Characterization of elastomeric scaffolds developed for tissue engineering applications by compression and nanoindentation tests, μ-Raman and μ-Brillouin spectroscopies

Multiscale investigation of viscoelastic properties of aqueous solutions of sodium alginate and evaluation of their biocompatibility

In order to get better knowledge of mechanical properties from microscopic to macroscopic scale of biopolymers, viscoelastic bulk properties of aqueous solutions of sodium alginate were studied at different scales by combining macroscopic shear rheology (Hz), diffusing-wave spectroscopy microrheology (kHz-MHz) and Brillouin spectroscopy (GHz). Structural properties were also directly probed by small-angle X-ray scattering (SAXS). The results demonstrate a change from polyelectrolyte behavior to neutral polymer behavior by increasing polymer concentration with the determination of characteristic sizes (persistence length, correlation length). The viscoelastic properties probed at the phonon wavelength much higher than the ones obtained at low frequency reflect the variation of microscopic viscosity. First experiments obtained by metabolic activity assays with mouse embryonic fibroblasts showed biocompatibility of sodium alginate aqueous solutions in the studied range of concentrations (2.5-10 g L-1) and consequently their potential biomedical applications.

Preparation and characterization of a new sustainable bio-based elastomer nanocomposites containing poly(glycerol sebacate citrate)/chitosan/n-hydroxyapatite for promising tissue engineering applications

Poly (glycerol sebacate citrate) (PGSC) has potential applications in tissue engineering due to its biodegradability and suitable elasticity. However, its applications are restricted owing to its acidity and high degradation rate. In this study, a new bio-nanocomposite based on PGSC has been synthesized by incorporating chitosan (CS) and various concentrations of hydroxyapatite nanoparticles (n-HA). It is assumed that the basicity of a CS and hydroxyl groups of n-HA will reduce the acidity of PGSC and control the rate of degradation. Also, the biocompatibility of n-HA and inherent hydrophilicity of CS can improve cell adhesion and proliferation of PGSC-based scaffolds. FTIR, XRD, FESEM, and EDX tests confirmed the synthesis of these nanocomposites and the interaction between each of the components. The results of the DMTA test also indicated the elastic behavior of the samples embedded with n-HA. The hydrophilicity assay demonstrated that the water contact angle of the scaffolds decreased as the concentration of n-HA augmented, and it reached the value of 44 ± 0.9° for nanocomposite containing 5 wt.% n-HA. The degradation rate of all PGSC nanocomposites was reduced due to the anionic groups of n-HA and CS. TGA assay indicated that the incorporation of n-HA led to the enhancement of scaffolds' thermal stability. Furthermore, the synergistic effect of CS and n-HA on the enhancement of protein adsorption and cell proliferation was confirmed through protein adhesion and MTT assay, respectively. Consequently, the addition of n-HA and CS perform the new bio-nanocomposites scaffolds based on PGSC with sufficient hydrophilicity, flexibility, and thermal stability in tissue engineering applications.

Effects of Titanium Implant Combined with Nano-Indentation in the Vertical Control of Physiological Anchorage Spee’s Wire System Corrective Technology

In the current research, there was, in the vertical control of physiological anchorage spee’s wire system (PASS) technology, an investigation on the role of titanium implant technology in combination with nano-indentation experiment the present research. The human jaw was selected as the sample to be cut vertically, by doing do, to obtain a test slice of about 2 mm through a cutting machine following the nano-indentation test. The slice was frozen and preserved in normal saline and taken out during the test. 40 outpatients who underwent orthodontic therapy were chosen as the research objects and rolled in a random manner into a control category and an category of observation. Then, mechanical biological therapy (MBT) correction was conducted for the outpatients from the control category and PASS correction therapy based on the nano-indentation experiment was for outpatients from the category of observation. Following therapy, the therapy conditions of these two categories were compared, showing that the load was a fixed value and the depth of the indentation was increasing. Under the action of external force, the periodontal ligament might undergo elastic deformation, changing with duration. Dentition alignment duration, ligation duration, and deligation duration were less for participants in the observation group compared to those in the control category (P less than 0.05). The inclination between the longitudinal plane of the top central incisor and the sella juncture root point plane (UI-SN angle), the spacing between both the top mandibular teeth margin and the nasal root juncture molar seat point (UI-NA distance), and the angle between the upper and lower central incisor tooth axis and the NA connection (UI-NA angle) were all significantly less pronounced in the category of observation than in the control category (P less than 0.05). However, the angle of upper and lower central incisor long axis (UI-LI angle) from the category of observation was hugely greater than that of the control category (P less than 0.05). The value of dental arch width in the category of observation was smaller significantly than the value of the control category (P less than 0.05), and the changes in dental arch width were larger than those in the control category (P less than 0.05). Besides, the measured values of X-ray projections of outpatients from the category of observation were higher at of the control category (P less than 0.05). In conclusion, nano-indentation experiment can accurately match the equipment required in the therapy. The application of titanium materials combined with the vertical control of PASS correction technology can effectively alleviate the clinical symptoms of outpatients so as to improve the therapy effect.

