Surface-Modified Sewage Sludge-Derived Carbonaceous Catalyst as a Persulfate Activator for Phenol Degradation

Lipid extraction in the primary sludge generated from urban wastewater treatment: characteristics and seasonal composition analysis

A seasonal study of the lipid composition of a primary sludge (dry and dewatered base) obtained from an urban wastewater treatment plant located in Aguascalientes (Mexico) is reported. This study assessed the variability in sludge composition to establish its potential as a raw material for biodiesel production. Lipid recovery was achieved by extraction using two solvents. Hexane was employed for lipid extraction from dry sludge, whereas hexane and ethyl butyrate were used for comparison with dewatered sludge. The formation (%) of fatty acid methyl esters (biodiesel) was determined using extracted lipids. The extraction results from the dry sludge showed 14 and 6% of recovered lipids and their conversion to biodiesel, respectively. For the dewatered sludge, the lipid recovery and biodiesel formation were 17.4 and 60% using hexane, and 23 and 77% for ethyl butyrate, respectively, on a dry basis. Statistical data indicated that lipid recovery depended on the physicochemical characteristics of sewage sludge, which were related to seasonal changes, population activities, and changes in plant configuration, among other factors. These variables must be considered in the design of large-scale extraction equipment for the application and commercial exploitation of biomass waste in biofuel production.

Hydrothermal synthesis of sewage sludge biochar for activation of persulfate for antibiotic removal: Efficiency, stability and mechanism

The use of biochar materials as catalysts to activate persulfate (PS) for the degradation of antibiotics has attracted much attention. In this study, a carbonaceous material (Cu/Zn-SBC) was prepared from sewage sludge by hydrothermal modification. The efficiency of PS activation by Cu/Zn-SBC was investigated using tetracycline (TC) as the model antibiotic. In the Cu/Zn-SBC + PS system, the TC removal rate reached 90.13% at 10 min and exceeded 99% within 4 h. This not only met the requirement of removing large amounts of pollutants in a short time but also achieved the complete removal of pollutants in the subsequent time. Additionally, the Cu/Zn-SBC + PS system was found to be dominated by radical and nonradical pathways. Cu, hydroxyl and carboxyl groups on the surface of Cu/Zn-SBC promoted the production of free radicals and non-free radicals. Under several changes in reaction conditions and water environment factors, the TC removal rate remained above 85% within 10 min. Furthermore, the removal rate of TC was still 85.79% when Cu/Zn-SBC combined with PS was reused twice and 77.14% when reused four times. This study provides an ideal solution for the treatment of sewage sludge, and offers a stable and efficient material for removing antibiotics from wastewater.

A sustainable reuse strategy of converting waste activated sludge into biochar for contaminants removal from water: Modifications, applications and perspectives

Conversion of sewage sludge to biochar for contaminants removal from water achieves the dual purpose of solid waste reuse and pollution elimination, in line with the concept of circular economy and carbon neutrality. However, the current understanding of sludge-derived biochar (SDB) for wastewater treatment is still limited, with a lack of summary regarding the effect of modification on the mechanism of SDB adsorption/catalytic removal aqueous contaminants. To advance knowledge in this aspect, this paper systematically reviews the recent studies on the use of (modified) SDB as adsorbents and in persulfate-based advanced oxidation processes (PS-AOPs) as catalysts for the contaminants removal from water over the past five years. Unmodified SDB not only exhibits stronger cation exchange and surface precipitation for heavy metals due to its nitrogen/mineral-rich properties, but also can provide abundant catalytic active sites for PS. An emphatic summary of how certain adsorption removal mechanisms of SDB or its catalytic performance in PS-AOPs can be enhanced by targeted regulation/modification such as increasing the specific surface area, functional groups, graphitization degree, N-doping or transition metal loading is presented. The interference of inorganic ions/natural organic matter is one of the unavoidable challenges that SDB is used for adsorption/catalytic removal of contaminants in real wastewater. Finally, this paper presents the future perspectives of SDB in the field of wastewater treatment. This review can contribute forefront knowledge and new ideas for advancing sludge treatment toward sustainable green circular economy.

Rhamnolipid-Enhanced ZVI-Activated Sodium Persulfate Remediation of Pyrene-Contaminated Soil

In soil, polycyclic aromatic hydrocarbons (PAHs) are tightly bound to organic components, but surfactants can effectively transform them from a solid to a liquid phase. In this study, the biosurfactant rhamnolipid (RL) was selected as the eluent; shaking elution in a thermostatic oscillator improved the elution rate of pyrene, and the effects of RL concentration, temperature, and elution time on the elution effect were compared. After four repeated washings, the maximum elution rate was 75.6% at a rhamnolipid concentration of 20 g/L and a temperature of 45 °C. We found that 38 μm Zero-Valent Iron (ZVI) had a higher primary reaction rate (0.042 h^-1), with a degradation rate of 94.5% when 3 g/L ZVI was added to 21 mM Na₂S₂O₈ at 60 °C. Finally, electron paramagnetic resonance (EPR) detected DMPO-OH and DMPO-SO₄ signals, which played a major role in the degradation of pyrene. Overall, these results show that the combination of rhamnolipid elution and persulfate oxidation system effectively remediated pyrene-contaminated soil and provides some implications for the combined remediation with biosurfactants and chemical oxidation.

