High transesterification activities of immobilized proteases in new ether-functionalized ionic liquids

Ionic Liquids in Metal, Photo-, Electro-, and (Bio) Catalysis

Ionic liquids (ILs) have unique physicochemical properties that make them advantageous for catalysis, such as low vapor pressure, non-flammability, high thermal and chemical stabilities, and the ability to enhance the activity and stability of (bio)catalysts. ILs can improve the efficiency, selectivity, and sustainability of bio(transformations) by acting as activators of enzymes, selectively dissolving substrates and products, and reducing toxicity. They can also be recycled and reused multiple times without losing their effectiveness. ILs based on imidazolium cation are preferred for structural organization aspects, with a semiorganized layer surrounding the catalyst. ILs act as a container, providing a confined space that allows modulation of electronic and geometric effects, miscibility of reactants and products, and residence time of species. ILs can stabilize ionic and radical species and control the catalytic activity of dynamic processes. Supported IL phase (SILP) derivatives and polymeric ILs (PILs) are good options for molecular engineering of greener catalytic processes. The major factors governing metal, photo-, electro-, and biocatalysts in ILs are discussed in detail based on the vast literature available over the past two and a half decades. Catalytic reactions, ranging from hydrogenation and cross-coupling to oxidations, promoted by homogeneous and heterogeneous catalysts in both single and multiphase conditions, are extensively reviewed and discussed considering the knowledge accumulated until now.

What do we learn from enzyme behaviors in organic solvents? - Structural functionalization of ionic liquids for enzyme activation and stabilization

Enzyme activity in nonaqueous media (e.g. conventional organic solvents) is typically lower than in water by several orders of magnitude. There is a rising interest of developing new nonaqueous solvent systems that are more "water-like" and more biocompatible. Therefore, we need to learn from the current state of nonaqueous biocatalysis to overcome its bottleneck and provide guidance for new solvent design. This review firstly focuses on the discussion of how organic solvent properties (such as polarity and hydrophobicity) influence the enzyme activity and stability, and how these properties impact the enzyme's conformation and dynamics. While hydrophobic organic solvents usually lead to the maintenance of enzyme activity, solvents carrying functional groups like hydroxys and ethers (including crown ethers and cyclodextrins) can lead to enzyme activation. Ionic liquids (ILs) are designable solvents that can conveniently incorporate these functional groups. Therefore, we systematically survey these ether- and/or hydroxy-functionalized ILs, and find most of them are highly compatible with enzymes leading to high activity and stability. In particular, ILs carrying both ether and tert-alcohol groups are among the most enzyme-activating solvents. Future direction is to learn from enzyme behaviors in both water and nonaqueous media to design biocompatible "water-like" solvents.

Lipase-Catalyzed Synthesis of Sucrose Monolaurate and Its Antibacterial Property and Mode of Action against Four Pathogenic Bacteria

The aim of this work was to evaluate the antibacterial activities and mode of action of sucrose monolaurate (SML) with a desirable purity, synthesized by Lipozyme TL IM-mediated transesterification in the novel ionic liquid, against four pathogenic bacteria including L. monocytogenes, B. subtilis, S. aureus, and E. coli. The antibacterial activity was determined by minimum inhibitory concentration (MIC), minimum bactericidal concentration (MBC), and the time⁻kill assay. SML showed varying antibacterial activity against tested bacteria with MICs and MBCs of 2.5 and 20 mM for L. monocytogenes, 2.5 and 20 mM for B. subtilis, 10 and 40 mM for S. aureus, respectively. No dramatic inhibition was observed for E. coli at 80 mM SML. Mechanism of bacterial inactivation caused by SML was revealed through comprehensive factors including cell morphology, cellular lysis, membrane permeability, K⁺ leakage, zeta potential, intracellular enzyme, and DNA assay. Results demonstrated that bacterial inactivation against Gram-positive bacteria was primarily induced by the pronounced damage to the cell membrane integrity. SML may interact with cytoplasmic membrane to disturb the regulation system of peptidoglycan hydrolase activities to degrade the peptidoglycan layer and form a hole in the layer. Then, the inside cytoplasmic membrane was blown out due to turgor pressure and the cytoplasmic materials inside leaked out. Leakage of intracellular enzyme to the supernatants implied that the cell membrane permeability was compromised. Consequently, the release of K⁺ from the cytosol lead to the alterations of the zeta potential of cells, which would disturb the subcellular localization of some proteins, and thereby causing bacterial inactivation. Moreover, remarkable interaction with DNA was also observed. SML at sub-MIC inhibited biofilm formation by these bacteria.

