Influence of the Alkyl Chain Length of the Imidazole Ionic Liquid-Type Surfactants on Their Aggregation Behavior with Sodium Dodecyl Sulfate

Dual function surfactants for pharmaceutical formulations: The case of surface active and antibacterial 1-tolyl alkyl biguanide derivatives

One interesting field of research in the view of developing novel surfactants for pharmaceutical and cosmetic applications is the design of amphiphiles showing further bioactive properties in addition to those commonly displayed by surface-active compounds. We propose here the chemical synthesis, and characterization of 1-o-tolyl alkyl biguanide derivatives, having different lengths of the hydrocarbon chain (C3, C6, and C10), and showing surface active and antibacterial/disinfectant activities toward both Gram-positive and Gram-negative bacteria. Both surface active properties in terms of critical micelle concentration (CMC) and surface tension at CMC (γCMC), as well as the antimicrobial activity in terms of minimum inhibitory concentrations (MICs), were strongly dependent on the length of the hydrocarbon chain. Particularly, the C6 and C10 derivatives have a good ability to decrease surface tension (γCMC <40 mN/m) at low concentrations (CMC < 12 mM) and a satisfactory antibacterial effect (MIC values between 0.230 and 0.012 mM against S. aureus strains and between 0.910 and 0.190 against P.aeruginosa strains). Interestingly, these compounds showed a disinfectant activity at the tested concentrations that was comparable to that of the reference compound chlorhexidine digluconate. All these results support the possible use of these amphiphilic compounds as antibacterial agents and disinfectants in pharmaceutical or cosmetic formulations.

Anti-corrosive non-aqueous DBSA/MEA lamellar liquid crystal lubrication system

HYPOTHESIS

Since lamellar liquid crystals (LLCS) could be used for lubrication, many LLCS systems have been constructed to improve lubrication performance. However, most studies focused on the LLCS of the water system, and its corrosiveness brought some limitations to its application. Therefore, it is necessary to construct a non-aqueous LLCS system with good lubrication and anti-corrosion properties to improve its applicability.

EXPERIMENTS

Anionic surfactant dodecyl benzene sulfonic acid (DBSA) was used to construct non-aqueous LLCS in different solvents, including monoethanolamine (MEA) and diethanolamine (DEA). DBSA/H₂O LLCS system was constructed for comparison. The LLCS was characterized by polarizing microscope (POM), small-angle X-ray scattering (SAXS), and rheology. Its microstructure was discussed. Meanwhile, we evaluated the lubrication and anti-corrosion performance of LLCS. Its lubrication mechanism was explained through tribology tests and X-ray photoelectron spectrometer (XPS) analysis of the wear scar surface. Its anti-corrosion mechanism was investigated by using the weightlessness method, electrochemical test method, and quantum chemical theoretical calculations.

FINDINGS

The DBSA/MEA non-aqueous LLCS system showed better lubrication performance than DBSA/DEA and DBSA/H₂O LLCS. It can adsorb on the surface of the friction pair to form a lubrication friction film, which plays a better role in reducing friction and wear. The DBSA/MEA LLCS is less corrosive to metals because it can effectively isolate oxygen and water in the air between friction pairs. Furthermore, the lone pair electrons in the 2p orbital of the N atom in the MEA molecule could coordinate with the 3d empty orbital of the Fe atom, forming a protective film on the metal surface, which plays a good anti-corrosion effect. This work not only enriched the study of non-aqueous LLCS but also expanded its potential applications in the field of lubrication.

Unusual Increasing Viscoelasticity of Wormlike Micelles Composed of Imidazolium Gemini Surfactants with Temperature

