Filter paper supported nZVI for continuous treatment of simulated dyeing wastewater

Biosynthesis of silver nanoparticles using tea leaf extract (camellia sinensis) for photocatalyst and antibacterial effect

Silver nanoparticles (C. AgNPs) are synthesized by the biological reduction method using extracts from green tea leaves (Camellia Sinensis) collected from tea hills at an altitude of 100 m above the ground. The chemicals present in the tea leaf extract act as reducing agents used to reduce Ag+ ions to silver atoms to form C. AgNPs in the solution. In this work, we optimized the C. AgNPs synthesis process by investigating the influence of reaction parameters such as concentration of tea leaf extract (1 ppm-50 ppm), reaction temperature (30 °C-60 °C), reaction time (5 min-100 min), and reaction rate (400 rpm-800 rpm) through absorption UV-Vis spectroscopy, TEM transmission electron microscopy, and spectroscopy X-ray. Organic compounds in tea leaf extract are detected by NMR measurement. The functional groups on the C. AgNPs are shown on the Fourier transform infrared (FTIR) spectrum. The C. AgNPs are used to degrade MB dye at 10 ppm concentration based on the photocatalytic effect using a 6500 K white light source. The C. AgNPs have also been studied for their antibacterial activity on two bacteria, Pseudomonas aeruginosa (P.A) and Staphylococcus aureus (S.A), while a positive control is Ampicillin 50 mg/ml and a negative control is H2O. The results reveal that the C. AgNPs with diameters in the range of 25 nm-55 nm degrade 10 ppm MB dye after 1 h with photodegradation efficiency up to 96 %. The antibacterial ability of C. AgNPs against both bacteria is good, even superior to that of Ampicillin. Furthermore, the particle synthesis efficiency and therefore the antibacterial activity as well as the photodegradation effect of C. AgNPs are higher than previously reported. At the same time, using green tea leaf extract to synthesize C. AgNPs creates environmentally friendly products. These useful behaviors are the potential to increase the scope and applicability of C. AgNPs, especially for biomedical applications in the near future.

Review on the degradation of chlorinated hydrocarbons by persulfate activated with zero-valent iron-based materials

Chlorinated hydrocarbons (CHCs) are often used in industrial processes, and they have been found in groundwater with increasing frequency in recent years. Several typical CHCs, including trichloroethylene (TCE), 1,1,1-trichloroethane (TCA), carbon tetrachloride (CT), etc., have strong cytotoxicity and carcinogenicity, posing a serious threat to human health and ecological environment. Advanced persulfate (PS) oxidation technology based on nano zero-valent iron (nZVI) has become a research hotspot for CHCs degradation in recent years. However, nZVI is easily oxidized to form the surface passivation layer and prone to aggregation in practical application, which significantly reduces the activation efficiency of PS. In order to solve this problem, various nZVI modification solutions have been proposed. This review systematically summarizes four commonly used modification methods of nZVI, and the theoretical mechanisms of PS activated by primitive and modified nZVI. Besides, the influencing factors in the engineering application process are discussed. In addition, the controversial views on which of the two (SO₄·^- and ·OH) is dominant in the nZVI/PS system are summarized. Generally, SO₄·^- predominates in acidic conditions while ·OH prefers neutral and alkaline environments. Finally, challenges and prospects for practical application of CHCs removal by nZVI-based materials activating PS are also analyzed.

Removal of Hexavalent Chromium in Aqueous Solution by Cellulose Filter Paper Loaded with Nano-Zero-Valent Iron: Performance Investigation and Numerical Modeling

Cr(VI) pollution in water bodies is very harmful to human health and the environment. Therefore, it is necessary to remove Cr(VI) from water. In this study, the composite (FP-nZVI) was prepared by loading nano-zero-valent iron (nZVI) onto cellulose filter paper (FP) using a liquid-phase reduction method to improve the dispersibility and oxidation resistance of nZVI. In batch experiments, the effects of iron loading of FP-nZVI, initial concentration of Cr(VI), temperature, and pH on Cr(VI) removal were particularly investigated. The maximum removal rate of 98.6% was achieved at 25 °C, pH = 5, initial concentration of Cr(VI) of 20 mg/L, and FeCl3·6H2O solution concentration of 0.8 mol/L. The removal of Cr(VI) by FP-nZVI conformed to a pseudo-second-order kinetic model and Langmuir isotherm model. The mechanism of Cr(VI) removal was a multi-step removal mechanism, involving adsorption, reduction, and coprecipitation. Column experiments investigated the effect of flow rate (1 mL/min, 3 mL/min, and 5 mL/min) on Cr(VI) removal. We found that increasing flow rate slightly decreased the removal rate of Cr(VI). The transport of Cr(VI) in composite porous media was simulated using HYDRUS-1D, and the results show that the two-site model can well simulate the reactive transport of Cr(VI). This study may provide a useful reference for the remediation of groundwater contaminated with Cr(VI) or other similar heavy metals using FP-nZVI.

