Significance of peripheral layer: the case of mucus flow through a ciliated tube using Rabinowitsch model

Modern medicine has taken energy loss during cilia beating in the human stomach, which under some circumstances causes blood flow to become acidic, very seriously. In current report covering a whole advancement and results for the impact of Rabinowitsch model with cilia-driven flow analysis with the help of ciliary beating in a cylindrical tube. The fluid is incompressible, and layers of fluid do not mix. The fluid flow with heat and mass transfer is firstly modeled in wave and then transformed into fixed frame. Exact solutions for stresses, temperature velocity, and concentration profiles whereas numerical pressure rise is obtained subject to relevant boundary conditions. The behavior of incipient parameters is shown graphically (plotted in MATHEMATICA 13.0) in the results section. The key findings obtained from graphical results show that maximum magnitude for velocity and temperature is achieved in middle layer of fluid whereas in the outer layer concentration profile is maximum. The current study may help researchers to develop new treatments for diseases such as cystic fibrosis, in which impaired ciliary function leads to mucus accumulation in the lungs. The attained exact and numerical outcomes are novel and offered here for first time in literature.

Evaluation of cadmium, lead, nickel and zinc status in biological samples of smokers and nonsmokers hypertensive patients

The objective of this study was to evaluate the association between trace and toxic elements zinc (Zn), cadmium (Cd), nickel (Ni) and lead (Pb) in biological samples (scalp hair, blood and urine) of smoker and nonsmoker hypertensive patients (n=457), residents of Hyderabad, Pakistan. For the purpose of comparison, the biological samples of age-matched healthy controls were selected as referents. The concentrations of trace and toxic elements were measured by atomic absorption spectrophotometer prior to microwave-assisted acid digestion. The validity and accuracy of the methodology were checked using certified reference materials and by the conventional wet acid digestion method on the same certified reference materials and real samples. The recovery of all the studied elements was found to be in the range of 97.8-99.3% in certified reference materials. The results of this study showed that the mean values of Cd, Ni and Pb were significantly higher in scalp hair, blood and urine samples of both smoker and nonsmoker patients than in referents (P<0.001), whereas the concentration of Zn was lower in the scalp hair and blood, but higher in the urine samples of hypertensive patients. The deficiency of Zn and the high exposure of toxic metals as a result of tobacco smoking may be synergistic with risk factors associated with hypertension.

Toxic metals distribution in different components of Pakistani and imported cigarettes by electrothermal atomic absorption spectrometer

It was extensively investigated that a significant flux of toxic metals, along with other toxins, reaches the lungs through smoking. In present study toxic metals (TMs) (Al, Cd, Ni and Pb) were determined in different components of Pakistani local branded and imported cigarettes, including filler tobacco (FT), filter (before and after normal smoking by a single volunteer) and ash by electrothermal atomic absorption spectrometer (ETAAS). Microwave-assisted digestion method was employed. The validity and accuracy of methodology were checked by using certified sample of Virginia tobacco leaves (ICHTJ-cta-VTL-2). The percentages (%) of TMs in different components of cigarette were calculated with respect to their total contents in FT of all branded cigarettes before smoking, while smoke concentration has been calculated by subtracting the filter and ash contents from the filler tobacco content of each branded cigarette. The highest percentage (%) of Al was observed in ash of all cigarettes, with range 97.3-99.0%, while in the case of Cd, a reverse behaviour was observed, as a range of 15.0-31.3% of total contents were left in the ash of all branded cigarettes understudy.

Assessment of water quality of polluted lake using multivariate statistical techniques: a case study

Multivariate statistical techniques, cluster analysis (CA) and principal component analysis (PCA) were applied to the data on water quality of Manchar Lake (Pakistan), generated during 2005-06, with monitoring at five different sites for 36 parameters. This study evaluated and interpreted complex water quality data sets and apportioned of pollution sources to get better information about water quality and to design a monitoring network. The chemical correlations were observed by PCA, which were used to classify the samples by CA, based on the PCA scores. Three significant sampling locations--(sites 1 and 2), (site 4) and (sites 3 and 5)--were detected on the basis of similarity of their water quality. The results revealed that the major causes of water quality deterioration were related to inflow of effluent from industrial, domestic, agricultural and saline seeps into the lake at site 1 and also resulting from people living in boats and fishing at sites 2 and 3.

