Review of Virus Inactivation by Visible Light

Photoinactivation of the bacteriophage PhiX174 by UVA radiation and visible light in SM buffer and DMEM-F12

OBJECTIVE

It has been observed that viruses can be inactivated by UVA radiation and visible light. The aim of this study is to investigate whether a medium that contains a photosensitizer might have an influence on viral reduction under irradiation by UVA, violet or blue light. Test virus is the bacteriophage PhiX174 in the photosensitizer-free SM buffer and DMEM-F12, which contains the known photosensitizer riboflavin.

RESULTS

The determined PhiX174 D90 doses in SM buffer and DMEM were 36.8 J/cm² and 13.6 J/cm² at 366 nm, 153.6 J/cm² and 129.1 J/cm² at 408 nm and 4988 J/cm² and 2477.1 J/cm² at 455 nm, respectively. It can be concluded that the medium has a large influence on the results. This might be caused by the photosensitizer riboflavin in DMEM-F12. As riboflavin is a key component in many cell culture media, irradiation experiments with viruses in cell culture media should be avoided if the investigation of intrinsical photoinactivation properties of viruses is aimed for.

UV-C irradiation as an effective tool for sterilization of porcine chimeric VP1-PCV2bCap recombinant vaccine

Ultraviolet irradiation is an effective method of virus and bacteria inactivation. The dose of UV-C light necessary for baculovirus inactivation by measurement of fluorescent GFP protein produced by baculovirus expression system after the irradiation of baculovirus culture in doses ranging from 3.5 to 42 J/m2 was determined. At a dose of 36.8 J/m2, only 0.5% of GFP-expressing cells were detected by flow cytometry and confocal microscopy. The stability of purified VP1-PCV2bCap protein produced by baculovirus expression system was analyzed after the irradiation at doses ranging from 3.5 to 19.3 J/m2. Up to the dose of 11 J/m2, no significant effect of UV-C light on the stability of VP1-PCV2bCap was detected. We observed a dose-dependent increase in VP1-PCV2bCap-specific immune response in BALB/c mice immunized by recombinant protein sterilized by irradiation in dose 11 J/m2 with no significant difference between vaccines sterilized by UV-C light and filtration. A substantial difference in the production of VP1-PCV2bCap specific IgG was observed in piglets immunized with VP1-PCV2bCap sterilized by UV-C in comparison with protein sterilized by filtration in combination with the inactivation of baculovirus by binary ethylenimine. UV-C irradiation represents an effective method for vaccine sterilization, where commonly used methods of sterilization are not possible.

Viricidal Efficacy of a 405-nm Environmental Decontamination System for Inactivation of Bacteriophage Phi6: Surrogate for SARS-CoV-2

The highly transmittable nature of SARS-CoV-2 has increased the necessity for novel strategies to safely decontaminate public areas. This study investigates the efficacy of a low irradiance 405-nm light environmental decontamination system for the inactivation of bacteriophage phi6 as a surrogate for SARS-CoV-2. Bacteriophage phi6 was exposed to increasing doses of low irradiance (~0.5 mW cm-2 ) 405-nm light while suspended in SM buffer and artificial human saliva at low (~103-4  PFU mL-1 ) and high (~107-8  PFU mL-1 ) seeding densities, to determine system efficacy for SARS-CoV-2 inactivation and establish the influence of biologically relevant suspension media on viral susceptibility. Complete/near-complete (≥99.4%) inactivation was demonstrated in all cases, with significantly enhanced reductions observed in biologically relevant media (P < 0.05). Doses of 43.2 and 172.8 J cm-2 were required to achieve ~3 log10 reductions at low density, and 97.2 and 259.2 J cm-2 achieved ~6 log10 reductions at high density, in saliva and SM buffer, respectively: 2.6-4 times less dose was required when suspended in saliva compared to SM buffer. Comparative exposure to higher irradiance (~50 mW cm-2 ) 405-nm light indicated that, on a per unit dose basis, 0.5 mW cm-2 treatments were capable of achieving up to 5.8 greater log10 reductions with up to 28-fold greater germicidal efficiency than that of 50 mW cm-2 treatments. These findings establish the efficacy of low irradiance 405-nm light systems for inactivation of a SARS-CoV-2 surrogate and demonstrate the significant enhancement in susceptibility when suspended in saliva, which is a major vector in COVID-19 transmission.

