Direct interface of chemistry to microbiological systems: membrane inlet mass spectrometry

Oxygen levels are key to understanding "Anaerobic" protozoan pathogens with micro-aerophilic lifestyles

Publications abound on the physiology, biochemistry and molecular biology of "anaerobic" protozoal parasites as usually grown under "anaerobic" culture conditions. The media routinely used are poised at low redox potentials using techniques that remove O₂ to "undetectable" levels in sealed containers. However there is growing understanding that these culture conditions do not faithfully resemble the O₂ environments these organisms inhabit. Here we review for protists lacking oxidative energy metabolism, the oxygen cascade from atmospheric to intracellular concentrations and relevant methods of measurements of O₂, some well-studied parasitic or symbiotic protozoan lifestyles, their homeodynamic metabolic and redox balances, organism-drug-oxygen interactions, and the present and future prospects for improved drugs and treatment regimes.

Membrane inlet mass spectrometer for the quasi-continuous on-site analysis of dissolved gases in groundwater

We developed a stand-alone system based on a membrane inlet mass spectrometer (MIMS) for measuring dissolved gas concentrations in groundwater under field conditions. The system permits the concentrations of dissolved gases (He, Ar, Kr, N(2), and O(2)) in groundwater to be determined quasi-continuously (every 12 min) with a precision of better than 4% for He and Kr, and with a precision of 1% for Ar, N(2), and O(2) in air-saturated water. The detection limits are below 3 × 10(-9) cm(3)(STP)(g) for the noble gases and below 400 × 10(-9)cm(3)(STP)(g) for N(2) and O(2). The results of a first deployment of the system in the field indicate that changes in the concentration of Ar that result from diel fluctuations of 3°C in the river water temperature were still able to be resolved in groundwater, although the corresponding temperature signal almost vanished.

Real time monitoring of a biogas digester with gas chromatography, near-infrared spectroscopy, and membrane-inlet mass spectrometry

Four methods of monitoring the anaerobic digestion process were studied at pilot scale. The methods employed were Micro Gas Chromatography (μ-GC) and Membrane Inlet Mass Spectrometry (MIMS) for measurements in the gas phase, Near Infrared Spectroscopy (NIRS) and pH in the liquid phase. Micro Gas Chromatography accurately measured H(2), CH(4), H(2)S, N(2) and O(2) in the headspace whereas the MIMS accurately measured CH(4), CO(2), H(2)S, reduced organic sulfur compounds and p-cresol, also in the headspace. In the liquid phase, NIRS was found to be suitable for estimating the concentrations of acetate, propionate and total volatile fatty acids (VFA) but the error of prediction was too large for accurate quantification. Both the μ-GC and NIRS were low maintenance methods whereas the MIMS required frequent cleaning and background measurements.

On-line measurement of oxidative degradation kinetics for trace gasoline contaminants in aqueous solutions and natural water by membrane introduction tandem mass spectrometry

Membrane introduction mass spectrometry (MIMS) was used to directly monitor the loss of trace gasoline contaminants (benzene, toluene, 2-methylthiophene and methylcyclohexane) in nanomolar (ppb) aqueous solutions under a variety of UV-induced advanced oxidation processes (AOP). The decay kinetics of these contaminants were followed simultaneously in "real-time" via tandem mass spectrometric techniques by re-circulating the reaction mixture in a closed loop over a semi-permeable membrane interface. The photocatalyzed degradations were observed to follow pseudo-first-order kinetics with rate constants ranging from 0.006 to 0.2 min⁻¹ depending on the reaction conditions. We report rate enhancements for several UV-based advanced oxidative processes using physiosorbed titanium dioxide (TiO₂/UV, TiO₂/UV/O₂, TiO₂/UV/H₂O₂) and compare these to the direct photolysis of H₂O₂ under otherwise identical conditions. The relative degradation rates of 4 trace contaminants are reported for reactions carried out in the same solution. The degradation kinetics were also monitored directly in a natural surface water spiked with the same contaminant suite. The observed decay kinetics in the presence of TiO₂ in air-saturated natural water were similar to those carried out in deionized water. However, when the photo-oxidation was enhanced by the addition of H₂O₂, the degradation was markedly slower in natural water relative to deionized water due to competition for photons by dissolved organic matter. This work further demonstrates the use of MIMS as a sensitive on-line measurement technique for "in-situ" reaction monitoring of organic contaminants at environmentally relevant concentrations in complex solutions and reactive media.

