Determination of aluminum in large volume parenteral drug products used in total parenteral nutrition therapy by ICP-MS with a dynamic reaction cell

Ozone reaction induced multiple ionic species for internal-cross-checkable determination of aluminium by tandem quadrupole inductively coupled plasma mass spectrometry

BACKGROUND

Aluminium is a mono-isotope element and can be determined by inductively coupled plasma mass spectrometry (ICP-MS). The measurement of aluminium by ICP-MS suffers potential spectral interferences from multiple elements, which make it challenging to ensure the reliability of the results. Fortunately, the availability of tandem quadrupole ICP-MS (i.e. ICP-QMS/QMS) made it possible to measure multiple aluminium related ionic species for analysis. In the present work, on-line generated ozone was introduced as the reaction gas to the ICP-QMS/QMS for the analysis of aluminium.

RESULTS

Multiple ionic species were obtained by using ozone as the cell gas for determination of aluminium by ICP-QMS/QMS. In comparison to oxygen, ozone apparently improved the yield of AlO+, AlO2+, and AlO3+ from the reaction with Al+, attributable to the exothermic reactions when ozone was used. Determination of aluminium with these product ions was investigated at multiple radio frequency (RF) power conditions (800 W-1600 W, step 200 W) for the plasma. At low power conditions (800 W and 1000 W), the measurement of each ion suffered notable non-spectral interferences and caused difference in sensitivities by around 20 % between a digested sample of tea leaf powder and a simple aluminium standard solution. Based on a standard addition method, the result of aluminium in a tea leaf powder certified reference material obtained with each product ion (AlOn+, n = 0 to 3) agreed with the certified value, and independent to the RF power of the plasma.

SIGNIFICANCE

Due to the endothermic reactions of aluminium ion with ozone, the yields of AlOn+ (n = 1 to 3) were greatly improved. As a results, the use of ozone as a reaction gas for ICP-QMS/QMS permitted the measurement of aluminium by multiple ionic species, AlOn+ (n = 0 to 3), which provide internal-cross-checkable quantitative results for this mono-isotopic element.

Comparing Aluminum Concentrations in Adult and Pediatric Parenteral Nutrition Solutions: Multichamber-Bag versus Compounded Parenteral Nutrition

Aluminum contamination in parenteral nutrition (PN) solutions can lead to neurotoxicity, reduced bone mass, and liver toxicity, especially in pediatric patients. Ingredients commonly used in PN compounding, such as vitamins, trace elements, calcium, and phosphate salts, contain significant amounts of aluminum. This study aimed to compare aluminum concentrations in multichamber-bag (MCB) and compounded PN for adults and pediatrics. A prospective study assessed aluminum concentrations in various types of MCB and compared them with compounded PN formulations with similar compositions. The types of MCB included Lipoflex® (without electrolytes), Omegaflex®, Finomel®, Smofkabiven® (with and without electrolytes), Olimel®, Clinimix®, and Numeta®. Overall, 80 aluminum determinations were included: 36 for MCBs and 44 for compounded PN. MCBs showed significantly lower aluminum concentrations than compounded PN: 11.37 (SD 6.16) vs. 21.45 (8.08) µg/L, respectively. Similar results were observed for adult (n = 40) and pediatric (n = 40) PN formulations (12.97 (7.74) vs. 20.78 (10.28) µg/L, and 9.38 (2.23) vs. 22.01 (5.82) µg/L, respectively). Significant differences were also found between MCBs depending on the manufacturing company. These findings suggest that MCBs PN offer a safer option for reducing aluminum contamination in PN. Harmonizing regulations concerning aluminum concentrations in PN solutions could help mitigate differences between PN formulations.

