Health risk assessment of PM2.5 on walking trips

Particle emissions from heated tobacco products

INTRODUCTION

This study determines the particle emissions from five heated tobacco products (HTPs).

METHODS

An aethalometer is used for the determination of black carbon (BC) and an aerosol monitor for total particulate matter (PM) concentration and also PM fractions (1, 2.5, 4, and 10 μm) in the mainstream emissions of 5 HTPs: IQOS, LIL, PULZE, ILUMA, and GLO. Fifteen different flavors were used, five sticks per flavor, which were smoked using a peristaltic pump under both ISO and Canadian smoking regimes. The method repeatability was determined using 15 sticks of one flavor for each brand for each smoking regime.

RESULTS

All HTPs emit particles, and more than 99.7% of the particles emitted are smaller than 1 μm. Both BC and PM emissions show quite low repeatability. Particle emissions increase in relation to the heating temperature and the intensity smoking regime, and are depending on the flavor used. BC corresponds to a small percentage of total PM.

CONCLUSIONS

Although HTPs are promoted as products of reduced risk compared to conventional cigarettes, high particle concentrations are detected in their emissions, depending on the smoking regime, the flavor used, and the operation parameters. PM emissions vary significantly between different brands under the ISO smoking regime, probably due to the heating temperature. In contrast, PM emissions under the Canadian smoking regime do not vary significantly between different brands. This could probably be attributed to the fact that increased puff frequency does not allow the device to cool down between puffs, resulting in an increase in PM emissions for all the brands, but not dependent on the maximum heating temperature of the device. BC emissions only consist of a very small fraction of PM and do not vary significantly between different brands under both smoking regimes.

Assessment of particulate matter inhalation during the trip process with the considerations of exercise load

A Particulate Matter (PM) inhalation model considering exercise load is established to evaluate the impact of PM on residents' travel health. The study chooses PM detectors to collect PM concentrations at the various transportation space, including walking, bicycle, bus, taxi, and subway. A multiple linear regression model revised by road greening is utilized to study the influence factors that have a potential impact on the PM concentration. The air inhalation model with the consideration of exercise load can be acquired by connecting the heart rate (HR) and individual characteristics. The PM_2.5 and PM₁₀ inhalation for a complete trip of traveler can be estimated using the proposed model based on air inhalation per time unit, travel time, and PM concentration. The analysis results using the experimental data in Xi'an indicate that PM concentrations in taxi carriage, bus carriage, and subway carriage are significantly different from those obtained from environmental monitoring stations. However, the difference is not significant in the locations of sidewalk, non-motorized lane, taxi station, bus station, subway concourse, and subway platform. PM concentration and humidity in background environment have a positive influence on the increase of PM concentration in transportation environment, while temperature and wind speed are negative. The mean values of air inhalation per time unit for male and female using each mode are in the range of 9.6-26.8 L/min and 9.8-27.8 L/min, respectively. Exposure time in non-motorized transportation has a large effect on PM inhalation of travelers, walking connections and waiting in motorized transportation are the main contributing states to PM inhalation of travelers. The results of the study can be used to predict travelers' PM inhalation in completed trips, and provide recommendations for travelers to choose a healthier mode.

Characteristics and health effects of particulate matter emitted from a waste sorting plant

Solid waste components can be recycled in waste paper and cardboard sorting plants (WPCSP) through a multistep process. This work collected 15 samples every six days from each of the 9 points selected to study the processes taking place in a WPCSP (135 particulate matter samples total). Examining the concentration and size fraction of particulate matter (i.e., PM₁, PM_2.5 and PM₁₀) in WPCSP is an essential issue to notify policy makers about the health impacts on exposed workers. The major activities for increasing of the concentration of PM in various processing units in the WPCSP, especially in hand-picking routes I and II were related to manual dismantling, mechanical grinding, mechanical agitation, and separation and movement of waste. The results of this work showed that a negative correlation between temperature and particulate matter size followed the order PM₁₀ > PM_2.5 > PM₁. Exposure to PM_2.5 and PM₁₀ in the WPCSP lead to possible risk (HI = 5.561 and LTCRs = 3.41 × 10^-6 to 9.43 × 10^-5 for PM_2.5 and HI = 7.454 for PM₁₀). The exposure duration and the previous concentrations had the most effect on the ILCRs and HQs for PM_2.5 and PM₁₀ in all sampling sites. Hence, because WPCSP are infected indoor environments (I/O ratio > 1), the use of control methods such as isolation of units, misting systems, blower systems equipped with bag houses, protective equipment, a mechanical ventilation system, and additional natural ventilation can reduce the amount of suspended PM, enhance worker safety, and increase the recycling rate.

