The composition and oxidative stability of vegetarian omega-3 algal oil nanoemulsions suitable for functional food enrichment

Flavor release and stability comparison between nano and conventional emulsion as influenced by saliva

Flavour release and emulsion stability depend on volatile organic compounds' environmental conditions, food microstructure, and physicochemical properties. The effect of pH (3.5 vs 7.0) and saliva addition on stability and flavour release from nano and conventional emulsions was investigated using particle size, charge and Lumisizer measurments. Larger particle sizes were observed at lower pressures and in saliva-containing emulsions. At 1700 bar, nano-emulsions (below 150 nm) were created at pH 3.5 and 7.0 including saliva-containing emulsions. As was clear from the creaming velocity measurements, saliva addition decreased the emulsion stability by reducing particle charges and increased viscosity by more than 50%, especially when prepared at pH 3.5 closer to the isoelectric point of the used emulsifier β-lactoglobulin (pH 5.2). (5.2). Flavour release from emulsions was measured at equilibrium using a phase ratio variation to determine partition coefficients and dynamically using an electronic nose. Partition coefficients of the flavour compounds for most conditions were two to four times lower in emulsions prepared at pH 7.0 than at pH 3.5 and in emulsions without saliva. Emulsions prepared with higher pressures showed stronger flavor release rates, while additional salvia dropped the release rate for ethyl acetate at pH 3.5. The physicochemical properties of flavour compounds, saliva addition and pH of emulsions influenced flavour release more than homogenization pressures. The potential in using nano-emulsions in food applications an be attributed higher stability and enhanced flavor release.

Effects of microencapsulation in dairy matrix on the quality characteristics and bioavailability of docosahexaenoic acid astaxanthin

BACKGROUND

Compared with free astaxanthin (Asta), docosahexaenoic acid astaxanthin monoester (Asta-C22:6) has higher stability and bioavailability. However, Asta-E is still unable to be used in the water system. Hence it is necessary to build a water-soluble delivery system. In this study, Asta-C22:6 microemulsion and microcapsule using whey protein isolate (WPI) and hydroxypropyl-β-cyclodextrin (HPβ-CD) as composite wall material were prepared. They were added to three dairy products (milk powder, yogurt and flavored dairy product). A dairy product rich in Asta-C22:6 with high bioavailability was designed by measuring quality characteristics, sensory evaluation and in vivo experiments.

RESULTS

Compared with spray drying, the freeze-drying microcapsule had a higher encapsulation efficiency (72.5%), water content (4%) and better solubility, and Asta-C22:6 microcapsule (1 g L^-1 ) yogurt had the best quality. The bioavailability of Asta-C22:6 microcapsule yogurt was further evaluated. After a single oral dose in mice, the bioavailability of Asta-C22:6 microcapsule in yogurt was significantly increased (C_max  = 0.31 μg mL^-1 , AUC_0-T  = 3.20 h μg mL^-1 ).

CONCLUSION

We successfully prepared Asta-C22:6 microcapsule yogurt, which improved the stability and bioavailability of Asta. The present research is meaningful for delivering unstable bioactive small molecules based on WPI and HPβ-CD. It provides an experimental basis for the application of Asta-C22:6 and the development of functional dairy products. © 2022 Society of Chemical Industry.

Production, Processing, and Protection of Microalgal n-3 PUFA-Rich Oil

Microalgae have been increasingly considered as a sustainable “biofactory” with huge potentials to fill up the current and future shortages of food and nutrition. They have become an economically and technologically viable solution to produce a great diversity of high-value bioactive compounds, including n-3 polyunsaturated fatty acids (PUFA). The n-3 PUFA, especially eicosapentaenoic acid (EPA) and docosahexaenoic acid (DHA), possess an array of biological activities and positively affect a number of diseases, including cardiovascular and neurodegenerative disorders. As such, the global market of n-3 PUFA has been increasing at a fast pace in the past two decades. Nowadays, the supply of n-3 PUFA is facing serious challenges as a result of global warming and maximal/over marine fisheries catches. Although increasing rapidly in recent years, aquaculture as an alternative source of n-3 PUFA appears insufficient to meet the fast increase in consumption and market demand. Therefore, the cultivation of microalgae stands out as a potential solution to meet the shortages of the n-3 PUFA market and provides unique fatty acids for the special groups of the population. This review focuses on the biosynthesis pathways and recombinant engineering approaches that can be used to enhance the production of n-3 PUFA, the impact of environmental conditions in heterotrophic cultivation on n-3 PUFA production, and the technologies that have been applied in the food industry to extract and purify oil in microalgae and protect n-3 PUFA from oxidation.