The viscoelasticity of wormlike micelles composed of ionic surfactants typically shows an exponential decrease with increasing temperature, which limits their application in relatively high-temperature (>90.0 °C) oilfields and the synthesis of functional materials as supramolecular templates at high temperatures. In this work, a series of imidazolium gemini surfactants, 1,9-(ethane-1,2-diyl)bis(3-alkyl-1H-imidazol-3-ium) bromide ([C_n-2-C_nim]Br₂, n = 12, 14, 16, 18, 20), were synthesized. Their surface activities and aggregation behaviors in water were studied by electrical conductivity, rheology, polarization optical microscopy, small-angle X-ray scattering, ζ potential, and hydrogen nuclear magnetic resonance measurements. [C₁₂-2-C₁₂im]Br₂ and [C₁₄-2-C₁₄im]Br₂ mainly precipitate in water. [C_n-2-C_nim]Br₂ (n = 16, 18, 20) forms lamellar liquid crystals over a large range of concentrations at low temperatures. With the increase of temperature, the lamellar liquid crystals transit to wormlike micelles. Interestingly, the viscoelasticity of the three wormlike micelles first increases to the maximum and then decreases with increasing temperature. These wormlike micelles without additives retain high viscoelasticity up to 90.0 °C or above. With the increase of the alkyl chain length of the surfactants, the transition temperature of lamellar liquid crystal to wormlike micelles and the disintegration temperature of wormlike micelles increase. The unusual increase of the viscoelasticity of wormlike micelles was due to the desorption of weakly bound counterions and the extension of the long hydrophobic chains of surfactants at high temperatures.

New insight into enhanced transport of multi-component porous covalent-organic polymers with alkyl chains as injection agents for levofloxacin removal in saturated sand columns

Levofloxacin (LEV) is prone to be retained in aquifers due to its strong adsorption affinity onto sand, thus posing a threat to groundwater quality. In-situ injection technology for remediating LEV-contaminated soil and groundwater is still challenging owing to the lack of appropriate remedial agents. Herein, two novel multi-component porous covalent-organic polymers (namely, SLEL-1 and SLEL-2) with alkyl chains were constructed through Schiff-base reactions to adsorb LEV from an aqueous solution, in which the kinetics, isotherms, influenced factors were investigated. Plausible adsorption mechanisms were proposed through characterization and experimental analysis, including pore filling effect, π-π electron-donor-acceptor (EDA) interaction, hydrogen bonding force, hydrophobic-hydrophobic interaction as well as electrostatic force. In addition, response surface methodology (RSM) revealed the treatment optimization and reciprocal relationship within multi-variables. Furthermore, taking advantage of favorable dispersion and outstanding competitive behavior, SLEL-1 was established as an in-situ adsorptive agent in dynamic saturated columns on a laboratory scale to investigate the removal of LEV from water-bearing stratum. Overall, the findings of this work provided an insight into the fabrication of SLELs as long-term mobile and reusable adsorptive agents for practical in-situ applications in the future.

Influencing the froth flotation of LiAlO2 and melilite solid solution with ionic liquids

In the present work experiments for single mineral flotation against LiAlO₂ and melilite s.s. were carried out for seven ionic liquids (ILs). From these, IL-1 with an imidazolium cation and a bromide anion and IL-7 with a pyridinium cation and a bromide anion were selected for further flotation experiments (dosage, pH). Flotation experiments were also conducted using naphthenic acid, a conventional flotation fatty acid-based collector, and FS-2, a commercial collector in order to compare the results with ILs. Moreover, the effects of different anions in the ILs on the flotation were evaluated and a significant influence on the hardness of anions was found on the flotation process. Finally, a pre-functionalization was also explored with modified cholesterol derivatives, comparing the effect of cholesterylsulfate and cholesterylphosphate on the flotation of LiAlO₂ and melilite s.s. This study is vital for the further optimization of lithium recovery from the pyrometallurgical recycling path of lithium-ion batteries and the flotation of primary minerals such as aluminosilicates.

Brij 30 Induced Transition of Rodlike Micelles to Wormlike Micelles and Gels in the Imidazole Ionic Liquid Surfactants: The Alkyl Chain Length Effect

