Response to the Letter to the Editor by Caraway et al. on "Tissue Temperature Increases by a 10 kHz Spinal Cord Stimulation System: Phantom and Bioheat Model"

Bioheat Model of Spinal Column Heating During High-Density Spinal Cord Stimulation

INTRODUCTION

High-density (HD) spinal cord stimulation (SCS) delivers higher charge per time by increasing frequency and/or pulse duration, thus increasing stimulation energy. Previously, through phantom studies and computational modeling, we demonstrated that stimulation energy drives spinal tissue heating during kHz SCS. In this study, we predicted temperature increases in the spinal cord by HD SCS, the first step in considering the potential impact of heating on clinical outcomes.

MATERIALS AND METHODS

We adapted a high-resolution computer-aided design-derived spinal cord model, both with and without a lead encapsulation layer, and applied bioheat transfer finite element method multiphysics to predict temperature increases during SCS. We simulated HD SCS using a commercial SCS lead (eight contacts) with clinically relevant intensities (voltage-controlled: 0.5-7 Vrms) and electrode configuration (proximal bipolar, distal bipolar, guarded tripolar [+-+], and guarded quadripolar [+--+]). Results were compared with the conventional and 10-kHz SCS (current-controlled).

RESULTS

HD SCS waveform energy (reflecting charge per second) governs joule heating in the spinal tissues, increasing temperature supralinearly with stimulation root mean square. Electrode configuration and tissue properties (an encapsulation layer) influence peak tissue temperature increase-but in a manner distinct for voltage-controlled (HD SCS) compared with current-controlled (conventional/10-kHz SCS) stimulation. Therefore, depending on conditions, HD SCS could produce heating greater than that of 10-kHz SCS. For example, with an encapsulation layer, using guarded tripolar configuration (500-Hz, 250-μs pulse width, 5-Vpeak HD SCS), the peak temperature increases were 0.36 °C at the spinal cord and 1.78 °C in the epidural space.

CONCLUSIONS

As a direct consequence of the higher charge, HD SCS increases tissue heating; voltage-controlled stimulation introduces special dependencies on electrode configuration and lead encapsulation (reflected in impedance). If validated with an in vivo measurement as a possible mechanism of action of SCS, bioheat models of HD SCS serve as tools for programming optimization.

Treatment of Painful Diabetic Neuropathy-A Narrative Review of Pharmacological and Interventional Approaches

Painful diabetic neuropathy (PDN) is a common complication of diabetes mellitus that is associated with a significant decline in quality of life. Like other painful neuropathic conditions, PDN is difficult to manage clinically, and a variety of pharmacological and non-pharmacological options are available for this condition. Recommended pharmacotherapies include anticonvulsive agents, antidepressant drugs, and topical capsaicin; and tapentadol, which combines opioid agonism and norepinephrine reuptake inhibition, has also recently been approved for use. Additionally, several neuromodulation therapies have been successfully used for pain relief in PDN, including intrathecal therapy, transcutaneous electrical nerve stimulation (TENS), and spinal cord stimulation (SCS). Recently, 10 kHz SCS has been shown to provide clinically meaningful pain relief for patients refractory to conventional medical management, with a subset of patients demonstrating improvement in neurological function. This literature review is intended to discuss the dosage and prospective data associated with pain management therapies for PDN.

Ten kilohertz SCS for Treatment of Chronic Upper Extremity Pain (UEP): Results from Prospective Observational Study

Background

Chronic upper extremity pain (UEP) has complex etiologies and is often disabling. It has been shown that 10 kHz SCS can provide paresthesia-free and durable pain relief in multiple pain types and improve the quality of life of patients.

Objective

To gain additional evidence on the safety and effectiveness of 10 kHz SCS for the treatment of chronic UEP.

Study Design

It was a prospective, multicenter, and observational study. The study was registered on ClinicalTrials.gov prospectively (clinical trial identifier: NCT02703818).

Setting

Multicenter.

Patients Intervention and Main Outcomes

A total of 43 subjects with chronic UEP of ≥5 cm (on a 0-10 cm visual analog scale; VAS) underwent a trial of 10 kHz SCS, and subjects with ≥40% pain relief received a permanent implant. All subjects had upper limb pain at baseline, while some had concomitant shoulder or neck pain. Subject outcomes were assessed for 12 months, and the primary outcome was the responder rate (percentage of subjects experiencing ≥50% pain relief from baseline) at three months.

Results

Thirty-eight subjects successfully completed the trial (88.3% success rate), 33 received permanent implants (five withdrew consent), and 32 had device activation (per protocol population). There were no paresthesias or uncomfortable changes in stimulation related to changes in posture during the study and there were no neurological deficits. Responder rates at 12 months for upper limb, shoulder, and neck pain in per protocol population (N=32) were 78.1%, 85.2%, and 75.0%, respectively. At 12 months, 84.4% of subjects were satisfied or very satisfied with 10 kHz SCS, and 38.7% either reduced or eliminated opioid usage.

Conclusion

This study further supports the effectiveness of 10 kHz SCS for chronic UEP treatment and documents the safety profile of the therapy.

Clinical Trial Identifier

NCT02703818.

Bio-Heat Model of Kilohertz-Frequency Deep Brain Stimulation Increases Brain Tissue Temperature

OBJECTIVES

Early clinical trials suggest that deep brain stimulation at kilohertz frequencies (10 kHz-DBS) may be effective in improving motor symptoms in patients with movement disorders. The 10 kHz-DBS can deliver significantly more power in tissue compared to conventional frequency DBS, reflecting increased pulse compression (duty cycle). We hypothesize that 10 kHz-DBS modulates neuronal function through moderate local tissue heating, analogous to kilohertz spinal cord stimulation (10 kHz-SCS). To establish the role of tissue heating in 10 kHz-DBS (30 μs, 10 kHz, at intensities of 3-7 mA_peak ), a decisive first step is to characterize the range of temperature changes during clinical kHz-DBS protocols.

MATERIALS AND METHODS

We developed a high-resolution magnetic resonance imaging-derived DBS model incorporating joule-heat coupled bio-heat multi-physics to establish the role of tissue heating. Volume of tissue activated (VTA) under assumptions of activating function (for 130 Hz) or heating (for 10 kHz) based neuromodulation are contrasted.

RESULTS

DBS waveform power (waveform RMS) determined joule heating at the deep brain tissues. Peak heating was supralinearly dependent on stimulation RMS. The 10 kHz-DBS stimulation with 2.3 to 5.4 mA_RMS (corresponding to 3 to 7 mA_peak ) produced 0.10 to 1.38°C heating at the subthalamic nucleus (STN) target under standard tissue parameters. Maximum temperature increases were predicted inside the electrode encapsulation layer (enCAP) with 2.3 to 5.4 mA_RMS producing 0.13 to 1.87°C under standard tissue parameters. Tissue parameter analysis predicted STN heating was especially sensitive (ranging from 0.44 to 1.35°C at 3.8 mA_RMS ) to decreasing enCAP electrical conductivity and decreasing STN thermal conductivity.

CONCLUSIONS

Subject to validation with in vivo measurements, neuromodulation through a heating mechanism of action by 10 kHz-DBS can indicate novel therapeutic pathways and strategies for dose optimization.