Characterization and quantification of methyl-benzotriazoles and chloromethyl-benzotriazoles produced from disinfection processes in wastewater treatment

Benzotriazoles and bisphenols in wastewater from the food processing industry and the quantitative changes during mechanical/biochemical treatment processes

Benzotriazoles (BTRs) and bisphenols (BPs), categorized as contaminants of emerging concern (CECs), pose significant risks to human health and ecosystems due to their endocrine-disrupting properties and environmental persistence. This study investigates the occurrence and behavior of nine BTRs and ten BPs in wastewater generated in a large-scale meat processing plant, evaluating the effectiveness of a modern mechanical-biological industrial on-site treatment plant in removing these contaminants, and based on the concentration levels from eleven sampling points at different stages of the treatment process. The method used to determine these micropollutants' concentration was ultrasound-assisted emulsification-microextraction for analytes isolation and gas chromatography-mass spectrometry for detection (USAEME-GC/MS). The results indicate that the rigorous quality control processes in the meat processing facility effectively limit the presence of these micropollutants, especially concerning BPs, which are absent or below detection limits in raw wastewater. While the concentrations of some of these micropollutants increased at different points in the treatment process, these values were relatively low, typically below one microgram per liter. Among the compounds analyzed, the only one present after completing the treatment was 5Cl-BTR (maximum concentration: 3007 ng/L), and these contamination levels are around seven times lower than the reference value associated with non-cancer health risk for drinking water. This study contributes to understanding these CECs in industrial wastewater and highlights the importance of effective treatment systems for environmental protection.

Examining the stability of viral RNA and DNA in wastewater: Effects of storage time, temperature, and freeze-thaw cycles

Wastewater-based epidemiology (WBE) has been demonstrably successful as a relatively unbiased tool for monitoring levels of SARS-CoV-2 virus circulating in communities during the COVID-19 pandemic. Accumulated biobanks of wastewater samples allow retrospective exploration of spatial and temporal trends for public health indicators such as chemicals, viruses, antimicrobial resistance genes, and the possible emergence of novel human or zoonotic pathogens. We investigated virus resilience to time, temperature, and freeze-thaw cycles, plus the optimal storage conditions to maintain the stability of genetic material (RNA/DNA) of viral +ssRNA (Envelope - E, Nucleocapsid - N and Spike protein - S genes of SARS-CoV-2), dsRNA (Phi6 phage) and circular dsDNA (crAssphage) in wastewater. Samples consisted of (i) processed and extracted wastewater samples, (ii) processed and extracted distilled water samples, and (iii) raw, unprocessed wastewater samples. Samples were stored at -80 °C, -20 °C, 4 °C, or 20 °C for 10 days, going through up to 10 freeze-thaw cycles (once per day). Sample stability was measured using reverse transcription quantitative PCR, quantitative PCR, automated electrophoresis, and short-read whole genome sequencing. Exploring different areas of the SARS-CoV-2 genome demonstrated that the S gene in processed and extracted samples showed greater sensitivity to freeze-thaw cycles than the E or N genes. Investigating surrogate and normalisation viruses showed that Phi6 remains a stable comparison for SARS-CoV-2 in a laboratory setting and crAssphage was relatively resilient to temperature variation. Recovery of SARS-CoV-2 in raw unprocessed samples was significantly greater when stored at 4 °C, which was supported by the sequencing data for all viruses - both time and freeze-thaw cycles negatively impacted sequencing metrics. Historical extracts stored at -80 °C that were re-quantified 12, 14 and 16 months after original quantification showed no major changes. This study highlights the importance of the fast processing and extraction of wastewater samples, following which viruses are relatively robust to storage at a range of temperatures.

Identifying organic micropollutants' transformation products from the soil dissipation experiment by non-targeted high-resolution mass spectrometry approach: Can we gain more than transformation product identity?

Risk assessment of environmental hazards originating from xenobiotics extensively used worldwide (e.g., pharmaceuticals, bisphenols, or preservatives) requires a combined study of their effects, mobility, dissipation mechanisms, and subsequent transformation product identification and evaluation. We have developed an efficient accelerated solvent extraction method for a broad range of micropollutants of variable physical-chemical properties in soils to enable more accurate hazard characterisation. Micropollutant recoveries from freeze-dried soils were 60-120%, with the exception of atorvastatin, fexofenadine, and telmisartan, which had reduced recoveries (40-66%). The observed matrix effect ranged from -26% to 17% and was corrected by the matrix matching standard for quantitative analysis. The method allows sensitive and reliable determination of a wide range of analytes in soil samples and, consequently, qualitative analysis of transformation products (TP) with variable physicochemical properties. We identified TPs of five compounds (venlafaxine, telmisartan, valsartan, atorvastatin, and sertraline) by applying suspect and non-targeted data analyses. To our knowledge, the transformation product of atorvastatin was reported for the first time. All others were found in soil or other matrices. Valsartan (formed valsartan acid) and atorvastatin (transformed probably by oxidative decarboxylation of beta, delta dihydroxy heptanoic acid chain to propionic acid) were modified to a relatively large extent. All other compounds identified were only hydroxylated (sertraline and telmisartan) or demethylated (venlafaxine). We estimated the stability and presence of the identified TPs based on the constructed time trends and the ratio between TP formation and degradation rates. We demonstrated how valuable a non-targeted approach can be for complex evaluation of the fate and effect of soil pollutants.