Formation, Stability and Properties of Hemp Seed Oil Emulsions for Application in the Cosmetics Industry

Hemp seed oil has good sun protection, repair, anti-allergy and anti-aging effects, and is a high quality raw material for the production of skincare products. However, the influence of surfactants and co-surfactants on the emulsification of hemp seed oil in aqueous solution has been rarely investigated. In this investigation, the surfactants and co-surfactants which were suitable for hemp seed oil emulsion were optimized, and the factors which influence the particle size and the stability of the emulsion were studied. Moreover, the application of hemp seed emulsion in different cosmetics was also further investigated. It was found that sorbitan monooleate/polysorbate-80 and glyceryl stearate were the most effective surfactant and co-surfactant in the emulsification of hemp seed oil. After three months the hemp seed oil emulsion had no layered separation and remained homogeneous at -48C, 258C and 408C. The water-resistant sunscreens and the hemp seed oil sunscreens were homogeneous pastes, had a soft texture and were stable at higher temperatures. No microorganisms were detected in these cosmetic creams. Therefore, hemp seed oil is suitable for sunscreen cosmetic materials.

Bioavailability and conversion of plant based sources of omega-3 fatty acids - a scoping review to update supplementation options for vegetarians and vegans

Omega-3 (n-3) fatty acids offer a plethora of health benefits with the majority of evidence showing beneficial effects from marine sources of eicosapentaenoic acid (EPA) and docosahexaenoic acid (DHA). Emerging research examines the effects of n-3 dietary intakes on blood markers of vegetarians and vegans, but official guidance for plant based marine alternatives is yet to reach consensus. This scoping review provides an overview of trials investigating bioavailability of plant n-3 oils including EPA and DHA conversion. Searches of MEDLINE, PubMed, CINAHL and clinical trial registers identified randomized controlled trials from January 2010 to September 2020. The 'Omega-3 index' (EPA + DHA (O3I)), was used to compare n-3 status, metabolic conversion and bioavailability. Two reviewers independently screened articles and extracted data on outcomes. From 639 identified articles, screening and eligibility checks gave 13 articles. High dose flaxseed or echium seed oil supplements, provided no increases to O3I and some studies showed reductions. However, microalgal oil supplementation increased O3I levels for all studies. Findings indicate preliminary advice for vegetarians and vegans is regular consumption of preformed EPA and DHA supplements may help maintain optimal O3I. Further studies should establish optimum EPA and DHA ratios and dosages in vegetarian and vegan populations.

Small-Angle Neutron Scattering Study of High Fat Fish Oil-In-Water Emulsion Stabilized with Sodium Caseinate and Phosphatidylcholine

We report on small-angle neutron scattering (SANS) investigations of separate phase domains in high fat (70%) oil-in-water emulsions emulsified with the combination of sodium caseinate (CAS) and phosphatidylcholine (PC). The emulsion as a whole was studied by contrast variation to identify scattering components dominated by individual emulsifiers. The emulsion was subsequently separated into the aqueous phase and the oil-rich droplet phase, which were characterized separately. Emulsions produced with 1.05% (w/w) CAS and PC fraction which varies between 1.75% (w/w) and 0.35% (w/w) provided droplets between 10 and 19 μm in surface weighted mean in 70% fish oil-in-water emulsions. At least two-third of the overall CAS is associated with the interface, while the rest remains with the aqueous phase. Six percent of PC formed a monolayer in the interface, while the rest of the PC remains in the droplet phase in the form of multilayers. When the separated components were resuspended, the resuspended emulsion showed similar characteristics compared to the original emulsion in terms of droplet size distribution and neutron scattering. Instead, CAS in the aqueous phase separated from the emulsion shows aggregation not present in the corresponding CAS-in-D₂O system.

The formation, stability of DHA/EPA nanoemulsion prepared by emulsion phase inversion method and its application in apple juice

This study prepared edible docosahexaenoic acid (DHA) and eicosapentaenoic acid (EPA) nanoemulsion using EPI (emulsion phase inversion) method. The method for preparing DHA and EPA nanoemulsions is safe, convenient, low in energy consumption and can be used for food production. Factors affecting particle size and stability during preparation were investigated. Based on the optimal particle size combination, stability studies including particle size and residual rates of DHA and EPA at different temperature, pH and metal ions. The results showed that the nanoemulsion had good stability at low temperature storage, near neutral pH and in the absence of transition metal ions such as Fe³⁺, Cu²⁺, Al³⁺. The experiment initially studied the effect of nanoemulsion on apple juice beverage on the basic properties of juice itself. It was feasible in practical application of edible nanoemulsion.