Synthesis and enhanced fluorescence of Ag doped CdTe semiconductor quantum dots

Strong coupling of hybrid states of light and matter in cavity-coupled quantum dot solids

The formation of plasmon-exciton (plexciton) polariton is a direct consequence of strong light-matter interaction, and it happens in a semiconductor-metal hybrid system. Here the formation of plasmon-exciton polaritons was observed from an AgTe/CdTe Quantum Dot (QD) solid system in the strong coupling regime. The strong coupling was achieved by increasing the oscillator strength of the excitons by forming coupled QD solids. The anti-crossing-like behaviour indicates the strong coupling between plasmonic and excitons state in AgTe/CdTe QD solids, resulting in a maximum Rabi splitting value of 225 meV at room temperature. The formation of this hybrid state of matter and its dynamics were studied through absorption, photoluminescence, and femtosecond transient studies.

Molecularly imprinted polymers-isolated AuNP-enhanced CdTe QD fluorescence sensor for selective and sensitive oxytetracycline detection in real water samples

A molecularly imprinted polymers (MIPs)-isolated AuNP-enhanced fluorescence sensor, AuNP@MIPs-CdTe QDs, was developed for highly sensitive and selective detection of oxytetracycline (OTC) in aqueous medium. The developed sensor combined the advantages of strong fluorescence signal of metal-enhanced fluorescence (MEF), high selectivity of MIPs, and stability of CdTe QDs. The MIPs shell with specific recognition served as an isolation layer to adjust the distance between AuNP and CdTe QDs to optimize the MEF system. The sensor demonstrated the detection limit as low as 5.22 nM (2.40 μg/L) for a concentration range of 0.1-3.0 μM OTC and good recovery rates of 96.0-103.0% in real water samples. In addition, high specificity recognition for OTC over its analogs was achieved with an imprinting factor of 6.10. Molecular dynamics (MD) simulation was utilized to simulate the polymerization process of MIPs and revealed H-bond formation as the mainly binding sites of APTES and OTC, and finite-difference time-domain (FDTD) analysis was employed to obtain the distribution of electromagnetic field (EM) for AuNP@MIPs-CdTe QDs. The experimental results combined with theoretical analyses not only provided a novel MIP-isolated MEF sensor with excellent detection performance for OTC but also established a theoretical basis for the development of a new generation of sensors.

Heterogeneity in Cation Exchange Ag+ Doping of CdSe Nanocrystals

Cation exchange is becoming extensively used for nanocrystal (NC) doping in order to produce NCs with unique optical and electronic properties. However, despite its ever-increasing use, the relationships between the cation exchange process, its doped NC products, and the resulting NC photophysics are not well characterized. For example, similar doping procedures on NCs with the same chemical compositions have resulted in quite different photophysics. Through a detailed single molecule investigation of a postsynthesis Ag+ doping of CdSe NCs, a number of species were identified within a single doped NC sample, suggesting the differences in the optical properties of the various synthesis methods are due to the varied contributions of each species. Electrostatic force microscopy (EFM), electron energy loss spectroscopy (EELS) mapping, and single molecule photoluminescence (PL) studies were used to identify four possible species resulting from the Ag+-CdSe cation exchange doping process. The heterogeneity of these samples shows the difficulty in controlling a postsynthesis cation exchange method to produce homogeneous samples needed for use in any potential application. Additionally, the heterogeneity in the doped samples demonstrates that significant care must be taken in describing the ensemble or average characteristics of the sample.

Synthesis and Characterization of CdTe QDs Capped with Branched 3MB3MP Ligand and Fluorescent Switching Detection of H2O2

Owing to the possibility for modification with various multifunctional ligand groups , and thereby attaining selective and sensitive detection; water soluble quantum dots (QDs) always attract scientific attention, in the...

Detection of Hg2+ by a Dual-Fluorescence Ratio Probe Constructed with Rare-Earth-Element-Doped Cadmium Telluride Quantum Dots and Fluorescent Carbon Dots

Quantum dots (QDs) and carbon quantum dots (CDs) are classes of zero-dimensional materials whose sizes can be ≤10 nm. They exhibit excellent optical properties and are widely used to prepare fluorescent probes for qualitative and quantitative detection of test objects. In this article, we used cerium chloride as the cerium source and used the in situ doped cerium (rare-earth element) to develop cadmium telluride (CdTe) quantum dots following the aqueous phase method. CdTe: Ce quantum dots were successfully synthesized. The solution of CdTe:Ce QDs was mixed with the CD solution prepared following the green microwave method to form a ratio fluorescence sensor that can be potentially used for the selective detection of mercury ions (Hg²⁺). We used transmission electron microscopy, X-ray photoelectron spectroscopy, X-ray diffraction, and other microscopy and spectral characterization techniques to validate that Ce had been successfully doped. The test results on the fluorescence performance revealed that Ce doping enhances the predoped fluorescence performance of the CdTe QDs. We have quantitatively detected Hg²⁺ using a ratiometric fluorescence sensor to show that in the range of 10-60 nM, the fluorescence quenching efficiency increases linearly with the increase in Hg²⁺ concentration. The linear correlation coefficient R ² = 0.9978, and its detection limit was found to be 2.63 nM L^-1. It was observed that other interfering ions do not significantly affect the fluorescence intensity of the probe. According to the results of the blank addition experiment, the developed proportional fluorescence probe can be used for the detection of Hg²⁺ in actual samples.

