CuFeS2 supported on dendritic mesoporous silica-titania for persulfate-assisted degradation of sulfamethoxazole under visible light

Sulfamethoxazole (SMX) is a prevalent sulfonamide antibiotic found in the environment, and it has a variety of detrimental effects on environmental sustainability and water safety. Recently, the combination of photocatalysis and sulfate radical-based advanced oxidation processes (SR-AOPs) has attracted a lot of interest as a viable technique for degradation of refractory pollutants. In this study, a visible light active CuFeS2 supported on dendritic mesoporous silica-titania (CuFeS2-DMST) photocatalyst was synthesized to improve the ability of TiO2 to activate persulfate (PS) by introducing CuFeS2 (Fe2+/Fe3+, Cu+/Cu2+ redox cycles). The CuFeS2-DMST/PS/Vis system demonstrated superior SMX degradation efficiency (88.9%, 0.0146 min-1) than TiO2 because of reduced e-/h+ recombination, excellent charge separation and mobility, and a greater surface area than TiO2. Furthermore, after four consecutive photocatalytic cycles, the system demonstrated moderate stability. From chemical quenching tests, O2●-, h+, 1O2, SO4●- and ●OH were found to be the main reactive oxidizing species. The formed intermediates during the degradation process were identified, and degradation mechanisms were proposed. This study proposes a viable technique for activating PS using a low-cost, stable, and high-surface-area TiO2-based photocatalyst, and this concept can be applied to design photocatalysts for water treatment.

Ordered mesoporous TiO2/SBA-15 confined CexWy catalysts for selective catalytic reduction of NO using NH3

The ordered mesoporous structure could improve the dispersion of nanoparticles, promote effective collision, and enhance redox capacity and surface acidity.

Dendritic fibrous nano-silica & titania (DFNST) spheres as novel cataluminescence sensing materials for the detection of diethyl ether

Selective and controllable cataluminescence (CTL) sensors for volatile organic compounds (VOCs) are significant for chemical safety, environmental monitoring, health effects on human beings, and so forth. Most of the exploited CTL-based sensors suffer relatively low response and poor selectivity because of their high sensitivities to interferential substances. In this investigation, dendritic fibrous nano-silica & titania (DFNST) spheres have been synthesized as novel sensing materials and the corresponding DFNST-based CTL sensor has been fabricated to detect diethyl ether with high selectivity via a method of utilizing one 440 nm bandpass filter. The as-prepared DFNST hybrids not only keep the excellent dendritic fibrous morphology but also bear ca. 21 wt% catalytic titanium oxide of anatase crystalline structure. The DFNST-based sensor exhibits extremely strong CTL emission at 440 nm toward diethyl ether against other VOCs like acetone, ethyl acetate, butanol, and so forth. The high response can be attributed to the unique architectural texture of DFNST. Under the optimum parameters, ether could be easily detected in a wide range from 2.0 to 40.0 mM with a fine detection limit of 1.55 mM (S/N = 3). Furthermore, the working life of this CTL sensor is satisfactory with outstanding stability and durability, far from damaging the morphology and activity of the DFNST sensing material. In conclusion, it is expected that this novel sensing material, the relevant CTL sensor, and the approach of employing the bandpass filter will be significant for the detection of diethyl ether in actual applications.

Dendritic fibrous nano-silica & titania (DFNST) nanospheres have been successfully prepared as the sensing materials for the detection of diethyl ether via a DFNST-based cataluminescence (CTL) sensor.