectroscopy, X-ray photoelectron spectroscopy (XPS), X-ray diffraction (XRD), and scanning electron microscopy (SEM). Cyclic voltammetry (CV) displayed an excellent electrocatalytic activity of the fMWCNTs-rePNMA composite towards the oxidation of DA. The developed fMWCNTs-rePNMA composite demonstrated a broad linear range from 5 to 90 μmol L^-1 with a low limit of detection (LOD) value of 2.23 μmol L^-1, and a fast response with a high sensitivity of 251.5 nA μmol^-1 L as determined from the calibration curve of the DA determination. In addition, the fMWCNTs-rePNMA composite selectively identified and quantified DA in the presence of ascorbic acid (AA) and uric acid (UA). Therefore, the fMWCNTs-rePNMA composite sensor shows potential to determine the level of DA in human urine.

Poly (Orange CD) sensor for paracetamol in presence of folic acid and dopamine

In the present work, Orange CD was chosen as an intriguing modifier for the electropolymerization on the surface of CPE by the CV technique. A novel, sensitive, and cost-effective poly (Orange CD) MCPE (PoOCD/MCPE) sensor was utilized for the selective detection of paracetamol (PA) in 0.2 M phosphate buffer solution (PBS) of pH 7.4. The oxidation peak current of PA was vastly enhanced at the sensor. The scan rate study is suggested that electro-oxidation of PA was adsorption-controlled. The pH study testifies the redox pathways transport with the same quantity of electrons and protons. The detection limit of PA is found to be 2.64 µM. DPV results show that substantial peak separation between PA, folic acid (FA), and dopamine (DA) could be facilitating their individual and simultaneous determination on the sensor. The decorated sensor demonstrates high sensitivity, stability, reproducibility, repeatability and has been successfully exploited for the detection of PA in a tablet with promising results.

An amplified electrochemical sensor employing a polymeric film and graphene quantum dots/multiwall carbon nanotubes in a deep eutectic solvent for sensitive analysis of paracetamol and 4-aminophenol

Herein, a nanocomposite consisting of graphene quantum dots, a deep eutectic solvent and carboxyl functionalized multiwall carbon nanotubes (GQDs + DES + MWCNTs-COOH) was prepared.

Three-Dimensional Au/Holey-Graphene as Efficient Electrochemical Interface for Simultaneous Determination of Ascorbic Acid, Dopamine and Uric Acid

The quantification of ascorbic acid (AA), dopamine (DA), and uric acid (UA) has been an important area of research, as these molecules’ determination directly corresponds to the diagnosis and control of diseases of nerve and brain physiology. In our research, graphene oxide (GO) with nano pores deposited with gold nanoparticles were self-assembled to form three-dimensional (3D) Au/holey-graphene oxide (Au/HGO) composite structures. The as-prepared 3DAu/HGO composite structures were characterized for their structures by X-ray diffraction, Raman spectrum, scanning electron microscopy, and transmission electron microscopy coupled with cyclic voltammograms. Finally, the proposed 3DAu/HGO displayed high sensitivity, excellent electron transport properties, and selectivity for the simultaneous electrochemical determination of AA, DA and UA with linear response ranges of 1.0–500 μM, 0.01–50 μM and 0.05–50 μM respectively. This finding paves the way for graphene applications as a biosensor for detecting three analytes in human serum.

Ultra-Capacitive Carbon Neural Probe Allows Simultaneous Long-Term Electrical Stimulations and High-Resolution Neurotransmitter Detection

We present a new class of carbon-based neural probes that consist of homogeneous glassy carbon (GC) microelectrodes, interconnects and bump pads. These electrodes have purely capacitive behavior with exceptionally high charge storage capacity (CSC) and are capable of sustaining more than 3.5 billion cycles of bi-phasic pulses at charge density of 0.25 mC/cm². These probes enable both high SNR (>16) electrical signal recording and remarkably high-resolution real-time neurotransmitter detection, on the same platform. Leveraging a new 2-step, double-sided pattern transfer method for GC structures, these probes allow extended long-term electrical stimulation with no electrode material corrosion. Cross-section characterization through FIB and SEM imaging demonstrate strong attachment enabled by hydroxyl and carbonyl covalent bonds between GC microstructures and top insulating and bottom substrate layers. Extensive in-vivo and in-vitro tests confirmed: (i) high SNR (>16) recordings, (ii) highest reported CSC for non-coated neural probe (61.4 ± 6.9 mC/cm²), (iii) high-resolution dopamine detection (10 nM level - one of the lowest reported so far), (iv) recording of both electrical and electrochemical signals, and (v) no failure after 3.5 billion cycles of pulses. Therefore, these probes offer a compelling multi-modal platform for long-term applications of neural probe technology in both experimental and clinical neuroscience.

