A systematic review on bioplastic-soil interaction: Exploring the effects of residual bioplastics on the soil geoenvironment

Landfill-mined soil-like fraction (LMSF) use in biopolymer composting: Material pre-treatment, bioaugmentation and agricultural prospects

Polylactic Acid (PLA) based compostable bioplastic films degrade under thermophilic composting conditions. The purpose of our study was to understand whether sample pre-treatment along with bioaugmentation of the degradation matrix could reduce the biodegradation time under a simulated composting environment. Sepcifically, we also explored whether the commercial composts could be replaced by landfill-mined soil-like fraction (LMSF) for the said application. The effect of pre-treatment on the material was analysed by tests like tensile strength analysis, hydrophobicity analysis, morphological analysis, thermal degradation profiling, etc. Subsequently, the degradation experiment was performed in a simulated composting environment following the ASTM D5338 standard, along with bioaugmentation in selected experimental setups. When the novel approach of material pre-treatment and bioaugmentation were applied in combination, the time necessary for 90% degradation was reduced by 27% using compost and by 23% using LMSF. Beyond the improvement in degradation rate, the water holding capacity increased significantly for the degradation matrices. With pH, C: N ratio and microbial diversity tested to be favourable through 16s metabarcoding studies, material pre-treatment and bioaugmentation allow LMSF to not only replace commercial compost in polymer degradation but also find immense application in the agricultural sector of drought-affected areas (for better water retention) after it has been used for PLA degradation.

Alternative end-of-life options for disposable bioplastic products: Degradation and ecotoxicity assessment in compost and soil

Four different end-of-life options for disposable bioplastic cups were investigated and compared based on their environmental implications. Two products with distinct polymeric composition were tested simulating the following scenarios at laboratory scale: i) industrial composting (180 days at 58 °C); ii) anaerobic digestion followed by industrial composting (45 days at 55 °C and 180 days at 58 °C); iii) anaerobic digestion followed by direct digestate use on soil for agricultural purposes (45 days at 55 °C and 180 days at 25 °C); iv) uncontrolled release into a soil environment (180 days at 25 °C). Ecotoxicity tests were run at the end of each experiment to investigate the effects of the materials on three main groups of terrestrial model organisms: plants, earthworms and nitrifying bacteria. Complete biodegradation of the cups was observed in 180 days in the scenarios involving composting environment. A low degree of biodegradation (22.9 ± 4.5%) of the digestates in soil was observed, warning for a potential micro-bioplastics discharge into the environment. No degradation was observed for the cups in soil during the same testing period. Ecotoxicity tests revealed a negative effect on plants biomass growth across all samples, which was 17-30% lower compared to the blank sample. The experimental campaign highlighted the need for a systematic assessment of controlled treatment of bioplastics, as well as the need for a harmonized legislative framework.

Evaluation of the production and extraction of polyhydroxybutyrate from volatile fatty acids by means of mixed cultures and B. cepacia

The global consumption of plastics generates accelerated environmental pollution in landfills and marine ecosystems. Biopolymers are the materials with the greatest potential to replace synthetic polymers in the market due to their good biodegradability, however, there are still several disadvantages, mainly related to their production cost. Considering the above, the generation of biodegradable and biocompatible bioplastics stands out as an alternative solution, some of which are made from renewable raw materials, including polyhydroxyalkanoates PHAs. Although much research has been done on bacteria with the capacity for intracellular accumulation of PHAs, among others, it is also possible to produce PHAs using mixed microbial cultures instead of a single microorganism, using natural microbial consortia that have the capacity to store high amounts of PHAs. In this contribution, three methods for the extraction and purification of PHAs produced by fermentation using volatile fatty acids as a carbon source at different concentrations were evaluated, using the pure strain Burkholderia cepacia 2G-57 and the mixed cultures of the activated sludge from the El Salitre WWTP, in order to select the best method from the point of view of environmental sustainability as this will contribute to the scalability of the process. The mixed cultures were identified by sequencing of the 16S gene. A yield of 89% was obtained from the extraction and purification of PHA using acetic acid as a solvent, which according to its properties is "greener" than chloroform. The polymer obtained was identified as polyhydroxybutylated PHB.

