Metal doped manganese oxide octahedral molecular sieve catalysts for degradation of diclofenac in the presence of peroxymonosulfate

In-situ construct CuInS2/Bi/Bi2MoO6 S-scheme/Schottky dual heterojunctions catalyst for enhanced photocatalytic degradation of diclofenac sodium

In this paper, the S-scheme/Schottky heterojunction photocatalyst (CuInS2/Bi/Bi2MoO6, CIS/Bi/BMO) was successfully constructed via a facile in-situ solvothermal method, aimed at enhancing its photocatalytic performance. The results of the study on the photocatalytic degradation of diclofenac sodium (DCF) under simulated solar light irradiation revealed that the as-prepared composite exhibited remarkable catalytic efficiency in comparison to the pristine Bi2MoO6 and CuInS2. The plasmonic bismuth (Bi) was formed during the solvothermal process. Subsequently, CuInS2 and Bi were grown on the surface of Bi2MoO6 leading to forming CIS/BMO S-scheme heterojunction, along with a Schottky junction between Bi and Bi2MoO6. The use of ethylene glycol as a support was the main reason for the significant improvement in photocatalytic efficiency in the degradation of DCF. Moreover, the probable photocatalytic mechanisms for the degradation of DCF had been proposed based on the active species quenching experiments. The eleven degradation products were detected by HPLC-MS, and the degradation reaction pathway of DCF was deduced. Additionally, the CIS/Bi/BMO photocatalyst exhibited a consistently high removal rate after four cycles. This study proposes a new strategy for designing efficient S-scheme/Schottky heterojunction photocatalysts for solar energy conversion.

Magnetic Co/CoOx@NCNT catalysts for activation of potassium peroxymonosulfate to deteriorate phenol from wastewater

Phenols are of much toxicological and they must be effectively removed from the wastewater from industries as well as sewage treatment. Such removal demands a special and strong composite. So, this piece of research aims to activate Potassium peroxymonosulfate (PPMS) with the large surface area of magnetite nitrogen-fixed porous carbon nanotube composites (Co/CoOx@NCNT). Increases in the graphitization degree and structural control brought about by the incorporation of reduced Graphite oxide (rGO) significantly increased the catalyst activity of Co/CoOx@NCNT. It was found that PPMS activation for phenol removal by Co/CoOx@NCNT was nearly as effective as by homogeneous Co²⁺, with nearly 100% removal efficiency in 10 min. Both high reusability and high recycling of Co/CoOx@NCNT were accomplished simultaneously by proving the technology of viability in practical applications. The PPMS activation mechanism in the Co/CoOx@NCNT/PPMS system was driven by the electron transmission from contaminants to PPMS through the sp^2- hybrid carbon nanotubes and nitrogen system. The selectivity of the Co/CoOx@NCNT/PPMS system to remove diverse organic compounds was determined by batch experiments. Due to the insignificant impact of radicals reactive on pollutant breakdown, the ability to inhibit species (such as Cl^- and natural organic materials) from a minor role was significantly decreased. These results not only shed light on the process of PPMS heterogeneous activation but also provided a framework for the balanced project of highly effective nanocarbon-based catalysts for PPMS activation.

The efficient degradation of diclofenac by ferrate and peroxymonosulfate: performances, mechanisms, and toxicity assessment

In this study, the degradation efficiency and reaction mechanisms of diclofenac (DCF), a nonsteroidal anti-inflammatory drug, by the combination of ferrate (Fe(VI) and peroxymonosulfate (PMS) (Fe(VI)/PMS) were systematically investigated. The higher degradation efficiency of DCF in Fe(VI)/PMS system can be obtained than that in alone persulfate (PS), Fe(VI), PMS, or the Fe(VI)/PS process at pH 6.0. DCF was efficiently removed in Fe(VI)/PMS process within a wide range of pH values from 4.0 to 8.0, with higher degradation efficiency in acidic conditions. The increasing reaction temperature (10 to 30 ℃), Fe(VI) dose (6.25 to 100 µM), or PMS concentration (50 to 1000 µM) significantly enhanced the DCF degradation. The existences of HCO₃¯, Cl¯, and humic acid (HA) obviously inhibited the DCF removal. Electron paramagnetic resonance (EPR), free radical quenching, and probing experiments confirmed the existence of sulfate radicals (SO₄^•¯), hydroxyl radicals (^•OH), and Fe(V)/ Fe(IV), which are responsible for DCF degradation in Fe(VI)/PMS system. The variations of TOC removal ratio reveal that the adsorption of organics with ferric particles, formed in the reduction of Fe(VI), also were functioned in the removal process. Sixteen DCF transformation byproducts were identified by UPLC-QTOF/MS, and the toxicity variation was evaluated. Consequently, eight reaction pathways for DCF degradation were proposed. This study provides theoretical basis for the utilization of Fe(VI)/PMS process.

