Development of QDs-based nanosensors for heavy metal detection: A review on transducer principles and in-situ detection

A sensitive analytical strategy of oligonucleotide functionalized fluorescent probes for detection of nusinersen sodium in human serum

Spinal muscular atrophy (SMA) is a rare autosomal recessive neuromuscular disease. Nusinersen sodium (NS) is the world's first antisense oligonucleotide (ASO) drug for SMA precise targeted therapy. However, the limited half-life of oligonucleotides and their tendency to accumulate in hepatic and renal tissues presented significant challenges for clinical investigation and therapeutic drug monitoring. In this study, we proposed an analytical strategy based on the specific capture of oligonucleotide functionalized fluorescent probes by single stranded binding proteins (SSB) for ultra-sensitive and high-throughput detection of nusinersen sodium in human serum. The magnetic nanoparticles modified with single-strand binding protein (MNPs-SSB) selectively bonded to the red fluorescent quantum dots functionalized with oligonucleotides (RQDs-ssDNA) that were complementary to nusinersen sodium. Upon interaction with nusinersen sodium, RQDs-ssDNA formed a double-stranded complex (RQDs-ssDNA-NS), resulting in enhanced red fluorescence after magnetic separation as it was no longer captured by MNPs-SSB but remained in the supernatant. A quantitative analysis of nusinersen sodium in biological samples was successfully achieved by establishing a relationship between fluorescence intensity and its concentration. The detection signal F/F0 exhibited a linear correlation (R2 = 0.9871) over a wide range from 0.1 nM to 200 nM, with a limit of detection (LOD) of 0.03 nM, demonstrating the high specificity and rapid analysis time (only 30 min). This method provided a novel approach for sensitive, high-throughput, and specific analysis of nusinersen sodium and similar ASO drugs.

Construction of a three-mode sensor based on gold nanoparticles and carbon quantum dots as probes for the detection of thiosemicarbazone

In this study, ginkgo leaves were used as a carbon source to synthesize carbon quantum dots (CQDs) with uniform particle size, high fluorescence (FL) intensity and strong stability, using a hydrothermal method. FL could be quenched by the FL resonance energy transfer effect between CQDs and gold nanoparticles (AuNPs), an important FL quenching agent. The electrostatic attraction between thiosemicarbazone (TSC) and citrate on the surface of AuNPs and the formation of a stable Au-S bond between TSC and AuNPs led to the aggregation of AuNPs and thus weakened the quenching effect on CQDs and partly recovered the FL. A sensor in FL mode for the detection of TSC was constructed based on the above-mentioned FL "off" and "on" phenomena. The results showed a good linear correlation in the concentration range 0-1.75 μM, and the limit of detection was as low as 0.05 μM. In addition, the aggregation of AuNPs caused by TSC also led to a change in the absorbance curve and color of the solution; colorimetric and chrominance detection modes were also constructed using these two types of changes, with sensitive responses ranging 0-2.25 μM and 0-1.60 μM and the limits of detection of 0.03 μM and 0.08 μM, respectively. More importantly, these three detection modes obtained satisfactory recovery rates in the detection of the TSC content in river water, liquor and wheat samples, and the detection results were mutually verified (95.18% to 104.96%).

A fluorescent method for bisphenol A detection based on enzymatic oxidation-mediated emission quenching of silicon nanoparticles

As a common raw material of industrial products, bisphenol A (BPA) is widely used in the production of food contact materials, and there is a high risk of exposure in food. However, BPA is a well-known endocrine disruptor and poses a serious threat to human health. Herein, a fluorescent sensing platform of BPA based on enzymatic oxidation-mediated fluorescence quenching of silicon nanoparticles (SiNPs) is established and used to the detection of BPA in food species. The SiNPs are prepared with a facile one-step synthesis and emit bright green fluorescence. BPA can be oxidized by horseradish peroxidase (HRP) and hydrogen peroxide (H2O2) to form a product which can quench the fluorescence of SiNPs through electron transfer. There is a good linear relationship between the fluorescence intensity and BPA concentration in the range of 1-100 μM. Therefore, a fluorometry of BPA is established with a low limit of detection (LOD) of 0.69 μM. This method has been applied to the determination of BPA in mineral drinking water, orange juice, and milk with satisfactory results. The fluorescent sensor of BPA based on SiNPs has favorable application foreground in the field of food safety analysis.

