Sorption Characteristics and Removal Efficiency of Organic Micropollutants in Drinking Water Using Granular Activated Carbon (GAC) in Pilot-Scale and Full-Scale Tests

Analysis of degradation and pathways of three common antihistamine drugs by NaClO, UV, and UV-NaClO methods

Antihistamines (ANTs) are medicines to treat allergic diseases. They have been frequently detected in the natural water environment, posing potential threats to the ecological environment and human health. In this study, the degradation of three common antihistamines, loratadine, fexofenadine, and cetirizine, was estimated under different oxidation methods (NaClO, UV, and UV-NaClO). The results showed that UV-NaClO had the highest degree of degradation on the drugs under most conditions: 100% degradation for fexofenadine within 20 s at pH 7 and 10. Under UV irradiation, the degradation efficiencies of the three drugs during 150 s were all above 77% at a pH of 7. The drugs' removal by NaClO was much lower than that of the previous two methods. In addition, this study explored the contribution rates of active oxygen species in the photolysis process. Among them, the contribution of ¹O₂ to the fexofenadine and cetirizine removal rate reached 70%. Different aqueous matrices (HCO₃^-, NO₃^-, and humic acid) had varying degrees of influence on the degradation. Acute toxicity tests and ultraviolet scans of the degradation products showed that the drugs were not completely mineralized, and the toxicities of the intermediates were even higher than those of the parent drugs. There were 9, 8, and 10 chloride oxidation products of loratadine, fexofenadine, and cetirizine, respectively, and 8 photolysis products of cetirizine were identified. For cetirizine, it was found that there were three identical intermediates produced by photodegradation and NaClO oxidation.

Adsorbent Minimization for Removal of Ibuprofen from Water in a Two-Stage Batch Process

Pharmaceutical products in water, also known as personal pharmaceutical products or PCPPs, are developing contaminants that have the potential to impair human health and the environment in a variety of ecosystems. In this work, waste date stones, a waste product obtained from the seedless dates manufacturing industry, were used to make acid-activated carbon. This material has been utilized to extract the medicinal component ibuprofen from water, with a high adsorption capacity of 126 mg ibuprofen per g of waste date stone-generated activated carbon. A design study was conducted to minimize the amount of activated carbon required, utilizing a two-stage batch adsorption system to optimize the usage of the activated carbon. To test the model and compare the quantities of adsorbent required in the two-stage and single-stage systems under various conditions, several variables were entered into the design model.

What's in the water? - Target and suspect screening of contaminants of emerging concern in raw water and drinking water from Europe and Asia

There is growing worry that drinking water can be affected by contaminants of emerging concern (CECs), potentially threatening human health. In this study, a wide range of CECs (n = 177), including pharmaceuticals, pesticides, perfluoroalkyl substances (PFASs) and other compounds, were analysed in raw water and in drinking water collected from drinking water treatment plants (DWTPs) in Europe and Asia (n = 13). The impact of human activities was reflected in large numbers of compounds detected (n = 115) and high variation in concentrations in the raw water (range 15-7995 ng L^-1 for ∑₁₇₇CECs). The variation was less pronounced in drinking water, with total concentration ranging from 35 to 919 ng L^-1. Treatment efficiency was on average 65 ± 28%, with wide variation between different DWTPs. The DWTP with the highest ∑CEC concentrations in raw water had the most efficient treatment procedure (average treatment efficiency 89%), whereas the DWTP with the lowest ∑₁₇₇CEC concentration in the raw water had the lowest average treatment efficiency (2.3%). Suspect screening was performed for 500 compounds ranked high as chemicals of concern for drinking water, using a prioritisation tool (SusTool). Overall, 208 features of interest were discovered and three were confirmed with reference standards. There was co-variation between removal efficiency in DWTPs for the target compounds and the suspected features detected using suspect screening, implying that removal of known contaminants can be used to predict overall removal of potential CECs for drinking water production. Our results can be of high value for DWTPs around the globe in their planning for future treatment strategies to meet the increasing concern about human exposure to unknown CECs present in their drinking water.