Acetic Acid Adsorption and Reactions on Ni(110)

Acetic acid adsorption and reactions at multiple surface coverage values on Ni(110) were studied with temperature-programmed desorption (TPD) and infrared reflection absorption spectroscopy (IRAS) at 90-500 K. The experimental measurements were interpreted with density functional theory (DFT) calculations that provided information on adsorbate geometries, energies, and vibrational modes. Below the monolayer saturation coverage of 0.36 ML at 90 K, acetic acid adsorbs mostly molecularly. Above this coverage, a physisorbed layer is formed with dimers and catemers, without detectable monomers. Dimers and catemers desorb as molecular acetic acid at 157 and 172 K, respectively. Between 90 and 200 K, the O-H bond in acetic acid breaks to form bridge-bonded bidentate acetate that becomes the dominant surface species. Desorption-limited hydrogen evolution is observed at 265 K. However, even after the acetate formation, acetic acid desorbs molecularly at 200-300 K due to recombination. Minor surface species observed at 200 K, acetyls or acetates with a carbonyl group, decompose below 350 K and generate adsorbed carbon monoxide. At 350 K, the surface likely undergoes restructuring, the extent of which increases with acetic acid coverage. The initial dominant bridge-bonded bidentate acetate species formed below 200 K remain on the surface, but they now mostly adsorb on the restructured sites. The acetates and all other remaining hydrocarbon species decompose simultaneously at 425 K in a narrow temperature range with concurrent evolution of hydrogen, carbon monoxide, and carbon dioxide. Above 425 K, only carbon remains on the surface.

Interaction of alkali acetates with silica supported PdAu

The temperature dependence of the interaction of PdAu alloy particles with alkali acetate promoters (MOAc; M⁺ = Li⁺, Na⁺, K⁺, Cs⁺) was studied by X-ray absorption and infrared spectroscopy as well as in situ X-ray diffraction.

Probing enantioselectivity on chirally modified Cu(110), Cu(100), and Cu(111) surfaces

Temperature programmed desorption methods have been used to probe the enantioselectivity of achiral Cu(100), Cu(110), and Cu(111) single crystal surfaces modified by chiral organic molecules including amino acids, alcohols, alkoxides, and amino-alcohols. The following combinations of chiral probes and chiral modifiers on Cu surfaces were included in this study: propylene oxide (PO) on L-alanine modified Cu(110), PO on L-alaninol modified Cu(111), PO on 2-butanol modified Cu(111), PO on 2-butoxide modified Cu(100), PO on 2-butoxide modified Cu(111), R-3-methylcyclohexanone (R-3-MCHO) on 2-butoxide modified Cu(100), and R-3-MCHO on 2-butoxide modified Cu(111). In contrast with the fact that these and other chiral probe/modifier systems have exhibited enantioselectivity on Pd(111) and Pt(111) surfaces, none of these probe/modifier/Cu systems exhibit enantioselectivity at either low or high modifier coverages. The nature of the underlying substrate plays a significant role in the mechanism of hydrogen-bonding interactions and could be critical to observing enantioselectivity. While hydrogen-bonding interactions between modifier and probe molecule are believed to induce enantioselectivity on Pd surfaces (Gao, F.; Wang, Y.; Burkholder, L.; Tysoe, W. T. J. Am. Chem. Soc. 2007, 129, 15240-15249), such critical interactions may be missing on Cu surfaces where hydrogen-bonding interactions are believed to occur between adjacent modifier molecules, enabling them to form clusters or islands.