Correlative Imaging of Motoneuronal Cell Elasticity by Pump and Probe Spectroscopy

Because of their role of information transmitter between the spinal cord and the muscle fibers, motor neurons are subject to physical stimulation and mechanical property modifications. We report on motoneuron elasticity investigated by time-resolved pump and probe spectroscopy. A dual picosecond geometry simultaneously probing the acoustic impedance mismatch at the cell-titanium transducer interface and acoustic wave propagation inside the motoneuron is presented. Such noncontact and nondestructive microscopy, correlated to standard atomic force microscopy or a fluorescent labels approach, has been carried out on a single cell to address some physical properties such as bulk modulus of elasticity, dynamical longitudinal viscosity, and adhesion.

Brillouin Light Scattering: Applications in Biomedical Sciences

Brillouin spectroscopy and imaging are emerging techniques in analytical science, biophotonics, and biomedicine. They are based on Brillouin light scattering from acoustic waves or phonons in the GHz range, providing a nondestructive contactless probe of the mechanics on a microscale. Novel approaches and applications of these techniques to the field of biomedical sciences are discussed, highlighting the theoretical foundations and experimental methods that have been developed to date. Acknowledging that this is a fast moving field, a comprehensive account of the relevant literature is critically assessed here.

The Use of Platelet-Rich Plasma to Promote Cell Recruitment into Low-Molecular-Weight Fucoidan-Functionalized Poly(Ester-Urea-Urethane) Scaffolds for Soft-Tissue Engineering

Due to their elastomeric behavior, polyurethane-based scaffolds can find various applications in soft-tissue engineering. However, their relatively inert surface has to be modified in order to improve cell colonization and control cell fate. The present study focuses on porous biodegradable scaffolds based on poly(ester-urea-urethane), functionalized concomitantly to the scaffold elaboration with low-molecular-weight (LMW) fucoidan; and their bio-activation with platelet rich plasma (PRP) formulations with the aim to promote cell response. The LMW fucoidan-functionalization was obtained in a very homogeneous way, and was stable after the scaffold sterilization and incubation in phosphate-buffered saline. Biomolecules from PRP readily penetrated into the functionalized scaffold, leading to a biological frame on the pore walls. Preliminary in vitro assays were assessed to demonstrate the improvement of scaffold behavior towards cell response. The scaffold bio-activation drastically improved cell migration. Moreover, cells interacted with all pore sides into the bio-activated scaffold forming cell bridges across pores. Our work brought out an easy and versatile way of developing functionalized and bio-activated elastomeric poly(ester-urea-urethane) scaffolds with a better cell response.

Brillouin Light Scattering Microspectroscopy for Biomedical Research and Applications: introduction to feature issue

There has been a marked revival of interest in brillouin light scattering spectroscopy/microscopy over the last decade in regards to applications related to all optically studying the mechanical problems associated with systems of biological and medical interest. This revival has been driven by advancements in spectrometer design, together with mounting evidence of the critical role that mechanical properties can play in biological processes as well as the onset of diverse diseases. This feature issue contains a series of papers spanning some of the latest developments in the field of Brillouin light scattering spectroscopy and microscopy as applied to systems of biomedical interest.