Detection and activity of iodine-131 in brown algae collected in the Japanese coastal areas

Effect of drying temperature on the quantitative analysis of 131I in algal samples by γ-spectrometry

131I has been extensively utilized in nuclear medicine, resulting in its widespread detection in coastal algal samples due to its discharge. Therefore, it is essential to monitor 131I in the coastal algal samples. γ-spectrometry is an expeditious method for measuring 131I, but this method requires the pretreatment of the algal sample. The effect on 131I in the algal sample during the oven-drying treatment is unclear. In this study, the Laminaria japonica Areschoug and Sargassum vachellianum Greville were collected at two locations and analyzed for 131I using γ-spectrometry. Additionally, the content of iodine was measured using an Inductively Coupled Plasma-Mass Spectrometer (ICP-MS) to clarify the effect of 131I loss during drying treatment at different temperatures. The results demonstrated that the dried Laminaria and Sargassum samples had calculated 131I activity concentration relative standard deviations (RSDs) of 6.34 % and 16.31 %, respectively, while the fresh samples exhibited RSDs of 11.70 % and 15.57 %. Additionally, the iodine content RSDs in the dried samples were 9.19 % for Laminaria and 10.34 % for Sargassum. Significantly, discrepancies in 131I activity concentration between the fresh and dried Laminaria and Sargassum were 5.4 % and 10.3 %. These findings indicate that the temperature factor in drying has no effect on 131I loss in Laminaria and Sargassum in the range of 70 °C-110 °C.

Occurrence of and radioanalytical methods used to determine medical radionuclides in environmental and biological samples. A review

Medical radionuclides are widely used in nuclear medicine practices today. Their production, handling and administration have different impacts on the environment and society due to the radioactive waste generated. Over recent years authors have taken an interest in the monitoring and safe disposal of this radiopharmaceutical waste, mainly in environmental and biological samples, and consequently a variety of radioanalytical methods for these matrices have been developed. The present review aims to outline the state of the art and the latest trends reported in the literature from 2007 to the present, focusing on the occurrence and determination of medical radionuclides in environmental and biological samples. Special attention is given to critically discussing the strengths and weaknesses of the different steps involved in determining medical radionuclides in these types of matrices. The methodologies presented are accompanied by examples.

A review of numerical models to predict the atmospheric dispersion of radionuclides

The field of atmospheric dispersion modeling has evolved together with nuclear risk assessment and emergency response systems. Atmospheric concentration and deposition of radionuclides originating from an unintended release provide the basis of dose estimations and countermeasure strategies. To predict the atmospheric dispersion and deposition of radionuclides several numerical models are available coupled with numerical weather prediction (NWP) systems. This work provides a review of the main concepts and different approaches of atmospheric dispersion modeling. Key processes of the atmospheric transport of radionuclides are emission, advection, turbulent diffusion, dry and wet deposition, radioactive decay and other physical and chemical transformations. A wide range of modeling software are available to simulate these processes with different physical assumptions, numerical approaches and implementation. The most appropriate modeling tool for a specific purpose can be selected based on the spatial scale, the complexity of meteorology, land surface and physical and chemical transformations, also considering the available data and computational resource. For most regulatory and operational applications, offline coupled NWP-dispersion systems are used, either with a local scale Gaussian, or a regional to global scale Eulerian or Lagrangian approach. The dispersion model results show large sensitivity on the accuracy of the coupled NWP model, especially through the description of planetary boundary layer turbulence, deep convection and wet deposition. Improvement of dispersion predictions can be achieved by online coupling of mesoscale meteorology and atmospheric transport models. The 2011 Fukushima event was the first large-scale nuclear accident where real-time prognostic dispersion modeling provided decision support. Dozens of dispersion models with different approaches were used for prognostic and retrospective simulations of the Fukushima release. An unknown release rate proved to be the largest factor of uncertainty, underlining the importance of inverse modeling and data assimilation in future developments.

