Dental Arch Asymmetry, Fluctuating Dental Asymmetry, and Dental Crowding: A Comparison of Tooth Position and Tooth Size Between Antimeres

Relating metric crown dimensions to underlying internal daily secretion rates in antimeric premolars

OBJECTIVES

The underlying cause for metric differences in antimeric tooth pairs is an important question for understanding dental variation. We hypothesize that localized variation in crown dimensions will be reflected in localized variation in daily enamel secretion rate.

DESIGN

Casts of pairs of human premolars from a tissue bank were 3D scanned using an optical scanning system (n = 32). Histological slides were created, and daily secretion rates (DSRs) were recorded in two areas of enamel that corresponded to scanner measurements. Antimeres were compared for both metric measurements and DSRs. Outliers for scanner measures were compared to significant differences in DSRs measurements in right and left teeth in corresponding areas.

RESULTS

Thirteen of the 16 individuals differed significantly in antimeric metric measurements, but only ten of those also differed in the underlying DSR. Fifteen of the 16 total individuals differed significantly in at least one DSR area.

DISCUSSION

While some individuals were outliers for metric measurements and had multiple areas of DSR differences, the majority of individuals had antimeric DSR differences regardless of metric differences. While there was no conclusive correlation between 3D metric analysis and underlying DSR differences, the most important result of this study is that DSR differences between antimeres are common.

Analysis of tooth anatomy in adults with ideal occlusion: A preliminary study

INTRODUCTION

The aim of this study was to investigate the vestibular anatomy of teeth in samples of adult Italian and Mozambican subjects in ideal occlusion and permanent dentition and identify any anatomic characteristics that may influence bonding in the straight-wire technique.

METHODS

Linear measurements and coordinates of each curve representing the clinical crown height and width of each tooth were acquired from digital models of each subject categorized to 1 of 2 groups: Italian (18 males, 22 females; mean age, 29.6 ± 5.7 years) or Mozambican (14 males, 15 females; mean age, 23.4 ± 5.9 years). All subjects had normal dentition and no previous orthodontic treatment, fillings, or prostheses. Method error and systematic error were calculated according to the Dahlberg formula (S² = ∑ d²/2n) and dependent Student t test (P <0.05), respectively. Tooth symmetry was investigated through a paired-samples t test (P <0.05) and sex difference via an independent-samples t test (P <0.05). After neither asymmetry nor sexual dimorphism was found, all data were pooled, inverting the signs of the X coordinates and then mirroring data. Subsequently, a 2-samples t test (P <0.05) and a multivariate cluster analysis were performed on the mirrored data to compare the 2 groups and to identify any within-group diversity for number of clusters for each tooth. Means of all linear measurements and coordinates (crown height and width) calculated for each cluster were reported and compared using a standard 2-samples t test (P <0.05).

RESULTS

Two clusters were identified for the maxillary second premolars and molars in Italian subjects, whereas in the Mozambican subjects, there were 2 clusters for the maxillary first premolars and lateral incisors and 3 clusters for the maxillary canines and central incisors. The mandibular arch was remarkably homogeneous, with only 1 cluster per tooth in each group. In the mandibular arch, statistical differences were recorded between ethnic groups in crown height at the central incisors and second molars and in crown width in the sector from the second premolar to the second molar.

CONCLUSIONS

There were considerable differences both between and within racial groups in crown height, crown width, and numbers of clusters, which should be taken into account during bonding. Although single-bracket placement guides specific for ethnicity may be feasible for the mandibular arch, the significant diversity in number of clusters in the maxillary arch indicates that more accurate bracket placement guides that take into account such heterogeneity are required.

Candidate gene analyses of 3-dimensional dentoalveolar phenotypes in subjects with malocclusion

INTRODUCTION

Genetic studies of malocclusion etiology have identified 4 deleterious mutations in genes DUSP6,ARHGAP21, FGF23, and ADAMTS1 in familial Class III cases. Although these variants may have large impacts on Class III phenotypic expression, their low frequency (<1%) makes them unlikely to explain most malocclusions. Thus, much of the genetic variation underlying the dentofacial phenotypic variation associated with malocclusion remains unknown. In this study, we evaluated associations between common genetic variations in craniofacial candidate genes and 3-dimensional dentoalveolar phenotypes in patients with malocclusion.