Rapid Detection of Amitriptyline in Dried Blood and Dried Saliva Samples with Surface-Enhanced Raman Spectroscopy

There is growing demand for rapid, nondestructive detection of trace-level bioactive molecules including medicines, toxins, biomolecules, and single cells, in a variety of disciplines. In recent years, surface-enhanced Raman scattering has been increasingly applied for such purposes, and this area of research is rapidly growing. Of particular interest is the detection of such compounds in dried saliva spots (DSS) and dried blood spots (DBS), often in medical scenarios, such as therapeutic drug monitoring (TDM) and disease diagnosis. Such samples are usually analyzed using hyphenated chromatography techniques, which are costly and time consuming. Here we present for the first time a surface-enhanced Raman spectroscopy protocol for the detection of the common antidepressant amitriptyline (AMT) on DBS and DSS using a test substrate modified with silver nanoparticles. The validated protocol is rapid and non-destructive, with a detection limit of 95 ppb, and linear range between 100 ppb and 1.75 ppm on the SERS substrate, which covers the therapeutic window of AMT in biological fluids.

Bifunctional two-dimensional copper-aluminum modified filter paper composite for efficient tetracycline removal: Synergy of adsorption and reusability by degradation

Herein, bifunctional two-dimensional copper-aluminum modified filter paper composite (2D-Cu/Al-C) was successfully prepared by simple calcination and showed ultrahigh adsorption performance and degradation potential. The adsorption removal of TC on 2D-Cu/Al-C all exceeded 92.2% under solution conditions of 10-200 mg/L TC, 100 mg/L 2D-Cu/Al-C, pH 8 and 298 K. The pseudo-second-order kinetic and Langmuir models better fitted the kinetic and isotherm data via spontaneous and exothermic process, and the maximum capacity of the 2D-Cu/Al-C was 2391.78 mg/g. Additionally, 2D-Cu/Al-C showed desired specific adsorption for TC (TC: 98.7%, norfloxacin: 5.8%, sulfamethoxazole: 2.1%, and ciprofloxacin: 1.8%) and it could effectively adsorbed TC even in the binary system (various coexisting ions or natural organic matter). After TC adsorbed on adsorbent was mineralized into CO₂ and H₂O by adding peroxydisulfate to generate high electrode potential radical in another limited systems, the 2D-Cu/Al-C still had ∼89.12% on TC removal (initial concentration of 50 mg/L) after five experimental cycles. Zeta potential, FT-IR and XPS results indicated that the multi-adsorption mechanism, including electrostatic interactions, complexation, and H-bonds, played a vital role in the fast and efficient adsorption process. Thus, the way of combining adsorption and regeneration via degradation are green, non-polluting strategy which are expected to be applied for water purification in future environmental remediation.

Modified nanoscale zero-valent iron in persulfate activation for organic pollution remediation: a review

Under the action of different activators, persulfate can produce sulfate radicals (SO₄·^-) with strong oxidizing ability, which can destruct many organic compounds. Meanwhile, persulfate is widely used in groundwater and soil remediation because of its fast reaction and wide application. With the high specific surface area and reactivity of nanoscale zero-valent iron (nZVI), it can enhance the degradation efficiency of the persulfate system on organic pollutants in soil and water as a persulfate activator. However, nZVI is easy to get oxidized and has a tendency to aggregation. To solve these problems, a variety of nZVI modification methods have been put forward and put into to applications in the activation of persulfate. This article will give a systematic introduction of the background and problems of nZVI-activated persulfate in the remediation of organic pollution. In addition, the modification methods and mechanisms of nZVI are summarized, and the applications and progress of modified nZVI-activated persulfate are reviewed. The factors that affect the removal of organic compounds by the activation system are discussed as well. Worldwide, the field studies and full-scale remediation using modified nZVI in persulfate activation are yet limited. However, the already known cases reveal the good prospect of applying modified nZVI in persulfate activation to organic pollution remediation.

Impact of long-term storage of various redox-sensitive supported nanocomposites on their application in removal of dyes from wastewater: Mechanisms delineation through spectroscopic investigations

For the prevention of freshwater reservoirs from contamination through industrial effluents, eco-friendly adsorbents with minimal aging impact are required. Here, redox-sensitive nanoscale zero-valent iron(nZVI) particles were supported on four different surfaces with varying bentonite(B)/charcoal(C) ratio to mimic layered and porous surfaces. Different dyes, i.e. rhodamine-B(RB) and methylene blue(MB) were reacted with redox-sensitive supported nZVI composites, and degradation mechanisms were delineated using FT-IR spectroscopic analysis of reaction precipitates. A 300-day exposure to open-air was provided to the composites to comparatively evaluate the impact of aging on their reactivity for dyes in wastewater. Results interpret that dyes removal was a combination of different interfacial chemical processes, i.e., reduction or organic degradation probably through Fenton like processes, along with sorption. These mechanisms were found to be surface dependent, i.e., nZVI on charcoal enriched porous surfaces, degrade dyes through organic degradation while on layered clay surfaces, MB gets removed through reduction with limited and slower RB removal. Nanocomposites show a minimal impact of aging with removal capacities >100 mg/g for BC-1/3-nZVI and C-nZVI for MB and 50-75 mg/g for RB with significant removal in wastewater. Overall, the study concludes C-nZVI and novel BC-1/3-nZVI as two efficient dye adsorbents with minimal aging impact.