Evaluation of arsenic, cobalt, copper and manganese in biological Samples of Steel mill workers by electrothermal atomic absorption Spectrometry

The determination of trace and toxic elements in biological samples (blood, urine and scalp hair samples) of human beings is an important clinical test. The aim of our present study was to determine the concentration of arsenic (As), copper (Cu), cobalt (Co) and manganese (Mn), in biological samples of male production workers (PW) and quality control workers (QW) of steel mill, with aged 25–55 years, to assess the possible influence of environmental exposure. For comparison purpose, the same biological samples of unexposed healthy males of same age group were collected as control subjects. The determination of all elements in biological samples was carried out by electrothermal atomic absorption spectrometry, prior to microwave assisted acid digestion. The accuracy of the As, Cu, Co and Mn measurements was tested by simultaneously analyzing certified reference materials (CRMs) and for comparative purposes conventional wet acid digestion method was used on the same CRMs. No significant differences were observed between the analytical results and the certified values, using both methods (paired t-test at P > 0.05). The results indicate that concentrations of As, Cu, Co and Mn in all three biological samples of the exposed workers (QW and PW) were significantly higher than those of the controls. The possible correlation of these elements with the etiology of different physiological disorders is discussed. The results were also demonstrated the need of attention for improvements in workplace, ventilation and industrial hygiene practices.

Time saving modified BCR sequential extraction procedure for the fraction of Cd, Cr, Cu, Ni, Pb and Zn in sediment samples of polluted lake

The mobility, availability and persistence of heavy metals (Cd, Cr, Cu, Ni, Pb and Zn) in contaminated lake sediment samples were evaluated by means of sequential extraction scheme, proposed by the Community Bureau of Reference protocol (BCR). The metal content in the extracts was measured by atomic absorption spectrometry. The precision and accuracy of the proposed procedure were evaluated by using a certified reference material BCR 701. The maximum recoveries for heavy metals (HMs) were observed for all three steps of BCR protocol at 32h total shaking period instead of previously reported 51h, with p>0.05. The lixiviation tests (DIN 38414-S4) were used to evaluate the leaching of HMs from sediment samples and it was observed that levels of water extractable HMs were low as compared to those values obtained by acid-soluble fraction of the BCR protocol.

Total dissolved and bioavailable elements in water and sediment samples and their accumulation in Oreochromis mossambicus of polluted Manchar Lake

The concentrations of 15 elements were determined in water, sediment and tissues of fish (Oreochromis mossambicus) collected from five sampling stations of Manchar Lake in 2005 for two successive seasons, winter (WS) and summer (SS). Elements analysis was performed by atomic absorption spectrometry with flame (FAAS) and electrothermal (ETAAS) modes, using multielement standard solution. The obtained results show that, the trace and toxic elements (As, Cd, Co, Cr, Cu, Fe, Mn, Ni, Pb and Zn) and macronutrients (Al, Ca, K, Mg and Na) concentrations in lake water were above the recommended drinking water standards by WHO. Concentrations of Na detected in lake water in WS and SS, were in the range of 445.5-562.7 and 420.6-643.5 mgl(-1), respectively. While among toxic elements As concentration in both seasons, have been found in the range of 60.4-88.9 and 64.9-101.8 microgl(-1) respectively, these values are 6-10 times higher than the permissible limit of WHO. The mean concentrations of elements understudy in muscles of fish were found as 2.35, 1.39, 0.46, 2.3, 1517.9, 2.2, 2.4 and 188.9 mgkg(-1) for As, Cd, Cr, Cu, Fe, Ni, Pb and Zn, respectively. High accumulation of toxic elements in fish tissues is indicating that some of the metal contaminants are entering the food chain. Correlations among the variables were identified by multivariate analysis. The extraction of elements from sediments with EDTA, to predict the bioavailability of trace and toxic elements, has shown that among them As, Cd and Zn were the most bioavailable elements in lake sediment.

