Assessment of bilateral asymmetry in cycling using a commercial instrumented crank system and instrumented pedals

One-Leg Stance Postural Sway Is Not Benefited by Bicycle Motocross Practice in Elite Riders

Balance has been positioned as an important performance skill in sport. Differences in postural control have been found between levels of expertise. However, this statement remains unanswered in some cyclic sports. This work aimed to describe the one-leg balance performance of a sample of elite BMX riders-racing and freestyle-compared to a control group formed by recreational athletes. The center of pressure (COP) of nineteen international BMX riders (freestyle, n = 7; racing, n = 12) and twenty physically active adults was analyzed in a 30-s one-leg stance test on both legs. COP dispersion and velocity variables were analyzed. Non-linear dynamics of postural sway were evaluated through Fuzzy Entropy and Detrended Fluctuation Analysis. BMX athletes did not show differences between legs in any of the variables. The control group did show differences between the dominant and non-dominant leg in the magnitude of variability of the COP in the mediolateral axis. Group comparison revealed non-significant differences. International BMX athletes did not show better balance parameters than the control group in a one-leg stance balance task. The adaptations derived from BMX practice do not have a significant impact in one-leg stance balance performance.

Cadence Detection in Road Cycling Using Saddle Tube Motion and Machine Learning

Most commercial cadence-measurement systems in road cycling are strictly limited in their function to the measurement of cadence. Other relevant signals, such as roll angle, inclination or a round kick evaluation, cannot be measured with them. This work proposes an alternative cadence-measurement system with less of the mentioned restrictions, without the need for distinct cadence-measurement apparatus attached to the pedal and shaft of the road bicycle. The proposed design applies an inertial measurement unit (IMU) to the seating pole of the bike. In an experiment, the motion data were gathered. A total of four different road cyclists participated in this study to collect different datasets for neural network training and evaluation. In total, over 10 h of road cycling data were recorded and used to train the neural network. The network's aim was to detect each revolution of the crank within the data. The evaluation of the data has shown that using pure accelerometer data from all three axes led to the best result in combination with the proposed network architecture. A working proof of concept was achieved with an accuracy of approximately 95% on test data. As the proof of concept can also be seen as a new method for measuring cadence, the method was compared with the ground truth. Comparing the ground truth and the predicted cadence, it can be stated that for the relevant range of 50 rpm and above, the prediction over-predicts the cadence with approximately 0.9 rpm with a standard deviation of 2.05 rpm. The results indicate that the proposed design is fully functioning and can be seen as an alternative method to detect the cadence of a road cyclist.

Effects of Exercise Intensity on Pedal Force Asymmetry during Cycling

The purpose of the current investigation was to examine the effects of exercise intensity and a participant’s cycling experience on asymmetry in pedal forces during cycling. Participants were classified as cycling experienced (CE) or non-cycling experienced (NCE) based on self-reported training history. Participants completed an incremental cycling test via a cycle ergometer with inspired and expired gases, capillary blood lactate and pedaling forces collected throughout the test. Group X exercise intensity comparisons were analyzed at workloads corresponding to 2 mmol/L and 4 mmol/L for the blood lactate accumulation and peak power output, respectively. No Group X exercise intensity interactions for any variables (p > 0.05) were observed. The main effect on the exercise intensity was observed for absolute (p = 0.000, η2 = 0.836) and relative (p = 0.000, η2 = 0.752) power outputs and pedal force effectiveness (PFE) (p = 0.000, η2 = 0.728). The main effect for the group was observed for absolute (p = 0.007, η2 = 0.326) and relative (p = 0.001, η2 = 0.433) power outputs, the absolute difference between the lower limbs in power production (p = 0.047, η2 = 0.191), the peak crank torque asymmetry index (p = 0.031, η2 = 0.222) and the PFE (p = 0.014, η2 = 0.280). The exercise intensity was observed to have no impact on asymmetry in pedaling forces during cycling.

Are the Assioma Favero Power Meter Pedals a Reliable Tool for Monitoring Cycling Power Output?

This study aimed to examine the validity and reliability of the recently developed Assioma Favero pedals under laboratory cycling conditions. In total, 12 well-trained male cyclists and triathletes (VO_2max = 65.7 ± 8.7 mL·kg⁻¹·min⁻¹) completed five cycling tests including graded exercises tests (GXT) at different cadences (70–100 revolutions per minute, rpm), workloads (100–650 Watts, W), pedaling positions (seated and standing), vibration stress (20–40 Hz), and an 8-s maximal sprint. Tests were completed using a calibrated direct drive indoor trainer for the standing, seated, and vibration GXTs, and a friction belt cycle ergometer for the high-workload step protocol. Power output (PO) and cadence were collected from three different brand, new pedal units against the gold-standard SRM crankset. The three units of the Assioma Favero exhibited very high within-test reliability and an extremely high agreement between 100 and 250 W, compared to the gold standard (Standard Error of Measurement, SEM from 2.3–6.4 W). Greater PO produced a significant underestimating trend (p < 0.05, Effect size, ES ≥ 0.22), with pedals showing systematically lower PO than SRM (1–3%) but producing low bias for all GXT tests and conditions (1.5–7.4 W). Furthermore, vibrations ≥ 30 Hz significantly increased the differences up to 4% (p < 0.05, ES ≥ 0.24), whereas peak and mean PO differed importantly between devices during the sprints (p < 0.03, ES ≥ 0.39). These results demonstrate that the Assioma Favero power meter pedals provide trustworthy PO readings from 100 to 650 W, in either seated or standing positions, with vibrations between 20 and 40 Hz at cadences of 70, 85, and 100 rpm, or even at a free chosen cadence.