Blue 405 nm LED light effectively inactivates bacterial pathogens on substrates and packaging materials used in food processing

This study investigates the antimicrobial effectiveness of 405 nm light emitting diodes (LEDs) against pathogenic Escherichia coli O157:H7, Listeria monocytogenes, Pseudomonas aeruginosa, Salmonella Typhimurium, and Staphylococcus aureus, in thin liquid films (TLF) and on solid surfaces. Stainless steel (SS), high density polyethylene (HDPE), low density polyethylene (LDPE), and borosilicate glass were used as materials typically encountered in food processing, food service, and clinical environments. Anodic aluminum oxide (AAO) coupons with nanoscale topography were used, to evaluate the effect of topography on inactivation. The impact of surface roughness, hydrophobicity, and reflectivity on inactivation was assessed. A 48 h exposure to 405 nm led to reductions ranging from 1.3 (E. coli) to 5.7 (S. aureus) log CFU in TLF and 3.1 to 6.3 log CFU on different solid contact surfaces and packaging materials. All inactivation curves were nonlinear and followed Weibull kinetics, with better inactivation predictions on surfaces (0.89 ≤ R2 ≤ 1.0) compared to TLF (0.76 ≤ R2 ≤ 0.99). The fastest inactivation rate was observed on small nanopore AAO coupons inoculated with L. monocytogenes and S. aureus, indicating inactivation enhancing potential of these surfaces. These results demonstrate significant promise of 405 nm LEDs for antimicrobial applications in food processing and handling and the healthcare industry.

The inhibitory and inactivating effects of visible light on SARS-CoV-2: A narrative update

Prior to the coronavirus disease-19 (COVID-19) pandemic, the germicidal effects of visible light (λ = 400 - 700 nm) were well known. This review provides an overview of new findings that suggest there are direct inactivating effects of visible light - particularly blue wavelengths (λ = 400 - 500 nm) - on exposed severe acute respiratory syndrome coronavirus 2 (SARS-CoV-2) virions, and inhibitory effects on viral replication in infected cells. These findings complement emerging evidence that there may be clinical benefits of orally administered blue light for limiting the severity of COVID-19. Possible mechanisms of action of blue light (e.g., regulation of reactive oxygen species) and important mediators (e.g., melatonin) are discussed.

Photoluminescent Properties of Phosphor Based on Perovskite CsPbBr3 Nanocrystals Combined with Violet Leds

The characteristics of an LED lighting system consisting of a commercial violet LED and a green phosphor based on CsPbBr₃ nanocrystals are studied in the context of development of LED illumination sources with antibacterial effects but without harmful effects on human health. The internal efficiency of the nanocrystalline phosphor in a silicone compound was found to exceed 40%, dropping noticeably because of heating for an electric current of ~0.1 A (phosphor excitation intensity ~0.1 W/mm²). This undesirable feature can be diminished by using a remote phosphor design for the illuminators and by using chemical techniques to improve the thermal stability of the nanocrystals.

Comparative Assessment of Pulsed and Continuous LED UV-A Lighting for Disinfection of Contaminated Surfaces

The germicidal efficacy of LED UV-A lighting has scarcely been compared in continuous and pulsed modes for contaminated surfaces. Herein, we compare the disinfection properties of pulsed versus continuous lighting at equal irradiances using a 365 nm LED device that replicates the doses of occupied-space continuous disinfection UV-A products. Representative organisms evaluated in this study included human-infectious enveloped and non-enveloped viruses (lentivirus and adeno-associated virus, respectively), a bacterial endospore (Bacillus atrophaeus), and a resilient gram-positive bacterium (Enterococcus faecalis). Nominal UV-A irradiances were tested at or below the UL standard limit for continuous human exposure (maximum irradiance of 10 W/m2). We observed photoinactivation properties that varied by organism type, with bacteria and enveloped virus being more susceptible to UV-A than non-enveloped virus and spores. Overall, we conclude that continuous-mode UV-A lighting is better suited for occupied-space disinfection than pulsing UV-A at equivalent low irradiances, and we draw comparisons to other studies in the literature.