Screening Disinfection Byproducts in Arid-Coastal Wastewater: A Workflow Using GC×GC-TOFMS, Passive Sampling, and NMF Deconvolution Algorithm

Disinfection during tertiary municipal wastewater treatment is a necessary step to control the spread of pathogens; unfortunately, it also gives rise to numerous disinfection byproducts (DBPs), only a few of which are regulated because of the analytical challenges associated with the vast number of potential DBPs. This study utilized polydimethylsiloxane (PDMS) passive samplers, comprehensive two-dimensional gas chromatography (GC×GC) coupled with time-of-flight mass spectrometry (TOFMS), and non-negative matrix factorization (NMF) spectral deconvolution for suspect screening of DBPs in treated wastewater. PDMS samplers were deployed upstream and downstream of the chlorination unit in a municipal wastewater treatment plant located in Abu Dhabi, and their extracts were analyzed using GC×GC-TOFMS. A workflow incorporating a multi-tiered, eight-filter screening process was developed, which successfully enabled the reliable isolation of 22 candidate DBPs from thousands of peaks. The NMF spectral deconvolution improved the match factor score of unknown mass spectra to the reference mass spectra available in the NIST library by 17% and facilitated the identification of seven additional DBPs. The close match of the first-dimension retention index data and the GC×GC elution patterns of DBPs, both predicted using the Abraham solvation model, with their respective experimental counterparts-with the measured data available in the NIST WebBook and the GC×GC elution patterns being those observed for the candidate peaks-significantly enhanced the accuracy of peak assignment. Isotopic pattern analysis revealed a close correspondence for 11 DBPs with clearly visible isotopologues in reference spectra, thereby further strengthening the confidence in the peak assignment of these DBPs. Brominated analogues were prevalent among the detected DBPs, possibly due to seawater intrusion. The fate, behavior, persistence, and toxicity of tentatively identified DBPs were assessed using EPI Suite™ and the CompTox Chemicals Dashboard. This revealed their significant toxicity to aquatic organisms, including developmental, mutagenic, and endocrine-disrupting effects in certain DBPs. Some DBPs also showed activity in various CompTox bioassays, implicating them in adverse molecular pathways. Additionally, 11 DBPs demonstrated high environmental persistence and resistance to biodegradation. This combined approach offers a powerful tool for future research and environmental monitoring, enabling accurate identification and assessment of DBPs and their potential risks.

Development and validation of a simultaneous method for the analysis of benzothiazoles and organic ultraviolet filters in various environmental matrices by GC-MS/MS

The presence of benzothiazoles (BTHs) and organic ultraviolet filters (UV filters) in aquatic ecosystems has emerged as a significant environmental issue, requiring urgent and efficient determination methods. A new, rapid, and sensitive determination method using gas chromatography triple quadrupole mass spectrometer (GC-MS/MS) was developed for the simultaneous extraction and analysis of 10 commonly used BTHs and 10 organic UV filters in surface water, wastewater, sediment, and sludge. For aqueous samples, solid-phase extraction (SPE) method was employed with optimizing of SPE cartridge type, pH, and elution solvent. For solid samples, ultrasonic extraction-solid-phase extraction purification (UE-SPE) and pressurized liquid extraction (PLE) methods were compared. And extraction conditions for ultrasonic extraction method (extraction solvents and extraction times) and PLE method (extraction temperatures and extraction cycles) were optimized. The limits of quantification for the 20 target compounds in surface water and wastewater were 0.01-2.12 ng/L and 0.05-6.14 ng/L, while those for sediment and sludge with UE-SPE method were 0.04-5.88 ng/g and 0.22-6.61 ng/g, respectively. Among the 20 target compounds, the recoveries ranged from 70 to 130% were obtained for 16, 15, 15, and 15 analytes in the matrix-spiked samples of surface water, wastewater, sediment, and sludge with three levels, respectively. And the precision was also acceptable with relative standard deviation (RSD) below 20% for all analytes. The developed methods were applied for the determination and quantification of target compounds in surface water, sediment, wastewater, and sludge samples collected from two wastewater treatment plants (WWTPs) and the Pearl River in Guangzhou, China. BTHs were frequently detected in surface water and wastewater, while UV filters were mainly found in sediment and sludge. Benzotriazole (BT) and 2-hydroxybenzothiazole (2-OH-BTH) were the two major BTHs in influent wastewater and surface water, respectively, with concentrations up to 966 and 189 ng/L. As for sediment and sludge, 2-(2'-hydroxy-5'-octylphenyl)-benzotriazole (UV-329) was a predominant chemical, detected at concentrations of 111 and 151 ng/g, respectively.

Determination of contaminants of emerging concern and their transformation products in treated-wastewater irrigated soil and corn

In many parts of the world, clean water has become increasingly scarce. Irrigation of agricultural land with treated wastewater is commonly used in response to water shortages but there is concern about the environmental fate and transport of contaminants present in the irrigation wastewater. This study aimed to examine the presence of wastewater sourced contaminants in soil and field grown corn (Zea mays) crops spray irrigated with treated wastewater. Soil, corn grain, leaves, and roots were sampled and tested from a long-term wastewater irrigation site as well as a non-irrigated control site in close geographic proximity. Samples were analyzed using comprehensive two-dimensional gas chromatography coupled to time of flight mass spectrometry (GC × GC-TOFMS) and both targeted and non-targeted analyses were conducted to determine chemical differences between the wastewater irrigated and control samples. Target compounds detected and quantified in the samples include herbicides, phthalates, and polycyclic aromatic hydrocarbons. Non-targeted analysis showed chemical differences between each the wastewater irrigated and control samples. Furthermore, new chloro-dimethyl-benzotriazole compounds, which are suspected to be transformation products created by the chlorine disinfection process of the wastewater treatment plant, were tentatively identified in the wastewater effluent. Twenty of these new benzotriazoles were detected and semi-quantified in the wastewater irrigated soil samples at a maximum concentration of 472 ng/g. Eight of the most abundant benzotriazoles were also detected in the corn roots at concentrations up to 56 ng/g.