Effects of foreign metal doping on the step-by-step oxidation process in M-OMS-2 catalyzed activation of PMS

Various metal cations M (M = Mg²⁺, Ca²⁺, Zn²⁺, Cu²⁺, Fe³⁺) were doped into the tunnel of manganese octahedral molecular sieve (OMS-2). Redox-inactive metal (Ca, Mg and Zn) doped OMS-2 exhibited better peroxymonosulfate (PMS) catalytic activity than redox metal-doped Cu-OMS-2 and Fe-OMS-2. Redox-inactive metals doping improves the conductivity and reducibility of the catalyst, while transition metal doping reduces the dispersion of manganese. More importantly, the degradation of ACE can be divided into two stages. In the first stage, ACE was oxidized dominantly through mediated electron transfer process. Subsequently, singlet oxygen (¹O₂) gradually dominated oxidative degradation in the second stage, which was derived from the reaction between superoxide radical (O₂^•-) and metastable manganese intermediates. The long half-life of O₂^•- on the surface of OMS-2 ensured the delay generation of ¹O₂. This study not only provides a new idea for improving the efficiency of heterogeneous catalysts activation of PMS, but also meaningful for the in-depth study of multiple reaction mechanisms in PMS activation processes.

Manganese-based advanced nanoparticles for biomedical applications: future opportunity and challenges

Nanotechnology is the most promising technology to evolve in the last decade. Recent research has shown that transition metal nanoparticles especially manganese (Mn)-based nanoparticles have great potential for various biomedical applications due to their unique fundamental properties. Therefore, globally, scientists are concentrating on the development of various new manganese-based nanoparticles (size and shape dependent) due to their indispensable utilities. Although numerous reports are available regarding the use of manganese nanoparticles, there is no comprehensive review highlighting the recent development of manganese-based nanomaterials and their potential applications in the area of biomedical sciences. The present review article provides an overall survey on the recent advancement of manganese nanomaterials in biomedical nanotechnology and other fields. Further, the future perspectives and challenges are also discussed to explore the wider application of manganese nanoparticles in the near future. Overall, this review presents a fundamental understanding and the role of manganese in various fields, which will attract a wider spectrum of the scientific community.

A novel LaFeO3 catalyst synthesized from sodium diethylenetriamine pentamethylene phosphonate for degradation of diclofenac through peroxymonosulfate activation: degradation pathways and mechanism study

A series of LaFeO3 catalysts were prepared using the sol–gel method with sodium diethylenetriamine pentamethylene phosphonate as the complexing agent and were applied to activate PMS to produce active oxides to degrade DCF.

Photo-assisted peroxymonosulfate activation via 2D/2D heterostructure of Ti3C2/g-C3N4 for degradation of diclofenac

In this paper, a two dimensional/two dimensional (2D/2D) heterostructure of Ti₃C₂/g-C₃N₄ (T/CN) was constructed and used to activate peroxymonosulfate (PMS) for the degradation of diclofenac (DCF) in water in the presence of light illumination. Compared with single photocatalytic process by T/CN (0.040/min) and with pure g-C₃N₄ nanosheets in PMS system (0.071/min), 5.0 and 3.0 times enhanced activities were achieved in the T/CN-PMS system at optimum Ti₃C₂ (1.0 wt%) loading under light illumination (0.21/min). Moreover, the decomposing processes of DCF in T/CN-PMS system were applicable in a wide initial pH range (3∼14), therefore, overcoming the limitation of pH dependence in traditional PMS system. Based on the synergistic effect of photocatalysis and PMS oxidation processes, the ¹O₂ was generated as primary reactive species for the removal of DCF in T/CN-PMS system. The DCF degradation mechanism was further proposed through the results of liquid chromatography-mass spectrometry (LC-MS) and density functional theory (DFT) calculations.

Transition element doped octahedral manganese molecular sieves (Me-OMS-2) as diclofenac adsorbents

Diclofenac (DCF) control measures have become an area of increased interest for environmental researchers due to the high environmental concentration and risk of DCF. Adsorption seems to be promising for DCF removal from the aqueous phase because of its specific superiority in comparison with biodegradation, membrane separation, and advanced oxidation or reduction. In this study, OMS-2 and metal-doped OMS-2 ((Me-OMS-2, with Me = Co, Cu or Ce) were prepared and tested as adsorbents for the removal of DCF. It was evident that the maximum adsorption capacity and rate of Ce-OMS-2 were much higher than those of the other adsorbents, which could be attributed to its large specific surface area and stereoscopic aperture structure. The experimental data are fitted the pseudo-second-order model, the Elovich equation and the Langmuir model well; moreover, the process is an endothermic and spontaneous thermodynamic process, during which the entropy increased, based on the experimental results, indicating that chemisorption was dominant during the DCF adsorption process onto Ce-OMS-2. By the integral of the peak deconvoluted from the XPS spectrum, the ratio of Mn³⁺/Mn⁴⁺ increased from 0.393 to 0.407, revealing that Mn(IV) is rarely reduced into Mn(III) during the DCF adsorption process.