Two-dimensional bismuth oxyselenide quantum dots as nanosensors for selective metal ion detection over a wide dynamic range: sensing mechanism and selectivity

Bismuth oxyselenide (Bi2O2Se) nanosheets, a new 2D non-van der Waals nanomaterial having unique semiconducting properties, could be favorable for various sensing applications. In the present report, a top-down chemical approach was adopted to synthesize ultrathin Bi2O2Se quantum dots (QDs) in an appropriate solution. The as-prepared 2D Bi2O2Se QDs with an average size of ∼3 nm, exhibiting strong visible fluorescence, were utilized for heavy-metal ion detection with high selectivity. The QDs show a high optical band gap and a reasonably high fluorescence quantum yield (∼4%) in the green region without any functionalization. A series of heavy metal ions were detected using these QDs. The as-prepared QDs exhibit selective detection of Fe3+ over a wide dynamic range with a high quenching ratio and a low detection limit (<0.5 μM). The mechanism of visible fluorescence and Fe3+ ion-induced quenching was investigated in detail based on a model involving adsorption and charge transfer. Density functional theory (DFT) first principles calculations show that fluorescence quenching occurred selectively due to the efficient trapping of electrons in the bandgap states created by the Fe atoms. This work presents a sustainable and scalable method to synthesize 2D Bi2O2Se QDs for heavy metal ion sensing over a wide dynamic range and these 2D QDs could find potential uses in gas sensors, biosensors and optoelectronics.

Valorised polypropylene waste based reversible sensor for copper ion detection in blood and water

Heavy metals and plastic pollutants are the two most disastrous challenges to the environment requiring immediate actions. In this work, a techno-commercially feasible approach to address both challenges is presented, where a waste polypropylene (PP) based reversible sensor is produced to selectively detect copper ions (Cu2+) in blood and water from different sources. The waste PP-based sensor was fabricated in the form of an emulsion-templated porous scaffold decorated with benzothiazolinium spiropyran (BTS), which produced a reddish colour upon exposure to Cu2+. The presence of Cu2+ was checked by naked eye, UV-Vis spectroscopy, and DC (Direct Current) probe station by measuring the current where the sensor's performance remained unaffected while analysing blood, water from different sources, and acidic or basic environment. The sensor exhibited 1.3 ppm as the limit of detection value in agreement with the WHO recommendations. The reversible nature of the sensor was determined by cyclic exposure of the sensor towards visible light turning it from coloured to colourless within 5 min and regenerated the sensor for the subsequent analysis. The reversibility of the sensor through exchange between Cu2+- Cu+ was confirmed by XPS analysis. A resettable and multi-readout INHIBIT logic gate was proposed for the sensor using Cu2+ and visible light as the inputs and colour change, reflectance band and current as the output. The cost-effective sensor enabled rapid detection of the presence of Cu2+ in both water and complex biological samples such as blood. While the approach developed in this study provides a unique opportunity to address the environmental burden of plastic waste management, it also allows for the possible valorization of plastics for use in enormous value-added applications.

Specific discrimination of zinc and manganese ions by label free dual emissive carbon dots by ratio-metric mode

Due to the worldwide ecological and environmental issues induced by heavy metal pollution, including zinc and manganese, the ratio-metric discrimination of Zn²⁺ and Mn²⁺ based on CDs is urgently required. In this work, reduced CDs (re-CDs) with the intrinsic dual emissive peaks are obtained, and specific discrimination of Zn²⁺ and Mn²⁺ is realized by re-CDs with ratio-metric mode. With the addition of Zn²⁺, the fluorescent (FL) intensity at 650 nm increases obviously, while that at 680 nm progressively decreases. However, the presence of Mn²⁺ would induce the quenching of FL intensity at 680 nm while that at 650 nm remains constant. Then the Zn²⁺ and Mn²⁺ can be separately determined with the ratio of FL intensity at 650 nm to that at 680 mm (F₆₅₀/F₆₈₀). Under optimal conditions, the limit of detection (LOD) of Zn²⁺ is determined to be 9.09 nmol/L, and that for Mn²⁺ is estimated to be 0.93 nmol/L, which is much lower than previously reported work and standard level of Zn²⁺ and Mn²⁺ permitted in drinking water by WHO. Moreover, the specific recognition of Mn²⁺ and Zn²⁺ can be realized via the addition of different masking agents (ethylenediamine for Zn²⁺ and triethanolamine for Mn²⁺). Furthermore, our results reveal that the structural changes from -NH-CO to -NC-OH induced by Zn²⁺ contribute to the shift of FL peak from 680 to 650 nm while both static and dynamic quenching processes are involved in the detection of Mn²⁺. The ratio-metric probe was successfully applied to Zn²⁺ and Mn²⁺ determination in human serum samples and Sandy Lake water.

