Quantitative determination of lercanidipine enantiomers in commercial formulations by capillary electrophoresis

Development of three ecological spectroscopic methods for analysis of betrixaban either alone or in mixture with lercanidipine: greenness assessment

Three eco-friendly spectrophotometric methods were developed for determination of the novel anticoagulant drug, betrixaban (BTX). The first method (method A) was based on direct analysis of BTX at 229.4 nm on the zero-order spectrum using methanol as the optimum solvent. While the second method (method B) was based on measuring difference absorption value (ΔA) of BTX at 335 nm, which was obtained from pH-induced spectral difference (difference spectra of BTX in 0.1 M NaOH versus 0.1 M HCl). The third method (method C) was based on measurement of the first-derivative amplitudes of BTX and its co-administered Ca channel blocker lercanidipine (LER) at 304 and 229 nm for simultaneous assay of BTX and LER, respectively. All methods were linear over concentration ranges of 1.0-20.0 and 8.0-80.0 µg ml^-1 for BTX in methods A and B, respectively, and of 1.0-20.0 and 1.0-25.0 µg ml^-1 for BTX and LER, respectively, in method C. The three methods were fully validated and assessed for greenness by three metrics: analytical eco-scale, green analytical procedure index and Analytical GREEnness metrics. The results indicated the validity and greenness of the proposed methods. Moreover, the methods were applied to assay the studied analytes in their dosage forms with high percentage of recovery and low percentage of relative s.d. values.

Optimization and Validation of a Facile RP-HPLC Method for Determination of Betrixaban and Lercanidipine in Pharmaceutical and Biological Matrices

A simple, accurate, rapid and sensitive reversed-phase high-performance liquid chromatography (RP-HPLC) method was established for determination of a novel non-vitamin K antagonist oral anticoagulant drug, betrixaban, and its co-administered calcium-channel blocker drug, lercanidipine, in pharmaceutical formulations and biological fluids. The proposed HPLC method was the first chromatographic method applied to estimate this mixture in a short chromatographic run (<6 min), high resolution between betrixaban/lercanidipine (Rs = 7.12) and acceptable values of limit of detection (LOD), limit of quantification (LOQ) and percentage of relative standard deviation (%RSD). The chromatographic separation was performed on a cyano column using a mobile phase composed of acetonitrile:methanol:water (35:35:30, v/v/v) containing 0.2% orthophosphoric acid adjusted to pH 3.2 by triethylamine, programmed with a flow rate of 1 mL/min with UV detection at 240 nm. The proposed method showed linearity over the concentration ranges of (0.20-20.0 μg/mL) and (0.25-25.0 μg/mL) for betrixaban and lercanidipine, respectively. All validation parameters met the acceptance criteria according to ICH guidelines in terms of linearity, LOD, LOQ, accuracy, precision, robustness, specificity and system suitability. The method was applied to assay the studied analytes in their pharmaceutical formulations with high % recovery (98-102%) and low %RSD (<1.5). Furthermore, the proposed method was successfully applied for the determination of betrixaban in spiked human plasma.

Stepwise optimization and sensitivity improvement of green micellar electrokinetic chromatography method to simultaneously determine some fluoroquinolones and glucocorticoids present in various binary ophthalmic formulations

A sensitive micellar electrokinetic chromatography method is presented to simultaneously quantify ofloxacin, gatifloxacin, dexamethasone sodium phosphate and prednisolone acetate. The method has the advantages of being rapid, accurate, reproducible, ecologically acceptable and sensitive. The electrophoretic separation utilized 20 mm borate buffer as background electrolyte with pH 10.0 ± 0.1 and 50 mm sodium dodecyl sulfate as a micelle forming molecule. A capillary tube (50 μm i.d., 33 cm) of fused silica was used and on-column diode array detection at 243 nm for dexamethasone sodium phosphate and prednisolone acetate, and 290 nm for ofloxacin and gatifloxacin. Various factors were optimized such as the background electrolyte (type, concentration and pH), addition of sodium dodecyl sulfate and its concentration, detection wavelength, applied voltage and injection parameters. The studied drugs were efficiently separated in 6.2 min, at 20 kV with high resolution. The greenness of the method was estimated using an eco-scale tool and the presented method was found to have excellent green characteristics. The method was validated in conformance with International Conference on Harmonization guidelines, with acceptable accuracy, precision and selectivity. The suggested method can be employed for the economic analysis of the four drugs in dissimilar binary combinations of eye drops saving solvents and chemicals.

