Low-Toxicity Solvents for the Extraction of Valuable Lipid Compounds from Octopus (Octopus vulgaris) Waste

This study focused on the recovery of valuable lipid compounds from octopus (Octopus vulgaris) by-products. Extraction conditions of total lipids (TLs), phospholipids (PLs), eicosapentaenoic acid (EPA), and docosahexaenoic acid (DHA) were optimized by employing a Simplex-Lattice design; for it, different relative concentrations of three low-toxicity solvents (ethanol, acetone, and ethyl acetate) were considered. The optimization process was also addressed in reference to fatty acid (FA) ratios (total polyunsaturated FAs/total saturated FAs and total ω3 FAs/total ω6 FAs). The variance analysis of multiple regression data demonstrated that the quadratic model was significant (p < 0.05) for TL, PL, and DHA values and the ω3/ω6 ratio. As a result, the following optimized values were obtained: 113.8 g·kg-1 dry by-products (TLs), 217.3 g·kg-1 lipids (PLs), 22.55 g·100 g-1 total FAs (DHA), and 3.70 (ω3/ω6 ratio). According to the model developed, optimized values were shown to correspond to the following relative solvent concentrations (ethanol/acetone/ethyl acetate): 0.46/0.00/0.54, 0.93/0.07/0.00, 0.83/0.17/0.00, and 0.64/0.00/0.36, respectively. Comparison to yields obtained by the conventional chloroform/methanol method was carried out. A novel strategy based on the employment of low-toxicity solvents is proposed for the extraction of valuable lipid constituents from octopus waste. A different solvent ratio would be necessary according to the lipid compound concerned.

Optimisation of Low-Toxicity Solvent Employment for Total Lipid and Tocopherol Compound Extraction from Patagonian Squid By-Products

The extraction of total lipids and tocopherol compounds from Patagonian squid (Doriteuthis gahi) by-products (viscera, heads, skin, etc.), resulting from squid mantel commercialisation, was studied. An optimisation simplex-lattice design by employing low-toxicity solvents (ethanol, acetone, and ethyl acetate) was carried out taking into account their relative concentrations. The variance analysis of data showed that the quadratic model was statistically significant (p < 0.05); empirical coded equations were obtained as a function of the low-toxicity solvent ratios. The optimised lipid extraction was obtained by employing the 0.642/0.318/0.040 (ethanol/acetone/ethyl acetate) solvent ratio, respectively, leading to an 84% recovery of the total lipids extracted by the traditional procedure. In all extracting systems tested, the presence of α-, γ-, and δ-tocopherol compounds was detected, α-tocopherol being the most abundant. For α-, γ-, and δ-tocopherol compounds, the optimisation process showed that acetone extraction led to the highest concentrations in the lipid extract obtained (2736.5, 36.8, and 2.8 mg·kg^-1 lipids, respectively). Taking into account the recovery yield on a by-product basis, the values obtained for the three tocopherols were included in the 88.0-97.7%, 80.0-95.0%, and 25-75% ranges, respectively, when compared to the traditional extraction. This study provides a novel and valuable possibility for α-tocopherol extraction from marine by-products.

Simplex-Lattice Hydration Prediction and Microstructure Verification of Cementitious Systems

In this investigation, the age-dependent hydration development of blended pastes containing Portland cement (PC), pulverized fuel ash (PFA) and silica fume (SF) was assessed by quantifying the amount of CH and non-evaporable water using thermo-gravimetric analysis (TGA). Microstructure was investigated using scanning electron microscope (SEM). It was observed that the amount of liberated CH increases up to three-days in PC-PFA binary blended pastes, after which it progressively decreases and this reduction was proportional to the PFA dosage. The introduction of SF to PC-PFA binary mixtures to form ternary blended pastes has caused an early reduction of CH at one day where the majority of SF has been consumed during the first seven-days. The incorporation of 10% SF to PC-PFA pastes altered the low rate of hydration at early age. In addition, the presence of PFA showed insignificant influence on the non-evaporable water content until three-days then its effect became significant after seven-days. On the other hand, SF increased the non-evaporable water content from early ages up to seven-days. However, beyond 28 days, the presence of SF did not exhibit further pozzolanic activity. Furthermore, the ternary blended systems significantly increased the non-evaporable water content within three to seven days compared to the reference paste. Moreover, prediction nonlinear models of these hydration parameters were developed using the simplex-lattice design and validated against the experimental results. The latter have been further supported with SEM microstructural analysis showing good agreement between the predicted and realistic hydration.