Corroding copper and steel exposed to intermittently flowing tap water promote biofilm formation and growth of Legionella pneumophila

Regulation and microbial response mechanism of nitric oxide to copper-containing swine wastewater treated by Pistia stratiotes

As a signaling molecule, Nitric oxide (NO) has been widely used in abiotic stress mitigation studies.Pistia stratiotes showed a good synergistic removal effect on heavy metals, nitrogen and phosphorus, but the high concentration of copper(Cu) in swine wastewater inhibited the comprehensive removal ability of Pistia stratiotes. At present, it is not clear how the addition of NO regulates the stress resistance mechanism of Pistia stratiotes to copper in swine wastewater, and the microbial response mechanism accompanying this process is not yet clear. Therefore, in the concentration range of 0.31∼4 mg·L-1Cu2+ and NO concentration of 0,0.05 and 0.1 mg L-1, the removal effect of Pistia stratiotes on copper from swine wastewater was studied. The results showed as follows: The treatment of non-available copper in groups M and H increased by 10.67% and 22.31%, respectively, compared with that in group L. The critical point of inhibiting effect of NO on growth rate was 2.03 mg·L-1Cu. By measuring three-dimensional fluorescence spectrum, combined with parallel factor analysis and principal component analysis, it was confirmed that exogenous addition of NO affected the humification degree of dissolved organic matter(DOM) and promoted the chelation of organic matter with copper. With the increase of Cu concentration, the Reyranella and Prosthecobacter with certain copper resistance gradually gained advantages. Redundancy analysis(RDA) showed that Emiticicia had a strong correlation with the removal rates of ammonia nitrogen, total phosphorus and copper in swine wastewater, while hgcI_clade had a strong correlation with the removal rates of total nitrogen. In conclusion, controlling the dosage of NO can effectively improve the tolerance and removal effect of Pistia stratiotes on copper in swine wastewater, which is of great significance for promoting the treatment and resource transformation of swine wastewater.

Microfluidic investigation of the impacts of flow fluctuations on the development of Pseudomonas putida biofilms

Biofilms play critical roles in wastewater treatment, bioremediation, and medical-device-related infections. Understanding the dynamics of biofilm formation and growth is essential for controlling and exploiting their properties. However, the majority of current studies have focused on the impact of steady flows on biofilm growth, while flow fluctuations are common in natural and engineered systems such as water pipes and blood vessels. Here, we reveal the effects of flow fluctuations on the development of Pseudomonas putida biofilms through systematic microfluidic experiments and the development of a theoretical model. Our experimental results showed that biofilm growth under fluctuating flow conditions followed three phases: lag, exponential, and fluctuation phases. In contrast, biofilm growth under steady-flow conditions followed four phases: lag, exponential, stationary, and decline phases. Furthermore, we demonstrated that low-frequency flow fluctuations promoted biofilm growth, while high-frequency fluctuations inhibited its development. We attributed the contradictory impacts of flow fluctuations on biofilm growth to the adjustment time (T0) needed for biofilm to grow after the shear stress changed from high to low. Furthermore, we developed a theoretical model that explains the observed biofilm growth under fluctuating flow conditions. Our insights into the mechanisms underlying biofilm development under fluctuating flows can inform the design of strategies to control biofilm formation in diverse natural and engineered systems.

The Behavior of Polymeric Pipes in Drinking Water Distribution System-Comparison with Other Pipe Materials

The inner walls of the drinking water distribution system (DWDS) are expected to be clean to ensure a safe quality of drinking water. Complex physical, chemical, and biological processes take place when water comes into contact with the pipe surface. This paper describes the impact of leaching different compounds from the water supply pipes into drinking water and subsequent risks. Among these compounds, there are heavy metals. It is necessary to prevent these metals from getting into the DWDS. Those compounds are susceptible to impacting the quality of the water delivered to the population either by leaching dangerous chemicals into water or by enhancing the development of microorganism growth on the pipe surface. The corrosion process of different pipe materials, scale formation mechanisms, and the impact of bacteria formed in corrosion layers are discussed. Water treatment processes and the pipe materials also affect the water composition. Pipe materials act differently in the flowing and stagnation conditions. Moreover, they age differently (e.g., metal-based pipes are subjected to corrosion while polymer-based pipes have a decreased mechanical resistance) and are susceptible to enhanced bacterial film formation. Water distribution pipes are a dynamic environment, therefore, the models that are used must consider the changes that occur over time. Mathematical modeling of the leaching process is complex and includes the description of corrosion development over time, correlated with a model for the biofilm formation and the disinfectants-corrosion products and disinfectants-biofilm interactions. The models used for these processes range from simple longitudinal dispersion models to Monte Carlo simulations and 3D modeling. This review helps to clarify what are the possible sources of compounds responsible for drinking water quality degradation. Additionally, it gives guidance on the measures that are needed to maintain stable and safe drinking water quality.