An Assessment of aluminum contamination in neonatal parenteral nutrition solutions based on measured versus labeled content

Aluminum can potentially cause toxicity in pediatrics and neonates receiving parenteral nutrition. Some PN solutions and ingredients in Saudi Arabia do not comply with US FDA regulations regarding aluminum exposure. This study aims to determine the aluminum concentration in samples of PN solutions and ingredients used to feed infants in Saudi Arabia. The aluminum in the samples was determined using inductively coupled plasma mass spectrometry. The concentration of metal contaminants in each sample was determined in triplicate. The aluminum content of 38 samples was investigated, 15 of which originated from components included in the prepared PN solutions. Among the 15 samples, the least measurable aluminum content was detected in potassium chloride solutions (0.81 mcg/L). In contrast, the greatest amount of aluminum was detected in potassium phosphate and calcium gluconate (141,64 mcg/L and 462.7 mcg/L), respectively. The results showed that the final PN solution (PNS) product contained more aluminum levels than the content ingredients; in addition, the study found a statistically significant relationship among 18 pediatric patients at KFMC who had intestinal failure and needed long-term parenteral nutrition. Specifically, their high aluminum levels, exceeding the normal range of 0.6 ng/ml, indicate that the current use of PN solutions will likely cause toxicity due to aluminum contamination in additives. Hence, reducing aluminum in PN solutions is imperative to ensure patient safety.

Aluminum and other chemical elements in parenteral nutrition components and all-in-one admixtures

BACKGROUND & AIMS

Parenteral nutrition (PN) can lead to high or even toxic exposure to aluminum (Al). We aimed to quantify concentrations of Al and other chemical elements of all-in-one (AIO) PN admixtures for adults prepared from commercial multichamber bags (Olimel® 5.7%, Omegaflex® special, SmofKabiven®, all with and without electrolytes) and vitamin and trace element additives over a 48-h period. Secondly, we determined the level of Al contamination resulting from admixing and infusion set use.

METHODS

We used dynamic reaction cell and kinetic energy discrimination inductively coupled plasma mass spectrometry (ICP-MS) to quantify Al, arsenic (As), cadmium (Cd), cobalt (Co), chromium (Cr), copper (Cu), iron (Fe), magnesium (Mg), manganese (Mn), molybdenum (Mo), nickel (Ni), antimony (Sb), selenium (Se), tin (Sn), vanadium (V), and zinc (Zn) in AIO PN admixtures. We extracted samples for analysis via the bag injection ports and infusion sets over a 48-h period after admixing. We compared the measured Al concentrations of AIO PN admixtures with calculated values based on the measured concentrations of individual chamber contents and additives.

RESULTS

Mean (standard deviation) baseline Al concentrations in AIO PN admixtures ranged from 10.5 (0.5) to 59.3 (11.4) μg/L and decreased slightly over the 48 h (estimate [standard error] -0.09 [0.02] μg/L/hour, p <0.001). Thus, certain products exceeded the widely accepted limit of 25 μg/L. There was no significant difference in Al concentrations between samples extracted via the bag injection ports or infusion sets (p = 0.33), nor between measured and calculated Al concentrations of AIO PN admixtures (p = 0.91).

CONCLUSION

Because certain commercially available PN admixtures for adults proved to contain excessively high levels of Al in our study, regulations and corresponding quality requirements at the authority level (e.g., Pharmacopoeia and regulatory authorities) are urgently required. Our results showed that the PN handling process (admixing and supplementing additives) or the materials of the infusion set did not lead to additional Al contamination to any extent. Moreover, calculated Al concentrations of AIO PN admixtures derived from individual chamber contents and additives are valid.

Stabilizers for Osmium Isotopes in Microwave-Irradiated Acid Digestion and Inductively Coupled Plasma Mass Spectrometry Analysis

Osmium is defined in the international council for harmonization (ICH-Q3D) guidelines as an element whose concentration can be determined by validated methods including microwave-assisted nitric acid digestion and inductively coupled plasma mass spectrometry. However, microwave digestion using nitric acid is known to result in osmium recoveries higher than the theoretical values in spiked tests because of the formation of highly volatile osmium tetroxide in an oxidation reaction. To stabilize osmium, the addition of thiourea as a complexing agent has been tested and proved its utility. It remains unclear whether other compounds can prevent the over-recovery of osmium. In this study, we investigated four compounds, thiourea, ascorbic acid, sodium sulfite, and potassium metabisulfite, that could reduce the overestimation of osmium isotopes. The minimum amounts of thiourea, ascorbic acid, sodium sulfite, and potassium metabisulfite required to stabilize 10 ng/mL osmium in blank matrix were 1.0, 1.0, 2.5, and 2.5 g/L, respectively. The relative standard deviations obtained from 12 analyses for each stabilization solution were less than 3.3% in thiourea, 12.7% in ascorbic acid, 9.0% in sodium sulfite, and 10.6% in potassium metabisulfite. The stabilization solutions were investigated in a digested tablet matrix and were found to be effective. The impact of adding stabilization solutions on the determination of all ICH-Q3D element concentrations was also evaluated. As stabilization solutions had a small or significant impact on the determination of some elements, it was concluded that osmium determination should be conducted independently.