Silver ion-doped CdTe quantum dots as fluorescent probe for Hg2+ detection

Mercury(ii), which is a well-known toxic species, exists in the industrial waste water in many cases. In the present work, CdTe quantum dots (QDs) are studied as a fluorescence probe for Hg²⁺ detection. Ag ions are induced to QDs to enlarge their detection concentration range. l-cysteine is employed in the QD-based fluorescence probe to connect QDs with Hg²⁺. X-ray diffraction, transmission electron microscopy and X-ray photoelectron spectroscopy results indicate the formation of zinc blende CdTe QDs with sizes of ∼5 nm and the existence of Ag⁺ in crystalline CdTe. Photoluminescence (PL) spectra and PL decay spectra were acquired to investigate the emission mechanism of Ag-doped CdTe QDs, revealing multi-emission in QD samples with higher concentrations of Ag⁺ doping. The highest PL quantum yield of the QD samples was 59.4%. Furthermore, the relationship between the fluorescence intensity and the concentration of Hg²⁺ has been established. Two linear relationships were obtained for the plot of F/F₀ against Hg²⁺ concentration, enlarging the detection concentration range of Hg²⁺.

Ag-doped CdTe QDs emit multiple-fluorescence peaks, and the relationship between fluorescence intensity and the concentration of Hg²⁺ is established. Two linear relationships are obtained, which is benefit to the extension of detection range.

The design of Mn2+&Co2+ co-doped CdTe quantum dot sensitized solar cells with much higher efficiency

High quality Mn2+-doped CdTe quantum dots (QDs), Co2+-doped CdTe QDs and Mn2+&Co2+ co-doped CdTe QDs were successfully synthesized via an aqueous phase method with mercaptopropanoic acid (MPA) ligands. The doped QDs maintain the same zinc blende structure of CdTe by X-ray diffraction (XRD). The Mn2+-doped CdTe QDs and Co2+-doped CdTe QDs both show a red-shift on absorption and photoluminescence (PL) spectra compared to pure CdTe QDs. In addition, Mn2+-doped CdTe QDs show a significant increase in the PL lifetime due to an orbitally forbidden d-d transition, which is of benefit to the reduction of electron recombination loss. Co2+ doping has a more matched doping energy level. In view of this, Mn2+&Co2+ co-doped CdTe QDs were applied as sensitizers for quantum dot sensitized solar cells, resulting in a significantly enhanced efficiency.

Development of a portable device for Ag+ sensing using CdTe QDs as fluorescence probe via an electron transfer process

Ag⁺ as one of the most commonly seen toxic heavy metal ions is involved in numerous vital biological processes, which would cause fatal damages and environmental contamination when Ag⁺ is excessive. In the present work, CdTe quantum dots (QDs) with green, orange, and red emission capped by mercaptoacetic acid (TGA) were synthesized at one time by controlling the synthesis time and utilized for Ag⁺ detection. Both fluorescence spectral red-shift and intensity decrease could be used for Ag⁺ discrimination. Fluorescence lifetime, Zeta potential, and XRD, etc. were carried out to analyze the detection mechanism. Results displayed that surface passivation and electron transfer due to binding effects of Ag⁺ to Te atom on traps of QDs could be relied on to explain the sensing mechanism. Additionally, in accordance with PCA analysis, Ag⁺ could be also be successfully differentiated from Hg²⁺ and the other metal ions. Importantly, a home-made portable device based on a 32 bit embed Micro Control Unit (MCU) system was first proposed for Ag⁺ detection. The power supply system adopt the mini-sized lithium cell instead of the power supply system, which ensure its practical applicability. The relative position of light source and detector is set at 90° to minimize the interference. According to the detection results, the linear detection range using the device was from 5 nM to 200 nM (with a larger coefficient of determination, R²), and the detection limit was calculated to be about 5 nM, which indicated that this proposed method and device could fulfil the practical application requirements.

One-pot synthesis of GSH-Capped CdTe quantum dots with excellent biocompatibility for direct cell imaging

In this work, we have developed one-pot aqueous synthesis of glutathione (GSH) binding CdTe quantum dots (QDs) for cell imaging. UV-Vis absorption spectrum, Fourier transform infrared spectrum, photoluminescence spectrum, and high-resolution transmission electron microscopy are applied to characterize the physical and chemical properties of the nanocomposites. The bioimaging efficiency of the GSH-capped CdTe QDs is further evaluated on Hela cells. The groups on the surface of QDs are able to bind to basic proteins, which are abundant in cell nuclei, enabling the application of QDs for direct cell imaging. Experimental results also indicate the GSH layer on the surface of QDs is able to reduce the cytotoxicity significantly. In conclusion, the as-prepared GSH-capped QDs are highly promising fluorescent probes for cell imaging in the near future.

Emerging tellurium nanostructures: controllable synthesis and their applications

Tellurium (Te) is a rare element in trace amounts of about one part per billion, comparable to that of platinum and ranked 75th in the abundance of the elements in the earth crust. Te nanostructures, as narrow bandgap semiconductors, have numerous potential applications in the fabrication of many modern devices. The past decades have witnessed an explosion in new strategies for synthesizing diverse emerging Te nanostructures with controlled compositions, sizes, shapes, and structures. Their structure-determined nature makes functional Te nanomaterials an attractive candidate for modern applications. This review focuses on the synthesis and morphology control of emerging Te nanostructures and summarizes the latest developments in the applications of Te nanostructures, such as their use as chemical transformation templates to access a huge family of nanowires/nanotubes, batteries, photodetectors, ion detection and removal, element doping, piezoelectric energy harvesting, gas sensing, thermoelectric devices and many other device applications. Various Te nanostructures with different shapes and structures will exploit the beneficial properties associated with their assembly process and nanofabrication. Finally, the prospects for future applications of Te nanomaterials are summarized and highlighted.

Construction of Ag-doped Zn–In–S quantum dots toward white LEDs and 3D luminescent patterning

The synthesis of green photoluminescent Ag-doped Zn–In–S quantum dots and their applications in patterning and white LEDs are reported.