The effect of the hydrocarbon chain length of ionic liquid surfactants 1-hexadecyl-3-alkyl imidazolium bromide [C₁₆imC_n]Br (n = 1-16) on their aggregation behavior with polyoxyethylene lauryl ether (Brij 30) in aqueous solution was inspected. The rheological behavior, thermal properties, and microstructures of the different samples were studied using freeze-fractured electron microscopy. The interactions between [C₁₆imC_n]Br and Brij 30 were studied using nuclear magnetic resonance spectroscopy and theoretical simulation. With the addition of Brij 30, the rodlike micelles of [C₁₆imC_n]Br (n = 1, 2, 4, and 6) transition into wormlike micelles. The effects of the molar ratio of Brij 30 and [C₁₆imC_n]Br and the hydrocarbon chain length of [C₁₆imC_n]Br on the Brij 30/[C₁₆imC_n]Br (n = 1, 2, 4, and 6) wormlike micelles were studied. When Brij 30 was mixed with the rodlike micelles of [C₁₆imC₈]Br, the Brij 30/[C₁₆imC₈]Br mixtures form wormlike micelles at low Brij 30 concentration and gels at high Brij 30 concentration. The [C₁₆imC_n]Br (n = 10, 12, 14, and 16) rodlike micelles were induced by Brij 30 to turn into the Brij 30/[C₁₆imC_n]Br gels. The effect of the [C₁₆imC_n]Br hydrocarbon chain length on their rodlike micelles with the addition of Brij 30 is also theoretically discussed.

Geometry transformation of ionic surfactants and adsorption behavior on water/n-decane-interface: calculation by molecular dynamics simulation and DFT study

Understanding the effect of surfactant structure on their ability to modify interfacial properties is of great scientific and industrial interest. In this work, we have synthesized four amide based ionic surfactants under acidic or basic conditions, including CTHA·HCl, CTEA·HCl, CTHA⁻Na⁺ and CTEA⁻Na⁺. Experiments have proved that the anionic surfactant with polyethylene oxide groups (CTEA⁻Na⁺) had the lowest surface tension on the water/n-decane interface. Molecular dynamics simulations have been applied to investigate the structural effect on the adsorption behavior of four different surfactants. The surface tension, interface thickness, interface formation energy, density profiles, order parameters, radial distribution function on the water/n-decane interfaces were calculated and compared. During the equilibrium states, we found that the interface configuration of two cationic surfactants are almost linear while the two anionic surfactants are changed to bending shapes due to the different positions of the hydrophilic head groups. Further DFT study and wavefunction analysis of surfactants have shown that CTEA⁻Na⁺ can form stronger vdW interactions with n-decane molecules due to a more neutral electrostatic potential distribution. Meanwhile, the introduction of polyethylene oxide groups has offered more H-bonding sites and resulted in more concentrated H-bonding interactions with water molecules. The difference of weak interactions may contribute to the conformational change and finally affect the interface properties of these ionic surfactants.

The difference of weak interactions may contribute to the conformational change and finally affect the interface properties of these ionic surfactants.

The wormlike micelles formed using an ionic liquid surfactant and polar organic solvents at low temperature without additives and their lubricant properties

Wormlike micelles (or reverse wormlike micelles) are flexible cylindrical chains that are normally formed in water (or a nonpolar organic solvent) at 25.0 °C or above; the formation of wormlike micelles at lower temperatures is rare. Here, we have reported wormlike micelles formed at low temperature using an ionic liquid surfactant (1-octadecyl-3-nonyl imidazolium bromide) in polar organic solvents (including 1,3-propanediol, 1,2-propylene glycol, N,N-dimethylformamide, and glycerol/1,2-propylene glycol mixture) in the absence of any additives. The viscoelasticity and morphology of the wormlike micelles were studied using rheology, small-angle X-ray scattering, and cryo-transmission electron microscopy. The viscoelastic properties of the wormlike micelles in polar solvents are affected by the solvent type (or the weight ratio of glycerol to 1,2-propylene glycol), surfactant concentration, and temperature. Moreover, the G' and G'' crossover twice in the dynamic curves, which is different from the case in water. The first crossover (at low frequency) corresponds to the relaxation time for the alkyl chains to disentangle from the transient network, and the second crossover (at high frequency) is related to the segmental motion of the chains. Furthermore, the tribological performance of these wormlike micelles is investigated at low temperature. It is found that the protective film (formed by the physical adhesion of the wormlike micelles on the surface of friction disk pair) and the tribochemical reaction together lead to good antifriction and antiwear performance, which indicates the application prospects of these wormlike micelles in low-temperature lubrication.