Design of silver-zinc-nickel spinel-ferrite mesoporous silica as a powerful and simply separable adsorbent for some textile dye removal

Silver-zinc-nickel spinel ferrite was prepared by the co-precipitation procedure with the precise composition Ag0.1Zn0.4Ni0.5Fe2O4 for bolstering pollutant removal effectiveness while upholding magnetic properties and then coated with a mesoporous silica layer. The surface characteristics and composition of Ag0.1Zn0.4Ni0.5Fe2O4@mSiO2 were confirmed using EDX, FT-IR, VSM, XRD, TEM, SEM, and BET methods. The surface modification of Ag-Zn-Ni ferrite with a silica layer improves the texture properties, where the specific surface area and average pore size of the spinel ferrite rose to 180 m2/g and 3.15 nm, respectively. The prepared spinel ferrite@mSiO2 has been utilized as an efficient adsorbent for eliminating methyl green (MG) and indigo carmine (IC) as models of cationic and anionic dyes from wastewater, respectively. Studying pH, Pzc, adsorbent dosage, dye concentration, and temperature showed that efficient removal of MG was carried out in alkaline media (pH = 12), while the acid medium (pH = 2) was effective for IC removal. Langmuir isotherm and pseudo-second-order kinetics were found to be good fits for the adsorption data. Both dyes were adsorbed in a spontaneous, endothermic process. A possible mechanism for dye removal has been proposed. The adsorbent was effectively recovered and reused.

Mesoporous silica nanoparticles with dual-targeting agricultural sources for enhanced cancer treatment via tritherapy

In this study, we introduced dual-targeting folic acid (FA) and hyaluronic acid (HA) modified on the surface of rice husk mesoporous silica nanoparticles (rMSNs). The rMSNs were employed as a drug delivery system loaded with camptothecin (CPT) as a model drug, Eu³⁺ ions as a photosensitizer for photodynamic therapy (PDT), bismuth (Bi) for photothermal therapy (PTT), and Gd³⁺ ions for magnetic resonance imaging (MRI) to develop novel nanoparticles, rMSN-EuGd-Bi@CPT-HA-FA, with dual-targeted function and triple therapy for cancer treatment. The results of the cell cytotoxicity experiment showed that the A549 cancer cells had a survival rate of approximately 35% when treated with 200 μg mL^-1 of rMSN-EuGd-Bi@CPT-HA-FA under 808 nm irradiation for 15 min. The dual-targeted function and synergistic treatment of CPT, PTT, and PDT were also responsible for the 20% survival rate of the A549 cancer cells treated with 200 μg mL^-1 of rMSN-EuGd-Bi@CPT-HA-FA under 808 nm irradiation for 30 min. The results showed that rMSN-EuGd-Bi@CPT-HA-FA can effectively combine chemotherapy (through CPT), PDT, and PTT for cancer treatment.

A Novel P@SiO2 Nano-Composite as Effective Adsorbent to Remove Methylene Blue Dye from Aqueous Media

This work aims to prepare a novel phosphate-embedded silica nanoparticles (P@SiO₂) nanocomposite as an effective adsorbent through a hydrothermal route. Firstly, a mixed solution of sodium silicate and sodium phosphate was passed through a strong acidic resin to convert it into hydrogen form. After that, the resultant solution was hydrothermally treated to yield P@SiO₂ nanocomposite. Using kinetic studies, methylene blue (MB) dye was selected to study the removal behavior of the P@SiO₂ nanocomposite. The obtained composite was characterized using several advanced techniques. The experimental results showed rapid kinetic adsorption where the equilibrium was reached within 100 s, and the pseudo-second-order fitted well with experimental data. Moreover, according to Langmuir, one gram of P@SiO₂ nanocomposite can remove 76.92 mg of the methylene blue dye. The thermodynamic studies showed that the adsorption process was spontaneous, exothermic, and ordered at the solid/solution interface. Finally, the results indicated that the presence of NaCl did not impact the adsorption behavior of MB dye. Due to the significant efficiency and promising properties of the prepared P@SiO₂ nanocomposite, it could be used as an effective adsorbent material to remove various cationic forms of pollutants from aqueous solutions in future works.

Removal of Cationic Dyes by Iron Modified Silica/Polyurethane Composite: Kinetic, Isotherm and Thermodynamic Analyses, and Regeneration via Advanced Oxidation Process