Construction of ratiometric Si-Mn:ZnSe nanoparticles for the immunoassay of SARS-CoV-2 spike protein

The continuing global spread of Coronavirus Disease 2019 (COVID-19), caused by severe acute respiratory syndrome coronavirus type 2 (SARS-CoV-2) infection, has led to an unprecedented global health crisis. Effective and affordable methods are needed to diagnose SARS-CoV-2 infection. In this work, a ratiometric fluorescence probe, Si-Mn:ZnSe nanoparticles, was constructed through the electrostatic interaction between Si dots and Mn:ZnSe QDs, and the fluorescence of Mn:ZnSe QDs has a specifical response to H₂O₂. An immunocomplex was formed by the recognition of capture antibody/spike (S) protein/spike neutralizing antibody/biotinylated second antibody/streptavidin/biotinylated catalase (CAT). In the presence of S protein, CAT effectively catalyzed the decomposition of H₂O₂ in the system, and the fluorescence of Mn:ZnSe QDs was not specifically quenched. Based on this principle, a ratiometric immunoassay of SARS-CoV-2 S protein was established. The sensitivity of the proposed ELISA method was comparable to that of the commercial kit. In addition, this method can effectively distinguish the pseudo-SARS-CoV-2 virus and other pseudovirus. Therefore, this method provided a reliable and potential direction for diagnosing SARS-CoV-2 infection.

Detection of Heavy Metal Ions by Ratiometric Photoelectric Sensor

In recent years, heavy metal pollution has become increasingly serious. Heavy metals exist in an environment mainly in the form of ions (heavy metal ions, HMs). They can contaminate food, water, soil, and the atmosphere, leading to serious harm to plants and animals. With high bioavailability and nonbiodegradability, HMs can accumulate through biomagnification. Consequently, heavy metal pollution has become the cause of many fatal diseases threatening human health and ecological environment. Therefore, the accurate detection of HMs is vital and necessary. In this paper, the harm and limit standards of heavy metals were systematically summarized and the common analysis methods were overviewed and compared. Specifically, the latest research progress of ratiometric photoelectric sensor, including optical and electrical sensor, were mainly described. The research status and advantages and disadvantages of a photoelectric sensor were summarized. Furthermore, the future directions were proposed, which provided the reference for the further research and application of the ratiometric photoelectric sensor.

Introducing a green nanocatalytic process toward the synthesis of benzo[a]pyrano-[2,3-c]phenazines utilizing copper oxide quantum dot-modified core-shell magnetic mesoporous silica nanoparticles as high throughput and reusable nanocatalysts

In this contribution, a green, simple, efficient, and straightforward nanocatalytic process was developed for the synthesis of benzo[a]pyrano[2,3-c]phenazine derivatives under mild thermal conditions. In this regard, the copper oxide quantum dot-modified magnetic silica mesoporous nanoparticles (M-MSNs/CuO(QDs)) were synthesized by surface modification of M-MSNs with CuO QDs to prepare a highly powerful magnetic core-shell nanocatalyst. The prepared nanocatalyst was then characterized for its functionality, size, morphology, elemental composition, surface area, crystallinity, and magnetic properties. Afterwards, it was applied for the synthesis of benzo[a]pyrano[2,3-c]phenazine derivatives under green reaction conditions. The factors affecting the reaction yield were optimized by the one-factor-at-a-time optimization method. Under obtained optimal conditions, the developed method showed a reaction yield range as high as 86-95% for different derivatives. The reusability studies were performed for indexing the cycling stability of the prepared magnetic nanocatalyst. The results exhibited that the catalytic efficiency of the nanocatalyst was saved for at least 5 operational times, showing high cycling stability of M-MSNs/CuO(QDs). Finally, the catalytic performances of the nanocatalyst was compared with the reported ones, revealing that the M-MSNs/CuO(QDs) presents very better performances toward the synthesis of benzo[a]pyrano[2,3-c]phenazine derivatives than the reported ones.

Quantum dot-based fluorescence immunosorbent assay for the rapid detection of bacitracin zinc in feed samples

Bacitracin zinc (BAC), a polypeptide antibiotic, is utilized as a feed additive due to its ability to promote growth in animals. However, the abuse of BAC can lead to a great threat to food safety. Therefore, there is an urgent need to develop a rapid and sensitive detection method. In this study, a monoclonal antibody (mAb) against BAC with excellent sensitivity and specificity was obtained. For the first time, quantum dots (QDs) were conjugated with the prepared mAb against BAC and rabbit anti-mouse antibody to fabricate a direct and an indirect competitive fluorescence-linked immunosorbent assay (dc-FLISA and ic-FLISA) to detect BAC. The IC₅₀ of dc-FLISA and ic-FLISA were 0.28 ng/ml and 0.17 ng/ml, respectively. The limits of detection were 0.0016 ng/ml and 0.001 ng/ml, respectively, and the detection ranges were 0.0016-46.50 ng/ml and 0.001-35.65 ng/ml, respectively. In addition, the recovery rate of the two methods ranged from 93.5% to 112.0%, and the coefficient of variation (CV) was less than 10%. Therefore, the methods developed in this work have the merits of low cost, simple operation, and high sensitivity, which provide an effective analytical tool for BAC residue detection in feed samples.