Application of membrane inlet mass spectrometry for online and in situ analysis of methane in aquatic environments

A method is presented for the online measurement of methane in aquatic environments by application of membrane inlet mass spectrometry (MIMS). For this purpose, the underwater mass spectrometer Inspectr200-200 was applied. A simple and reliable volumetric calibration technique, based on the mixing of two end member concentrations, was used for the analysis of CH(4) by MIMS. To minimize interferences caused by the high water vapor content, permeating through the membrane inlet system into the vacuum section of the mass spectrometer, a cool-trap was designed. With the application of the cool-trap, the detection limit was lowered from 100 to 16 nmol/L CH(4). This allows for measurements of methane concentrations in surface and bottom waters of coastal areas and lakes. Furthermore, in case of membrane rupture, the cool-trap acts as a security system, avoiding total damage of the mass spectrometer by flushing it with water. The Inspectr200-200 was applied for studies of methane and carbon dioxide concentrations in coastal areas of the Baltic Sea and Lake Constance. The low detection limit and fast response time of the MIMS allowed a detailed investigation of methane concentrations in the vicinity of gas seepages.

An enzyme derivatized polydimethylsiloxane (PDMS) membrane for use in membrane introduction mass spectrometry (MIMS)

Membrane introduction mass spectrometry (MIMS) provides direct measurement of volatile and semivolatile analytes in condensed and gas-phase samples without sample preparation steps. Although MIMS has numerous advantages that include direct, on-line, real-time analysis with low detection limits, current applications of MIMS are predominantly limited to volatile and semivolatile analytes that permeate hydrophobic membranes (e.g., polydimethylsiloxane; PDMS). We report the first enzyme modified PDMS membrane for use with MIMS. This was achieved by immobilizing Candida rugosa lipase directly onto the surface of oxidized PDMS. These surface immobilized enzymes catalyze ester hydrolysis, releasing an alcohol product at the membrane interface that is readily detected. We have successfully used an enzyme modified membrane for the analysis and quantification of low-volatility and hydrophilic esters. We report the quantification of several carboxylic acid esters in dilute aqueous solutions, including a phthalate monoester carboxylate that is not readily detected by conventional MIMS. This new interface demonstrates the potential for extending the range and versatility of MIMS.

Observation of a chaotic multioscillatory metabolic attractor by real-time monitoring of a yeast continuous culture

We monitored a continuous culture of the yeast Saccharomyces cerevisiae by membrane-inlet mass spectrometry. This technique allows very rapid simultaneous measurements (one point every 12 s) of several dissolved gases. During our experiment, the culture exhibited a multioscillatory mode in which the dissolved oxygen and carbon dioxide records displayed periodicities of 13 h, 36 min and 4 min. The 36- and 4-min modes were not visible at all times, but returned at regular intervals during the 13-h cycle. The 4-min mode, which has not previously been described in continuous culture, can also be seen when the culture displays simpler oscillatory behavior. The data can be used to visualize a metabolic attractor of this system, i.e. the set of dissolved gas concentrations which are consistent with the multioscillatory state. Computation of the leading Lyapunov exponent reveals the dynamics on this attractor to be chaotic.

Hydrogen sulfide: clandestine microbial messenger?

Although the toxicity of hydrogen sulfide (H(2)S) has been substantiated for almost 230 years, its pivotal roles in both aerobic and anaerobic organisms have only recently become evident. In low oxygen environments with millimolar concentrations of H(2)S, it functions as an electron donor and as an energy source in some systems. At micromolar levels, intracellular H(2)S in aerobic organisms has a vital role in redox balancing. At even lower concentrations, H(2)S provides essential signals in yeast, in the brain and in smooth and cardiac muscles. Here, other possible coordinating roles within and between microorganisms are suggested, including the possibility that H(2)S functions as a signalling mediator in prokaryotes. It is expected that future research will uncover a host of novel functions, not only in eukaryotes but also in prokaryotic species.