Determination of cadmium in whole blood and scalp hair samples of Pakistani male lung cancer patients by electrothermal atomic absorption spectrometer

A large number of epidemiologic studies have been undertaken to identify potential risk factors for cancer, amongst which the association with cadmium has received considerable attention. There is compelling evidence in support of positive associations between cadmium and risk of lung cancer. In present study we measured the concentration of Cd in whole blood and scalp hair samples of 120 male lung cancer patients (smokers) and 150 controls or referents (smokers and nonsmokers) from different cities of Pakistan. Both referents and patients were of same age group (ranged 40-70 years), socio-economic status, localities and dietary habits. The scalp hair and whole blood samples were oxidized by 65% nitric acid: 30% hydrogen peroxide (2:1) ratio in microwave oven. To check the validity of the proposed method, a conventional wet acid digestion method was used to obtain total Cd concentration in certified samples of human hair BCR 397 and Clincheck control-lyophilized human whole blood. All digests were analyzed for Cd concentration by electrothermal atomic absorption spectrometer (ETAAS). The results of this study showed that the average Cd concentration was higher in the blood and scalp hair of lung cancer patients at different stages as compared to controls (p<001). The smoker referents have high level of Cd in both biological samples as compared to nonsmoker subjects. These results illustrate that the patients who continued smoking after confirmed diagnosis of lung cancer have 34.2-67.26 and 22.4-57.3% more Cd in blood samples and scalp hair than lung cancer patients who cease smoking. This study is compelling evidence in support of positive associations between cadmium, cigarette smoking and lung cancer risk.

An ultrasonic assisted extraction method to release heavy metals from untreated sewage sludge samples

A rapid ultrasound accelerated sequential extraction procedure has been used to develop sequential extraction proposed by BCR protocol (the community Bureau of Reference now the European Union "Measurement and Testing Programme"). The effects of the ultrasonic treatment on the extraction of Cu, Cd, Cr, Pb, Ni and Zn from untreated sewage sludge collected from industrial site of Hyderabad city (Pakistan) were compared with those obtained from conventional sequentional extraction procedure of modified BCR protocol. In BCR method, each extraction steps takes 10h, where as with the use of compromise sonication conditions in ultrasonic bath, steps 1-3 of the sequential extraction (excluding the hydrogen peroxide digestion in step 3, which was not performed with sonication) could be completed in 30, 30 and 30 min, respectively. Extractable Cd, Cr, Pb and Ni contents were obtained by both comparable methodologies were measured by electrothermal atomic absorption spectrometry (ETAAS), while for Cu and Zn Flame atomic absorption spectrometry (FAAS) was used. The validations of both methods were compared by the analysis of certified reference material of soil amended with sewage sludge (BCR 483). According to statistical evaluation of the results, the proposed accelerated extraction method is valid alternative to conventional shaking with much shorter extraction time with p value <0.05. The overall metal recoveries in steps 1-3 (excluding residual step) were 95-100% of those obtained with the conventional BCR protocol, except for Cu extracted (91.6%) as related to indicative values of Cu in BCR 483 obtained in 1-3 steps. The results of the partitioning study of untreated industrial waste water sewage sludge, indicate that more easily mobilized forms (acid exchangeable) were predominant for Cd and Zn, in contrast, the largest amount of Pb and Cr was associated with the iron/manganese oxide and organic matter/sulphide fractions.

Evaluating the mobility of toxic metals in untreated industrial wastewater sludge using a BCR sequential extraction procedure and a leaching test

The distribution and speciation of toxic metals in industrial wastewater sludge (IWS) was investigated. In this work, the modified BCR three-stage sequential extraction procedure was applied to the fractionation of Cr Pb Ni, and Cd in untreated industrial wastewater sludge from industrial sites in Hyderabad (Pakistan). The extracts were analyzed using electrothermal atomic absorption spectrometry. The procedure was evaluated using a certified reference material for soil mixed with sewage sludge BCR 483. The results from the partitioning study indicate that more easily mobilized forms (acid exchangeable) of Cd were dominant. The oxidizable fraction was dominant for all four toxic metals. Metal recovery was good, with <4% difference between the total metal recovered through the extractant steps and the total metal determined after microwave digestion. Lixiviation tests (DIN 38414-S4) were used to evaluate the leaching of toxic species from IWS, and it was observed that levels of leachable toxic metals were low compared to the amount of metal extracted in the exchangeable fraction of the BCR protocol.