Temperature and composition dependence of the density, viscosity and refractive index of binary mixtures of a novel gemini ionic liquid with acetonitrile

Excess molar volume VEm for the system of [MPiC₆Py][NTf₂]₂ (1) + MeCN (2) at various temperatures; solid line, Redlich–Kister correlation.

DNA-Based Asymmetric Catalysis: Role of Ionic Solvents and Glymes

Recently, DNA has been evaluated as a chiral scaffold for metal complexes to construct so called 'DNA-based hybrid catalysts', a robust and inexpensive alternative to enzymes. The unique chiral structure of DNA allows the hybrid catalysts to catalyze various asymmetric synthesis reactions. However, most current studies used aqueous buffers as solvents for these asymmetric reactions, where substrates/products are typically suspended in the solutions. The mass transfer limitation usually requires a long reaction time. To overcome this hurdle and to advance DNA-based asymmetric catalysis, we evaluated a series of ionic liquids (ILs), inorganic salts, deep eutectic solvents (DES), glymes, glycols, acetonitrile and methanol as co-solvents/additives for the DNA-based asymmetric Michael addition. In general, these additives induce indistinguishable changes to the DNA B-form duplex conformation as suggested by circular dichroism (CD) spectroscopy, but impose a significant influence on the catalytic efficiency of the DNA-based hybrid catalyst. Conventional organic solvents (e.g. acetonitrile and methanol) led to poor product yields and/or low enantioselectivities. Most ILs and inorganic salts cause the deactivation of the hybrid catalyst except 0.2 M [BMIM][CF3COO] (95.4% ee and 93% yield) and 0.2 M [BMIM]Cl (93.7% ee and 89% yield). Several other additives have also been found to improve the catalytic efficiency of the DNA-based hybrid catalyst (control reaction without additive gives >99% ee and 87% yield): 0.4 M glycerol (>99% ee and 96% yield at 5 °C or 96.2% ee and 83% yield at room temperature), 0.2 M choline chloride/glycerol (1:2) (92.4% ee and 90% yield at 5 °C or 94.0% ee and 88% yield at room temperature), and 0.5 M dipropylene glycol dimethyl ether (>99% ee and 87% yield at room temperature). The use of some co-solvents/additives allows the Michael addition to be performed at a higher temperature (e.g. room temperature vs 5 °C) and a shorter reaction time (24 h vs 3 days). In addition, we found that a brief pre-sonication (5 min) of DNA in MOPS buffer prior to the reaction could improve the performance of the DNA-based hybrid catalyst. We have also shown that this DNA-based catalysis method is suitable for a variety of different substrates and relatively large-scale reactions. In conclusion, a judicious selection of benign co-solvents/additives could improve the catalytic efficiency of DNA-based hybrid catalyst.

Glymes as new solvents for lipase activation and biodiesel preparation

Glymes (i.e. glycol diethers) were explored as alternative benign solvents for enzymatic reactions, specifically the lipase-catalyzed transesterification. Long-chain glymes were found highly compatible with immobilized Candida antarctica lipase B (iCALB), leading to higher enzyme activities and stabilities than t-butanol and ionic liquids (e.g. the rate of transesterification in diethylene glycol dibutyl ether (G2-Bu) was 77% higher than that in t-butanol). Furthermore, soybean oil was found fully miscible with glymes, which enabled a homogeneous reaction mixture for the enzymatic preparation of biodiesel. In the presence of glymes, CALB showed a very high tolerance to high methanol concentrations (up to 60-70% v/v), and nearly stoichiometric triglyceride conversions could be obtained under mild reaction conditions. A laboratory scale-up achieved a high conversion of soybean oil (95.5%). This study suggests that glymes can be environmentally friendly and inexpensive solvents for lipase-catalyzed reactions, such as the enzymatic preparation of biodiesel.

Ether- and alcohol-functionalized task-specific ionic liquids: attractive properties and applications

