Magnetic Resonance Imaging (MRI) and Relaxation Spectrum Analysis as Methods to Investigate Swelling in Whey Protein Gels

Role of Flaxseed Gum and Whey Protein Microparticles in Formulating Low-Fat Model Mayonnaises

Flaxseed gum (FG) and whey protein microparticles (WPMs) were used to substitute fats in model mayonnaises. WPMs were prepared by grinding the heat-set whey protein gel containing 10 mM CaCl₂ into small particles (10–20 µm). Then, 3 × 4 low-fat model mayonnaises were prepared by varying FG (0.3, 0.6, 0.9 wt%) and WPM (0, 8, 16, 24 wt%) concentrations. The effect of the addition of FG and WPMs on rheology, instrumental texture and sensory texture and their correlations were investigated. The results showed that all samples exhibited shear thinning behavior and ‘weak gel’ properties. Although both FG and WPMs enhanced rheological (e.g., viscosity and storage modulus) and textural properties (e.g., hardness, consistency, adhesiveness, cohesiveness) and kinetic stability, this enhancement was dominated by FG. FG and WPMs affected bulk properties through different mechanisms, (i.e., active filler and entangled polysaccharide networks). Panellists evaluated sensory texture in three stages: extra-oral, intra-oral and after-feel. Likewise, FG dominated sensory texture of model mayonnaises. With increasing FG concentration, sensory scores for creaminess and mouth-coating increased, whereas those of firmness, fluidity and spreadability decreased. Creaminess had a linear negative correlation with firmness, fluidity and spreadability (R² > 0.985), while it had a linear positive correlation with mouth-coating (R² > 0.97). A linear positive correlation (R² > 0.975) was established between creaminess and viscosity at different shear rates/instrumental texture parameters. This study highlights the synergistic role of FG and WPMs in developing low-fat mayonnaises.

Physical characterization of high methoxyl pectin and sunflower oil wax emulsions: A low-field 1 H NMR relaxometry study

Pectin-wax-based emulsion systems could be used to form edible films and coatings with desired water permeability characteristics. Pectin is often used in food industry due to its gelling and viscosity increasing properties. Physical properties of pectin are highly dependent on its esterification degree. Waxes are commonly used as edible coatings to enhance the water barrier properties of food products. This study focuses on preparing emulsions with sunflower oil wax (SFW) and high methoxyl pectin (HMP) at different concentrations for any possible edible film or coating formulations. Sunflower oil (SFO) was added as the dispersed oil phase to these emulsions. Characterization of the emulsions was performed by using particle size, rheology, and time domain nuclear magnetic resonance (NMR) relaxometry measurements. Effects of HMP concentration and the presence of SFO in the emulsion formulations were explored. Mean particle size values were recorded between 1 and 3 µm. Rheology measurements showed that increasing HMP concentrations and presence of SFO in emulsions resulted in more pseudoplastic behavior. NMR transverse relaxation times (T₂ ) were measured to detect the differences between the emulsions. Relaxation spectrum analysis was also conducted for a detailed understanding of the transverse relaxations. Addition of SFO and higher HMP concentrations decreased the T ₂ values of the emulsion systems (P < 0.05). However, T₂ decreasing effect of SFO was compensated at 10% (w/w) HMP concentration showing that SFO was well dispersed in this particular emulsion formulation. Changes in the rheological behavior and relaxation times provided insight on the formation and stability of the emulsions. PRACTICAL APPLICATION: Findings of this study can be utilized and integrated to produce edible films and coatings with different water permeability characteristics. This study showed that NMR relaxometry parameters were also effective in monitoring and determining the physical characteristics of the pectin-wax-based emulsion systems as other conventional techniques including rheology and particle size measurements. Our NMR relaxometry findings were in correlation with the flow behavior and particle size results of the investigated emulsion systems.

NMR Relaxometry and magnetic resonance imaging as tools to determine the emulsifying characteristics of quince seed powder in emulsions and hydrogels

Quince seed powder (QSP) is known to exhibit emulsification properties and could be used as a natural emulsifier in colloidal food systems. In this study, emulsion-based alginate hydrogels were formulated using QSP and xanthan gum (XG) as stabilizers. The objective of the study was to show the emulsifying power of QSP in emulsions and their hydrogels using Time Domain (TD) NMR Relaxometry and Magnetic Resonance Imaging (MRI). Rheology and mean particle size measurements for emulsions and scanning electron microscope (SEM) experiments for hydrogels were further conducted as complementary methods. QSP containing emulsions were found to have longer T₂ relaxation times than XG samples (p < 0.05). Addition of either QSP or XG produced a more pseudoplastic flow behavior (p < 0.05) on the emulsions. Relaxation times were also obtained by MR images through T₂ maps. Relaxation decay curves showed the presence of two proton compartments in hydrogels; protons associated with the polymer matrix and protons interacting with the oil phase. The contribution of the first proton pools was the largest in QSP hydrogels confirmed by the lowest standard deviation in the T₂ maps. This behavior was explained by the emulsification ability of QSP. Results showed that NMR Relaxometry and MR images could be used to understand the emulsifying nature of QSP and many other hydrocolloids.

