Predicting Oral Absorption of fenofibrate in Lipid-Based Drug Delivery Systems by Combining In Vitro Lipolysis with the Mucus-PVPA Permeability Model

In Vitro Digestion-In Situ Absorption Setup Employing a Physiologically Relevant Value of the Membrane Surface Area/Volume Ratio for Evaluating Performance of Lipid-Based Formulations: A Comparative Study with an In Vitro Digestion-Permeation Model

The aim of this study is to establish and test an in vitro digestion-in situ absorption model that can mimic in vivo drug flux by employing a physiologically relevant value of the membrane surface area (S)/volume (V) ratio for accurate prediction of oral drug absorption from lipid-based formulations (LBFs). Three different types of LBFs (Type IIIA-MC, Type IIIA-LC, and Type IV) loaded with cinnarizine (CNZ), a lipophilic weak base with borderline permeability, and a control suspension were prepared. Subsequently, a simultaneous in vitro digestion-permeation experiment was conducted using a side-by-side diffusion cell with a dialysis membrane having a low S/V value. During digestion, CNZ partially precipitated for Type IV, while it remained solubilized in the aqueous phase for Type IIIA-MC and Type IIIA-LC in the donor compartment. However, in vitro drug fluxes for Type IIIA-MC and Type IIIA-LC were lower than those for Type IV due to the reduced free fraction of CNZ in the donor compartment. In pharmacokinetic studies, a similar improvement in in vivo oral exposure relative to suspension was observed, regardless of the LBFs used. Consequently, a poor correlation was found between in vitro permeation and areas under the plasma concentration-time curve (AUCoral) (R2 = 0.087). A luminal concentration measurement study revealed that this discrepancy was attributed to the extremely high absorption rate of CNZ in the gastrointestinal tract compared to that across a dialysis membrane evaluated by the in vitro digestion-permeation model, i.e., the absorption of CNZ in vivo was completed regardless of the extent of the free fraction, owing to the rapid removal of CNZ from the intestine. Subsequently, we aimed to predict the oral absorption of CNZ from the same formulations using a model that demonstrated high drug flux by employing the physiologically relevant S/V value and rat jejunum segment as an absorption sink (for replicating in vivo intestinal permeability). Predigested formulations were injected into the rat intestinal loop, and AUCloop values were calculated from the plasma concentration-time profiles. A better correlation was found between AUCloop and AUCoral (R2 = 0.72), although AUCloop underestimated AUCoral for Type IV due to the precipitation of CNZ during the predigestion process. However, this result indicated the importance of mimicking the in vivo drug absorption rate in the predictive model. The method presented herein is valuable for the development of LBFs.

How can Electrospinning Further Service Well for Pharmaceutical Researches?

The past two decades have witnessed the enormous success and progress of electrospinning, as well as its broad and useful applications in pharmaceutics as a laboratory pharmaceutical nanotechnology. Everything in the past is a preface, in which the large screen opens for electrospinning and electrospun nanofibers (particularly those multiple-fluid electrospinning processes and the related multiple-chamber nanostructures) to stride into a new stage and the real commercial applications. In this commentary, four hot regions are identified for the further progress of the applications of electrospinning in pharmaceutics, in which electrospinning and its products can provide more and better services to the development of pharmaceutics.

Leveraging the use of in vitro and computational methods to support the development of enabling oral drug products: An InPharma commentary

Due to the strong tendency towards poorly soluble drugs in modern development pipelines, enabling drug formulations such as amorphous solid dispersions, cyclodextrins, co-crystals and lipid-based formulations are frequently applied to solubilize or generate supersaturation in gastrointestinal fluids, thus enhancing oral drug absorption. Although many innovative in vitro and in silico tools have been introduced in recent years to aid development of enabling formulations, significant knowledge gaps still exist with respect to how best to implement them. As a result, the development strategy for enabling formulations varies considerably within the industry and many elements of empiricism remain. The InPharma network aims to advance a mechanistic, animal-free approach to the assessment of drug developability. This commentary focuses current status and next steps that will be taken in InPharma to identify and fully utilize 'best practice' in vitro and in silico tools for use in physiologically based biopharmaceutic models.

