Separation and determination of synthetic impurities of sildenafil (Viagra) by reversed-phase high-performance liquid chromatography

Investigation of the Presence of Sildenafil in Herbal Dietary Supplements by Validated HPLC Method

Objectives

As the first FDA-approved phosphodiesterase type 5 inhibitor, sildenafil (SDF) is widely used in the treatment of erectile dysfunction due to its strong pharmacodynamic activity. Since many food supplements are now involved in illegal adulteration, the presence of SDF in food supplements is very important because of their toxicological risks. In this study a simple fast, reliable high-performance liquid chromatography method with ultraviolet (UV) detector has been developed and validated for SDF analysis in herbal dietary supplements (HDSs).

Materials and Methods

10 mM phosphate buffer containing 0.1% triethylamine (pH 3.5) and acetonitrile (65:35, v/v), as mobile phase was applied isocratically to a reverse phase C₁₈ analytical (4.6×250 mm, 5 μm) column. Chromatographic separation was achieved by a C₁₈ reverse-phase analytical column 4.6×250 mm, 5 μm particle size, using acetonitrile, with 10 mM phosphate buffer containing 0.1% triethylamine (65:35, v/v, pH 3.5) as a mobile phase. The mobile phase flow rate was 1 mL min^-1 and the column temperature was 35°C. The UV detector was set at 293 nm. The liquid-liquid extraction method used in the study provided a simple and practical method for the recovery of SDF in HDSs and their obtained values ranged from 87.6 to 111.7%.

Results

The method showed linearity with an excellent correlation coefficient (r²>0.999). Moreover, it was specific and sensitive with the limit of quantification, 6.5 ng mL^-1. Intraday and interday method precision was ≤8.2 (relative standard deviation %). Intraday and interday method accuracy was between -4.0 and 7.1 (RE%). The method was strong according to the robustness test results obtained from UV detection, mobile phase buffer pH, column temperature, and flow rate changes. The described procedure was simple, fast, precise, and feasible for routine adulteration analysis of SDF, especially in food control or toxicology laboratories. This method was successfully applied to 50 individual solid and liquid form HDSs.

Conclusion

The results showed that 37 out of 50 samples of HDSs (represented 74.0%) examined contained SDF between 0.01 and 465.47 mg/g, 150.87±127.48 (mean ± standard deviation), which could lead to serious health problems and might even be fatal for consumers. The described procedure was found to be simple, rapid, precise and feasible for routine adulteration analysis of SDF, especially in food control or toxicology laboratories.

Testing of complementarity of PDA and MS detectors using chromatographic fingerprinting of genuine and counterfeit samples containing sildenafil citrate

Counterfeit medicines are a global threat to public health. High amounts enter the European market, which is why characterization of these products is a very important issue. In this study, a high-performance liquid chromatography-photodiode array (HPLC-PDA) and high-performance liquid chromatography-mass spectrometry (HPLC-MS) method were developed for the analysis of genuine Viagra®, generic products of Viagra®, and counterfeit samples in order to obtain different types of fingerprints. These data were included in the chemometric data analysis, aiming to test whether PDA and MS are complementary detection techniques. The MS data comprise both MS1 and MS2 fingerprints; the PDA data consist of fingerprints measured at three different wavelengths, i.e., 254, 270, and 290 nm, and all possible combinations of these wavelengths. First, it was verified if both groups of fingerprints can discriminate between genuine, generic, and counterfeit medicines separately; next, it was studied if the obtained results could be ameliorated by combining both fingerprint types. This data analysis showed that MS1 does not provide suitable classification models since several genuines and generics are classified as counterfeits and vice versa. However, when analyzing the MS1_MS2 data in combination with partial least squares-discriminant analysis (PLS-DA), a perfect discrimination was obtained. When only using data measured at 254 nm, good classification models can be obtained by k nearest neighbors (kNN) and soft independent modelling of class analogy (SIMCA), which might be interesting for the characterization of counterfeit drugs in developing countries. However, in general, the combination of PDA and MS data (254 nm_MS1) is preferred due to less classification errors between the genuines/generics and counterfeits compared to PDA and MS data separately.

Synthesis of core-shell magnetic molecularly imprinted polymers and detection of sildenafil and vardenafil in herbal dietary supplements

An analytical procedure for selective extraction of sildenafil and vardenafil in herbal dietary supplements (HDSs) has been set up by using the magnetic molecularly imprinted polymers (MMIPs) as the extraction and clean-up materials, followed by high performance liquid chromatography-ultraviolet (HPLC-UV). The MMIPs were prepared by a surface molecular imprinting technique, using Fe(3)O(4) magnetite as a magnetically susceptible component, sildenafil as template molecule, 2-(trifluoromethyl) acrylic acid (TFMAA) as functional monomer, ethylene glycol dimethacrylate (EGDMA) as polymeric matrix components. The MMIPs were characterized by transmission electron microscope (TEM), Fourier transform infrared spectrometer (FT-IR), X-ray diffraction (XRD) and vibrating sample magnetometer (VSM), respectively. The heterogeneity of the MMIPs was modeled with the Freundlich isotherm equation. The resulting MMIPs had high recognition ability and fast binding kinetics for sildenafil. The MMIPs were used as dispersive solid-phase extraction (DSPE) materials to selectively extract sildenafil and vardenafil from HDSs, the contents of sildenafil and vardenafil were found to be 8.05 and 3.86 μg g(-1), respectively, and the average recoveries in spiked HDSs were 70.91-91.75% with a relative standard deviation (R.S.D.) below 7%. The MMIPs were successfully used to selectively enrich and determine sildenafil and vardenafil from HDSs.