A comprehensive review on persulfate activation treatment of wastewater

With increasingly serious environmental pollution and the production of various wastewater, water pollutants have posed a serious threat to human health and the ecological environment. The advanced oxidation process (AOP), represented by the persulfate (PS) oxidation process, has attracted increasing attention because of its economic, practical, safety and stability characteristics, opening up new ideas in the fields of wastewater treatment and environmental protection. However, PS does not easily react with organic pollutants and usually needs to be activated to produce oxidizing active substances such as sulfate radicals (SO₄^-) and hydroxyl radicals (OH) to degrade them. This paper summarizes the research progress of PS activation methods in the field of wastewater treatment, such as physical activation (e.g., thermal, ultrasonic, hydrodynamic cavitation, electromagnetic radiation activation and discharge plasma), chemical activation (e.g., alkaline, electrochemistry and catalyst) and the combination of the different methods, putting forward the advantages, disadvantages and influencing factors of various activation methods, discussing the possible activation mechanisms, and pointing out future development directions.

Removal of pharmaceuticals from water using sewage sludge-derived biochar: A review

In recent years, considerable attention has been paid to the beneficial utilization of sewage sludge to reduce the risks associated with sludge disposal. Besides other applications of sludge, biochar produced from sludge has also been employed for the elimination of various pollutants from water. This review critically evaluates the recent progress in applications of sludge-based biochar for the adsorption of pharmaceuticals from water. The synthesis techniques of biochar production from sludge and their effects on physicochemical characteristics of produced biochar are discussed. The removal of various pharmaceuticals by sludge-based biochar are described in detail, with the emphasis on the adsorption mechanism and their reusability potential. It is evident from the literature that sludge-based biochar has demonstrated excellent potential for the adsorption of numerous pharmaceuticals from the aqueous phase. The major hurdles and issues related to the synthesis of sludge-based biochar and applications are highlighted, with reference to the adsorption of pharmaceuticals. Finally, a roadmap is suggested along with future research directions to ensure the sustainable production of biochar from sludge and its applications in water treatment.

The sorption of Tebuconazole and Linuron from an Aqueous Environment with a Modified Sludge-Based Biochar: Effect, Mechanisms, and Its Persistent Free Radicals Study

In this study, the sludge-based biochar was prepared and utilized as an adsorbent for the removal of two commonly used pesticides in agriculture, namely tebuconazole (Teb) and linuron (Lin) in an aqueous solution. The main contributing factors such as biochar preparation conditions, persistent free radicals as well as contact time, agitation speed, biochar dose, temperature, and pH were investigated. The physicochemical properties were characterized by SEM + EDS, FTIR, BET, EPR, etc. The results showed that the maximum adsorption capacities based on the Langmuir model was 7.8650 mg g−1 for tebuconazole and that based on Freundlich model was 9.0645 mg·g-1 for linuron at 25°C. The pseudo-second-order kinetic equations were all fitted well to the kinetic process of the adsorption of the two pesticides with all R2 ≥ 0.915. The maximum values of tebuconazole adsorption capacity occur at pH = 3. Meanwhile, linuron was not affected by pH. Both Cr6+ (r = −0.793∗∗/ −0.943∗∗) and humic acid (r = −0.798∗∗/ −0.947∗∗) significantly inhibited the adsorption amount of tebuconazole and linuron onto the biochar. Electron spin resonance signals (ESR) indicated that environmentally persistent radicals (EPFRs) are preferentially formed at lower pyrolysis temperatures and lower transition metal concentrations. The g-factors for BC400, BC600, BCF400, and BCF600 were 2.0036, 2.0035, 2.0034, and 2.0033, respectively, indicating that the EPFRs mainly have a carbon-centered structure with adjacent oxygen atoms. In addition, to close to the actual situation, natural water (from YanTai) was collected to simulate pesticide contamination. This study demonstrates that sludge-based biochar can achieve efficient removal of tebuconazole and linuron in aqueous environment in a short period of time with no secondary environmental risk especially on the waste activated sludge.

Enhancement of Biogas Production via Co-Digestion of Wastewater Treatment Sewage Sludge and Brewery Spent Grain: Physicochemical Characterization and Microbial Community

The present study intends to evaluate a synergy towards enhanced biogas production by co-digesting municipal sewage sludge (SS) with brewery spent grain (BSG). To execute this, physicochemical and metagenomics analysis was conducted on the sewage sludge substrate. The automatic methane potential test system II (AMPTS II) biochemical methane potential (BMP) batch setup was operated at 35 ± 5 °C, pH range of 6.5–7.5 for 30 days’ digestion time on AMPTS II and 150 days on semi-continuous setup, where the organic loading rate (OLR) was guided by pH and the volatile fatty acids to total alkalinity (VFA/TA) ratio. Metagenomics analysis revealed that Proteobacteria was the most abundant phyla, consisting of hydrolytic and fermentative bacteria. The archaea community of hydrogenotrophic methanogen genus was enriched by methanogens. The highest BMP was obtained with co-digestion of SS and BSG, and 9.65 g/kg of VS. This not only increased biogas production by 104% but also accelerated the biodegradation of organic matters. However, a significant reduction in the biogas yield, from 10.23 NL/day to 2.02 NL/day, was observed in a semi-continuous process. As such, it can be concluded that different species in different types of sludge can synergistically enhance the production of biogas. However, the operating conditions should be optimized and monitored at all times. The anaerobic co-digestion of SS and BSG might be considered as a cost-effective solution that could contribute to the energy self-efficiency of wastewater treatment works (WWTWs) and sustainable waste management. It is recommended to upscale co-digestion of the feed for the pilot biogas plant. This will also go a long way in curtailing and minimizing the impacts of sludge disposal in the environment.