Emerging dye pollution from textile industrial effluents is becoming more challenging for researchers worldwide. The contamination of water by dye effluents affects the living organisms in an ecosystem. Methylene blue (MB) and malachite green (MG) are soluble dyes with a high colour intensity even at low concentration and are hazardous to living organisms. The adsorption method is used in most wastewater plants for the removal of organic pollutants as it is cost-effective, has a high adsorption capacity, and good mechanical stabilities. In this study, a composite adsorbent was prepared by impregnating iron modified silica (FMS) onto polyurethane (PU) foam to produce an iron modified silica/polyurethane (FMS/PU) composite. The composite adsorbent was utilised in batch adsorption of the cationic dyes MB and MG. The effect of adsorption parameters such as the adsorbent load, pH, initial dye concentration, and contact time were discussed. Adsorption kinetics and isotherm were implemented to understand the adsorption mechanism for both dyes. It was found that the adsorption of MB and MG followed the pseudo-second order model. The Langmuir model showed a better fit than the Freundlich model for the adsorption of MB and MG, indicating that the adsorption occurred via the monolayer adsorption system. The maximum adsorption capacity of the FMS/PU obtained for MB was 31.7 mg/g, while for MG, it was 34.3 mg/g. The thermodynamic study revealed that the adsorption of MB and MG were exothermic and spontaneous at room temperature. In addition, the regeneration of FMS/PU was conducted to investigate the composite efficiency in adsorbing dyes for several cycles. The results showed that the FMS/PU composite could be regenerated up to four times when the regeneration efficiency dropped drastically to less than 20.0%. The impregnation of FMS onto PU foam also minimised the adsorbent loss into the environment.

Efficient Removal of Dyes from Aqueous Solution by Adsorption on L-Arginine-Modified Mesoporous Silica Nanoparticles

The use of mesoporous silica modified with L-arginine (Ar-MSNPs) for the removal of ionic dyes from aqueous solutions has been investigated. Several analytical techniques have been used to determine the characteristics of nanoadsorbents. The removal of crystal violet and fluorescein was performed using the batch method to investigate the effects of cultivation pH, initial concentrations of dyes, and exposure time on adsorption efficiency. The optimum adsorption of fluorescein was achieved at pH 2, whereas the optimum adsorption of crystal violet was achieved at pH 13. The equilibrium was established in both systems at 20 min at low concentrations, and approximately 30 min at high concentrations. The equilibrium adsorption data was analyzed using Langmuir and Freundlich isotherm models. The correlation coefficient (R2) values of the isotherms presented the best fit with the Langmuir isotherm. The adsorption kinetic data was fitted with the pseudo second-order model for both systems.

Aspartic Acid- and Glycine-Functionalized Mesoporous Silica as an Effective Adsorbent to Remove Methylene Blue from Contaminated Water

In this work, aspartic acid- and glycine-functionalized mesoporous silica nanoparticles (Asp-MSNs and Gly-MSNs) were successfully prepared and applied as adsorbents for removal of methylene blue (MB) from contaminated water. The mesoporous structure of the fabricated nanomaterials was confirmed by nitrogen adsorption/desorption with specific surface area of ca. 700 m2/g and pore volume of 0.9 cm3/g for both Asp-MSNs and Gly-MSNs. The average size of the nanoadsorbents was estimated to be ca. 290 nm as characterized by scanning electron microscopy (SEM) and transmission electron microscope (TEM). The physical and chemical properties of the Asp-MSNs and Gly-MSNs were also characterized by Fourier transform infrared (FTIR) spectroscopy, zeta potential, and elemental analysis. Asp-MSNs and Gly-MSNs exhibited good adsorption performance for removal of cationic organic dyes (MB). The equilibrium adsorption capacity of Asp-MSNs and Gly-MSNs was found to be 55 mg·g−1 and 43 mg·g−1, respectively, under the optimal conditions. The Langmuir model and pseudo-second-order equation exhibited good correlation with the isotherm and adsorption kinetic data for MB, respectively.

Highly Efficient and Rapid Removal of Methylene Blue from Aqueous Solution Using Folic Acid-Conjugated Dendritic Mesoporous Silica Nanoparticles

Dendritic Mesoporous Silica Nanoparticles (DMSNs) are considered superior in the adsorption of unfavorable chemical compounds and biological pollutants. Herein, we have synthesized folic acid-terminated dendritic mesoporous silica nanoparticles (FA-DMSN) for the removal of cationic dyes, methylene blue (MB), from aqueous solutions. The structural, morphological, functional, specific surface area, pore size distribution, and thermal properties of the synthesized DMSNs were identified using a scanning electron microscope (SEM), a transmission electron microscope (TEM), Fourier transform infrared spectroscopy (FTIR), dynamic light scattering (DLS), Brunauer−Emmett−Teller (BET), and Thermogravimetric Analyzer (TGA). The synthesized DMSNs exhibited a high surface area (521 m2 −1) and pore volume (1.2 cm3 g−1). In addition, it features both wide pore size and narrow distributions, which strongly affect the adsorption performance in terms of the equilibrium uptake time. Moreover, the impact of pH, contacting time, and dye’s initial concentration on the removal efficiency of MB was studied. The extraction efficiency of FA-DMSN was found to be three times more effective than the bare DMSN materials. Langmuir isotherm fitted the experimental data very well with a correlation coefficient value of 0.99. According to the Langmuir model, the maximum adsorption capacity was 90.7 mg/g. Furthermore, the intra−particle diffusion model revealed a significantly fast intra-particle diffusion which can be attributed to the presence of the large pore’s channels. Finally, the fast adsorption of MB molecules, reaching their equilibrium capacity within tens of seconds, as well as the low cost and ease of FA-DMSN fabrication, makes the developed material an effective adsorbent for water remediations.