Heavy metal concentrations in Brazilian port areas and their relationships with microorganisms: can pollution in these areas change the microbial community?

The objectives of this study were to analyze the difference in ways in which metals polluting Brazilian port areas influence bacterial communities and the selection of resistant strains. The hypothesis tested was that port areas would have microbial communities significantly different from a pristine area, mainly due to a greater load of metals found in these areas. Sediment samples were collected in two port areas (Santos and São Sebastião) and one pristine area (Ubatuba). Total DNA was extracted and MiSeq sequencing was performed. A hundred strains were isolated from the same samples and were tested for metal resistance. The community composition was similar in the two port regions, but differed from the pristine area. Microbial diversity was significantly lower in the port areas. The phyla Proteobacteria, Cyanobacteria, and Thermodesulfobacteria exhibited positive correlations with copper and zinc concentrations. Chloroflex, Nitrospirae, Planctomycetes, and Chlorobi exhibited negative correlations with copper, chromium, and zinc. Cr and Zn had higher concentrations at port areas and were responsible to select more metal-resistant strains. Some genera were found to be able to easily develop metal resistance. The most isolated genera were Bacillus, Vibrio, and Pseudomonas. This type of study can illustrate, even in very complex natural environments, the influence of pollution on the community as a whole and the consequences of these changes.

The Response of a 16S Ribosomal RNA Gene Fragment Amplified Community to Lead, Zinc, and Copper Pollution in a Shanghai Field Trial

Industrial and agricultural activities have caused extensive metal contamination of land throughout China and across the globe. The pervasive nature of metal pollution can be harmful to human health and can potentially cause substantial negative impact to the biosphere. To investigate the impact of anthropogenic metal pollution found in high concentrations in industrial, agricultural, and urban environments, 16S ribosomal RNA gene amplicon sequencing was used to track change in the amplified microbial community after metal contamination in a large-scale field experiment in Shanghai. A total of 1,566 operational taxonomic units (OTUs) identified from 448,108 sequences gathered from 20 plots treated as controls or with lead, zinc, copper, or all three metals. Constrained Analysis of Principal Coordinates ordination did not separate control and lead treatment but could separate control/lead, zinc, copper, and three metal treatment. DESeq2 was applied to identify 93 significantly differentially abundant OTUs varying in 211 pairwise instances between the treatments. Differentially abundant OTUs representing genera or species belonging to the phyla Chloroflexi, Cyanobacteria, Firmicutes, Latescibacteria, and Planctomycetes were almost universally reduced in abundance due to zinc, copper, or three metal treatment; with three metal treatment abolishing the detection of some OTUs, such as Leptolyngbya, Desmonostoc muscorum, and Microcoleus steenstrupii. The greatest increases due to metal treatment were observed in Bacteroidetes, Actinobacteria, Chlamydiae, Nitrospirae, and Proteobacteria (α, β, δ, and γ); the most (relative) abundant being uncharacterized species within the genera Methylobacillus, Solirubrobacter, and Ohtaekwangia. Three metal treatment alone resulted in identification of 22 OTUs (genera or species) which were not detected in control soil, notably including Yonghaparkia alkaliphila, Pedobacter steynii, Pseudolabrys taiwanensis, Methylophilus methylotrophus, Nitrosospira, and Lysobacter mobilis. The capacity to track alterations of an amplified microbial community at high taxonomic resolution using modern bioinformatic approaches, as well as identifying where that resolution is lost for technical or biological reasons, provides an insight into the complexity of the microbial world resisting anthropogenic pollution. While functional assessment of uncharacterized organisms within environmental samples is technically challenging, an important step is observing those organisms able to tolerate extreme stress and to recognize the extent to which important amplifiable community members still require characterization.