ZnO supported on high silica HZSM-5 as new catalysts for dehydrogenation of propane to propene in the presence of CO2

Research Progress on Propylene Preparation by Propane Dehydrogenation

At present, the production of propylene falls short of the demand, and, as the global economy grows, the demand for propylene is anticipated to increase even further. As such, there is an urgent requirement to identify a novel method for producing propylene that is both practical and reliable. The primary approaches for preparing propylene are anaerobic and oxidative dehydrogenation, both of which present issues that are challenging to overcome. In contrast, chemical looping oxidative dehydrogenation circumvents the limitations of the aforementioned methods, and the performance of the oxygen carrier cycle in this method is superior and meets the criteria for industrialization. Consequently, there is considerable potential for the development of propylene production by means of chemical looping oxidative dehydrogenation. This paper provides a review of the catalysts and oxygen carriers employed in anaerobic dehydrogenation, oxidative dehydrogenation, and chemical looping oxidative dehydrogenation. Additionally, it outlines current directions and future opportunities for the advancement of oxygen carriers.

CO2-Assisted Dehydrogenation of Propane to Propene over Zn-BEA Zeolites: Impact of Acid–Base Characteristics on Catalytic Performance

Research results about the influence of BEA zeolite preliminary dealumination on the acid–base characteristics and catalytic performance of 1% Zn-BEA compositions in propane dehydrogenation with CO2 are presented. The catalyst samples, prepared through a two-step post-synthesis procedure involving partial or complete dealumination of the BEA specimen followed by the introduction of Zn2+ cations into the T-positions of the zeolite framework, were characterized using XRD, XPS, MAS NMR, SEM/EDS, low-temperature N2 ad/desorption, C3H8/C3H6 (CO2, NH3)-TPD, TPO-O2, and FTIR-Py techniques. Full dealumination resulted in the development of a mesoporous structure and specific surface area (BET) with a twofold decrease in the total acidity and basicity of Zn-BEA, and the formation of Lewis acid sites and basic sites of predominantly medium strength, as well as the removal of Brønsted acid sites from the surface. In the presence of the ZnSiBEA catalyst, which had the lowest total acidity and basicity, the obtained selectivity of 86–94% and yield of 30–33% for propene (at 923 K) exceeded the values for ZnAlSiBEA and ZnAlBEA. The results of propane dehydrogenation with/without carbon dioxide showed the advantages of producing the target olefin in the presence of CO2 using Zn-BEA catalysts.

Advanced zeolite and ordered mesoporous silica-based catalysts for the conversion of CO2 to chemicals and fuels

For many years, capturing, storing or sequestering CO₂ from concentrated emission sources or from air has been a powerful technique for reducing atmospheric CO₂. Moreover, the use of CO₂ as a C1 building block to mitigate CO₂ emissions and, at the same time, produce sustainable chemicals or fuels is a challenging and promising alternative to meet global demand for chemicals and energy. Hence, the chemical incorporation and conversion of CO₂ into valuable chemicals has received much attention in the last decade, since CO₂ is an abundant, inexpensive, nontoxic, nonflammable, and renewable one-carbon building block. Nevertheless, CO₂ is the most oxidized form of carbon, thermodynamically the most stable form and kinetically inert. Consequently, the chemical conversion of CO₂ requires highly reactive, rich-energy substrates, highly stable products to be formed or harder reaction conditions. The use of catalysts constitutes an important tool in the development of sustainable chemistry, since catalysts increase the rate of the reaction without modifying the overall standard Gibbs energy in the reaction. Therefore, special attention has been paid to catalysis, and in particular to heterogeneous catalysis because of its environmentally friendly and recyclable nature attributed to simple separation and recovery, as well as its applicability to continuous reactor operations. Focusing on heterogeneous catalysts, we decided to center on zeolite and ordered mesoporous materials due to their high thermal and chemical stability and versatility, which make them good candidates for the design and development of catalysts for CO₂ conversion. In the present review, we analyze the state of the art in the last 25 years and the potential opportunities for using zeolite and OMS (ordered mesoporous silica) based materials to convert CO₂ into valuable chemicals essential for our daily lives and fuels, and to pave the way towards reducing carbon footprint. In this review, we have compiled, to the best of our knowledge, the different reactions involving catalysts based on zeolites and OMS to convert CO₂ into cyclic and dialkyl carbonates, acyclic carbamates, 2-oxazolidones, carboxylic acids, methanol, dimethylether, methane, higher alcohols (C₂₊OH), C₂₊ (gasoline, olefins and aromatics), syngas (RWGS, dry reforming of methane and alcohols), olefins (oxidative dehydrogenation of alkanes) and simple fuels by photoreduction. The use of advanced zeolite and OMS-based materials, and the development of new processes and technologies should provide a new impulse to boost the conversion of CO₂ into chemicals and fuels.