Mechanism of Water Dynamics in Hyaluronic Dermal Fillers Revealed by Nuclear Magnetic Resonance Relaxometry

1 H spin-lattice nuclear magnetic resonance relaxation experiments were performed for five kinds of dermal fillers based on hyaluronic acid. The relaxation data were collected over a broad frequency range between 4 kHz and 40 MHz, at body temperature. Thanks to the frequency range encompassing four orders of magnitude, the dynamics of water confined in the polymeric matrix was revealed. It is demonstrated that translation diffusion of the confined water molecules exhibits a two-dimensional character and the diffusion process is slower than diffusion in bulk water by 3-4 orders of magnitude. As far as rotational dynamics of the confined water is concerned, it is shown that in all cases there is a water pool characterized by a rotational correlation time of about 4×10-9  s. In some of the dermal fillers a fraction of the confined water (about 10 %) forms a pool that exhibits considerably slower (by an order of magnitude) rotational dynamics. In addition, the water binding capacity of the dermal fillers was quantitatively compared.

Physico-Chemical Changes of Composite Whey Protein Hydrogels in Simulated Gastric Fluid Conditions

Polysaccharide blended whey protein isolate (WPI) hydrogels were developed for the delivery of black carrot ( Daucus carota) concentrate as bioactive agent in simulated gastric fluid (SGF). Pectin (PC), gum tragacanth (GT), and xanthan gum (XG) were blended as additional polymers to modulate the release characteristics of the WPI hydrogels. Experiments showed that sole whey protein (C), XG, and GT blended hydrogels possessed restricted release profiles 67%, 61%, and 67%, respectively, whereas PC samples attained higher release rates (83%) ( p < 0.05). Interactions between polymers and aqueous medium were analyzed by nuclear magnetic resonance relaxometry. C (82 ms) and GT (84 ms) hydrogels attained higher T₂ values than PC (74 ms) and XG (73 ms) samples in SGF. Hardness of only XG hydrogels increased from 1.9 to 4.1 N after gastric treatment. Physicochemical changes within hydrogels during release were also investigated, and hydrogels were proved to be appropriate for desired delivery purposes.

Formation and properties of gels based on lipo-plexes

Aqueous systems containing sodium taurodeoxycholate and, eventually, soybean lecithin were investigated. Depending on the relative amounts of two such species, molecular, micellar, vesicular, liquid crystalline, and solid phases were formed. In the presence of bovine serum albumin, micellar and vesicular systems form lipo-plexes. The latter self-organize into gels, depending on composition and thermal treatments. According to scanning electron microscopy, vesicle-based gels obtained from lipo-plexes form sponge-like entities, whereas micelle-based ones self-arrange in fibrous organizations. Gels are characterized by a significant viscoelasticity in a wide temperature and frequency range. Rheological data were interpreted by assuming strict relations between the system response and the self-organization of the lipo-plexes into gels. It was inferred that differences in the gel properties depend on the different self-assembly modes of the aggregates formed by the mentioned lipo-plexes. Use of the above systems in biomedical applications, mostly in the preparation of matrices requiring the use of smart and biocompatible gels, is suggested.

Effects of sucrose and urea on soy hull pectic polysaccharide gel induced by D-glucono-1,5-lactone

Gelation properties of pectic polysaccharide extracted with ammonium oxalate from soybean hulls assisted by microwave were seldom studied. Water mobility in soy hull pectic polysaccharide (SHPP) was firstly studied by low field NMR. D-Glucono-1,5-lactone (GDL) and sucrose both could decrease spin-spin relaxation times (T2) of SHPP solutions which indicated the SHPP network formed. Rheological analysis conformed that SHPP gel was formed induced by GDL and enhanced by sucrose. Urea can increase T2 and collapse the network of SHPP. TGA was used to draw the profiles of water desorption from SHPP solutions or gels, during heating at a controlled rate. It was found that sucrose increased the bound water content and urea acted a conversely role. Hydrogen bond is the main force to maintain SHPP gel network.