Respirometric 13C flux analysis, Part I: design, construction and validation of a novel multiple reactor system using on-line membrane inlet mass spectrometry

A novel method for (13)C flux analysis based on on-line CO(2) labeling measurements is presented. This so-called respirometric (13)C flux analysis requires multiple parallel (13)C labeling experiments using differently labeled tracer substrates. In Part I of the work, a membrane-inlet mass spectrometry-based measurement system with 6 parallel reactors with each 12 ml liquid volume and associated experimental and computational methods for the respirometric (13)C data acquisition and evaluation are described. Signal dynamics after switching between membrane probes follow exactly first-order allowing extrapolation to steady state. Each measurement cycle involving 3 reactors takes about 2 min. After development of a dynamic calibration method, the suitability and reliability of the analysis was examined with a lysine-producing mutant of Corynebacterium glutamicum using [1-(13)C(1)], [6-(13)C(1)], [1,6-(13)C(2)] glucose. Specific rates of oxygen uptake and CO(2) production were estimated with an error less than +/-0.3 mmol g(-1) h(-1) and had +/-3% to +/-10% deviations between parallel reactors which is primarily caused by inaccuracies in initial biomass concentration. The respiratory quotient could be determined with an uncertainty less than +/-0.02 and varied only +/-3% between reactors. Fractional labeling of CO(2) was estimated with much higher precision of about +/-0.001 to +/-0.005. The detailed statistical analysis suggested that these data should be of sufficient quality to allow physiological interpretation and metabolic flux estimation. The obtained data were applied for the respirometric (13)C metabolic flux analysis in Part II.

Determination of methyl tert-butyl ether in gasoline: a comparison of three fast methods based on mass spectrometry

A high-speed quantitative analysis of methyl tert-butyl ether (MTBE) using three different methods with mass spectrometry detection has been performed. The first method is based on fast chromatography and required an analysis time of 5.23 min per sample, although a certain period (6 min) was necessary for the initial measurement conditions to be regained prior to analysing the next sample. The other two are non-separative methods and are based on direct injection and headspace generation. The analysis times were 1.5 and 3.5 min, respectively, although in the latter case an additional period of time was required to extract volatiles from the sample. The analytical characteristics of all three methods are highly satisfactory in terms of linearity, lack of fit, precision and accuracy. The methods were applied to the determination of MTBE in different gasoline samples. The non-separative methods afforded slightly higher concentrations than those found when fast chromatography was used; this is due to the presence of other minor components that contribute to the abundance of the ion at m/z 73, characteristic of MTBE. We propose a correction that removes this error very satisfactorily and allows the same results to be obtained with all three methodologies proposed.

On-line monitoring of CO2 production inLactococcus lactis during physiological pH decrease using membrane inlet mass spectrometry with dynamic pH calibration

Monitoring CO2 production in systems, where pH is changing with time is hampered by the chemical behavior and pH-dependent volatility of this compound. In this article, we present the first method where the concentration and production rate of dissolved CO2 can be monitored directly, continuously, and quantitatively under conditions where pH changes rapidly ( approximately 2 units in 15 min). The method corrects membrane inlet mass spectrometry (MIMS) measurements of CO2 for pH dependency using on-line pH analysis and an experimentally established calibration model. It is valid within the pH range of 3.5 to 7, despite pH-dependent calibration constants that vary in a non-linear fashion with more than a factor of 3 in this interval. The method made it possible to determine the carbon dioxide production during Lactococcus lactis fermentations, where pH drops up to 3 units during the fermentation. The accuracy was approximately 5%. We used the method to investigate the effect of initial extracellular pH on carbon dioxide production during anarobic glucose fermentation by non-growing Lactocoocus lactis and demonstrated that the carbon dioxide production rate increases considerably, when the initial pH was increased from 6 to 6.8.