Research progress of CO2 oxidative dehydrogenation of propane to propylene over Cr-free metal catalysts

CO₂-assisted oxidative dehydrogenation of propane (CO₂-ODHP) is an attractive strategy to offset the demand gap of propylene due to its potentiality of reducing CO₂ emissions, especially under the demands of peaking CO₂ emissions and carbon neutrality. The introduction of CO₂ as a soft oxidant into the reaction not only averts the over-oxidation of products, but also maintains the high oxidation state of the redox-active sites. Furthermore, the presence of CO₂ increases the conversion of propane by coupling the dehydrogenation of propane (DHP) with the reverse water gas reaction (RWGS) and inhibits the coking formation to prolong the lifetime of catalysts via the reverse Boudouard reaction. An effective catalyst should selectively activate the C-H bond but suppress the C-C cleavage. However, to prepare such a catalyst remains challenging. Chromium-based catalysts are always applied in industrial application of DHP; however, their toxic properties are harmful to the environment. In this aspect, exploring environment-friendly and sustainable catalytic systems with Cr-free is an important issue. In this review, we outline the development of the CO₂-ODHP especially in the last ten years, including the structural information, catalytic performances, and mechanisms of chromium-free metal-based catalyst systems, and the role of CO₂ in the reaction. We also present perspectives for future progress in the CO₂-ODHP.

CeO2-Promoted PtSn/SiO2 as a High-Performance Catalyst for the Oxidative Dehydrogenation of Propane with Carbon Dioxide

The oxidative dehydrogenation of propane with CO₂ (CO₂-ODP) has been extensively investigated as a promising green technology for the efficient production of propylene, but the lack of a high-performance catalyst is still one of the main challenges for its industrial application. In this work, an efficient catalyst for CO₂-ODP was developed by adding CeO₂ to PtSn/SiO₂ as a promoter via the simple impregnation method. Reaction results indicate that the addition of CeO₂ significantly improved the catalytic activity and propylene selectivity of the PtSn/SiO₂ catalyst, and the highest space-time yield of 1.75 g(C₃H₆)·g(catalyst)^-1·h^-1 was achieved over PtSn/SiO₂ with a Ce loading of 6 wt%. The correlation of the reaction results with the characterization data reveals that the introduction of CeO₂ into PtSn/SiO₂ not only improved the Pt dispersion but also regulated the interaction between Pt and Sn species. Thus, the essential reason for the promotional effect of CeO₂ on CO₂-ODP performance was rationally ascribed to the enhanced adsorption of propane and CO₂ originating from the rich oxygen defects of CeO₂. These important understandings are applicable in further screening of promoters for the development of a high-performance Pt-based catalyst for CO₂-ODP.

Coupling of propane with CO2 to propylene over Zn-promoted In/HZSM-5 catalyst

The ZnIn/HZSM-5 catalyst was prepared by the wetness impregnation method, and the structure of catalyst was characterized by XRD, SEM, TEM, H2-TPR, NH3-TPD, XPS, TG, and N2 adsorption–desorption and then investigated in the coupling of propane with CO2 to propylene. It is found that the addition of Zn species is beneficial to the dispersion of In2O3 over HZSM-5, which plays an important role in propene formation, and adjusts the acidity distribution of In/HZSM-5 catalyst, as well as significantly improves the activity of In/HZSM-5 catalyst. The selectivity of propylene is 68.21% in the coupling of propane with CO2 over ZnIn/HZSM-5 catalyst when the time on stream (TOS) is 2 h, reaction temperature is 580 °C, reaction pressure is 0.3 MPa, C3H6:CO2:N2 = 1:4:5, catalyst mass is 0.2 g, and space velocity is 6000 mL gcat−1 h−1. However, the selectivity of propylene is only 63.33% and 0.25% in the propane dehydrogenation or CO2 hydrogenation reaction, respectively. The ZnIn/HZSM-5 catalyst showed a higher stability with only 0.80% conversion drop after three cycles.

C–H and C–C bond activation of propane to propylene and ethylene selectivity assisted by CO2 over titania catalysts

C–H and C–C bond activation of propane to propylene and ethylene selectivity assisted by CO2 over titania catalysts.