Commercially Available Cell-Free Permeability Tests for Industrial Drug Development: Increased Sustainability through Reduction of In Vivo Studies

Replacing in vivo with in vitro studies can increase sustainability in the development of medicines. This principle has already been applied in the biowaiver approach based on the biopharmaceutical classification system, BCS. A biowaiver is a regulatory process in which a drug is approved based on evidence of in vitro equivalence, i.e., a dissolution test, rather than on in vivo bioequivalence. Currently biowaivers can only be granted for highly water-soluble drugs, i.e., BCS class I/III drugs. When evaluating poorly soluble drugs, i.e., BCS class II/IV drugs, in vitro dissolution testing has proved to be inadequate for predicting in vivo drug performance due to the lack of permeability interpretation. The aim of this review was to provide solid proofs that at least two commercially available cell-free in vitro assays, namely, the parallel artificial membrane permeability assay, PAMPA, and the PermeaPad^® assay, PermeaPad, in different formats and set-ups, have the potential to reduce and replace in vivo testing to some extent, thus increasing sustainability in drug development. Based on the literature review presented here, we suggest that these assays should be implemented as alternatives to (1) more energy-intense in vitro methods, e.g., refining/replacing cell-based permeability assays, and (2) in vivo studies, e.g., reducing the number of pharmacokinetic studies conducted on animals and humans. For this to happen, a new and modern legislative framework for drug approval is required.

Development and validation of a porcine artificial colonic mucus model reflecting the properties of native colonic mucus in pigs

Colonic mucus plays a key role in colonic drug absorption. Mucus permeation assays could therefore provide useful insights and support rational formulation development in the early stages of drug development. However, the collection of native colonic mucus from animal sources is labor-intensive, does not yield amounts that allow for routine experimentation, and raises ethical concerns. In the present study, we developed an in vitro porcine artificial colonic mucus model based on the characterization of native colonic mucus. The structural properties of the artificial colonic mucus were validated against the native secretion for their ability to capture key diffusion patterns of macromolecules in native mucus. Moreover, the artificial colonic mucus could be stored under common laboratory conditions, without compromising its barrier properties. In conclusion, the porcine artificial colonic mucus model can be considered a biorelevant way to study the diffusion behavior of drug candidates in colonic mucus. It is a cost-efficient screening tool easily incorporated into the early stages of drug development and it contributes to the implementation of the 3Rs (refinement, reduction, and replacement of animals) in the drug development process.

Comparison of Cellular Monolayers and an Artificial Membrane as Absorptive Membranes in the in vitro Lipolysis-permeation Assay

Permeation across Caco-2 cells in lipolysis-permeation setups can predict the rank order of in vivo drug exposure obtained with lipid-based formulations (LBFs). However, Caco-2 cells require a long differentiation period and do not capture all characteristics of the human small intestine. We therefore evaluated two in vitro assays with artificial lecithin-in-dodecane (LiDo) membranes and MDCK cells as absorptive membranes in the lipolysis-permeation setup. Fenofibrate-loaded LBFs were used and the results from the two assays compared to literature plasma concentrations in landrace pigs administered orally with the same formulations. Aqueous drug concentrations, supersaturation, and precipitation were determined in the digestion chamber and drug permeation in the receiver chamber. Auxiliary in vitro parameters were assessed, such as permeation of the taurocholate, present in the simulated intestinal fluid used in the assay, and size of colloidal structures in the digestion medium over time. The LiDo membrane gave a similar drug distribution as the Caco-2 cells and accurately reproduced the equivalent rank-order of fenofibrate exposure in plasma. Permeation of fenofibrate across MDCK monolayers did not, however, reflect the in vivo exposure rankings. Taurocholate flux was negligible through either membrane. This process was therefore not considered to significantly affect the in vitro distribution of fenofibrate. We conclude that the artificial LiDo membrane is a promising tool for lipolysis-permeation assays to evaluate LBF performance.

Current challenges and future perspectives in oral absorption research: An opinion of the UNGAP network

Although oral drug delivery is the preferred administration route and has been used for centuries, modern drug discovery and development pipelines challenge conventional formulation approaches and highlight the insufficient mechanistic understanding of processes critical to oral drug absorption. This review presents the opinion of UNGAP scientists on four key themes across the oral absorption landscape: (1) specific patient populations, (2) regional differences in the gastrointestinal tract, (3) advanced formulations and (4) food-drug interactions. The differences of oral absorption in pediatric and geriatric populations, the specific issues in colonic absorption, the formulation approaches for poorly water-soluble (small molecules) and poorly permeable (peptides, RNA etc.) drugs, as well as the vast realm of food effects, are some of the topics discussed in detail. The identified controversies and gaps in the current understanding of gastrointestinal absorption-related processes are used to create a roadmap for the future of oral drug absorption research.