Ultrasensitive, highly selective, and real-time detection of protein using functionalized CNTs as MIP platform for FOSPR-based biosensor

Nanomaterials-based electrochemical biosensors for diagnosis of COVID-19

Since the outbreak of corona virus disease 2019 (COVID-19), this pandemic has caused severe death and infection worldwide. Owing to its strong infectivity, long incubation period, and nonspecific symptoms, the early diagnosis is essential to reduce risk of the severe illness. The electrochemical biosensor, as a fast and sensitive technique for quantitative analysis of body fluids, has been widely studied to diagnose different biomarkers caused at different infective stages of COVID-19 virus (SARS-CoV-2). Recently, many reports have proved that nanomaterials with special architectures and size effects can effectively promote the biosensing performance on the COVID-19 diagnosis, there are few comprehensive summary reports yet. Therefore, in this review, we will pay efforts on recent progress of advanced nanomaterials-facilitated electrochemical biosensors for the COVID-19 detections. The process of SARS-CoV-2 infection in humans will be briefly described, as well as summarizing the types of sensors that should be designed for different infection processes. Emphasis will be supplied to various functional nanomaterials which dominate the biosensing performance for comparison, expecting to provide a rational guidance on the material selection of biosensor construction for people. Finally, we will conclude the perspective on the design of superior nanomaterials-based biosensors facing the unknown virus in future.

Enhancement of the SPR Effect in an Optical Fiber Device Utilizing a Thin Ag Layer and a 3092A Liquid Crystal Mixture

This paper is a continuation of previous work and shows the enhancement of the surface plasmon resonance effect in a tapered optical fiber device. The study investigated liquid crystal cells containing a tapered optical fiber covered with a silver nanolayer, surrounded by a low refractive index liquid crystal in terms of the properties of light propagation in the taper structure. Silver films with a thickness of d = 10 nm were deposited on the tapered waist area. Measurements were performed at room temperature; liquid crystal steering voltage U from 0 to 200 V, with and without any amplitude modulation with a frequency of f = 5 Hz, and the wavelength λ ranged from 550 to 1200 nm. A significant influence of the initial arrangement of liquid crystals molecules on light propagation was observed. Three types of liquid crystal cells—orthogonal, parallel, and twist—were considered. During the measurements, resonant peaks were obtained—the position of which can also be controlled by the type of liquid crystal cells and the steering voltage. Based on the obtained results, the best parameters, such as highest peak’s width reduction, and the highest SNR value were received for twisted cells. In addition, the present work was compared with the previous work and showed the possibility of improving properties of the manufactured probes, and consequently, the surface plasmon resonance effect. In the presented paper, the novelty is mainly focused on the used materials as well as suitable changes in applied technological parameters. In contrast to gold, silver is characterized by different optic and dielectric properties, e.g., refractive index, extension coefficient, and permittivity, which results in changes in the light propagation and the SPR wavelengths.

Bovine Serum Albumin Protein Detection by a Removable SPR Chip Combined with a Specific MIP Receptor

Nowadays, the development of simple, fast, and low-cost selective sensors to detect substances of interest is of great importance in several application fields. Among this kind of sensors, those based on surface plasmon resonance (SPR) represent a promising category, since they are highly sensitive, versatile, and label-free. In this work, an SPR probe, based on a poly(methyl methacrylate) (PMMA) slab waveguide covered by a gold nanofilm, combined with a specific molecularly imprinted polymer (MIP) receptor for bovine serum albumin (BSA) protein, has been realized and experimentally characterized. The obtained experimental results have shown a limit of detection (LOD) equal to about 8.5 × 10−9 M. This value is smaller than the one achieved by another SPR probe, based on a D-shaped plastic optical fiber (POF), functionalized with the same MIP receptor; more specifically, the obtained LOD was reduced by about three orders of magnitude with respect to the POF configuration. Moreover, concerning the D-shaped POF configuration, no manufacturing process is present in the proposed sensor configuration. In addition, fibers are used only to connect the simple sensor chip with a light source and a detector, promoting a bio-chemical sensing approach based on disposable, low-cost, and removable chips.

Hierarchical cage-frame type nanostructure of CeO2 for bio sensing applications: from glucose to protein detection

Self-assembled hierarchical nanostructures are slowly superseding their conventional counterparts for use in biosensors. These morphologies show high surface area with tunable porosity and packing density. Modulating the interfacial interactions and subsequent particle assembly occurring at the water-and-oil interface in inverse miniemulsions, are amongst the best strategies to stabilize various type of hollow nanostructures. The paper presents a successful protocol to obtain CeO₂ hollow structures based biosensors that are useful for glucose to protein sensing. The fabricated glucose sensor is able to deliver high sensitivity (0.495 μA cm^-2 nM^-1), low detection limit (6.46 nM) and wide linear range (0 nM to 600 nM). CeO₂ based bioelectrode can also be considered as a suitable candidate for protein sensors. It can detect protein concentrations varying from 0 to 30 µM, which is similar or higher than most reports in the literature. The limit of detection (LOD) for protein was ∼0.04 µM. Therefore, the hollow CeO₂ electrodes, with excellent reproducibility, stability and repeatability, open a new area of application for cage-frame type particles.

Deformable molecularly imprinted nanogels permit sensitivity-gain in plasmonic sensing

Soft molecularly imprinted nanogels (nanoMIPs), selective for human transferrin (HTR), were prepared via a template assisted synthesis. Owing to their soft matter, the nanoMIPs were observed to deform at binding to HTR: while no relevant changes were observed in the hydrodynamic sizes of HTR-free compared to HTR-loaded nanoMIPs, the HTR binding resulted in a significant increment of the nanoMIP stiffness, with the mean Young's modulus measured by AFM passing from 17 ± 6 kPa to 56 ± 18 kPa. When coupled to a plastic optical fibre (POF) plasmonic platform, the analyte-induced nanoMIP-deformations amplified the resonance shift, enabling to attain ultra-low sensitivities (LOD = 1.2 fM; linear dynamic range of concentrations from 1.2 fM to 1.8 pM). Therefore, soft molecularly imprinted nanogels that obey to analyte-induced deformation stand as a novel class of sensitivity-gain structures for plasmonic sensing.

Carbon-Based Nanomaterials for Plasmonic Sensors: A Review

The surface plasmon resonance (SPR) technique is a remarkable tool, with applications in almost every area of science and technology. Sensing is the foremost and majorly explored application of SPR technique. The last few decades have seen a surge in SPR sensor research related to sensitivity enhancement and innovative target materials for specificity. Nanotechnological advances have augmented the SPR sensor research tremendously by employing nanomaterials in the design of SPR-based sensors, owing to their manifold properties. Carbon-based nanomaterials, like graphene and its derivatives (graphene oxide (GO)), (reduced graphene oxide (rGO)), carbon nanotubes (CNTs), and their nanocomposites, have revolutionized the field of sensing due to their extraordinary properties, such as large surface area, easy synthesis, tunable optical properties, and strong compatible adsorption of biomolecules. In SPR based sensors carbon-based nanomaterials have been used to act as a plasmonic layer, as the sensitivity enhancement material, and to provide the large surface area and compatibility for immobilizing various biomolecules, such as enzymes, DNA, antibodies, and antigens, in the design of the sensing layer. In this review, we report the role of carbon-based nanomaterials in SPR-based sensors, their current developments, and challenges.

Preparation of enzyme-functionalized carbon nanotubes and their application in glucose and Fe2+ detection through “turn on” and “turn off” approaches

Herein, we report the preparation of enzyme-conjugated carbon nanotubes for the detection of Fe²⁺ and glucose with enhanced signal intensity.