Stereoscopic MR imaging

An MR-compatible stereoscopic in-room 3D display for MR-guided interventions

BACKGROUND AND METHODS

A commercial three-dimensional (3D) monitor was modified for use inside the scanner room to provide stereoscopic real-time visualization during magnetic resonance (MR)-guided interventions, and tested in a catheter-tracking phantom experiment at 1.5 T. Brightness, uniformity, radio frequency (RF) emissions and MR image interferences were measured.

RESULTS AND DISCUSSION

Due to modifications, the center luminance of the 3D monitor was reduced by 14%, and the addition of a Faraday shield further reduced the remaining luminance by 31%. RF emissions could be effectively shielded; only a minor signal-to-noise ratio (SNR) decrease of 4.6% was observed during imaging. During the tracking experiment, the 3D orientation of the catheter and vessel structures in the phantom could be visualized stereoscopically.

Two eyes see more than one: double echo stereoscopic MRA for rapid 3D visualization of vascular structures

OBJECT

A three-dimensional (3D) visualization of the target region during intravascular interventions in real-time is challenging since the acquisition of a time-consuming 3D dataset is required. In this work, a novel stereoscopic double echo sequence for achieving 3D depth perception by sampling only two oblique projection images is presented.

MATERIALS AND METHODS

A double echo (DE) FLASH pulse sequence was developed to acquire continuously stereoscopic image pairs of the vascular target anatomy. Stereo image data were displayed on a stereoscopic 3D LCD monitor in real time after image reconstruction. Phantom experiments followed by a depth perception test were performed to assess the usability of the stereo image pairs for 3D visualization. In an animal experiment the sequence was tested in vivo and was compared with a slower interleaved (IL) sequence variant.

RESULTS

In the phantom experiments an SNR difference of 6 % between left and right image was found which did not influence the depth perception. The DE acquisition was superior to the IL sequence (SNR(DE) = 10.3, 2.3 images/s over SNR(IL) = 7.1, 1.7 images/s), and during contrast enhancement the abdominal arterial vasculature was clearly perceived as a 3D structure.

CONCLUSION

A novel stereoscopic DE pulse sequence can be utilized for the fast 3D stereoscopic visualization of vascular structures in real-time.

Techniques for fast stereoscopic MRI

Stereoscopic MRI can impart 3D perception with only two image acquisitions. This economy over standard multiplanar 3D volume renderings allows faster frame rates, which are needed for real-time imaging applications. Real-time 3D perception may enhance the appreciation of complex anatomical structures, and may improve hand-eye coordination while manipulating a medical device during an image-guided interventional procedure. To this goal, a system is being developed to acquire and display stereoscopic MR images in real-time. A clinically used, fast gradient-recalled echo-train sequence has been modified to produce stereo image pairs. Features have been added for depth cueing, view sharing, and bulk signal suppression. A workstation was attached to a clinical MR scanner for fast data extraction, image reconstruction and stereoscopic image display.

Catheter-tracking FOV MR fluoroscopy

Recent improvements in intravascular magnetic resonance imaging techniques mandate an accurate method of monitoring the introduction of MR catheter probes into the vessel of interest. For this purpose, a novel imaging protocol and a display method have been designed. First, a roadmap 3D image data set with standard pulse sequences is obtained using an external imaging coil. Subsequently, using very narrow rectangular-FOV fast-spoiled gradient recalled (SPGR), a movie of the percutaneous placement procedure of an MR catheter probe is acquired at a rate of 7.3 frames/second. In this protocol, the probe is used to transmit RF pulses and receive MR signal. A computer program was written for image unwrapping and for displaying the unwrapped movie frames on the roadmap image. In an alternative protocol, the movie frames in two projection angles were acquired in an interleaved fashion. Frames were unwrapped and combined with a 3D roadmap and displayed on a Silicon Graphics workstation equipped with stereovision goggles. Using these methods, percutaneous catheter placement in a phantom and a dog was examined. In conclusion, a new visualization technique for MR catheter placement is proposed. Combining this technique with high resolution intravascular MRI techniques may result in a very useful diagnostic tool for the evaluation of atherosclerosis and other vessel diseases.

Generation of depth-perception information in stereoscopic nuclear magnetic resonance imaging by non-linear magnetic field gradients

Stereoscopic NMR images have been produced in the past. However, because of the gradients are linear, only isometric projections can be produced, i.e., they do not carry correct depth-perception information. The resulting stereoscopic image will not have correct relative sizes at different depths. This paper gives an analysis of what perception information is needed and shows that it can be produced by a non-linear magnetic field gradient. The concept is exemplified by simulations and its implementation is demonstrated successfully by experiments. The depth-encoding gradient can be generated by static steel pieces or by current loops. The procedure can be incorporated into any existing hardware and pulse sequences, and has potential application in surgery.

Ultrasmall superparamagnetic iron oxide to enhance MRA of the renal and coronary arteries: studies in human patients

OBJECTIVE

Our goal was to determine the feasibility of using an intravascular MR contrast agent to improve 3D MRA.

MATERIALS AND METHODS

Three-dimensional TOF MRA was performed in nine patients both prior to and following the administration of an ultrasmall particle superparamagnetic iron oxide contrast agent (AMI 227). The lengths of both renal arteries were measured from the maximum intensity projection (MIP) images as well as the individual partitions. Seven of these patients also were studied by a 3D coronary artery MRA sequence. Signal-to-noise ratio (SNR) and contrast-to-noise ratio (CNR) measurements of the right coronary artery were determined both prior to and following the administration of AMI 227. Statistical analysis of both renal artery lengths and right coronary SNR and CNR was performed using a one tailed paired t test comparing pre- and postcontrast images.

RESULTS

The renal artery lengths significantly increased (right and artery: 30%, p = 0.001; left renal artery: 25%, p < 0.008) when measured from the individual axial slice partitions. No significant increase in length was observed on the MIP images following contrast. In the right coronary artery, the SNR increased by an average of 80% (p = 0.008) and CNR increased by an average of 109% (p = 0.007). Increased background signal and superimposed venous structures reduced the measurable lengths of the renal arteries from the MIP images.

CONCLUSION

These studies support the hypothesis that 3D MRA in the body will benefit from the use of intravascular contrast agents. Nevertheless, conventional MIP processing is unable to reveal the full advantage of the contrast improvement.

Stereoscopic display of MR angiograms

Recent developments in magnetic resonance (MR) allow high resolution imaging of flowing blood. To overcome the tomographic nature of conventional MR acquisitions, projection angiograms can be produced. These angiograms are similar in their display of blood vessels to plain film or digital subtraction angiograms. However, the three-dimensional information inherent in them is partly lost when single projections are viewed. We describe a method of three-dimensional display consisting of stereo pairs of the MR angiograms. With these an examiner experienced in stereo viewing can recover depth perception.