A Critical Review on the Factors that Influence Opportunistic Premise Plumbing Pathogens: From Building Entry to Fixtures in Residences

Residential buildings provide unique conditions for opportunistic premise plumbing pathogen (OPPP) exposure via aerosolized water droplets produced by showerheads, faucets, and tubs. The objective of this review was to critically evaluate the existing literature that assessed the impact of potentially enhancing conditions to OPPP occurrence associated with residential plumbing and to point out knowledge gaps. Comprehensive studies on the topic were found to be lacking. Major knowledge gaps identified include the assessment of OPPP growth in the residential plumbing, from building entry to fixtures, and evaluation of the extent of the impact of typical residential plumbing design (e.g., trunk and branch and manifold), components (e.g., valves and fixtures), water heater types and temperature setting of operation, and common pipe materials (copper, PEX, and PVC/CPVC). In addition, impacts of the current plumbing code requirements on OPPP responses have not been assessed by any study and a lack of guidelines for OPPP risk management in residences was identified. Finally, the research required to expand knowledge on OPPP amplification in residences was discussed.

Formation mechanisms and supervisory prediction of scaling in water supply pipelines: A review

The scaling problem in the water supply pipeline will increase the resistance coefficient of the pipeline and the pressure of the water supply pipeline, which will not only affect the operation safety of the water supply pipeline, but also cause energy waste. The scale in the pipeline will also enrich heavy metal ions and pathogenic microorganisms, affecting the safety of water supply water quality and causing secondary pollution of water quality. At present, a lot of research has been done on the composition structure and crystallization process of the scale. The study found that calcite is the main component of the scale; the scale process is a heterogeneous nucleation process induced by heavy metal particles and their corrosion products in the pipeline. The introduction of electrochemical detection technology, density functional theory and molecular dynamics simulation has greatly improved the accuracy and timeliness of water scaling conditions detection and realized the visualization of scaling mechanism. In this paper, the measurement methods of the scale in the water supply pipeline and the corresponding material composition and crystal structure characteristics are reviewed, and the mechanism of the scale and the water quality conditions are summarized. At the end of this paper, based on summarizing the existing water quality scaling tendency evaluation methods, it is proposed to establish a water quality potential scaling risk assessment framework based on Puckorius scaling index (PSI) and electrochemical impedance spectroscopy (EIS) in the future.

Iron carriers promote biofilm formation and p-nitrophenol degradation

Vertical baffled biofilm reactors (VBBR) equipped with Plastic-carriers and Fe-carriers were employed to explore the effect of biofilm carriers on biofilm formation and p-nitrophenol (PNP) degradation. The results showed that Fe-carriers enhanced biofilm formation and PNP degradation. The maximum thickness of biofilm grown on the Fe-carriers was 1.5-fold higher than that on the Plastic-carriers. The Fe-VBBR reached a maximum rate of PNP removal at 13.02 μM L^-1 h^-1 with less sodium acetate addition (3 mM), while the maximum rate of PNP removal was 11.53 μM L^-1 h^-1 with more sodium acetate addition (6 mM) in the Plastic-based VBBR. High-throughput sequencing suggested that the Fe-VBBR had a higher biodiversity of the bacterial community in evenness, and the Achromobacter genus and Xanthobacteraceae family were as main PNP degraders. Kyoto Encyclopedia of Genes and Genomes (KEGG) Orthology analysis suggested more abundances of iron uptake genes were expressed to transport iron into the cytoplasm under an iron-limited condition in two VBBRs, and the metabolic pathway of PNP degradation went through 4-nitrocatechol and 1,2,4-benzenetriol. Our results provide a new insight for iron enhancing biofilm formation and PNP degradation.