Binuclear cobalt phthalocyanine supported on manganese octahedral molecular sieve: High-efficiency catalyzer of peroxymonosulfate decomposition for degrading propranolol

Propranolol (PRO) is widely detected in the aquatic environment and proved to be detrimental to multifarious aquatic organisms. In view of some virtues of sulfate radicals than hydroxyl radicals, advanced oxidation technologies that involve the activation of peroxymonosulfate (PMS) have stimulated wide-ranging research on the PRO removal. In this paper, a composite (C₂NOMS-2) of amino-functionalized manganese octahedral molecular sieve (NOMS-2) and binuclear cobalt phthalocyanine (Co₂CPc) was synthesized easily, and utilized as a catalyzer for PMS to degrade PRO in water. The apparent rate constants of PRO degradation by PMS with C₂NOMS-2 as a catalyst was found to be higher than with NOMS-2, Co₂CPc and the composite of uninuclear cobalt phthalocyanine (CoCPc) and NOMS-2. The catalytic ability of C₂NOMS-2 was investigated under various reaction conditions: catalyst dosages (0.5-2.0 g/L), PMS doses (50-500 mg/L), initial pH (5-11), reaction temperature (20-35 °C), and natural water constituents (Cl^-, HCO₃^-, and sodium huminate). Radical scavenging tests and electron paramagnetic resonance spectroscopy showed that ¹O₂ was the most critical reactive oxygen species, and conceivable mechanisms of PMS activation with C₂NOMS-2 were proposed established on the curve estimation of high-resolution XPS spectra, revealing that the generation of reactive oxygen species was mainly resulted from the cycles of Mn³⁺/Mn⁴⁺, Co³⁺/Co²⁺ and surface lattice oxygen/surface adsorbed oxygen. The intermediate products of propranolol degradation were identified by LC-MS/MS. Cycling experiments and ion dissolution detection suggested that C₂NOMS-2 could maintain satisfactory stability in an aqueous system.

Heterogeneous activation of persulfate by Co3O4-CeO2 catalyst for diclofenac removal

A series of Co₃O₄-CeO₂ mixed metal oxides were synthesized by co-precipitation method and successfully used to activate persulfate for diclofenac removal. The effects of Co:Ce mole ratio, calcination temperature and calcination time on the catalytic activities were investigated. Results showed that the activity of Co₃O₄-CeO₂ catalysts increased with Co:Ce mole ratio from 1:9 to 7:3, and decreased with the calcination temperature from 300 to 800 °C. 90% diclofenac was removed with Co₇Ce₃-300-1 catalyst (Co:Ce = 7:3, calcinated at 300 °C for 1 h) after 15 min. Moreover, short calcination time and low temperature resulted in smaller crystallite size, more structural defects, more active crystal surfaces and larger surface area of the catalyst, which led to higher removal efficiency of diclofenac. The high ratios of Co²⁺/Co³⁺, Ce³⁺/Ce⁴⁺ and O_ads/O_latt were very important to enhance the catalytic activity. Finally, a potential reaction mechanism was proposed based on characterization of the fresh and spent catalysts.

Cobalt tetracarboxyl phthalocyanine-manganese octahedral molecular sieve (OMS-2) as a heterogeneous catalyst of peroxymonosulfate for degradation of diclofenac

A composite of cobalt tetracarboxyl phthalocyanine and amino-functionalized manganese octahedral molecular sieve (CNOMS-2) was synthesized in a simple way, and applied for degrading diclofenac in aqueous media by catalyzing of peroxymonosulfate heterogeneously. The experiment results revealed that the CNOMS-2/PMS system was highly efficient for DCF degradation in the pH range of 5-9, and the mechanism involved the generation of OH, SO₄⁻ and ¹O₂ by the activation of PMS. The main reactive oxygen species was found to be ¹O₂ by radical scavenging experiments and electron paramagnetic resonance (EPR) spectroscopy. Further, a carboxylation product of DCF at m/z 340 was found to be a prominent intermediate of the reaction in this system specially, as determined by LC-MS/MS. The reusability and ion leaching concentrations under different pH were also examined to determine the application prospects of the catalyst.