Capillary electrophoretic methods for quality control analyses of pharmaceuticals: A review

Capillary electrophoresis represents a promising technique in the field of pharmaceutical analysis. The presented review provides a summary of capillary electrophoretic methods suitable for routine quality control analyses of small molecule drugs published since 2015. In total, more than 80 discussed methods are sorted into three main sections according to the applied electroseparation modes (capillary zone electrophoresis, electrokinetic chromatography, and micellar, microemulsion, and liposome-electrokinetic chromatography) and further subsections according to the applied detection techniques (UV, capacitively coupled contactless conductivity detection, and mass spectrometry). Key parameters of the procedures are summarized in four concise tables. The presented applications cover analyses of active pharmaceutical ingredients and their related substances such as degradation products or enantiomeric impurities. The contribution of reported results to the current knowledge of separation science and general aspects of the practical applications of capillary electrophoretic methods are also discussed.

Single isomer cyclodextrins as chiral selectors in capillary electrophoresis

Since decades, cyclodextrins are one of the most powerful selectors in chiral capillary electrophoresis for the enantioseparation of diverse organic compounds. This review concerns papers published over the last decade (from 2009 until nowadays), dealing with the capillary electrophoretic application of single isomer cyclodextrin derivatives in chiral separations. Following a brief overview of their synthetic approaches, the inventory of the neutral, negatively and positively charged (including both permanently ionic and pH-tunable ionizable substituents) and zwitterionic CD derivatives is presented, with insights to underlying structural aspects by NMR spectroscopy and molecular modeling. CE represents an ideal tool to study the weak, non-covalent supramolecular interactions. The published methods are reviewed in the light of enantioselectivity, enantiomer migration order and the fine-tuning of enantiodiscrimination by the substitution pattern of the single entity selector molecules, which is hardly possible for their randomly substituted counterparts. All the reviewed publications herein support that cyclodextrin-based chiral capillary electrophoresis seems to remain a popular choice in pharmaceutical and biomedical analysis.

Enantiomeric Determination of Drugs in Pharmaceutical Formulations and Biological Samples by Electrokinetic Chromatography

Chirality is a relevant issue in the pharmaceutical field due to the different biological activity that enantiomers of a chiral drug can show. In fact, the desired biological or pharmaceutical activity might be present in only one of the enantiomers, while the other enantiomer(s) may have different biological activity, be inactive or even toxic. This has motivated in recent years the development of drugs marketed as pure enantiomers to avoid exposing the organism to the action of enantiomers that may not be active or even harmful to health. Thus, it is of high interest to develop enantioselective analytical methodologies to control the presence of enantiomeric impurities and to understand the enantioselective metabolism of chiral drugs. This review gives an overview about the analytical strategies developed by electrokinetic chromatography (EKC) from 2010 to June 2019 for the enantiomeric determination of drugs in both pharmaceutical formulations and biological samples. The types of chiral selectors used, the migration order of enantiomers, their resolution, the detection technique employed and the sensitivity achieved are revised and compared. Also, applications to assess the enantiomeric purity control of pharmaceutical formulations and to determine chiral drugs in biological samples to study their metabolism are included. Advantages and limitations of the chiral methods developed by EKC are also discussed.

Solvent Front Position Extraction procedure with thin-layer chromatography as a mode of multicomponent sample preparation for quantitative analysis by instrumental technique

A concept of using thin-layer chromatography to multicomponent sample preparation for quantitative determination of solutes followed by instrumental technique is presented. Thin-layer chromatography (TLC) is used to separate chosen substances and their internal standard from other components (matrix) and to form a single spot/zone containing them at the solvent front position. The location of the analytes and internal standard in the solvent front zone allows their easy extraction followed by quantitation by HPLC.