Serological reactivity of inactivated SARS-CoV-2 vaccine based on an S-RBD neutralizing antibody assay

OBJECTIVES

This study aimed to explore the regularity of S-RBD domain antibody reactivity after immunization with inactivated SARS-CoV-2 vaccine and evaluate the effect of this vaccine on the immune response.

DESIGN OR METHODS

Venous blood samples were collected from 1156 healthcare workers who participated in the phase III clinical trial of the SARS-CoV-2 inactivated vaccine. The S-RBD domain antibody levels in the serum were detected by ELISA 14 days after the first and second active immunization, respectively.

RESULTS

The positive rates after inoculation of the first and second vaccination of S-RBD domain antibody against SARS-CoV-2 were 28.03% and 86.76%, respectively. The mean inhibition rate of S-RBD domain antibody against positive samples was 57.18 ± 18.87% after the second vaccination at 14 days. Sex and age had no effects on the positive rate. The positive rate was decreased in the high BMI group. Single-factor logistic analysis showed that there was no significant correlation between age and positive rate. BMI was negatively correlated with the positive rate.

CONCLUSIONS

After 2 immunizations, the positive rate of SARS-CoV-2 S-RBD domain antibody was high, and the vaccine had good immunogenicity. The improvement of the immune strategy should focus on the effects of BMI and other factors.

Diesel-derived PM2.5 induces impairment of cardiac movement followed by mitochondria dysfunction in cardiomyocytes

Particulate matter (PM) in polluted air can be exposed to the human body through inhalation, ingestion, and skin contact, accumulating in various organs throughout the body. Organ accumulation of PM is a growing health concern, particularly in the cardiovascular system. PM emissions are formed in the air by solid particles, liquid droplets, and fuel - particularly diesel - combustion. PM_2.5 (size < 2.5 μm particle) is a major risk factor for approximately 200,000 premature deaths annually caused by air pollution. This study assessed the deleterious effects of diesel-derived PM_2.5 exposure in HL-1 mouse cardiomyocyte cell lines. The PM_2.5-induced biological changes, including ultrastructure, intracellular reactive oxygen species (ROS) generation, viability, and intracellular ATP levels, were analyzed. Moreover, we analyzed changes in transcriptomics using RNA sequencing and metabolomics using gas chromatography-tandem mass spectrometry (GC-MS/MS) and liquid chromatography-tandem mass spectrometry (LC-MS/MS) in PM_2.5-treated HL-1 cells. Ultrastructural analysis using transmission electron microscopy revealed disruption of mitochondrial cristae structures in a PM_2.5 dose-dependent manner. The elevation of ROS levels and reduction in cell viability and ATP levels were similarly observed in a PM_2.5 dose-dependently. In addition, 6,005 genes were differentially expressed (fold change cut-off ± 4) from a total of 45,777 identified genes, and 20 amino acids (AAs) were differentially expressed (fold change cut-off ± 1.2) from a total of 28 identified AAs profiles. Using bioinformatic analysis with ingenuity pathway analysis (IPA) software, we found that the changes in the transcriptome and metabolome are highly related to changes in biological functions, including homeostasis of Ca²⁺, depolarization of mitochondria, the function of mitochondria, synthesis of ATP, and cardiomyopathy. Moreover, an integrated single omics network was constructed by combining the transcriptome and the metabolome. In silico prediction analysis with IPA predicted that upregulation of mitochondria depolarization, ROS generation, cardiomyopathy, suppression of Ca²⁺ homeostasis, mitochondrial function, and ATP synthesis occurred in PM_2.5-treated HL-1 cells. In particular, the cardiac movement of HL-1 was significantly reduced after PM_2.5 treatment. In conclusion, our results assessed the harmful effects of PM_2.5 on mitochondrial function and analyzed the biological changes related to cardiac movement, which is potentially associated with cardiovascular diseases.