Exploring the hidden environmental pollution of microplastics derived from bioplastics: A review

Bioplastics might be an ecofriendly alternative to traditional plastics. However, recent studies have emphasized that even bioplastics can end up becoming micro- and nano-plastics due to their degradation under ambient environmental conditions. Hence, there is an urgent need to assess the hidden environmental pollution caused by bioplastics. However, little is known about the evolutionary trends of bibliographic data, degradation pathways, formation, and toxicity of micro- and nano-scaled bioplastics originating from biodegradable polymers such as polylactic acid, polyhydroxyalkanoates, and starch-based plastics. Therefore, the prime objective of the current review was to investigate evolutionary trends and the latest advancements in the field of micro-bioplastic pollution. Additionally, it aims to confront the limitations of existing research on microplastic pollution derived from the degradation of bioplastic wastes, and to understand what is needed in future research. The literature survey revealed that research focusing on micro- and nano-bioplastics has begun since 2012. This review identifies novel insights into microbioplastics formation through diverse degradation pathways, including photo-oxidation, ozone-induced degradation, mechanochemical degradation, biodegradation, thermal, and catalytic degradation. Critical research gaps are identified, including defining optimal environmental conditions for complete degradation of diverse bioplastics, exploring micro- and nano-bioplastics formation in natural environments, investigating the global occurrence and distribution of these particles in diverse ecosystems, assessing toxic substances released during bioplastics degradation, and bridging the disparity between laboratory studies and real-world applications. By identifying new trends and knowledge gaps, this study lays the groundwork for future investigations and sustainable solutions in the realm of sustainable management of bioplastic wastes.

Effect of biodegradable PBAT microplastics on the C and N accumulation of functional organic pools in tropical latosol

Microplastics (MPs) pollution is becoming an emerging global stressor for soil ecosystems. However, studies on the impacts of biodegradable MPs on soil C sequestration have been mainly based on bulk C quantity, without considering the storage form of C, its persistency and N demand. To address this issue, the common poly (butylene adipate-co-terephthalate) (PBAT) was used as the model, and its effects on soil functional organic pools, including mineral-associated (MAOM), particulate (POM) and dissolved organic matter (DOM), were investigated from the novel coupled perspective of C and N stocks. After adding PBAT-MPs, the contents of soil POM-C, DOM-C, and MAOM-C were increased by 546.9 %-697.8 %, 54.2 %-90.3 %, and 13.7 %-18.9 %, respectively. Accordingly, the total C increased by 116.0 %-191.1 %. Structural equation modeling showed that soil C pools were regulated by PBAT input and microbial metabolism associated with C and N enzymes. Specifically, PBAT debris could be disguised as soil C to promote POM formation, which was the main pathway for C accumulation. Inversely, the MAOM-C and DOM-C formation was attributed to the PBAT microbial product and the selective consumption in DOM-N. Random forest model confirmed that N-activated (e.g., Nitrospirae) and PBAT-degrading bacteria (e.g., Gemmatinadetes) were important taxa for soil C accumulation, and the key enzymes were rhizopus oryzae lipas, invertase, and ammonia monooxygenase. The soil N accumulation was mainly related to the oligotrophic taxa (e.g., Chloroflexi and Ascomycota) associated with aggregate formation, decreasing the DOM-N by 46.9 %-84.3 %, but did not significantly change the total N storage and other N pools. Collectively, the findings highlight the urgency to control the nutrient imbalance risk of labile N loss and recalcitrant C enrichment in POM to avoid the depressed turnover rate of organic matter in MPs-polluted soil.

Organic composts as A vehicle for the entry of microplastics into the environment: A comprehensive review

Plastic pollution is a widespread issue that poses a threat to agroecosystems. Recent data on microplastic (MP) pollution from compost and its application to soil have highlighted the potential impact of micropollutants that may be transferred from compost. Thus, we aim with this review to elucidate the distribution-occurrence, characterization, fate/transport, and potential risk of MPs from organic compost to gain comprehensive knowledge and mitigate the adverse impacts of compost application. The concentration of MPs in compost was up to thousands of items/kg. Among micropollutants, fibers, fragments, and films are the most common, with small MPs having a higher potential to absorb other pollutants and cause harm to organisms. Various synthetic polymers, including polyethylene (PE), polypropylene (PP), polyethylene terephthalate (PET), polystyrene (PS), polyvinyl chloride (PVC), polyester (PES), and acrylic polymers (AP), have been widely used of plastic items. MPs are emerging pollutants that can have diverse effects on soil ecosystems, as they can transfer potential pollutants from MPs to compost and then to the soil. Following the microbial degradation scheme, the transfer chain from plastics to compost to soil can be broken down into main stages, i.e., colonization - (bio)fragmentation - assimilation - and mineralization. Microorganisms and adding biochar play an essential role during composting, which can be an effective solution to enhance MP degradation. Findings have shown that stimulating free radical generation could promote the biodegradation efficacy of MPs and possibly remove their occurrence in compost, thereby reducing their contribution to ecosystem pollution. Furthermore, future recommendations were discussed to reduce ecosystem risks and health challenges.