Seawater desalination based drinking water: Microbial characterization during distribution with and without residual chlorine

Monitoring the changes that occur to water during distribution is vital to ensure water safety. In this study, the biological stability of reverse osmosis (RO) produced drinking water, characterized by low cell concentration and low assimilable organic carbon, in combination with chlorine disinfection was investigated. Water quality at several locations throughout the existing distribution network was monitored to investigate whether microbial water quality changes can be identified. Results revealed that the water leaving the plant had an average bacterial cell concentration of 10³ cells/mL. A 0.5-1.5 log increase in bacterial cell concentration was observed at locations in the network. The residual disinfectant was largely dissipated in the network from 0.5 mg/L at the treatment plant to less than 0.1 mg/L in the network locations. The simulative study involving miniature distribution networks, mimicking the dynamics of a distribution network, fed with the RO produced chlorinated and non-chlorinated drinking water revealed that distributing RO produced water without residual disinfection, especially at high water temperatures (25-30 °C), poses a higher chance for water quality change. Within six months of operation of the miniature network fed with unchlorinated RO produced water, the adenosine triphosphate (ATP) and total cell concentration (TCC) in the pipe biofilm were 4 × 10² pg ATP/cm² and 1 × 10⁷ cells/ cm². The low bacterial cell concentration and organic carbon concentration in the RO-produced water did not prevent biofilm development inside the network with and without residual chlorine. The bacterial community analysis using 16S ribosomal RNA (rRNA) gene sequencing revealed that mesophilic bacteria with higher temperature tolerance and bacteria associated with oligotrophic, nutrient-poor conditions dominated the biofilm, with no indication of the existence of opportunistic pathogenic species. However, chlorination selected against most bacterial groups and the bacterial community that remained was mainly the bacteria capable of surviving disinfection regimes. Biofilms that developed in the presence of chlorine contained species classified as opportunistic pathogens. These biofilms have an impact on shaping the water quality received at the consumer tap. The presence of these bacteria on its own is not a health risk indicator; viability assessment and qPCRs targeting genes specific to the opportunistic pathogens as well as quantitative microbiological risk assessment (QMRA) should be included to assess the risk. The results from this study highlight the importance of implementing multiple barriers to ensure water safety. Changes in water quality detected even when high-quality disinfected RO-produced water is distributed highlight microbiological challenges that chlorinated systems endure, especially at high water temperatures.

Opportunistic pathogens exhibit distinct growth dynamics in rainwater and tap water storage systems

Opportunistic pathogens (OPs) are emerging microbial contaminants in engineered water systems, yet their growth potential in rainwater systems has not been evaluated. The purpose of this study was to compare the growth dynamics of bacterial OPs and related genera (Pseudomonas aeruginosa, Legionella spp., L. pneumophila, Mycobacterium spp., and M. avium), two amoebal hosts (Acanthamoeba spp. and Vermamoeba vermiformis), and the fecal indicator Escherichia coli in simulated rainwater and tap water storage systems (SWSSs). Quantitative polymerase chain reaction (q-PCR) analysis of target microorganisms in SWSS influents and effluents demonstrated that P. aeruginosa and Legionella thrived in rainwater, but not in tap water. V. vermiformis proliferated in both rainwater and tap water polyvinyl chloride (PVC) SWSSs, while mycobacteria were largely absent in rainwater SWSSs. Tank materials exerted stronger influence on target microorganisms in rainwater SWSSs relative to tap water SWSSs, with species-specific responses noted in bulk water and biofilm. For instance, P. aeruginosa and V. vermiformis had the highest gene copy numbers in PVC rainwater SWSS effluents and biofilm, while Legionella peaked in stainless steel rainwater SWSS effluents and PVC rainwater SWSS biofilm. These results highlighted the OP contamination risks in rainwater storage systems and provided insights into rainwater system design and operation in terms of OP control.

Copper Surfaces in Biofilm Control

Biofilms are structures comprising microorganisms associated to surfaces and enclosed by an extracellular polymeric matrix produced by the colonizer cells. These structures protect microorganisms from adverse environmental conditions. Biofilms are typically associated with several negative impacts for health and industries and no effective strategy for their complete control/eradication has been identified so far. The antimicrobial properties of copper are well recognized among the scientific community, which increased their interest for the use of these materials in different applications. In this review the use of different copper materials (copper, copper alloys, nanoparticles and copper-based coatings) in medical settings, industrial equipment and plumbing systems will be discussed considering their potential to prevent and control biofilm formation. Particular attention is given to the mode of action of copper materials. The putative impact of copper materials in the health and/or products quality is reviewed taking into account their main use and the possible effects on the spread of antimicrobial resistance.