The Role of CO2 as a Mild Oxidant in Oxidation and Dehydrogenation over Catalysts: A Review

Carbon dioxide (CO2) is widely used as an enhancer for industrial applications, enabling the economical and energy-efficient synthesis of a wide variety of chemicals and reducing the CO2 levels in the environment. CO2 has been used as an enhancer in a catalytic system which has revived the exploitation of energy-extensive reactions and carry chemical products. CO2 oxidative dehydrogenation is a greener alternative to the classical dehydrogenation method. The availability, cost, safety, and soft oxidizing properties of CO2, with the assistance of appropriate catalysts at an industrial scale, can lead to breakthroughs in the pharmaceutical, polymer, and fuel industries. Thus, in this review, we focus on several applications of CO2 in oxidation and oxidative dehydrogenation systems. These processes and catalytic technologies can reduce the cost of utilizing CO2 in chemical and fuel production, which may lead to commercial applications in the imminent future.

Enhanced propane dehydrogenation to propylene over zinc-promoted chromium catalysts

A small-size Zn–Cr spinel with defect sites formed by adding Zn to Cr₂O₃ is favorable for the PDH reaction.

Zinc-Based Curing Activators: New Trends for Reducing Zinc Content in Rubber Vulcanization Process

The efficiency of sulfur vulcanization reaction in rubber industry is generally improved thanks to the combined use of accelerators (as sulphenamides), activators (inorganic oxides), and co-activators (fatty acids). The interaction among these species is responsible for the formation of intermediate metal complexes, which are able to increase the reactivity of sulfur towards the polymer and to promote the chemical cross-links between the rubber chains. The high number of species and reactions that are involved contemporarily in the process hinders the complete understanding of its mechanism despite the long history of vulcanization. In this process, ZnO is considered to be the most efficient and major employed activator and zinc-based complexes that formed during the first steps of the reaction are recognized to play a main role in determining both the kinetic and the nature of the cross-linked products. However, the low affinity of ZnO towards the rubber entails its high consumption (3–5 parts per hundred, phr) to achieve a good distribution in the matrix, leading to a possible zinc leaching in the environment during the life cycle of rubber products (i.e., tires). Thanks to the recent recognition of ZnO ecotoxicity, especially towards the aquatic environment, these aspects gain a critical importance in view of the urgent need to reduce or possibly substitute the ZnO employed in rubber vulcanization. In this review, the reactivity of ZnO as curing activator and its role in the vulcanization mechanism are highlighted and deeply discussed. A complete overview of the recent strategies that have been proposed in the literature to improve the vulcanization efficiency by reducing the amount of zinc that is used in the process is also reported.

Facile synthesis of ordered mesoporous zinc alumina catalysts and their dehydrogenation behavior

Ordered mesoporous Zn/Al2O3 materials with varying Zn content were simply prepared via an evaporation-induced self-assembly (EISA) method. Dehydrogenation of isobutane to isobutene was carried out on these materials; an isobutane conversion of 45.0% and isobutene yield of 39.0% were obtained over the 10%Zn/Al2O3 catalyst at 580 °C with 300 h-1 GHSV. The obtained materials with Zn content up to 10% possess large specific surface area and big pore volume and zinc species can be highly dispersed on the surface or incorporated into the framework. The acidity of these catalysts was changed by the introduction of Zn, the decrease of strong acid sites is conducive to the promotion of isobutene selectivity and the weak and medium acidic sites played an important role in isobutane conversion. In addition, these catalysts exhibited good catalytic stability, due to the effective inhibition of coke formation by the ordered mesoporous structure.

Silicalite-1 zeolite acidification by zinc modification and its catalytic properties for isobutane conversion

Silicalite-1 zeolite was successfully acidified by zinc modification, the prepared Znx/S-1 catalysts exhibited excellent catalytic performances in both isobutane dehydrogenation and butene isomerization reactions.

Effect of steam and CO2 on ethane activation over Zn-ZSM-5

Hydrolysis of Zn(ii) sites in Zn-ZSM-5 suppresses ethane oligomerization and aromatization.

Bio-oil production via catalytic solvolysis of biomass

Recent studies have found that biomass has great potential as a substitute for natural fossil fuels.

ZnO modified ZSM-5 and Y zeolites fabricated by atomic layer deposition for propane conversion

Zeolite supported highly dispersed ZnO fabricated by ALD is an effective catalyst for conversion of propane to propylene and aromatics.

Phosphorous-modified ordered mesoporous carbon for catalytic dehydrogenation of propane to propylene

In the DH of propane, the PO groups were believed to be electron donors for CO active centers, or independent active centers.