Microbial copper reduction method to scavenge anthropogenic radioiodine

Unexpected reactor accidents and radioisotope production and consumption have led to a continuous increase in the global-scale contamination of radionuclides. In particular, anthropogenic radioiodine has become critical due to its highly volatile mobilization and recycling in global environments, resulting in widespread, negative impact on nature. We report a novel biostimulant method to effectively scavenge radioiodine that exhibits remarkable selectivity for the highly difficult-to-capture radioiodine of >500-fold over other anions, even under circumneutral pH. We discovered a useful mechanism by which microbially reducible copper (i.e., Cu(2+) to Cu(+)) acts as a strong binder for iodide-iodide anions to form a crystalline halide salt of CuI that is highly insoluble in wastewater. The biocatalytic crystallization of radioiodine is a promising way to remove radioiodine in a great capacity with robust growth momentum, further ensuring its long-term stability through nuclear I(-) fixation via microcrystal formation.

Medically-Derived (131)I as a Tool for Investigating the Fate of Wastewater Nitrogen in Aquatic Environments

Medically derived (131)I (t1/2 = 8.04 d) is discharged from water pollution control plants (WPCPs) in sewage effluent. Iodine's nutrient-like behavior and the source-specificity of (131)I make this radionuclide a potentially valuable tracer in wastewater nitrogen studies. Iodine-131 was measured in Potomac River water and sediments in the vicinity of the Blue Plains WPCP, Washington, DC, USA. Dissolved (131)I showed a strong, positive correlation with δ(15)N values of nitrate (δ(15)NO3(-)) in the river, the latter being a traditional indicator of nutrient inputs and recycling. Surface water δ(15)NO3(-) values ranged from 8.7 to 33.4‰; NO3(-) + NO2(-) concentrations were 0.39-2.79 mg N L(-1) (26-186 μM). Sediment profiles of particulate (131)I and δ(15)N indicate rapid mixing or sedimentation and in many cases remineralization of a heavy nitrogen source consistent with wastewater nitrogen. Values of δ(15)N in sediments ranged from 4.7 to 9.3‰. This work introduces (131)I as a tool to investigate the short-term fate of wastewater nitrogen in the Potomac River and demonstrates the general utility of (131)I in aquatic research.

Iodine-131 in sewage sludge from a small water pollution control plant serving a thyroid cancer treatment facility

Iodine-131 (half-life = 8.04 d) is the most widely used radionuclide in medicine for therapeutic purposes. It is excreted by patients and is discharged directly to sewer systems. Despite considerable dilution in waste water and the relatively short half-life of I, it is readily measured in sewage. This work presents I concentrations in sewage sludge from three water pollution control plants (WPCPs) on Long Island, NY. Iodine-131 concentrations ranged from 0.027 ± 0.002 to 148 ± 4 Bq g dry weight. The highest concentrations were measured in the Stony Brook WPCP, a relatively small plant (average flow = 6.8 × 10 L d) serving a regional thyroid cancer treatment facility in Stony Brook, NY. Preliminary radiation dose calculations suggested further evaluation of dose to treatment plant workers in the Stony Brook WPCP based on the recommendations of the Interagency Steering Committee on Radiation Standards.

Behavior of medically-derived 131I in the tidal Potomac River

Iodine-131 (t1/2=8.04 d) is administered to patients for treatment of thyroid disorders, excreted by patients and discharged to surface waters via sewage effluent. Radionuclides generally behave like their stable analogs; therefore, medically-derived (131)I is useful as a transport-reaction tracer of anthropogenic inputs and the aquatic biogeochemistry of iodine. Iodine-131 was measured in Potomac River water and sediments in the vicinity of the Blue Plains Water Pollution Control Plant (WPCP), Washington, DC, USA. Concentrations measured in sewage effluent from Blue Plains WPCP and in the Potomac River suggest a relatively continuous source of this radionuclide. The range of (131)I concentrations detected in surface water was 0.076±0.006 to 6.07±0.07 Bq L(-1). Iodine-131 concentrations in sediments ranged from 1.3±0.8 to 117±2 Bq kg(-1) dry weight. Partitioning in the sewage effluent from Blue Plains and in surface waters indicated that (131)I is associated with colloidal and particulate organic material. The behavior of medically-derived (131)I in the Potomac River is consistent with the nutrient-like behavior of natural iodine in aquatic environments. After discharge to the river via sewage effluent, it is incorporated into biogenic particulate material and deposited in sediments. Solid phase sediment profiles of (131)I indicated rapid mixing or sedimentation of particulate debris and diagenetic remineralization and recycling on short time scales.