Overwintering covered with soil or avoiding burial of wine grapes under cold stress: Chinese wine industry's past and future, challenges and opportunities

In northwest China, where winter is extremely cold and the grapevine is vulnerable to freezing damage, the application of soil covering has promoted the vigorous development of the local grape and wine industries. However, in recent years, the negative effects of burying soil for cold protection on the environment have gradually emerged. In some viticultural regions, the phenomenon of "summer forest, winter desert" has appeared. Therefore, it is urgent for the Chinese grape industry to find a better solution to overwinter safely and environmentally friendly. This review summarizes the advantages and disadvantages of widely used solutions to overwinter such as covering vines with soil, breeding of cold-resistant grapes, cold-resistant cultivation model, physical and chemical covering materials, and protected grape facilities were reviewed. Future overwintering measures were proposed which avoid burial and grape overwintering research directions. It also provides a theoretical foundation and technical support to improve grape yield and quality in northwest China.

Thickness effects of polyethylene and biodegradable film residuals on soil properties and dryland maize productivity

Plastic film residuals are increasingly remaining in cultivated lands. However, it is a critical issue how residual plastic type and thickness affect soil properties and crop yield. To address this issue, in situ landfill was conducted using thick polyethylene (PEt1), thin polyethylene (PEt2), thick biodegradable (BIOt1), thin biodegradable (BIOt2) residues, and CK (control) with no residues landfill in a semiarid maize field. The findings demonstrated that the impact of various treatments on soil characteristics and maize yield varied considerably. Soil water content decreased by 24.82% in PEt1 and 25.43% in PEt2, compared to BIOt1 and BIOt2, respectively. BIOt2 treatment increased soil bulk density by 1.31 g cm^-3 and lowered soil porosity by 51.11%, respectively; it also elevated the silt/clay proportion by 49.42% relative to CK. In contrast, microaggregate composition in PEt2 was higher (43.02%). Moreover, BIOt2 lowered soil nitrate (NO₃^-) and ammonium (NH₄⁺) content. Compared with other treatments, BIOt2 resulted in significantly higher soil total nitrogen (STN) and lower SOC/STN. Finally, BIOt2 exhibited the lowest water use efficiency (WUE) (20.57 kg ha^-1 mm^-1) and yield (6896 kg ha^-1) among all the treatments. Therefore, BIO film residues exhibited detrimental impacts on soil quality and maize productivity compared to PE film ones. Considering film thickness, thin residual films more evidently influenced soil quality and maize productivity than thick film ones.

Perceiving biobased plastics as an alternative and innovative solution to combat plastic pollution for a circular economy

Plastic waste from fossil-based sources, including single-use packaging materials, is continuously accumulating in landfills, and leaching into the environment. A 2021 UN Environment Programme (UNEP) report suggests that the plastic pollution is likely to be doubled by 2030, posing a major challenge to the environment and the overall global plastic waste management efforts. The use of biobased plastics such as polyhydroxyalkanoates (PHAs) as a biodegradable substitute for petroleum-based plastics could be a feasible option to combat this issue which may further result in much lower carbon emissions and energy usage in comparison to conventional plastics as additional advantages. Though recent years have seen the use of microbes as biosynthetic machinery for biobased plastics, using various renewable feedstocks, the scaled-up production of such materials is still challenging. The current study outlays applications of biobased plastics, potential microorganisms producing biobased plastics such as Cupriavidus necator, Bacillus sp., Rhodopseudomonas palustris, microalgae, and mixed microbial cultures, and inexpensive and renewable resources as carbon substrates including industrial wastes. This review also provides deep insights into the operational parameters, challenges and mitigation, and future opportunities for maximizing the production of biobased plastic products. Finally, this review emphasizes the concept of biorefinery as a sustainable and innovative solution for biobased plastic production for achieving a circular bioeconomy.