Ethanol, not water, should be used as the dispersant when measuring microplastic particle size distribution by laser diffraction

Size distribution is a crucial characteristic of microplastics (MPs). A typical method for measuring this property is wet laser diffraction. However, when measuring size distributions of MPs, despite it being a poor dispersant for many MPs, water is commonly selected, potentially limiting the reliability of reported measurements. To evaluate dispersant suitability, different aqueous concentrations of ethanol (0, 10, 20, 30, 40, 50, 75, 100 wt%) and aqueous solutions of 0.001 wt% Triton X-100 and a mixture comprising 10 wt% sodium pyrophosphate and 10 wt% methanol were used as dispersants in a laser granulometer (Mastersizer 2000) to determine particle size distributions (PSDs) of granular polyethylene MP35, MP125 and MP500 particles (nominally <35, <125 and, < 500 μm in size). The reliability of the PSDs depended on the dispersant used and size of primary MPs. With increasing ethanol concentrations, PSD curves of MP35 particles shifted from multi-modal to mono-modal distributions. The measured size distribution reduced from 1588.7 to 4.5 μm in water to 39.9 to 0.1 μm in 100 wt% ethanol. Generally, as ethanol concentration increased, uncertainty associated with the PSD parameters decreased. Although Triton X-100 and the mixed solution also showed better dispersion than water, measured particle sizes and coefficient of variation (COV, %) were notably larger than those for 100 wt% ethanol. Similar trends were observed for larger-sized MP125 and MP500 particles, but differences in PSD curves, PSD parameters, and COV (%) among dispersants were less pronounced. In all dispersants, the volume weighted mean diameters (VWMD) in 100 wt% ethanol (MP35: 14.1 μm, MP125: 102.5 μm, MP500: 300.0 μm) were smallest and close to diameters determined from microscope observations (MP35: 14.6 μm, MP125: 109.0 μm, MP500: 310.6 μm). Therefore, for accurate determinations of the PSDs of MP by wet laser diffraction, ethanol rather than water should be used as the dispersant.

Analysis of the Algae Growth Dynamics in the Hydroponic System with LEDs Nighttime Lighting Using the Laser Granulometry Method

The latest research focused on the analysis of algal growth and the dynamics of their growth use the laser diffraction technique, enabling determination of the volume fraction of suspended particles with specific diameters in aqueous solution as well as their fractal dimensions. This study focuses on the possibility of using a laser granulometer to assess the growth dynamics of algae growing in treated wastewater in a hydroponic system, supported by artificial lighting with the use of light-emitting diodes (LEDs). On the basis of the measurements, the fractal dimension (Df) of algae was determined. An attempt was made to apply the modified Avrami equation describing the crystallization process for the analysis of algae growth dynamics in wastewater. Presented results show that the fractal dimension of suspended matter, largely created by algae, in the case of additional lighting of the hydroponic system at night, takes lower values (Df ~ 1.0) than in sewage without additional light source (Df ~ 2.0). In each measurement series, the fractal dimension of particles in the tank with lighting in the end of the experiment was about 33-43% lower than in the tank without LEDs. The analysis of changes in particle diameters calculated on the basis of Avrami equation largely corresponds with the stages of algae growth. During the measurement series with lower air temperatures, the growth of algae in the tank with additional light was faster than in the tank without LEDs. The obtained information can be the basis for determining the effective method of removing algae from wastewater treated in the hydroponic system, before they are discharged to the receiver in order to prevent the outflow of increased concentrations of total suspended solids.

Analysis of Granulometric Composition of Algal Suspensions in Wastewater Treated with Hydroponic Method

The aim of the study was to determine the changes in suspension particle size identified in biologically treated wastewater, which was then treated in hydroponic system with use of engineering lighting by the light-emitting diodes (LED). The study was subjected to wastewater purified under laboratory conditions, in a hydroponic system using the effect of macrophytes Pistia stratiotes and growing algae. Measurement of particle size was made using a laser granulometer. Analysis of the results showed that the additional lighting of the hydroponic system with LED can significantly influence the ability of the suspension particles to agglomerate and, consequently, determine their sedimentation properties. In hydroponic system supported by additional lighting, more particles were observed with equivalent diameter D(3.2) smaller than 10 μm than those in the tank without additional lighting, indicating a higher reactivity of the particles. Determining the size of equivalent diameters D(4.3) allowed us to observe that in hydroponic system, particles of relatively small size predominate, which negatively affects the sedimentation process of the suspensions. Determination of particle size of suspensions consisting mainly of algae and the dynamics of their changes are the basis for specification of an effective method of removing particles from the system to protect the receiver from excessive suspension concentrations.