Three-dimensional porous self-assembled chestnut-like nickel-cobalt oxide structure as an electrochemical sensor for sensitive detection of hydrazine in water samples

Three-dimensional NiCo₂O₄ is a kind of superior sensing material owing to its high electron transfer capability, large available surface area and numbers of active sites. In this work, NiCo₂O₄ of the three-dimensional chestnut-like structure were easily achieved through a one step hydrothermal process. Afterwards, the morphology and structure were characterized by scanning electron microscope (SEM), transmission electron microscope (TEM), X-ray powder diffraction (XRD), Fourier transform infrared spectroscopy (FTIR), and X-ray photoelectron spectroscopy (XPS). Based on the three-dimensional porous chestnut-like NiCo₂O₄, an electrochemical sensor for hydrazine (N₂H₄) detection is fabricated. This electrochemical platform can realize good selectivity, excellent stability, high sensitivity (∼2154.4 μA mM^-1 cm^-2), and low detection limit (0.3 μM), as well as a wide linear range from 1 μM to 1096 μM. The synergistic effect of nickel-cobalt in such mixed transition metal oxides which Co in Co₃O₄ is partially replaced by Ni are beneficial for enhancing sensing properties. This study proves that three-dimensional porous chestnut-like NiCo₂O₄ is electrochemically active for catalytic performance which is particular and promising material for good application in the practical detection of N₂H₄.

Colorimetric detection of melamine in milk based on Triton X-100 modified gold nanoparticles and its paper-based application

In this study, we have developed a method for rapid, highly efficient and selective detection of melamine. The negatively charged citrate ions form an electrostatic layer on gold nanoparticles (AuNPs) and keep the NPs dispersed and stable. When citrate-capped AuNPs were further modified with Triton X-100, it stabilized the AuNPs against the conditions of high ionic strength and a broad pH range. However, the addition of melamine caused the destabilization and aggregation of NPs. This may be attributed to the interaction between melamine and the AuNPs through the ligand exchange with citrate ions on the surface of AuNPs leading Triton X-100 to be removed. As a result, the AuNPs were unstable, resulting in the aggregation. The aggregation induced a wine red-to-blue color change, and a new absorption peak around 630nm appeared. Triton X-100-AuNPs could selectively detect melamine at the concentration as low as 5.1nM. This probe was successfully applied to detect melamine in milk. Furthermore, paper-based quantitative detection system using this colorimetric probe was also demonstrated by integrating with a smartphone.

Ultrafine Pt–Ni bimetallic nanoparticles anchored on reduced graphene oxide nanocomposites for boosting electrochemical detection of dopamine in biological samples

The present report demonstrates the development of a Pt–Ni/rGO composite electrochemical sensor for the detection of dopamine.

An ultra-sensitive electrochemical sensor for the detection of acetaminophen in the presence of etilefrine using bimetallic Pd–Ag/reduced graphene oxide nanocomposites

In this study we report a one-step procedure for the fabrication of Pd–Ag bimetallic nanoparticles on the surface of a graphene oxide (rGO) support.

Electrochemical preparation of two nanostructured poly(sulfosalicylic acid) films with different morphologies and properties for selective sensing of dopamine: Comparative study

Two nanostructured poly(sulfosalicylic acid) (PSA) films were synthesized from room temperature ionic liquid (RTIL) or aqueous solution on a glassy carbon electrode (GCE) via potentiodynamic electropolymerization. The morphology and properties of the PSA films were characterized with scanning electron microscopy (SEM), scanning probe microscopy (SPM), electrochemical impedance spectroscopy (EIS) and cyclic voltammetry (CV). It was found that solvent had a major influence on the morphology and electrochemical properties of the resultant PSA films. The PSA(Ι) film, which was prepared from RTIL, consists of granular particles with cracks, whereas the PSA(II) film prepared from aqueous solution consists of nano-triangles with a more compact surface. The blocking effect of the PSA(Ι) film for the [Fe(CN)₆]^3-/4- electrochemical probe is much stronger, and a remarkably enhanced voltammetric response of the [Ru(NH₃)₆]³⁺ electrochemical probe can be observed for the PSA(II) film. When it is used to detect dopamine in the presence of a high concentration of ascorbic acid, PSA(II)/GCE has three linear parts with better discrimination and a detection limit of 0.03μM. For PSA(Ι)/GCE, there are two linear parts with a detection limit of 0.05μM. However, the reproducibility and storage stability of PSA(Ι)/GCE are better than those of PSA(ΙI)/GCE.

Magnetism-assisted modification of screen printed electrode with magnetic multi-walled carbon nanotubes for electrochemical determination of dopamine

A simple and sensitive dopamine (DA) electrochemical sensor was fabricated based on magnetism-assisted modification of screen printed electrode (SPE) with magnetic multi-walled carbon nanotubes (mMWCNTs). The mMWCNTs modified electrodes (mMWCNTs/SPE) combines the advantages of SPE and the simultaneous contribution of magnetic nanoparticles (MNPs) and MWCNTs, increasing sensitivity and selectivity of DA detection. The linearity was found between 5μM to 180μM, with the limit of detection (LOD) of 0.43μM. In the mean time, this modified electrode exhibited excellent selectivity for DA detection with almost no interference from ascorbic acid (AA), which co-exists with DA in many bio-samples and causes common interference. Finally, this novel electrode has been applied to determine DA concentration in spiked human blood serum and satisfactory recovery was found in the range of 97.43-102.94% with the RSDs of less than 2.27%. This work developed a sensitive and reliable electrochemical analytical method based on mMWCNTs/SPE, which exhibits great potential for diagnosis of the diseases related to DA.