In recent years, the designer nature of ionic liquids (ILs) has driven their exploration and exploitation in countless fields among the physical and chemical sciences. A fair measure of the tremendous attention placed on these fluids has been attributed to their inherent designer nature. And yet, there are relatively few examples of reviews that emphasize this vital aspect in an exhaustive or meaningful way. In this critical review, we systematically survey the physicochemical properties of the collective library of ether- and alcohol-functionalized ILs, highlighting the impact of ionic structure on features such as viscosity, phase behavior/transitions, density, thermostability, electrochemical properties, and polarity (e.g. hydrophilicity, hydrogen bonding capability). In the latter portions of this review, we emphasize the attractive applications of these functionalized ILs across a range of disciplines, including their use as electrolytes or functional fluids for electrochemistry, extractions, biphasic systems, gas separations, carbon capture, carbohydrate dissolution (particularly, the (ligno)celluloses), polymer chemistry, antimicrobial and antielectrostatic agents, organic synthesis, biomolecular stabilization and activation, and nanoscience. Finally, this review discusses anion-functionalized ILs, including sulfur- and oxygen-functionalized analogs, as well as choline-based deep eutectic solvents (DESs), an emerging class of fluids which can be sensibly categorized as semi-molecular cousins to the IL. Finally, the toxicity and biodegradability of ether- and alcohol-functionalized ILs are discussed and cautiously evaluated in light of recent reports. By carefully summarizing literature examples on the properties and applications of oxy-functional designer ILs up till now, it is our intent that this review offers a barometer for gauging future advances in the field as well as a trigger to spur further contemplation of these seemingly inexhaustible and--relative to their potential--virtually untouched fluids. It is abundantly clear that these remarkable fluidic materials are here to stay, just as certain design rules are slowly beginning to emerge. However, in fairness, serendipity also still plays an undeniable role, highlighting the need for both expanded in silico studies and a beacon to attract bright, young researchers to the field (406 references).

Protease activation in glycerol-based deep eutectic solvents

Deep eutectic solvents (DESs) consisting of mixtures of a choline salt (chloride or acetate form) and glycerol are prepared as easily accessible, biodegradable, and inexpensive alternatives to conventional aprotic cation-anion paired ionic liquids. These DES systems display excellent fluidity coupled with thermal stability to nearly 200 °C. In this work, the transesterification activities of cross-linked proteases (subtilisin and α-chymotrypsin), immobilized on chitosan, were individually examined in these novel DESs. In the 1:2 molar ratio mixture of choline chloride/glycerol containing 3% (v/v) water, cross-linked subtilisin exhibited an excellent activity (2.9 μmo l min(-1) g(-1)) in conjunction with a selectivity of 98% in the transesterification reaction of N-acetyl-L-phenylalanine ethyl ester with 1-propanol. These highly encouraging results advocate more extensive exploration of DESs in protease-mediated biotransformations of additional polar substrates and use of DESs in biocatalysis more generally.

Biodiesel synthesis and conformation of lipase from Burkholderia cepacia in room temperature ionic liquids and organic solvents

Biodiesel synthesis and conformation of Burkholderia cepacia lipase (BCL) were studied in 19 different room temperature ionic liquids (RTLLs) with a range of cation and anion structures. Overall, anion selection had a greater influence on biodiesel conversion than cation choice. RTILs containing Tf2N- and PF6- anions were suitable reaction media, while RTIL of [OmPy][BF4] was the best reaction medium with a biodiesel yield of 82.2±1.2%. RTILs with strong water miscible properties showed very low biodiesel yields. Conformational analysis by FT-IR revealed that higher biodiesel conversion in RTILs was correlated with a low tendency in α-helix content of BCL. An ultrasound-assisted biocatalysis process in RTILs was used to improve mass transfer rate, leading to 83% reduction of the reaction time for biodiesel production.

New eutectic ionic liquids for lipase activation and enzymatic preparation of biodiesel

The enzymatic preparation of biodiesel has been hampered by the lack of suitable solvents with desirable properties such as high lipase compatibility, low cost, low viscosity, high biodegradability, and ease of product separation. Recent interest in using ionic liquids (ILs) as advanced reaction media has led to fast reaction rates and high yields in the enzymatic synthesis of biodiesel. However, conventional (i.e., cation-anion paired) ILs based on imidazolium and other quaternary ammonium salts remain too expensive for wide application at industrial scales. In this study, we report on newly-synthesized eutectic ILs derived from choline acetate or choline chloride coupled with biocompatible hydrogen-bond donors, such as glycerol. These eutectic solvents have favorable properties including low viscosity, high biodegradability, and excellent compatibility with Novozym(®) 435, a commercial immobilized Candida antarctica lipase B. Furthermore, in a model biodiesel synthesis system, we demonstrate high reaction rates for the enzymatic transesterification of Miglyol(®) oil 812 with methanol, catalyzed by Novozym(®) 435 in choline acetate/glycerol (1:1.5 molar ratio). The high conversion (97%) of the triglyceride obtained within 3 h, under optimal conditions, suggests that these novel eutectic solvents warrant further exploration as potential media in the enzymatic production of biodiesel.