METHODS

Pretreatment dental casts or cone-beam computed tomographic images from 300 healthy subjects were digitized with 48 landmarks. The 3-dimensional coordinate data were submitted to a geometric morphometric approach along with principal component analysis to generate continuous phenotypes including symmetric and asymmetric components of dentoalveolar shape variation, fluctuating asymmetry, and size. The subjects were genotyped for 222 single-nucleotide polymorphisms in 82 genes/loci, and phenotpye-genotype associations were tested via multivariate linear regression.

RESULTS

Principal component analysis of symmetric variation identified 4 components that explained 68% of the total variance and depicted anteroposterior, vertical, and transverse dentoalveolar discrepancies. Suggestive associations (P < 0.05) were identified with PITX2, SNAI3, 11q22.2-q22.3, 4p16.1, ISL1, and FGF8. Principal component analysis for asymmetric variations identified 4 components that explained 51% of the total variations and captured left-to-right discrepancies resulting in midline deviations, unilateral crossbites, and ectopic eruptions. Suggestive associations were found with TBX1AJUBA, SNAI3SATB2, TP63, and 1p22.1. Fluctuating asymmetry was associated with BMP3 and LATS1. Associations for SATB2 and BMP3 with asymmetric variations remained significant after the Bonferroni correction (P <0.00022). Suggestive associations were found for centroid size, a proxy for dentoalveolar size variation with 4p16.1 and SNAI1.

CONCLUSIONS

Specific genetic pathways associated with 3-dimensional dentoalveolar phenotypic variation in malocclusions were identified.

Evaluating fluctuating asymmetry in a Brazilian population with non-syndromic cleft lip and/or palate

OBJECTIVE

The objective of this work was to analyse the levels of dermatoglyphic asymmetry between both parents and individuals with non-syndromic cleft lip and/or palate (NSCL/P) and unaffected control trios.

METHODS

A case-control analysis was carried out of 51 affected trios (unaffected parents and NSCL/P subjects), and 50 unaffected control trios. Finger and palm prints were taken from each participant, and dermatoglyphic patterns, the number of lines on the digits, and the palmar angles were recorded. To determine the level of fluctuating asymmetry the case group was compared with the control group, significance accepted at p ≤ 0.05.

RESULTS

There was a statistically significant difference between the atd angles (angle between the lines triradii a and t and triradii t and d) of fathers of those affected by NSCL/P, and the dermatoglyphic patterns of the affected mothers, with significantly more arches in the control group. However, in this study, multiple comparisons were used, and the results must be evaluated as initial findings and evaluated carefully since the significance disappears after correction for multiple comparisons. Other parameters did not differ between groups. There was no difference in parameters among patients affected by NSCL/P.

CONCLUSIONS

Based on these results it is speculated that the mechanisms responsible for the formation of NSCL/P may be associated with those responsible for deviations in the asymmetry of the atd angles in the fathers and dermatoglyphic patterns of the mothers of affected patients. Besides, further studies are required to determine the real relationship between these conditions.

Maturation of teeth adjacent to dental agenesis site

OBJECTIVE

The purpose of this study was to evaluate the developmental stage of teeth adjacent to the agenesis site in comparison to their antimeres.

MATERIALS AND METHODS

Panoramic views of 39 patients with unilateral dental agenesis and 42 normal controls were evaluated. The dental developmental stage (normal or delayed) of the teeth adjacent to the agenesis site was determined for each patient using the Haavikko's method, while the overall dental age was determined by Becker's method.

RESULTS

No statistically significant difference was found in the developmental stage of teeth adjacent to the agenesis, compared to their antimere and to the same teeth in the normal control group. However, the prevalence of cases with no difference in development was almost double for the tooth distal to the agenesis site compared to the tooth mesial to the agenesis site in the hypodontia group (84.6% distal and 43.6% mesial; p < 0.001) and in the control group (83.3% distal and 52.4% mesial; p < 0.002). In most of the cases the tooth distal to the agenesis site was the 1st permanent molar.

CONCLUSIONS

(1) No difference was found between the developmental stage of teeth adjacent to the agenesis site and their antimeres. (2) Teeth mesial to the agenesis site showed some delay in development compared to teeth distal to the agenesis site, in this study. (3) The 1st molars, which were in most of the cases the distal adjacent tooth to the site of agenesis, showed developmental stability. (4) Additional longitudinal studies are needed to examine the dental developmental pattern in patients with agenesis.