Selective Membrane Sensor for Aluminum Determination in Food Products, Real Samples and Standard Alloys

The study involves the fabrication of an aluminum liquid membrane sensor based on the association of aluminum ions with the cited reagent 2,9-dimethyl-4,11-diphenyl -1,5,8,12-tetraaza cyclote tradeca-1,4,8,11-tetraene [DDTCT]. The characteristics slope (58 mV), rapid and linear response for aluminum ion was displayed by the proposed sensor within the concentration range 2.5 × 10^-7-1.5 × 10^-1 M, the detection limit (1.6 × 10^-7) M, the selectivity behavior toward some metal cations, the response time 10 s), lifetime (150 days), the effect of pH on the suggested electrode potential and the requisite analytical validations were examined. The suitable pH range was (5.0-8.0 ), in this range the proposed electrode response is independent of pH. The suggested electrode was applied to detect the aluminum ions concentration in food products, real samples and standard alloys. The resulting data by the suggested electrode were statistically analyzed, and compared with the previously reported aluminum ion-selective electrodes in the literature.

Green Supramolecular Solvent-Based Liquid-Phase Microextraction Method for Spectrophotometric Determination of Aluminum in Food, Water, Hair and Urine Samples

Background:

Aluminum Al(III) is the most significant metal in the earth's crust to which humans are frequently exposed and has several industrial applications. On the other hand, Al (III) has high potential toxic impacts on some human pathologies like Parkinson and Alzheimer's disease. So, it is very important to monitor and determine the trace level of Al (III) in various environmental and biological samples.

Objective:

In the present work, a novel green supramolecular Solvent-Based Liquid-Phase Microextraction (SS-LPME) procedure has been developed to preconcentrate and determine aluminum (III) in various real samples.

Methods:

The proposed procedure was based on the application of 1-decanol/THF as a Supramolecular Solvent (SS) system and quinalizarin as a chelating agent. Al(III)-quinalizarin hydrophobic complex was obtained at pH 7.0, extracted into supramolecular solvent phase (1- decanol/THF), centrifuged and then measured spectrophotometrically at 580 nm. The impact of different analytical parameters on the microextraction efficiency was studied and optimized. The validation of the proposed preconcentration procedure was checked using certified reference materials.

Results:

The calibration curve was linear in the range of 2.0-150 μg L-1. The developed method has preconcentration factor of 40 and detection limit (LOD) was 0.20 μg L-1. The precision of the method was confirmed with low relative standard deviation (RSD ≤ 1.0%).

Conclusion:

This study explores the effectiveness of quinalizarin for the first time together with SS to develop green SS-LPME method to preconcentrate and separate trace quantities of Al (III) in real water, fruit juice, food, hair, and urine samples collected from Saudi Arabia.

Novel spectrophotometric method for the determination of aluminum in soda drinks packed in cans and plastic bottles

In the present work, a new spectrophotometric method was developed for the determination of aluminum in soda drinks packed in different materials. Reaction among Al(III), phenylfluorone (PF) and cetylpyridinium chloride (CPC) in slightly alkaline medium was explored for this purpose. The method was optimized regarding to its chemical parameters in order to establish better conditions in terms of sensitivity and selectivity. The results obtained showed that the concentration of CPC presented remarkable influence on the sensitivity and acted as a sensitizer for the studied system. The possible interferences of some metallic cations were evaluated and the cations Cu(II), Mn(II), and Zn(II) presented noticed interference on the Al(III) signal. So, their interference was eliminated by using EDTA with minimum loss of sensitivity. The results obtained in the determination of total aluminum in soda drinks by the developed methodology were not statistically different from those obtained by electrothermal atomic absorption spectrometry. In the optimized conditions the method presented a linear range of 5-100 microg L(-1). The limits of detection and quantification were 0.81 and 2.7 microg L(-1), respectively. The methodology was successfully applied in the determination of aluminum in 10 samples of soda drinks packed in cans and plastic bottles.