Iodine speciation in deep eutectic solvents

Investigation of oligomeric proanthocyanidins extracted from Rhodiolae Crenulatae Radix et Rhizomes using deep eutectic solvents and identified via data-dependent acquisition mass-spectroscopy

In this study, 34 deep eutectic solvents (DESs) were successfully prepared for the extraction of proanthocyanidin from Rhodiolae Crenulatae Radix et Rhizomes. The extraction process was optimized using single factor exploration and Box-Behnken design-response surface analysis. The extraction rate was significantly improved when the molar ratio of choline chloride to 1,3-propanediol was 1:3.5 and the water content was 30% (V/V) in DESs. AB-8 macroporous resin and ethyl acetate were used for separation and refining, and the oligomer-rich proanthocyanidin components were eventually obtained. The ultraviolet (UV) and infrared (IR) spectra showed that the proanthocyanidins were mainly composed of catechin and epicatechin. To further clarify the chemical composition of proanthocyanidin, an ion scan list containing 156 proanthocyanidins precursors was obtained by constructing a proanthocyanidins structural library and mass defect filtering (MDF) algorithm, combined with the full mass spectrometry (MS)/dd-MS2 scan mode that turns on the "if idle pick others" function. By using ultra-high performance liquid chromatography and high-resolution MS (UHPLC/HRMS), the analysis used both targeted and non-targeted methods to detect proanthocyanidins. Finally, 50 oligomeric proanthocyanidin (OPC) compounds were identified, including 7 monomers, 22 dimers, 20 trimers, and 1 tetramer, most of which were procyanidins of proanthocyanidins (84%), and a small amount of prodelphinidin (14%) and other types of proanthocyanidins (2%), which enabled the systematic characterization of proanthocyanidin components from Rhodiolae Crenulatae Radix et Rhizomes. Meanwhile, the comparison with the grape seeds OPCs standard (United States Pharmacopeia) revealed that the proanthocyanidins in Rhodiolae Crenulatae Radix et Rhizomes were more abundant, suggesting that the proanthocyanidins in Rhodiolae Crenulatae Radix et Rhizomes has promising applications.

Zinc and Lead Leaching from Sphalerite-Galena Concentrate Using Deep Eutectic Solvents Based on Choline Chloride: Effect of Roasting and Iodine as Oxidizing Agent

The traditional metallurgical routes for producing lead and zinc from primary sources have a significant environmental footprint. Thus, using less pollutant solvents, such as deep eutectic solvents (DESs), would offer a greener solution in metal extraction. This study explores the use of three DESs based on choline chloride (ChCl) (1:2 ChCl-urea, 1:2 ChCl-ethylene glycol, and 1:2 ChCl-glycerol) for recovering Zn and Pb from a sphalerite-galena concentrate of the mining region in Ecuador. Leaching tests of the concentrate (untreated and roasted at 600 °C) in each DES were conducted (30 °C-24 h). The effect of adding iodine as an oxidizing agent was also evaluated. Recoveries of 2% (Zn) and 14% (Pb) were reported when leaching the untreated concentrate with DES. These recovery values increased to 11% (Zn) and 99% (Pb) after adding iodine during the leaching of the untreated concentrate. Roasting had a similar effect on leaching, increasing the recovery values of Zn (75%) and Pb (90%). Combining roasting as a pretreatment and iodine as an oxidizing agent produced higher Zn recoveries (99%) and Pb (99%). These results were compared to recoveries in acid leaching (H2SO4 and HNO3), revealing the potential of DESs as an alternative for metal recovery from primary sources.

A case study using spectroscopy and computational modelling for Co speciation in a deep eutectic solvent

Cobalt has a vital role in the manufacturing of reliable and sustainable clean energy technologies. However, the forecasted supply deficit for cobalt is likely to reach values of 150 kT by 2030. Therefore, it is paramount to consider end-of-life devices as secondary resources for cobalt. Electrorecovery of cobalt from leached solutions has attracted attention due to the sustainability of the recovery process over solvent extraction followed by chemical precipitation. Recently, we reported Co electrorecovery from two different cobalt sources (CoCl2·6H2O and CoSO4·7H2O) using ethylene glycol : choline chloride (EG : ChCl) in a 4.5 : 1 molar ratio, leading to higher purity and easier electrodeposition when sulfate was present as an additive. Here, Co2+ speciation is reported for the two EG : ChCl systems depending on the cobalt source using several spectroscopic techniques (e.g. NMR, EPR, FTIR) in combination with molecular dynamics simulations. Monodentate coordination of SO42- to Co2+, forming the tetrahedral [CoCl3(SO4)]3- was observed as the dominant structure in the system containing CoSO4·7H2O, whereas the system comprising CoCl2·6H2O shows a homoleptic tetrahedral [CoCl4]2- as the dominant structure. This resulted in knowledge being gained regarding Co2+ speciation and the correlation with electrochemistry will contribute to the science required for designing safe electrolytes for efficient electrorecovery.

Sequential Selective Dissolution of Coinage Metals in Recyclable Ionic Media

Coinage metals Cu, Ag, and Au are essential for modern electronics and their recycling from waste materials is becoming increasingly important to guarantee the security of their supply. Designing new sustainable and selective procedures that would substitute currently used processes is crucial. Here, we describe an unprecedented approach for the sequential dissolution of single metals from Cu, Ag, and Au mixtures using biomass-derived ionic solvents and green oxidants. First, Cu can be selectively dissolved in the presence of Ag and Au with a choline chloride/urea/H2O2 mixture, followed by the dissolution of Ag in lactic acid/H2O2. Finally, the metallic Au, which is not soluble in either solution above, is dissolved in choline chloride/urea/Oxone. Subsequently, the metals were simply and quantitatively recovered from dissolutions, and the solvents were recycled and reused. The applicability of the developed approach was demonstrated by recovering metals from electronic waste substrates such as printed circuit boards, gold fingers, and solar panels. The dissolution reactions and selectivity were explored with different analytical techniques and DFT calculations. We anticipate our approach will pave a new way for the contemporary and sustainable recycling of multi-metal waste substrates.

A novel method for extracting metals from asteroids using non-aqueous deep eutectic solvents

Extra-terrestrial mining and metal processing are vital for access to strategic metals for space exploration. This study demonstrates for the first time the catalytic dissolution of metals from meteorite proxies of metal-rich asteroids using a deep eutectic solvent (DES). DESs are of particular interest for extra-terrestrial mining as they can be designed to have relatively low vapour pressures and could potentially be made from organic waste products created in extra-terrestrial settlements. Three types of meteorites were investigated: two chondrites (H3, H5) and one iron (IAB-MG) meteorite. Chondrite samples were composed of silicates (olivine, pyroxene) with metal-rich phases occurring as native metal alloys, sulphides and oxides. Metallic Fe-Ni and troilite (FeS) are the most abundant metal-bearing phases in all three samples, particularly in the iron-rich meteorite. The samples were subjected to chemical micro-etching experiments with iodine and iron(III) chloride as oxidising agents in a DES formed from the mixture of choline chloride and ethylene glycol. Micro-etching experiments demonstrated that Fe-Ni rich phases are effectively leached out in this system, while other mineral phases remain unreactive.