Effect of inactivating RNA viruses by coupled UVC and UVA LEDs evaluated by a viral surrogate commonly used as a genetic vector

RNA viruses are ubiquitous in nature, many of which can cause severe infectious syndromes to humanity, e.g., the SARS-CoV-2 virus. Ultraviolet (UV) radiation has been widely studied for inactivating various species of microorganisms, including viruses. The most applicable UV light for viruses ranges from 200nm to 280nm in wavelength, i.e., UVC. More recently, the synergy of UVA light with UVC has been studied in disinfecting bacteria in polluted water. However, little attention has been paid to studying viral inactivation by coupled UVC and UVA LEDs. The necessity of such research is to find an effective and economical solution for the LEDs of these two bands. Along this track, we attempt to tackle two major challenges. The first is to find a suitable viral surrogate that can safely be used in ordinary labs. In this aspect, lentivirus is commonly used as a genetic vector and has been selected to surrogate RNA viruses. Another is to determine the effective dosage of the coupled UVC and UVA light. To this end, the surrogate lentivirus was irradiated by 280nm (UVC) LEDs, 365nm (UVA) LEDs, and their combination at various doses. Survival rates were detected to compare the efficacy of various options. Moreover, the viral RNA damage was detected by RT-qPCR to disclose the mechanism of viral death. The results have shown that for the same duration of irradiation, the effect of the full-power 280nm LEDs is equivalent to that of the half-power 280nm LEDs combined with a suitable radiant power of the 365nm LEDs. The observations have been further confirmed by the effect of damaging the viral RNA by either the 280nm or 365nm light. In conclusion, the experimental results provide clear evidence of alleviating the requirement of UVC LEDs in viral inactivation by substituting them partially with UVA LEDs.

Visible 405 nm Violet-Blue Light Successfully Inactivates HIV-1 in Human Plasma

Despite significant advances in ensuring the safety of the blood supply, there is continued risk of transfusion transmitted infections (TTIs) from newly emerging or re-emerging infections. Globally, several pathogen reduction technologies (PRTs) for blood safety have been in development as an alternative to traditional treatment methods. Despite broad spectrum antimicrobial efficacy, some of the approved ultraviolet (UV) light-based PRTs, understandably due to UV light-associated toxicities, fall short in preserving the full functional spectrum of the treated blood components. As a safer alternative to the UV-based microbicidal technologies, investigations into the use of violet-blue light in the region of 405 nm have been on the rise as these wavelengths do not impair the treated product at doses that demonstrate microbicidal activity. Recently, we have demonstrated that a 405 nm violet-blue light dose of 270 J/cm² was sufficient for reducing bacteria and the parasite in plasma and platelets suspended in plasma while preserving the quality of the treated blood product stored for transfusion. Drawn from the previous experience, here we evaluated the virucidal potential of 405 nm violet-blue light dose of 270 J/cm² on an important blood-borne enveloped virus, the human immunodeficiency virus 1 (HIV-1), in human plasma. Both test plasma (HIV-1 spiked and treated with various doses of 405 nm light) and control plasma (HIV-1 spiked, but not treated with the light) samples were cultured with HIV-1 permissive H9 cell line for up to 21 days to estimate the viral titers. Quantitative HIV-1 p24 antigen (HIV-1 p24) levels reflective of HIV-1 titers were measured for each light dose to assess virus infectivity. Our results demonstrate that a 405 nm light dose of 270 J/cm² is also capable of 4–5 log HIV-1 reduction in plasma under the conditions tested. Overall, this study provides the first proof-of-concept that 405 nm violet-blue light successfully inactivates HIV-1 present in human plasma, thereby demonstrating its potential towards being an effective PRT for this blood component safety.

Influence of Visible Violet, Blue and Red Light on the Development of Cataract in Porcine Lenses

Background and Objectives: Cataract is a disease that is globally prevalent in today’s population and occurs mostly in the elderly. It is an opacity of the lens that worsens vision and can lead to blindness. One well-known risk factor of cataract is ultraviolet (UV) radiation. However, increasing exposure to modern artificial light sources like light emitting diodes (LEDs) and displays might have an impact on cataract formation due to possible high (and hidden) blue radiation. An ex-vivo study indicates that intense blue radiation causes cataract in porcine lenses. The goal of this work is the investigation whether violet or red light also lead to cataract formation in porcine lenses and to compare the impact of the different wavelengths. Materials and Methods: LEDs with wavelengths of 407 nm (violet), 463 nm (blue) and 635 nm (red) are used to irradiate ex–vivo porcine lenses with a dose of 6 kJ/cm². Before and after irradiation the lens transmissions are measured and dark field images are taken to determine cataract formation. The same procedure is performed for unirradiated controls. Results: The results of the transmission measurements are in accordance with the results of the dark field images and state that 635 nm (red) is inducing no or only weak cataract. In comparison to the dark field images the transmission measurements exhibit stronger cataract formation for 407 nm than for 463 nm irradiation while the dark field images show similar cataract formation for both wavelengths. Conclusions: Visible light of short wavelengths cause cataract formation in porcine eyes, and it cannot be excluded that these wavelengths, which are emitted by modern LED illuminants, also pose a danger to human eyes.