Aerobic and anaerobic regulation induced different degradation behaviors of parachloronitrobenzene in soil by microwave activated persulfate oxidation

Degradation of organic pollutants by the Cl-/PMS process

The viewpoints on whether high concentrations of chloride ion (Cl-) promote or inhibit the oxidation activity of activated persulfates are still inconclusive. Furthermore, the degradation of organic pollutants by the persulfates in the presence of high Cl- concentrations without any activation medium has not yet been studied. In this work, the efficiency and mechanism of degradation of organic pollutants such as carbamazepine (CBZ), sulfadiazine (SDZ), and phenol (PN) by Cl--activated PMS (denoted as Cl-/PMS) were investigated. Results showed that Cl- could effectively activate PMS for the complete removal of CBZ, SDZ, and PN with reaction kinetic constants of 0.4516 min-1, 0.01753 min-1, and 0.06805 min-1, respectively. Parameters such as PMS dose, Cl- concentration, solution pH, and initial concentrations of organic pollutants that affect the degradation efficiencies of the Cl-/PMS process were optimized. Unlike conventional activated persulfates, it was confirmed that the free chlorine was the main active species in the Cl-/PMS process. Finally, the degradation by-products of CBZ and SDZ as well as their toxicity were detected, and a possible degradation pathway for CBZ and SDZ was proposed. Though higher toxic chlorinated by-products were generated, the Cl-/PMS process was still an efficient oxidation method for the removal of organic pollutants in aqueous solutions which contain high concentrations of Cl-.

Removal of total petroleum hydrocarbons from oil-based drilling cuttings by a heat activation persulfate-based process

Oil-based drilling cuttings (OBDC) are typical hazardous wastes generated during shale gas extraction. In this study, two persulfate-based advanced oxidation processes (AOPs), heat/PMS and heat/PDS, have been used to treat OBDC. The results showed that for the heat/PMS process, within a certain range, the oxidant dosage, temperature, and reaction time were significantly positively correlated with the degree of total petroleum hydrocarbon (TPH) removal. When these parameters were increased from their initial values to 3.57 mmol/g, 70°C, and 80 min, respectively, TPH removal rates increased significantly, by 20.95%, 18.68%, and 16.41%, respectively. However, further increases in these parameters had little effect on the TPH removal rate. Similar observations were made for the heat/PDS process. There are other differences between the two processes, including that the heat/PDS process required less oxidant to reach an effective activation state than the heat/PMS process, but required a higher temperature and a longer reaction time. Fourier-transform infrared spectrometry and gas chromatography-mass spectrometry have shown that both processes could effectively remove the light components of linear paraffins contained in OBDC. The heat/PMS process performed significantly better than the heat/PDS process in removing aromatic hydrocarbons and long-chain alkanes. Scanning electron microscopy, energy-dispersive spectrometry, and X-ray diffraction analysis implied that the elemental and mineral compositions of OBDC were not significantly modified by reaction in the heat/PMS and heat/PDS processes. This study may provide theoretical support for the technological development of heat activation and persulfate-based AOPs to remove TPH from OBDC.