Discharges of nuclear medicine radioisotopes in Spanish hospitals

Given the increasing use of radiopharmaceuticals in medicine, the aim of this paper is to determine radioactivity levels in the effluents of hospitals with Nuclear Medicine Departments. The radiological study of hospital discharges was carried out by gamma spectrometry, and liquid scintillation spectrometry to determine (14)C and (3)H contents. On March 9th and April 19th, 2010, daily radioactivity levels were monitored from 8:30 a.m. to 7:30 p.m. Each sample was collected at a specific control point of two major public hospitals in Granada (Spain). The analytical results show the presence of radionuclides such as (99m)Tc, (131)I, (67)Ga, and (111)In.They are frequently used in nuclear medicine for diagnostic and/or therapeutic purposes. This study shows the differences between direct and after-storage discharges and also justifies the need of storage tanks in hospitals with nuclear medicine departments. Moreover, monitoring of (99m)Tc released at hospital control points can be a useful tool for optimizing the safety conditions of storage tanks and discharge of radionuclides.

Radiolabeling of methanol extracts of yarrow (Achillea millefolium l) in rats

PURPOSE: Current study is focused on extraction with methanol, purification, labeling with 131I using iodogen method of the yarrow plant and investigating in vivo biological activity using biodistribution and imaging studies on healthy animal models. The aim of the study is to contribute plant extracts to discover new drugs in the diagnosis and treatment of several diseases. METHODS: Nine female and nine male healthy Wistar albino rats, which were approximately 100-150 g in weight, were used for biodistribution studies. For imaging studies four healthy male Balb-C mice were used. Quality control studies were done utilizing thin layer radio chromatography (TLRC) and high performance liquid chromatography (HPLC) methods. For biodistribution studies, 131I radiolabeled Peak 7 (131I-Peak 7) was sterilized and injected into the tail veil of rats and imaging studies were obtained using Kodak FX PRO in vivo Imaging System. RESULTS: The radiolabeling yield of each purified the bioactive extracts of the yarrow plant, seven peaks was between 79 and 92%. The highest radiolabeling yield was calculated for 131I radiolabeled seventh peak (131I-Peak 7) (92.78±5.04, n=5). For this reason the biodistribution and imaging studies were done for 131I-Peak 7. That's why; these studies with Peak 7 were carried out. CONCLUSION: Peak 7 was radiolabeled with 131I in high yield for using imaging and therapeutic studies in nuclear medical applications.

Canopy-forming kelps as California's coastal dosimeter: 131I from damaged Japanese reactor measured in Macrocystis pyrifera

The Fukushima Daiichi Nuclear Plant, damaged by an earthquake and tsunami on March 11, 2011 released large amounts of (131)I into the atmosphere, which was assimilated into canopy blades of Macrocystis pyrifera sampled from coastal California. The specific activity calculated to the estimated date of deposition/assimilation ranged from 0.6 to 2.5 Bq gdwt(-1), levels greater than those measured from kelps from Japan and Canada prior to the release. These (131)I levels represent a significant input into the kelp forest ecosystem. Canopy-forming kelps are a natural coastal dosimeter that can measure the exposure of the coastal environment to (131)I and perhaps other radioisotopes released from nuclear accidents. An organizational mechanism should be in place to ensure that they are sampled immediately and continuously after such releases.