Unilateral and Bilateral Strength Asymmetry among Young Elite Athletes of Various Sports

Background and objective: Type of physical activity may influence morphological and muscular asymmetries in the young population. However, less is known about the size of this effect when comparing various sports. The aim of this study was to identify the degree of bilateral asymmetry (BA) and the level of unilateral ratio (UR) between isokinetic strength of knee extensors (KE) and flexors (KF) among athletes of three different types of predominant locomotion in various sports (symmetric, asymmetric and hybrid). Material and methods: The analyzed group consisted of young elite athletes (n = 50). The maximum peak muscle torque of the KE and KF in both the dominant (DL) and non-dominant (NL) lower limb during concentric muscle contraction at an angular velocity of 60°·s⁻¹ was measured with an isokinetic dynamometer. Results: Data analysis showed a significant effect of the main factor (the type of sport) on the level of monitored variables (p = 0.004). The type of sport revealed a significant difference in the bilateral ratio (p = 0.01). The group of symmetric and hybrid sports achieved lower values (p = 0.01) of BA in their lower limb muscles than those who played asymmetric sports. The hybrid sports group achieved higher UR values (p = 0.01) in both lower limbs. Conclusions: The results indicate that sports with predominantly symmetrical, asymmetrical, and hybrid types of locomotion affected the size of the BA, as well as the UR between KE and KF in both legs in young athletes. We recommend paying attention to regular KE and KF strength diagnostics in young athletes and optimizing individual compensatory exercises if a higher ratio of strength asymmetry is discovered.

Biomechanics of all-out handcycling exercise: kinetics, kinematics and muscular activity of a 15-s sprint test in able-bodied participants

This study aims to quantify the kinematics, kinetics and muscular activity of all-out handcycling exercise and examine their alterations during the course of a 15-s sprint test. Twelve able-bodied competitive triathletes performed a 15-s all-out sprint test in a recumbent racing handcycle that was attached to an ergometer. During the sprint test, tangential crank kinetics, 3D joint kinematics and muscular activity of 10 muscles of the upper extremity and trunk were examined using a power metre, motion capturing and surface electromyography (sEMG), respectively. Parameters were compared between revolution one (R1), revolution two (R2), the average of revolution 3 to 13 (R3) and the average of the remaining revolutions (R4). Shoulder abduction and internal-rotation increased, whereas maximal shoulder retroversion decreased during the sprint. Except for the wrist angles, angular velocity increased for every joint of the upper extremity. Several muscles demonstrated an increase in muscular activation, an earlier onset of muscular activation in crank cycle and an increased range of activation. During the course of a 15-s all-out sprint test in handcycling, the shoulder muscles and the muscles associated to the push phase demonstrate indications for short-duration fatigue. These findings are helpful to prevent injuries and improve performance in all-out handcycling.

Spatiotemporal analysis of 3D kinematic asymmetry in professional cycling during an incremental test to exhaustion

This study investigated the influence of an incremental exercise on bilateral asymmetry through the spatio-temporal evolution of 3D joint angular displacement, using the Normalized Symmetry Index ([Formula: see text]) and cross-correlation methods. Twelve professional cyclists performed an incremental test to exhaustion, during which motion capture was used. Results revealed a decrease in range of motion between the first and last stages for twelve of the eighteen joint rotations, with the highest impact observed for right hip flexion/extension (61.8 ± 4.7° to 58.8 ± 4.1°, p < 0.05, ES = 0.68). For both stages, significant bilateral differences greater than 10° were observed for hip and knee flexion/extension (p < 0.05, ES>0.90) and ankle and hip internal/external rotation (p < 0.05, ES>0.25). Cross-correlation displayed the lowest pattern similarities for hip abduction/adduction and the highest similarities for knee flexion/extension, ankle plantarflexion/dorsiflexion and hip internal/external rotation. The cross-correlation method showed that the right leg was mostly ahead of time with respect to the left leg, a trend that was accentuated with power output increase. Instantaneous [Formula: see text] fluctuated up to 18% throughout the pedalling cycle, with different behaviour between the power and recovery phases. This study demonstrated the workload effects on side-to-side joint angular pattern similarity.