Spectrophotometric determination of sildenafil citrate in pure form and in pharmaceutical formulation using some chromotropic acid azo dyes

Two simple and highly sensitive spectrophotometric methods were developed for the quantitative determination of the drug sildenafil citrate (SC), Viagra, in pure form and in pharmaceutical formulations, through ion-associate formation reactions (method A) with mono-chromotropic acid azo dyes, chromotrope 2B (I) and chromotrope 2R (II) and ion-pair reactions (method B) with bi-chromotropic acid azo dyes, 3-phenylazo-6-o-carboxyphenylazo-chromotropic acid (III), bis-3,6-(o-hydroxyphenylazo)-chromotropic acid (IV), bis-3,6-(p-N,N-dimethylphenylazo)-chromotropic acid (V) and 3-phenylazo-6-o-hydroxyphenylazo-chromotorpic acid (VI). The reaction products, extractable in methylene chloride, were quantitatively measured at 540, 520, 540, 570, 600 and 575 nm using reagents, I-VI, respectively. The reaction conditions were studied and optimized. Beer's plots were linear in the concentration ranges 3.3-87.0, 3.3-96.0, 5.0-115.0, 2.5-125.0, 8.3-166.7 and 0.8-15.0 microg mL(-1) with corresponding molar absorptivities 1.02 x 10(4), 8.34 x 10(3), 6.86 x 10(3), 5.42 x 10(3), 3.35 x 10(3) and 2.32 x 10(4)Lmol(-1) cm(-1) using reagents I-VI, respectively. The limits of detection and Sandell's sensitivities were calculated. The methods were successfully applied to the analysis of commercial tablets (Vigoran) and the recovery study reveals that there is no interference from the common excipients that are present in tablets. Statistical comparison of the results was performed with regard to accuracy and precision using Student's t- and F-tests at 95% confidence level. There is no significant difference between the reported and proposed methods with regard to accuracy and precision.

The usefulness of 2D DOSY and 3D DOSY-COSY 1H NMR for mixture analysis: application to genuine and fake formulations of sildenafil (Viagra)

Two-dimensional diffusion ordered spectroscopy (DOSY) (1)H NMR is proposed to analyze drugs that are complex mixtures in order to discriminate genuine from fake formulations. The method was applied to the analysis of 17 formulations of sildenafil, one being genuine Viagra and the others illegally manufactured formulations of this drug coming from India, Syria and China. It enabled (i) distinguishing imitations or counterfeit from the authentic formulation, (ii) detecting the presence of sildenafil or adulterants, (iii) gaining information on the formulation process by detection of various excipients, thus giving a precise and global 'signature' of the manufacturer. Even though some samples are slightly overdosed, the quality of products manufactured in India and Syria was better than that of Chinese formulations which were adulterated with vardenafil and homosildenafil. This study also presents a three-dimensional DOSY-COSY (1)H NMR experiment that provides both virtual separation and structural information.

Simultaneous determination of sildenafil, vardenafil and tadalafil as forbidden components in natural dietary supplements for male sexual potency by high-performance liquid chromatography-electrospray ionization mass spectrometry

A high-performance liquid chromatographic method coupled with ultraviolet detection and electrospray ionization mass spectrometry (HPLC-UV-ESI-MS) was developed for simultaneous determination of banned additives-sildenafil, vardenafil and tadalafil in dietary supplements for male sexual potency. The separation was achieved on a C18 column with acetonitrile and aqueous solution (20 mmol ammonium acetate, 0.2% formic acid) as mobile phase at a flow rate of I ml/min with a linear gradient program. UV detection was at 292 nm. Identification of drugs was accomplished using ESI-MS. Good linearity between response (peak area) and concentration was found over a concentration range of 0.8-80 microg/ml for sildenafil; 2.25-225 microg/ml for vardenafil; and 1.1-110 microg/ml for tadalafil, with regression coefficient is better than 0.999. The recovery of the method ranged from 93.3 to 106.1%, and the relative standard deviation varied from 2.0 to 5.6% (n = 6). The method has been successfully applied to the analysis of practical samples of natural dietary supplements.

Literature-Based Generation of Hypotheses on Chemical Composition Using Database Co-occurrence of Chemical Compounds

Candidates for identification of unknown constituents in a sample to be chemically analyzed are hypothetical. It is proposed to generate these hypotheses according to the co-occurrence of different chemical compounds with a known sample constituent in the chemical literature. The efficiency of the co-occurrence approach for predicting chemical compositions was tested for 67 impurities in 17 chemical/pharmaceutical products. The relative co-occurrence of impurity compounds and these products in the Chemical Abstracts Service database was evaluated and compared with corresponding values for several reference groups of probability sampled compounds from the literature. Almost all impurities (97%) and only < or = 8% randomly sampled compounds co-occurred with these chemical products. Mean and median values of relative co-occurrence for impurities are much higher than those of probability sampled compounds which co-occurred with the products. For the combination of impurities and the probability sample of 396 interfering compounds, the power to predict the chemical composition using the highest co-occurrences is 0.49-0.59. The co-occurrence value can also be considered as an "empiric" indicator of chemical similarity useful to generate new hypotheses on relationships both between compounds and between compounds and their properties.